• Tunnel and Underground Space
• /
• v.14 no.2
• /
• pp.79-85
• /
• 2004

수로터널은 일반적으로 상수 및 용수를 도수할 목적으로 설치하는 터널로서 기능상 여러가지로 분류할 수 있으나, 도로, 철도, 지하철 같은 교통터널(transportiontunnel)과는 달리 터널내에 수압의 작용이 반복되는 특징이 있으며, 이를 기본으로 하여 내수압의 작용 유무에 따라 자유수면(무압터널)터별과 압력터널로 분류된다(Fig. 1. 참조). 또한, 용도에 따라 상하수도 터널, 발전용 터널, 여수로(spillway) 터널, 가배수(diversion) 터널 및 방류(outlet) 터널로 분류되고 있다. 본 고에서는 이러한 수로터널 중 터널식 여수로에서 발생할 수 있는 공동현상(cavitation)에 대하여 발생원 인과 대처방안 및 피해사례에 대하여 정리하고자 한다.(중략)

• 유체기계공업학회:학술대회논문집
• /
• 2001.11a
• /
• pp.185-190
• /
• 2001

The cavitation causes suction performance and efficiency of the high-speed pump to be reduced significantly To diminish these effects, the inducer has been used. Most of the inducer is designed at a maximum efficiency point of the pump, therefore suction performance drop due to effects of flow separation and inlet inverse flow is often observed at off-design point. The objective of this study is to find out the cavitation modes at various conditions by applying event detection technique and to design an inducer reducing cavitation. The pressure fluctuations at each cavitating condition were measured at inducer inlet and outlet locations using pressure transducers, which were located 90 degrees apart from each other to identify the cavitation modes. The time-frequency characteristics were analyzed by using Choi-williams distribution. In the second part of this paper, the inducer design method which uses nominal performance characteristic and onset condition of cavitation is introduced and applied to real situation.

• 한국전산유체공학회:학술대회논문집
• /
• 2011.05a
• /
• pp.31-40
• /
• 2011

Unsteady sheet cavitation on a three-dimensional twisted hydrofoil was studied using an unsteady Reynolds-averaged Navier-Stokes equations solver based on a cell-centered finite volume method. As a verification test of the computational method. non-cavitating and cavitating flow over a modified NACA66 foil section was simulated and validated against existing experimental data. The numerical uncertainties of forces and pressure were evaluated for three levels of mesh resolution. The computed pressure on the foil and the cavity shedding behavior were validated by comparing with existing experimental data. The cavity shedding dynamics by re-entrant jets from the end and sides of the cavity were investigated.

• Journal of Energy Engineering
• /
• v.24 no.2
• /
• pp.17-21
• /
• 2015

Restriction orifices in the feed and bleed circuit of nuclear power plant are designed using computer program capable of handling multiple hole cascade orifice assembly. Single hole stages of orifice assembly are alternated with multihole stages where necessary. The distance between stages is such that it allows full pressure recovery. The minimum static pressure is higher than vapor pressure at the operating temperature so that cavitation does not occur. Piping sizes are reviewed and increased if necessary to improve rigidity.

• Korean Architects
• /
• no.8 s.400
• /
• pp.70-89
• /
• 2002

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.9
• /
• pp.150-155
• /
• 2019

Cavitation refers to a phenomenon in which empty spaces occur in a fluid due to changes in pressure and a velocity. When a liquid moves at a high speed, the pressure drops below the vapor pressure, and vapor bubbles are generated in the liquid. This study used CFD to analyze the flow of fluid machinery used in marine and offshore plants. The goals are to ensure the validity of the analysis method for marine propellers in an open water test, to increase the forward ratio, and to use FLUENT to understand the flow pattern due to cavitation. A three-dimensional analysis was performed and compared with experimental data from MOERI. The efficiency was highest at advance ratios of 0.7 - 0.8. Thrust was generated due to the difference between the pressure surface and the suction surface, and it was estimated that bubbles would be generated in the vicinity of the back side surface rather than the face side of the propeller, resulting in more cavitation. The cavitation decreased sharply as the advance ratio increased. The thrust and torque coefficients were comparable to those of the MOERI experimental data except at the advance ratio of 1, which showed a difference of less than 5%. Therefore, it was confirmed that CFD can evaluate an open water propeller test.

• Journal of the Korean Institute of Gas
• /
• v.1 no.1
• /
• pp.101-105
• /
• 1997

When the water curtain system is employed to keep the liquefied gas in the underground storage cavern, clogging is observed in borehole. Since this phenomenon causes serious difficulties in managing LPG storage cavern, it needs to detect the degree of clogging accurately under various circumstances. Thus, in this study the active factors of clogging, that is, groundwater head, injection water flowrate, and seepage water flowrate, were investigated experimentally using a physical model. Experimental results show that groundwater head around storage cavern increases as cavern Pressure increases, while it decreases as clogging becomes severe. The pressure in storage cavern is required to reduce up to atmospheric pressure in order to detect and identify the degree of clogging more accurately. The decrease of uroundwater head due to clogging slows down as the pressure in borehole increases. As amounts of suspended matters in injected water increase, both injection water flowrate and seepage water flowrate decrease linearly with time, and the flowrate of injection water drops rapidly compared with seepage water flowrate.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.18 no.6
• /
• pp.610-616
• /
• 2012

All the countries in the world is currently facing the full scale of energy-climate era currently, and making strong energy policy that will lead to green growth of the future energy resources by utilizing renewable energy as the basis of entering the advanced country becomes the goal of development that satisfies the demand for energy in 21st century. Recently, ocean energy attracted the attention along with the necessity of developing renewable energy. Ocean energy is the one of most prominent recyclable and clean resources that has not been developed yet. So, it is highly required to develop good tidal current energy conversion system in coastal area. The inflow angle that acts against tidal current turbine, seabed effect and the change of efficiency along the occurrence of cavitation were investigated through the wake flow characteristics in this study. Power coefficient degradation by seabed effect did not appear in the condition of this calculation. Efficiency degradation appeared from above $10^{\circ}$ regarding inflow angle and power coefficient was calculated as lower by 7 % at $45^{\circ}$. Torque and power coefficient increased as inflow velocity rose, but power coefficient degradation appeared from above 3m/s when the cavitation happened. So, it was recognized that the larger inflow angle and occurrence of cavitation become the reason for power degradation through the flow characteristics.

• Culinary science and hospitality research
• /
• v.22 no.8
• /
• pp.219-225
• /
• 2016

This study was conducted to investigate the amount of fat, vitamins and minerals in milk can be affected by hydrodynamic cavitation since cavitation is recently focused on as one of the sterilization methods. Vitamins (vitamin A, $B_2$), minerals (Ca, P, Mg, Zn) and fat contents were measured according to Ministry of Food and Drug Safety's Processing Standards and Component Specifications of Animal Product. Vitamin A & $B_2$ contents decreased approximately 23% & 19%, respectively after cavitation. Minerals content showed no change after cavitation. Also, P and Mg contents were reduced after cavitation to 2 mg/100g and 0.1 mg/100g, showing no change. Milk fat content was 3.46% before cavitation and 3.41% after cavitation, displaying no difference. Hydrodynamic cavitation process displays a possibility to replace existing pasteurizing method, as it does not change vitamin or mineral contents in milk. Therefore, a more clear and systematic research on hydrodynamic cavitation pasteurization is needed to distribute excellent quality milk and to emphasize physiochemical properties and quality change of existing heat pasteurization process.

• Proceeding of EDISON Challenge
• /
• 2013.04a
• /
• pp.349-353
• /
• 2013

공동주위의 유동에 대한 연구결과를 보면 개방형 공동(L/D<10)과 밀폐형 공동(L/D>13)으로 구별하는 데 개방형 공동은 앞전에서 발생한 자유전단층이 뒷전 부근에 재부착하여 공동을 완전히 연결하므로, 자유전단층과 외부유동과의 상호작용으로 발생하는 심한 압력변화에 의해 진동현상이 나타나게 된다. 이것은 큰 소음을 유발하고, 구조물의 고장 혹은 파괴의 원인이 되기도 하고, 공력 성능 및 안정성에 해를 주고 민감한 계기를 손상 시킬 수도 있다. 본 논문에서는 공동을 연구하기 위해 EDISON_CFD를 사용하여 공동의 시뮬레이션하기 위해 격자를 구성하고 세장비를 각각 1/5, 1/3, 1/2, 1, 2, 5 로 변화를 주어 M=1.5 일 때 밀도, 압력, 마하수와 유동구조를 세장비에 따라 결과를 비교, 분석한다.