DOI QR코드

DOI QR Code

Experimental shear strengthening of GFRC beams without stirrups using innovative techniques

  • Hany, Marwa (Department of Civil Engineering, Benha Faculty of Engineering, Benha University) ;
  • Makhlouf, Mohamed H. (Department of Civil Engineering, Benha Faculty of Engineering, Benha University) ;
  • Ismail, Gamal (Department of Civil Engineering, Benha Faculty of Engineering, Benha University) ;
  • Debaiky, Ahmed S. (Department of Civil Engineering, Benha Faculty of Engineering, Benha University)
  • Received : 2021.10.13
  • Accepted : 2022.05.22
  • Published : 2022.08.25

Abstract

Eighteen (18) (120×300×2200 mm) beams were prepared and tested to evaluate the shear strength of Glass Fiber Reinforced Concrete (GFRC) beams with no shear reinforcement, and evaluate the effectiveness of various innovative strengthening systems to increase the shear capacity of the GFRC beams. The test variables are the amount of discrete glass fiber (0.0, 0.6, and 1.2% by volume of concrete) and the type of longitudinal reinforcement bars (steel or GFRP), the strengthening systems (externally bonded (EB) sheet, side near-surface mounted (SNSM) bars, or the two together), strengthening material (GFRP or steel) links, different configurations of NSM GFRP bars (side bonded links, full wrapped stirrups, side C-shaped stirrups, and side bent bars), link spacing, link inclination angle, and the number of bent bars. The experimental results showed that adding the discrete glass fiber to the concrete by 0.6%, and 1.2% enhanced the shear strength by 18.5% and 28%, respectively in addition to enhancing the ductility. The results testified the efficiency of different strengthening systems, where it is enhanced the shear capacity by a ratio of 28.4% to 120%, and that is a significant improvement. Providing SNSM bent bars with strips as a new strengthening technique exhibited better shear performance in terms of crack propagation, and improved shear capacity and ductility compared to other strengthening techniques. Based on the experimental shear behavior, an analytical study, which allows the estimation of the shear capacity of the strengthened beams, was proposed, the results of the experimental and analytical study were comparable by a ratio of 0.91 to 1.15.

Keywords

References

  1. Abdul-Zaher, A.S., Abdul-Hafez, L.M., Tawfic, Y.R. and Hammed, O. (2016), "Shear behavior of fiber reinforced concrete beams", JES. J. Eng. Sci., 44(2), 132-144.
  2. ACI 440.1R-06 (2006), Guide for the Design and Construction of Structural Concrete Reinforced with FRP Bars, Reported by ACI Committee 440, American Concrete Institute, USA.
  3. ACI Committee 318 (2014), Building Code Requirements for Structural Concrete ACI, Vols. 318-14.
  4. ACI Committee 440 (2008), Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete Structures (ACI 440.2R-02), American Concrete Institute, Farmington Hills, Mich.
  5. Ahmadi, M., Kheyroddin, A., Dalvand, A. and Kioumarsi, M. (2020), "New empirical approach for determining the nominal shear capacity of steel fiber reinforced concrete beams", Constr. Build. Mater., 234(20), 117293. https://doi.org/10.1016/j.conbuildmat.2019.117293.
  6. Al-Rousan, R.Z. and Issa, M.A. (2016), "The effect of beam depth on the shear behavior of reinforced concrete beams externally strengthened with carbon fiber-reinforced polymer composites", Adv. Struct. Eng., 19(11), 1769-1779. https://doi.org/10.1177/1369433216649386.
  7. AlShadidi, R.M.H., Hassan, H.F. and Mohammed, M.H. (2016), "Shear behavior of high strength concrete beams reinforced with GFRP bars and strengthened by CFRP sheets", J. Eng. Sustain. Develop. (JEASD), 20(1), 102-117.
  8. Ata, E.S.S. and Moustaf, O. (2011), "Experimental analysis of RC beam strengthened with discrete glass fiber. Facta universitatisseries", Arch. Civil Eng., 9(2), 205-215. https://doi.org/10.2298/FUACE1102205A.
  9. Bukhari, I.A., Vollum, R.L., Ahmad, S. and Sagaseta, J. (2010), "Shear strengthening of reinforced concrete beams with CFRP", Mag. Concrete Res., 62(1), 65-77. https://doi.org/10.1680/macr.2008.62.1.65.
  10. Chen, G.M., Teng, J.G. and Chen, J.F. (2012), "Shear strength model for FRP-strengthened RC beams with adverse FRP-steel interaction", J. Compos. Constr., 17(1), 50-66. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000313.
  11. Chen, G.M., Teng, J.G., Chen, J.F. and Rosenboom, O.A. (2010), "Interaction between steel stirrups and shear-strengthening FRP strips in RC beams", J. Compos. Constr., 14(5), 498-509. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000120.
  12. De Lorenzis, L. and Teng, J. (2007), "Near-surface mounted FRP reinforcement: An emerging technique for strengthening structures", Compos. Part B: Eng., 38(2), 119-143. https://doi.org/10.1016/j.compositesb.2006.08.003.
  13. Dias, S.J.E. and Barros, J.A.O. (2010), "Performance of reinforced concrete T beams strengthened in shear with NSM CFRP laminates", Eng. Struct., 32(2), 373-384. https://doi.org/10.1016/j.engstruct.2009.10.001.
  14. Dias, S.J.E. and Barros, J.A.O. (2012a), "NSM shear strengthening technique with CFRP laminates applied in highstrength concrete beams with or without pre-cracking", Compos. Part B: Eng., 43(2), 290-301. https://doi.org/10.1016/j.compositesb.2011.09.006.
  15. Dinh, H.H., Parra-Montesinos, G.J. and Wight, J.K. (2011), "Shear strength model for steel fiber reinforced concrete beams without stirrup reinforcement", J. Struct. Eng., 137(10), 1039-1051. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000362.
  16. El-Hacha, R. and Rizkalla, S.H. (2004), "Near-surface-mounted fiber-reinforced polymer reinforcements for flexural strengthening of concrete structures", ACI Struct. J., 101(5), 717-726.
  17. El-Sayed, A.K., El-Salakawy, E.F. and Benmokrane, B. (2006), "Shear strength of FRP-reinforced concrete beams without transverse reinforcement", ACI Mater. J., 103(2), 235.
  18. Farahmand, F. (1996), "Shear behavior of concrete beams reinforced with glass fiber reinforced plastic", A Thesis presented to the University of Manitoba in partial fulfilment of the requirements for the degree of Master of Science
  19. Ibrahim, A.M., Mansor, A.A. and Hameed, M. (2017), "Structural behavior of strengthened RC beams in shear using CFRP strips", Open Civil Eng. J., 11(1), 205-215. https://doi.org/10.2174/1874149501711010205.
  20. Jin, L., Xia, H., Jiang, X.A. and Du, X. (2020), "Size effect on shear failure of CFRP-strengthened concrete beams without web reinforcement: Meso-scale simulation and formulation", Compos. Struct., 236, 111895. https://doi.org/10.1016/j.compstruct.2020.111895.
  21. Karzad, A.S., Leblouba, M., Al Toubat, S. and Maalej, M. (2019), "Repair and strengthening of shear-deficient reinforced concrete beams using Carbon Fiber Reinforced Polymer", Compos. Struct., 223, 110963. https://doi.org/10.1016/j.compstruct.2019.110963.
  22. Khalifa, A.M. (2016), "Flexural performance of RC beams strengthened with near surface mounted CFRP strips", Alex. Eng. J., 55(2), 1497-1505. https://doi.org/10.1016/j.aej.2016.01.033.
  23. Medhlom, M.K. (2016), "Shear capacity of steel fiber non-metallic (GFRP) reinforced concrete beams strengthened in shear using CFRP laminates", Civil Environ. Res., 8(8), 103-117.
  24. Monika, K., Renata, K. and Joaquim, A.O. (2017), "Influence of longitudinal GFRP reinforcement ratio on the shear capacity of concrete beams without stirrups", Procedia Eng., 193, 361-368. https://doi.org/10.1016/j.proeng.2017.06.225.
  25. Noel, M. and Soudki, K. (2011), "Evaluation of FRP posttensioned slab bridge strips using AASHTO-LRFD bridge design specifications", J. Bridge Eng., 16, 839-846. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000226.
  26. Panahi, M. and Izadinia, M. (2018), "A parametric study on the flexural strengthening of reinforced concrete beams with near surface mounted FRP bars", Civil Eng. J., 4(8), 1917-1929. https://doi.org/10.28991/cej-03091126
  27. Said, M., Abd El-Azim, A.A., Ali, M.M., El-Ghazaly, H. and Shaaban, I. (2020), "Effect of elevated temperature on axially and eccentrically loaded columns containing Polyvinyl Alcohol (PVA) fibers", Eng. Struct., 204, 110065. https://doi.org/10.1016/j.engstruct.2019.110065.
  28. Said, M., Adam, M.A., Mahmoud, A.A. and Shanour, A.S. (2016), "Experimental and analytical shear evaluation of concrete beams reinforced with glass fiber reinforced polymers bars", Constr. Build. Mater., 102, 574-591. https://doi.org/10.1016/j.conbuildmat.2015.10.185.
  29. Seo, S.Y., Lee, M.S. and Feo, L. (2016), "Flexural analysis of RC beam strengthened by partially de-bonded NSM FRP strip", Compos. Part B: Eng., 101, 21-30. https://doi.org/10.1016/j.compositesb.2016.06.056.
  30. Shanour, A.S., Said, M., Arafa, A.I. and Maher, A. (2018), "Flexural performance of concrete beams containing engineered cementitious composites", Constr. Build. Mater., 180, 23-34. https://doi.org/10.1016/j.conbuildmat.2018.05.238.
  31. Sharaky, I.A., Torres, L. and Sallam, H. (2015), "Experimental and analytical investigation into the flexural performance of RC beams with partially and fully bonded NSM FRP bars/strips", Compos. Struct., 122, 113-126. https://doi.org/10.1016/j.compstruct.2014.11.057.
  32. Siddika, A., Al Mamun, M.A., Alyousef, R. and Amran, Y.M. (2019), "Strengthening of reinforced concrete beams by using fiber-reinforced polymer composites: A review", J. Build. Eng., 25, 100798. https://doi.org/10.1016/j.jobe.2019.100798.
  33. Soliman, A.E.K.S. (2012), "Efficiency of using discrete fibers on the shear behavior of RC beams", Ain Shams Eng. J., 3(3), 209-217. https://doi.org/10.1016/j.asej.2012.03.006.
  34. Thamrin, R. and Haris, S. (2019), "Shear capacity of reinforced concrete beams strengthened with web side bonded CFRP sheets", MATEC Web of Conferences, 258, 04010. https://doi.org/10.1051/matecconf/201925804010.
  35. Zhang, S.S., Yu, T. and Chen, G M. (2017), "Reinforced concrete beams strengthened in flexure with near-surface mounted (NSM) CFRP strips: Current status and research needs", Compos. Part B: Eng., 131, 30-42. https://doi.org/10.1016/j.compositesb.2017.07.072.