Acknowledgement
This work has been supported by the UAV High Efficiency Turbine Research Center program of Defense Acquisition Program Administration and Agency for Defense Development.
References
- Bryer, D, W., and Pankhurst, R. C., 1971, "Pressure-probe methods for determining wind speed and flow direction," HMSO.
- Treaster, A. L., and Yocum, A. M., 1979., "The calibration and application of five-hole probes," ISA Trans. Vol. 18(3), pp. 23-34
- Pisasale, A. J., and Ahmed, N. A., 2002, "A novel method for extending the calibration range of five-hole probe for highly three-dimensional flows," Flow Meas. Instrum., Vol. 13(1-2), pp. 23-30. https://doi.org/10.1016/S0955-5986(02)00011-0
- Paul, A. R., Upadhyay, R. R., and Jain, A., 2011, "A novel calibration algorithm for five-hole pressure probe," Int. J. Eng. Sci. Technol., Vol. 3(2).
- Georgiou, D. P., and Milidonis, K. F., 2014, "Fabrication and calibration of a sub-miniature 5-hole probe with embedded pressure sensors for use in extremely confined and complex flow areas in turbomachinery research facilities," Flow Meas. Instrum., Vol 39, pp. 54-63. https://doi.org/10.1016/j.flowmeasinst.2014.07.005
- Gerner, A. A., Maurer, C. L., and Gallington, R. W., 1984, "Non-nulling seven-hole probes for high angle flow measurement. Exp. Fluids," Vol. 2(2), pp. 95-103. https://doi.org/10.1007/BF00261328
- Lee, S. W., and Jun, S. B., 2005, "Reynolds number effects on the non-nulling calibration of a cone-type five-hole probe for turbomachinery applications," J. Mech. Sci. Tech., Vol. 19(8), pp. 1632-1648. https://doi.org/10.1007/BF03023940
- Sumner, D., 2002, "A comparison of data-reduction methods for a seven-hole probe," J. Fluids Eng., Vol. 124(2), pp. 523-527. https://doi.org/10.1115/1.1455033