• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.40 no.3
• /
• pp.10-17
• /
• 2003

In this paper, genetic algorithm (GA)-based Thin Film Bulk Acoustic Resonator (FBAR) RF filter design technique is proposed. Since the BVD(Butterworth-Van Dyke) lumped element model is valid only around the resonance, FBAR filter design technique based on BVD circuit has an approximate error. Instead of using BVD model, optimizing filter design method utilizes an analytical electrical impedance equation of FBAR. The geometry of FBAR such as thickness of the piezoelectric layer and area which significantly affect the filter response is optimized by GA. US-PCS Rx Bandpass filter obtained by the proposed technique shows a better response comparing with the typical and BVD-based filter.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.3 no.2
• /
• pp.25-30
• /
• 2010

In this paper, a novel notch resonator is proposed based on Rectanglar Split Ring Resonator (R-RSS) element. We represented the electrical characteristics for R-SRR elements coupled with microstrip line, and measured result is compared with electromagnetic simulation (HFSS) result. We also solved equivalent circuit for R-SRR element, and also discussed influences of change structural parameters of R-SRR. the size of R-SRR is the most important parameters for frequency tuning. Also we can make tunable resonator form the basic structure. This novel resonator can apply to design of tunable bandpass filter and voltage control oscillator.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.12
• /
• pp.41-45
• /
• 2015

In this paper, the single port dual-band resonator for magnetic resonance wireless power transfer is proposed. The proposed dual-band resonator is consists of 20 turns spiral coil, a single loop, matching circuit, lumped elements, and a single port. The two sides of the matching circuit are connected to via holes. The spiral coil is operated at MF-band and single loop is operated at HF-band, respectively. We use two of the same structure resonators and simulated and the power transfer efficiency was calculated. The efficiency of simulation and measurement is above 60% at the MF and HF bands, and the distance is 100 mm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.12 no.2
• /
• pp.133-138
• /
• 1987

In this paper the tuning characteristics of resonant frequencies are experimentally studied through the variation of the length of the inner conducting rod in a re-enterant eavity resonator. The re-enterant eavity resonator consists of a coaxial cable and a cylindrical wave guide. The length of the inner conducting rod can be varied to the longitudinal direction. The resonant frequencies of TMonq modes are measured according to the arbitrary length. In order to verify the propriety of experimental results, experimental results are compared with other theoretical results. The results in this paper can be applied to wave meter and resonant circuit of amplifier. They will be use to vary resonant frequencies of a dielectric resonator in MIC and filter.

• The Journal of the Acoustical Society of Korea
• /
• v.16 no.1
• /
• pp.76-80
• /
• 1997

Acoustic resonance characteristics were analyzed and their effect on the refrigerating capability were experimentally verified on a fabricated Hofler-type thermoacoustic refrigerating system. Factors governing the overall resonance are the resonator composed of a cavity and two pipes, the loudspeaker driving the resonator, and rear side impedance characteristics of speaker housing. All these are coupled with electric constants of the speaker to exhibit electric resonance. Also the 'wall-effect' within the resonator causes attenuation to reduce the sharpness of the resonance. Analysis and experiments showed housing and the wall-effect of the resonator reduce the sharpness of resonance. Maintaining the accuracy of the resonance is, therefore, very important for efficient refrigeration.

• Proceedings of the KIPE Conference
• /
• 2012.07a
• /
• pp.377-378
• /
• 2012

DC-DC 컨버터를 인터리브 방식으로 제어하면 출력 전류 리플이 저감되고, 출력 필터 커패시터의 용량을 줄일 수 있다. 하지만 공진(Resonance)을 통해 전력을 전달하는 LLC 공진형 컨버터의 경우 회로를 구성하는 공진 인덕터 및 공진 커패시터의 오차(Tolerance)로 인해 출력 전류 리플의 언밸런스가 심화될 수 있다. 따라서 이를 개선할 수 있는 방법에 대한 연구가 필요하다. 본 논문에서는 Y결선 정류기를 이용한 3상 인터리브드 LLC 공진형 컨버터의 출력 전류 리플 밸런싱 방법을 제안한다. 제안된 방법은 3상 인터리브드 LLC 공진형 컨버터와 각 LLC 공진형 컨버터 앞단의 Bridgeless PFC가 독립적으로 추가되어 회로가 구성된다. 3상 인터리브드 LLC 공진형 컨버터는 분할된 위상으로 비독립적으로 제어하며 출력 전류 리플의 언밸런스를 Bridgeless PFC의 출력 전압을 가변함으로써 개선할 수 있는 방법을 제안하고 이를 시뮬레이션(PSIM)을 통해 제안된 밸런싱 방법을 검증하였다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.12
• /
• pp.992-995
• /
• 2018

The wireless charging of body-embedded medical instruments and wireless power transfer to various inside dielectric-materials is still a future technology that has not yet been achieved. This paper proposes methods for controlling the capacitance of the resonators and installing air pockets on the top and bottom sides of the resonators for optimal design, which considered efficiency and resonant frequency in accordance with the electromagnetic characteristics of the dielectric medium. In future, the results of this research will be utilized as the basic research data to design and restore resonant frequency of resonators embedded in various dielectric environments.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.11 no.3
• /
• pp.216-223
• /
• 2006

The high efficiency full-bridge LLC resonant converter using a contact-less transformer Is proposed for the photovoltaic power generation system. For the series resonance with a series capacitor, the LLC resonant converter utilizes the leakage inductance and magnetizing inductance of a contact-less transformer Unlike the conventional series resonant converter operated to the continuous resonant current at above resonance frequency, the proposed converter operates to the discontinuous resonant current at the narrow frequency control range below resonance frequency. Due to the discontinuous mode resonant current, the proposed converter can be achieved the zero voltage switching (ZVS) in the primary switches and the zero current switching (ZCS) in the secondary rectification diodes without my auxiliary circuit. In this paper, the experimental results of the proposed full-bridge LLC resonant converter using a contact-less transformer are verified on the simulation based on the theoretical analysis and the 150W experimental prototype.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.10
• /
• pp.2639-2645
• /
• 2009

This paper describes a CPW oscillator using a spiral resonator. Spiral resonators are very useful in design CPW oscillators since they show a relatively higher Q than CPW hairpin and helical resonators. Prior to the design of oscillators, three CPW resonators are designed and compared. Electromagnetic (EM) simulation are performed for an improved design in design the CPW resonators and oscillators. Three oscillators are designed at 5.7 GHz using the mentioned CPW resonators. The measured output power of three CPW oscillators using the helical, hairpin, and spiral resonators are 2.55 dBm, 2.64 dBm, and 4.98 dBm, respectively. In addition, the size of three resonators are $102.15mm^2,\;130.05mm^2,\;80.625mm^2$, respectively, so it is proven that the proposed CPW oscillator using the spiral resonator has a smaller size than the others.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.3
• /
• pp.351-358
• /
• 1999

This paper describes the mode identification of resonant frequencies in dielectric loaded circular cylindrical cavity. To identify the mode of resonant frequencies, the calculated resonant frequencies were compared with the simulated ones in the air-filled circular cylindrical cavity by Microstripes EM simulator. With z-oriented magnetic field excitation, we could get only TE mode resonance, while all the modes including TM mode were observed with $\phi$-oriented magnetic field excitation. We could identify the modes with the two excitation methods. We applied the identification method to a dielectric loaded circular cylindrical cavity and compared these results with experimental ones. To certify the method, we traced resonance frequencies with varying the dielectric height. We observed that the resonance of $TE_{011}$ mode was changed dramatically while the variation of the $TE_{111}$ and $TE_{211}$ modes are relatively small.