Abstract
In this study, as part of the development of an autonomous flying personal aircraft, an equivalent model of the main wing assembly of an Optionally Piloted Personal Air Vehicle (OPPAV) was developed. Reliability of the developed equivalent model was verified by eigenvalue analysis. The main wing assembly consisted of a main wing, an inboard pod, and an outboard pod. First, for developing an equivalent model of each component, components to produce the equivalent model were divided into several sections. Nodes were then created on the axis of the equivalent model at both ends of each section. In addition, static analysis with unit force and unit moment was performed to calculate the deformation or the amount of rotation at the node to be used in the equivalent model. Equivalent axial, bending, and torsional stiffness of each section were calculated by applying the beam theory. Once the equivalent stiffness of each section was calculated, information of a mass and moment of inertia for each section was entered by creating a lumped mass in the center of each section. An equivalent model was developed using beam element. Finally, the reliability of the developed equivalent model was verified by comparison with results of mode analysis of the fine model.
본 연구에서는 신개념 항공교통수단으로 활용될 자율비행 개인항공기 개발의 일환으로 자율비행 개인항공기 주익조립체의 등가모델을 생성한 후 고유모드 해석을 통해 생성된 등가모델의 신뢰성을 검증하였다. 주익조립체는 주익, 안쪽파드, 바깥쪽 파드로 구성되어 있다. 먼저, 각 부품의 등가모델을 생성하기 위해서 해당 부품을 몇 개의 구역으로 분할하고, 각 구역의 양 끝단에 등가모델 축상에 놓이는 절점들을 생성하였다. 그리고, 단위하중과 단위모멘트을 부과한 정적해석을 통해 변형량 또는 회전량을 계산하고, 빔 이론식을 적용하여 각 부품들의 등가 축강성, 굽힘강성, 비틀림강성을 계산하였다. 그리고, 각 구역 중앙에 집중질량을 생성하여 질량과 관성모멘트 정보를 입력하고, 빔 요소를 사용하여 등가모델을 생성하였다. 최종적으로 상세모델의 모드해석 결과와의 비교를 통해 생성된 등가모델의 신뢰성을 확인하였다.