Journal of the Korea Academia-Industrial cooperation Society (한국산학기술학회논문지)

The Korea Academia-Industrial cooperation Society (한국산학기술학회)
권호 표지
DOI QR코드

DOI QR Code

Verification of Parameters Influencing Bond Strength between Fiber-Reinforced Polymer Laminates and Concrete

연속섬유(FRP)시트와 콘크리트의 부착강도 영향 요인 검증

  • Ko, Hune-Bum (Department of Architecture, Inha Technical College)
  • 고훈범 (인하공업전문대학 건축과)
  • Received : 2020.05.27
  • Accepted : 2020.09.04
  • Published : 2020.09.30
Download PDF
⟨ Previous Next ⟩

Abstract

Fiber-reinforced polymer (FRP) laminate sheets, which are lightweight with high strength, are commonly used to reinforce concrete structures. The bonding strength is vital in structural design. Therefore, experiments and analytical studies with differing variables (concrete compressive strength and tensile strength, the elastic modulus of concrete and FRP, thickness of concrete and FRP, width of concrete and FRP, bond length, effective bond length, fracture energy, maximum bond stress, maximum slip) have been conducted to obtain an accurate numerical model of the bond strength between an FRP sheet and concrete. Although many models have been proposed, no validated model has emerged that could be used easily in practice. Therefore, this study analyzed the parameters that influence the bond strength that were used in 23 of the proposed models (Khalifa model, Iso model, Maeda model, Chen model, etc.) and compared them to the test results of 188 specimens via the numerical results of each model. As a result, an easy-to-use practical model with a simple and high degree of expression was proposed based on the Iso model combined with the effective bond length model that was proposed by Holzenkӓmpfer.

최근 콘크리트 구조물을 보강하는데 경량이며 높은 강도를 가지고 있는 FRP(Fiber Reinforced Polymer)시트의 사용이 증가하고 있는데 구조물 보강 설계 시 부착 강도가 매우 중요하다. 그래서 FRP시트와 콘크리트 사이의 부착 강도에 대한 정확한 수치 모델을 얻기 위하여 많은 연구자가 다양한 변수(콘크리트 압축강도 및 인장강도, 콘크리트와 FRP의 탄성계수, 콘크리트와 FRP의 폭과 두께, 파괴에너지, 부착 길이, 유효부착길이, 최대 부착 응력과 최대 슬립)를 가지고 실험과 해석 연구를 수행하여 왔다. 결과적으로 많은 모델이 도출되었으나 실무에 쉽게 사용될 수 있는 검증된 모델은 제시되지 않았다. 그래서 본 연구는 현재까지 제안된 23개의 모델(Khalifa 모델, Iso 모델, Maeda 모델, Chen 모델 등)로부터 부착 강도에 미치는 요인을 분석하고 188개의 시험체에 대한 부착 강도 실험값을 각 모델들의 수치 결과 값과 비교하여 수식이 간단하고 높은 정도를 가진 사용하기 쉬운 모델을 제시하고자 하였다. 결과적으로 부착 강도 모델로 Iso 모델과 Holzenkӓmpfer 모델의 유효부착길이에 근거한 실용성 있는 모델을 제안하였다.

Keywords

References

  1. J. F. Chen, J. G. Teng, "Anchorage strength models for FRP and steel plates bonded to concrete", Journal of Structural Engineering, Vol. 127, No. 7, pp. 784-791, 2001. DOI: https://doi.org/10.1061/(ASCE)0733-9445(2001)127:7(784)
  2. T. Tanaka, Shear resisting mechanism of reinforced concrete beams with CFS as shear reinforcement, Graduation thesis, Hokkaido University, Japan, 1996.
  3. Y. Sato, T. Ueda, Y. Kakuta, T. Tanaka, "Shear reinforcing effect of carbon fibre sheet attached to side of reinforced concrete beams", Proc. of 2nd international conference on advanced composite materials in bridges and structures, Canadian Society for Civil Engineering, Montreal, pp. 621-627, 1996.
  4. Y. Hiroyuki, Z. Wu, "Analysis of debonding fracture properties of CFS strengthened member subject to tension", Proc. of 3rd international symposium on non-metallic (FRP) reinforcement for concrete structures, Vol. 1, pp. 287-294, 1997.
  5. H. Yoshizawa, Z. Wu, "Predicting Bond Strength between FRP Plates and Concrete Substrate: Applications of GMDH and MNLR Approaches", Proc. of 3rd international symposium on non-metallic (FRP) reinforcement for concrete structures, Vol. 1, pp. 284-294, 1997.
  6. T Maeda, Y Asano, Y Sato, T Ueda, Y Kakuta, "A study on bond mechanism of carbon fiber sheet", Proc. of 3rd international symposium on non-metallic (FRP) reinforcement for concrete structures, Vol. 1, Sapporo, Japan Concrete Institute, p.279-285, 1997.
  7. B. Taljsten, Plate bending: Strengthening of existing concrete structures with epoxy bonded plates of steel or fibre reinforced plastics. Doctoral thesis, Lulea University of Technology, Sweden, 1994.
  8. H. Yuan, Z. S. Wu, "Interfacial fracture theory in structures strengthened with composite of continuous fiber", Proc. of the Symposium of China and Japan, Science and Technology of the 21st Century, Tokyo, Japan, pp. 142-155, 1999.
  9. H. Yuan, Z. Wu, H. Yoshizawa, "Theoretical solution on interfacial stress transfer of externally bonded steel/composite laminates", Journal of Structural Mechanics and Earthquake Engineering, JSCE, Vol. 18, NO.1, pp. 27-39, April 2001. DOI:http://dx.doi.org/10.2208/jscej.2001.675_27
  10. L. D. Lorenzis, B. Miller, A. Nanni, "Bond of Fiber-Reinforced Polymer Fibers to Concrete", ACI Materials Journal, Vol. 98, No. 3, pp. 256-264, 2001.
  11. D. Van Gemert, "Force transfer in epoxy-bonded steel-concrete joints", International Journal of Adhesion and Adhesives, pp. 67-72, 1980.
  12. B. B. Adhikary, H. Mutsuyoshi, "Study on the bond between concrete and externally bonded CFRP sheet", Proc. of 5th international symposium on Fiber reinforced concrete structures(FRPRCS-5), Thomas Telford Publishing, Vol. 1, pp. 371-378, 2001.
  13. A Khalifa, WJ Gold, A Nanni, A Aziz, "Contribution of externally bonded FRP to shear capacity of RC flexural members", Journal of Composites for Construction, ASCE, Vol. 2, No. 4, pp. 195-203, 1998. DOI:https://doi.org/10.1061/(ASCE)1090-0268(1998)2:4(195)
  14. K. Izumo, N. Saeki, M. Fukao, T. Horiguchi, "Bond behavior and strength between fiber sheets and concrete", Transactions of the Japan Concrete Institute, pp. 423-430, 1999.
  15. Japanese Concrete Institute, Technical Report of Technical Committee on Retrofit Technology, Proc. of the International Symposium on Latest Achievement of Technology and Research on Retrofitting Concrete Structures, Kyoto, Japan, pp. 4-42, 2003.
  16. Y. X. Yang, Q. R. Yue, Y. C. Hu, "Experimental study on bond performance between carbon fiber sheets and concrete", Journal of Building Structures, Vol. 22, No. 3, pp. 36-42, 20019(in Chinese). https://doi.org/10.3321/j.issn:1000-6869.2001.03.007
  17. Y. Sato, K. Kimura, Y. Kobatake, "Bond behaviors between CFRP sheet and concrete", Journal of structural construction engineering, AIJ, No. 500, pp. 75-82, 1997(in Japanese).
  18. J. Dai, T. Ueda, Y Sato, "Development of the nonlinear bond stress-slip model of fiber reinforced plastics sheet-concrete interfaces with a simple method", Journal of composites for construction, ASCE, Vol. 9, No. 1, pp. 52-62, 2005. DOI: https://doi.org/10.1061/(ASCE)1090-0268(2005)9:1(52)
  19. U. Neubauer, F. S. Rostasy, "Design aspects of concrete structures strengthened with externally bonded CFRP-plates", Pro. of the 7th International Conference on Structural Faults and Repair, Vol. 2, Edinburgh, Scotland, pp. 109-118, July 1997.
  20. P. Holzenkampfer, Ingenieurmodelle des verbundes geklebter bewehrung fur betonbauteile, Dissertation, TU Braunschweig, 1994(In German).
  21. M. Blaschko, R. Niedermeier, K. Zilch, "Bond failure modes of flexural members strengthened with FRP", Proc. of the second international conference on composites in Infrastructure, Tucson, Arizona, USA, Vol. 1, pp. 315-327, 1998.
  22. fib, Externally bonded FRP reinforced for RC structures, fib Bulletin 14 TC Report, 2001.
  23. CNR-DT 200, Guide for the design and construction of externally bonded FRP systems for strengthening existing structures, A Report prepared for the CSA technical committee on reinforced concrete design, 2001.
  24. J. F. Chen, J. G. Teng, "Anchorage strength models for FRP and steel plates bonded to concrete", Journal of structural engineering, ASCE, Vol. 127, No. 7, pp. 784-791, July 2001. DOI: https://doi.org/10.1061/(ASCE)0733-9445(2001)127:7(784)
  25. X. Z. Lu, J. G. Teng, L. P. Ye, J. J. Jiang, "Bond-slip models for FRP sheets/plates bonded to concrete", Engineering Structures, Vol. 27, NO.6, pp. 920-937, 2005. DOI:https://doi.org/10.1016/j.engstruct.2005.01.014
  26. U. S. Camli, B. Binici, "Strength of carbon fiber reinforced polymers bonded to concrete and masonry", Construction and Building Materials, Vol. 21, No. 7, pp. 1431-1446, July 2007. DOI:https://doi.org/10.1016/j.conbuildmat.2006.07.003
  27. Z. Tan, Experimental research for RC beam strengthened with GFRP, Master thesis, Tsinghua University, China, 2002(in Chinese).
  28. H. D. Zhao, Y. Zhang, M. Zhao, "Research on the bond performance between CFRP plate and concrete", Proc. of 1st conference on FRP-concrete structures of China, pp. 247-253, 2000.
  29. K. Takeo, H. Matsushita, T. Makizumi, G. Nagashima, "Bond characteristics of CFRP sheets in the CFRP bonding technique", Proc. of Japan concrete institute, Vol. 19, No. 2, pp. 1599-1604, June 1997.
  30. H. T. Ren, Study on basic theories and long time behavior of concrete structures strengthened by fiber reinforced polymers, Ph.D. thesis, Dalian University of Technology, China, 2003(in Chinese).
  31. T. Ueda, Y. Sato, Y. Asano, "Experimental study on bond strength of continuous carbon fiber sheet." Proc. of 4th international symposium on fiber reinforced polymer reinforcement for reinforced concrete structures, SP-188, Farmington Hills(MI), ACI, pp. 407-416, 1999.
  32. Z. S. Wu, H. Yuan, Y. Hiroyuki, K. Toshiyuki, "Experimental/analytical study on interfacial fracture energy and fracture propagation along FRP-concrete interface", ACI International SP-201-8, pp. 133-152, 2001.
  33. H. Ko, Y. Sato, "Bond stress-slip relationship between FRP sheet and concrete under cyclic Load", Journal of composites for construction, ASCE, Vol. 11, No. 4, pp. 419-426, 2007. DOI: https://doi.org/10.1061/(ASCE)1090-0268(2007)11:4(419)
  34. B. A. Bimal, M. Hiroshi, "Study on the bond between concrete and externally bonded CFRP sheet", Proc. of 5th international symposium on FRP reinforcement for concrete structures, Cambridge, University of Cambridge, pp. 371-378, 2001.
  35. P. Carlo, T Davide, M. Claudio, "Experimental study on bond behavior between concrete and FRP reinforcement", Journal of composites for construction, ASCE, Vol. 12, No. 2, pp. 180-189, 2008. DOI: https://doi.org/10.1061/(ASCE)1090-0268(2008)12:2(180)
  36. A Kamiharako, T Shimomura, K Maruyama K, "The Influence of the substrate on the bond behavior of continuous fiber sheet", Proc. Japan Concrete Institute, Vol. 25, No. 2, pp. 1735-1740, 2003(in Japanese).
  37. A Kamiharako, T Shimomura, K Maruyama K, N. Hiroyuki, "Analysis of bond and debonding behavior of continuous fiber sheet bonded on concrete", Journal of The Japan Society of Civil Engineers, Vol. 45, No. 634, pp. 197-208, 1999(in Japanese). DOI:https://doi.org/10.2208/jscej.1999.634_197