DOI QR코드

DOI QR Code

A Study on the Improvement of Hydrogen Tank Fueling Performance Using MC Methods

MC 기법을 이용한 수소 탱크 충전 성능 향상에 관한 연구

  • JIAH CHOI (Department of Mechanical System Engineering, Pukyong National University Graduate School of General Studies) ;
  • SANGWON JI (Department of Mechanical System Engineering, Pukyong National University) ;
  • JISEONG JANG (Department of Mechanical System Engineering, Pukyong National University)
  • 최지아 (국립부경대학교 일반대학원 기계시스템공학과) ;
  • 지상원 (국립부경대학교 기계시스템공학전공) ;
  • 장지성 (국립부경대학교 기계시스템공학전공)
  • Received : 2023.08.25
  • Accepted : 2023.10.12
  • Published : 2023.10.30

Abstract

SAE J2601, hydrogen fueling protocols, proposes two charging methods. The first is the table-based fueling protocol, and the second is the MC formula-based fueling protocol. Among them, MC formula-based fueling protocol calculates and supplies the target pressure and pressure ramp rate (PRR) using the pre-cooling temperature of the hydrogen and the physical parameters of the tank in the vehicle. The coefficient of the MC formula for deriving MC varies depending on the physical parameters of the tank in the vehicle. However, most studies use the MC coefficient derived from SAE J2601 as it is, despite the difference in the physical parameters of the tank applied to the study and the tank used to derive the MC coefficient from SAE J2601. In this study, the MC coefficient was derived by applying the hydrogen tank currently used, and the difference with the fueling performance using the MC coefficient proposed in SAE J2601 was verified. In addition, the difference was confirmed by comparing and analyzing the fueling performance of the table-based method currently used in hydrogen fueling stations and the MC formula-based method using MC coefficient derived in this study.

Keywords

Acknowledgement

본 논문은 부경대학교 자율창의학술연구비(2023년)에 의하여 연구되었음.

References

  1. Society of Automotive Engineers (SAE) International, "Fueling protocols for light duty gaseous hydrogen surface vehicles (J2601_201407)", SAE International, 2014. Retrieved from https://www.sae.org/standards/content/j2601_201407/.
  2. Society of Automotive Engineers (SAE) International, "Fueling protocols for light duty gaseous hydrogen surface vehicles (J2601_201612)", SAE International, 2016. Retrieved from https://www.sae.org/standards/content/j2601_201612/.
  3. M. Monde, P. Woodfield, T. Takano, and M. Kosaka, "Estimation of temperature change in practical hydrogen pressure tanks being filled at high pressures of 35 and 70 MPa", International Journal of Hydrogen Energy, Vol. 37, No. 7, 2012, pp. 5723-5734, doi: https://doi.org/10.1016/j.ijhydene.2011.12.136.
  4. R. O. Cebolla, B. Acosta, N. de Miguel, and P. Moretto, "Effect of precooled inlet gas temperature and mass flow rate on final state of charge during hydrogen vehicle refueling", International Journal of Hydrogen Energy, Vol. 40, No. 13, 2015, pp. 4698-4706, doi: https://doi.org/10.1016/j.ijhydene.2015.02.035.
  5. W. Kang, J. Shin, S. H. Lee, B. R. Yoon, and U. Baek, "Development of hydrogen flow field standard in hydrogen refueling station", Journal of Hydrogen and New Energy, Vol. 33, No. 6, 2022, pp. 684-691, doi: https://doi.org/10.7316/KHNES.2022.33.6.684.
  6. K. Reddi, A. Elgowainy, N. Rustagi, and E. Gupta, "Impact of hydrogen SAE J2601 fueling methods on fueling time of light-duty fuel cell electric vehicles", International Journal of Hydrogen Energy, Vol. 42, No. 26, 2017, pp. 16675-16685, doi: https://doi.org/10.1016/j.ijhydene.2017.04.233.
  7. H. Luo, J. Xiao, P. Benard, R. Chahine, and T. Yang, "Dynamic simulation of hydrogen fueling performance based on look-up table and MC methods", In: Z. Sun, P. Das, editors. Proceedings of the 9th International Conference on Energy Engineering and Environmental Engineering. ICEEEE 2022; 2022 Dec 9-10; Sanya, China. Environmental Science and Engineering. Cham: Springer; 2023, pp. 23-35, doi: https://doi.org/10.1007/978-3-031-30233-6_3.
  8. R. Harty and S. Mathison, "Improving hydrogen tank refueling performance through the use of an advanced fueling algorithm - The MC method", In: Proceedings of the National Hydrogen Association Hydrogen Conference & Expo; 2010 May 3-6; Long Beach, CA, USA. Retrieved from https://nha.confex.com/nha/2010/webprogram/Paper4917.html.
  9. S. Mathison, K. Handa, T. McGuire, T. Brown, T. Goldstein, and M. Johnston, "Field validation of the MC default fill hydrogen fueling protocol", SAE International Journal of Alternative Powertrains, Vol. 4, No. 1, 2015, pp. 130-144, doi: https://doi.org/10.4271/2015-01-1177.
  10. J. A. Choi, S. W. Ji, and J. S. Jang, "A study on the modeling of fueling hydrogen tank in vehicle using dispenser", Journal of Drive and Control, Vol. 19, No. 2, 2022, pp. 36-44, doi: https://doi.org/10.7839/ksfc.2022.19.2.036.