DOI QR코드

DOI QR Code

Experimental research on dynamic response of red sandstone soil under impact loads

  • Wang, Tong (School of Civil Engineering, Xi'an University of Architecture and Technology) ;
  • Song, Zhanping (School of Civil Engineering, Xi'an University of Architecture and Technology) ;
  • Yang, Jianyong (School of Resources and Environmental Engineering, Jiangxi University of Science and Technology) ;
  • Wang, Junbao (School of Civil Engineering, Xi'an University of Architecture and Technology) ;
  • Zhang, Xuegang (School of Civil Engineering, Xi'an University of Architecture and Technology)
  • Received : 2018.09.18
  • Accepted : 2019.03.06
  • Published : 2019.03.20

Abstract

The cycling impact test of red sandstone soil under different axial pressure and different impact loads are conducted to reveal the mechanical properties and energy consumption mechanism of red sandstone soil with static-dynamic coupling loading. The results show that: Under the action of different axial pressure and different impact loads, the peak stress of the specimen increases, and then tends to be stable with the times of impact. With the increase of impact times, the specific energy absorption value of the red sandstone soil specimen is increased first and then gentle development trend. When the impact loads are certain, the larger the axial pressure is, the smaller the peak value of energy absorption, which indicates that the energy utilization rate is not high under the condition of large axial pressure. Through the analysis of energy utilization, it is found that the smaller the impact load, the higher the energy utilization rate. The greater the axial pressure, the lower the energy utilization rate. when the axial pressure is large, the impact loads corresponding to the maximum values of reflectivity, transmissivity and absorptivity are the same. The relationship between reflectivity and transmissivity is negatively correlated.

Keywords

Acknowledgement

Supported by : National Natural Science Foundation

References

  1. Chakraborty, T., Mishra, S., Loukus, J., Halonen, B. and Bekkala, B. (2016), "Characterization of three himalayan rocks using a split hopkinson pressure bar", Int. J. Rock Mech. Min. Sci., 85, 112-118. https://doi.org/10.1016/j.ijrmms.2016.03.005
  2. Cheng, W.C., Song, Z.P., Tian, W. and Wang, Z.F. (2018), "Shield tunnel uplift and deformation characterisation: A case study from Zhengzhou metro", Tunn. Undergr. Sp. Technol., 79, 83-95. https://doi.org/10.1016/j.tust.2018.05.002
  3. Cheng, X.S., Xu, W.W., Yue, C.Q., Du, X.L. and Dowding, C.H. (2014), "Seismic response of fluid-structure interaction of undersea tunnel during bidirectional earthquake", Ocean Eng., 75(1), 64-70. https://doi.org/10.1016/j.oceaneng.2013.11.017
  4. Davies, E.D.H. and Hunter, S.C. (1963), "The dynamic compression testing of solidsbythe method of the split hopkinson bar", Mech. Phys. Solids, 11(3), 155-179 https://doi.org/10.1016/0022-5096(63)90050-4
  5. Hill, R. (1950), The Mathematical Theory of Plasticity, Oxford University Press, New York, U.S.A.
  6. Hong, L., Zhou, Z.L., Yin, T.B., Liao, G.Y. and Ye, Z.Y. (2009), "Energy consumption in rock fragmentation at intermediate strain rate", J. Central South Univ., 16(4), 677-682. https://doi.org/10.1007/s11771-009-0112-5
  7. Huang, M., Xu, C.S., Zhan, J.W. and Wang, J.B. (2017), "Comparative study on dynamic properties of argillaceous siltstone and its grouting-reinforced body", Geomech. Eng., 13(2), 333-352. https://doi.org/10.12989/GAE.2017.13.2.333
  8. Jayasinghe, L.B., Zhou, H.Y., Goh, A.T.C., Zhao, Z.Y. and Gui, Y.L. (2017), "Pile response subjected to rock blasting induced ground vibration near soil-rock interface", Comput. Geotech., 82, 1-15. https://doi.org/10.1016/j.compgeo.2016.09.015
  9. Jin, J.F., Li, X.B. and Zhong, H.B. (2013), "Study of dynamic mechanical characteristic of sandstone subjected to threedimensional coupled static-cyclic impact loadings", Chin. J. Rock Mech. Eng., 32(7), 1358-1372.
  10. Kawamata, Y., Nakayama, M., Towhata, I. and Yasuda, S. (2016), "Dynamic behaviors of underground structures in e-defense shaking experiments", Soil Dyn. Earthq. Eng., 82, 24-39. https://doi.org/10.1016/j.soildyn.2015.11.008
  11. Kim, E., Garcia, A. and Changani, H. (2018), "Fragmentation and energy absorption characteristics of red, berea and buff sandstones based on different loading rates and water contents", Geomech. Eng., 14(2), 151-159. https://doi.org/10.12989/GAE.2018.14.2.151
  12. Kishii, T. (2016), "Utilization of underground space in Japan", Tunn. Undergr. Sp. Technol. Incorp. Trenchless Technol. Res., 55, 320-323. https://doi.org/10.1016/j.tust.2015.12.007
  13. Li, D.W. and Fan, J.H. (2018), "A study of mechanical property of artificial frozen clay under dynamic load", Adv. Civ. Eng., 1-8.
  14. Li, M., Mao, X.B., Lu, A.H., Tao, J., Zhang, G.H., Zhang, L.Y. and Li, C. (2014), "Effect of specimen size on energy dissipation characteristics of red sandstone under high strain rate", Int. J. Min. Sci. Technol., 24(2), 151-156. https://doi.org/10.1016/j.ijmst.2014.01.002
  15. Li, X.B., Li, C.J., Cao, W.Z. and Tao, M. (2018), "Dynamic stress concentration and energy evolution of deep-buried tunnels under blasting loads", Int. J. Rock Mech. Min. Sci., 104, 131-146. https://doi.org/10.1016/j.ijrmms.2018.02.018
  16. Liu, X.H., Dai, F., Zhang, R. and Liu, J.F. (2015), "Static and dynamic uniaxial compression tests on coal rock considering the bedding directivity", Environ. Earth Sci., 73(10), 5933-5949. https://doi.org/10.1007/s12665-015-4106-3
  17. Luo, H., Lu, H., Cooper, W.L. and Komanduri, R. (2011), "Effect of mass density on the compressive behavior of dry sand under confinement at high strain rates", Exper. Mech., 51(9), 1499-1510. https://doi.org/10.1007/s11340-011-9475-2
  18. Mishra, S., Rao, K.S., Gupta, N.K. and Kumar, A. (2018), "Damage to shallow tunnels in different geomaterials under static and dynamic loading", Thin-Walled Struct., 126, 138-149. https://doi.org/10.1016/j.tws.2017.11.051
  19. Nikadat, N. and Marji, M.F. (2016), "Analysis of stress distribution around tunnels by hybridized fsm and ddm considering the influences of joints parameters", Geomech. Eng., 11(2), 269-288. https://doi.org/10.12989/gae.2016.11.2.269
  20. Omidvar, M., Iskander, M. and Bless, S. (2012), "Stress-strain behavior of sand at high strain rates", Int. J. Impact Eng., 49(2), 192-213. https://doi.org/10.1016/j.ijimpeng.2012.03.004
  21. Ranjbarnia, M., Oreste, P., Fahimifar, A. and Arya, A. (2016), "Analytical-numerical solution for stress distribution around tunnel reinforced by radial fully grouted rockbolts", Int. J. Numer. Anal. Meth. Geomech., 40(13), 1844-1862. https://doi.org/10.1002/nag.2517
  22. Song, B., Chen, W.N. and Luk, V. (2009), "Impact compressive response of dry sand", Mech. Mater., 41(6), 777-785. https://doi.org/10.1016/j.mechmat.2009.01.003
  23. Song, Z.P., Yang, T.T. and Jiang, A.N. (2016), "Elastic-plastic numerical analysis of tunnel stability based on the closest point projection method considering the effect of water pressure", Math. Prob. Eng., 1-12.
  24. Wang, J.B., Song, Z.P., Zhao, B.Y., Liu, X.R., Liu, J. and Lai, J.X. (2017), "A study on the mechanical behavior and statistical damage constitutive model of sandstone", Arab. J. Sci. Eng., 43(10), 5179-5192. https://doi.org/10.1007/s13369-017-3016-y
  25. Yang, R.S., Chen, J., Yang, L.Y., Fang, S.Z. and Liu, J. (2017), "An experimental study of high strain-rate properties of clay under high consolidation stress", Soil Dyn. Earthq. Eng., 92, 46-51. https://doi.org/10.1016/j.soildyn.2016.09.036

Cited by

  1. Optimization Analysis of Controlled Blasting for Passing through Houses at Close Range in Super-Large Section Tunnels vol.2019, 2019, https://doi.org/10.1155/2019/1941436
  2. A Theoretical Calculation Method of Influence Radius of Settlement Based on the Slices Method in Tunnel Construction vol.2020, 2020, https://doi.org/10.1155/2020/5804823
  3. Energy Evolution Principles of Shock-Wave in Sandstone under Unloading Stress vol.24, pp.10, 2019, https://doi.org/10.1007/s12205-020-1691-9
  4. A New Zoning Method of Blasting Vibration Based on Energy Proportion and Its SVM Classification Models vol.2021, 2019, https://doi.org/10.1155/2021/6697682