• 한국전기전자재료학회논문지
• /
• 제17권9호
• /
• pp.973-978
• /
• 2004

This work describes the effect of conducting materials on the electrochemical performances of electric double layer capacitor. Three kinds of Carbon black, such as Acethylene Black, Super P Black, Ketjen black supplied by Denki Kagaku Kogyo, MMM Carbon, Ketjen Black International Co. respectively, was added in carbon-Polytetrafluoroethylene (PTFE) electrode, which composition is activated carbon : carbon black : PTFE = 80 : 15 : 5 wt.%, and were compared with their electrochemical properties. The electrode with Ketjen Black has showed the lowest resistance than other carbon black, and also exhibited the better rate capability between 0.5 mA/cm$^2$ ∼ 100 mA/cm$^2$ current density in unit cell capacitor. On the other hand, as increasing the composition of Ketjen Black, the specific resistances of electrodes were decreased and Ketjen Black content higher than 15 wt% increased. The best rate capability was obtained at the electrode with 15 wt.% of Ketjen Black in unit cell capacitor. This behaviors would be correlated with the dense structure of electrode.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 C
• /
• pp.2022-2024
• /
• 2005

Electrical double-layer capacitor (EDLC) is an electrochemical energy storage device in which electric charges only accumulated by a pure electrostatic attraction force are stored on the electrolyte-electrode interface in a form of double layer and separated by the electrolyte. The composite was prepared by mixing nanosize $TiO_2$ and activated carbon through a means of ultrasonic vibration in ethanol solution for 30 min in various mass ratios of $AC:TiO_2$ to form activated carbone-semiconducting oxide composites. Either 1.0 M $LiClO_4/EC-DEC$ or $Et_4NBF_4$/EC-DEC was used as the electrolyte. It was found that with modification of $TiO_2$, the specific capacitance of activated carbon measured at $1mA/cm^2$ was increased from 40 to 50 F/g. This method is unique in comparison the conventional method because it uses semiconducting TiO2 other than electrochemically active materials such as $RuO_2$. The increase in specific capacitance could be attributed to the decrease in electric polarization, caused by the introduction of $RuO_2$.

• 대한안전경영과학회지
• /
• 제2권2호
• /
• pp.95-108
• /
• 2000

Electrochemical charateristics of activated carbon fiber cloth(ACFC) electrode were studied with propylene carbonate(PC), ${\gamma}$-butyrolactone(GBL) and N,N-dimethyl-formamide(DMF) as a solvent and tetraethylammoniumtetrafluoroborate(TEABF$_4$), tetraethylammoniumhexafluorophosphate(TEABF$_{6}$), tetrabutylammoniumtetrafluoroborate(TBABF$_4$) and tetrabutylammonium hexafluorophosphate(TBAPF$_6$) as an electrolytes(active material). The concentrations of electrolytes were in the range of 0.2~1.2 N, the volume ratios of PC and DMF as a mixed solvent system, were 90：10, 80：20, 70：30, 60：40, 50：50, and 40：60 vol%. Electrochemical characteristics such as electric conductivity, internal resistance, and electric capacitance of fabricated unit cells were measured after the moisture of activated material was removed with molecular sieve. Electrochemical characteristics were better in mixed solvents system than in mono solvent system. The mono solvent system of 1.0 N electrolyte of GBL/TEABF$_4$ with activated carbon cloth electrodes showed better result but the mixed solvent system with PC and DMF/TEABF$_4$(50：50 vol%) and the concentration of 1.0 N electrolyte showed the best characteristics. Internal resistance was 3.47 $\Omega$ and specific capacitance was 19.1 F/g respectively.y.

• Journal of Electrochemical Science and Technology
• /
• 제9권3호
• /
• pp.220-228
• /
• 2018

This study introduced a carbon-free electrode for $Li-O_2$ cells with the aim of suppressing the side reactions activated by carbon material. Micro-particles of poly(3,4-ethylenedioxythiophene) (PEDOT), a conducting polymer, were used as the base material for the air electrode of $Li-O_2$cells. The PEDOT micro-particles were treated with $H_2SO_4$ to improve their electronic conductivity, and LiBr and CsBr were used as the redox mediators to facilitate the dissociation of there action products in the electrode and reduce the over-potential of the $Li-O_2$ cells. The capacity of the electrode employing PEDOT micro-particles was significantly enhanced via $H_2SO_4$ treatment, which is attributed to the increased electronic conductivity. The considerable capacity enhancement and relatively low over-potential of the electrode employing $H_2SO_4$-treated PEDOT micro-particles indicate that the treated PEDOT micro-particles can act as reaction sites and provide storage space for the reaction products. The cyclic performance of the electrode employing $H_2SO_4$-treated PEDOT micro-particles was superior to that of a carbon electrode. The results of the Fourier-transform infrared spectroscopic analysis showed that the accumulation of residual reaction products during cycling was significantly reduced by introducing the carbon-free electrode based on $H_2SO_4$-treated PEDOT micro-particles, compared with that of the carbon electrode. The cycle life was improved owing to the effect of the redox mediators. The refore, the use of the carbon -free electrode combined with redox mediators could realize excellent cyclic performance and low over-potential simultaneously.

• 전기화학회지
• /
• 제4권3호
• /
• pp.98-103
• /
• 2001

EDLC(electric double layer capacitor)용 활성탄소전극의 제조공정을 dip coating method, doctor blade coating method, paste rolling method로 달리하여 전기화학적 특성과 비축전 용량을 조사하였다. Dip coating method에 의한 전극제조시 전해질염으로 LiPF6를 이용하고 유기용매로 PC-DEC를 이용한 EDLC의 비축전 용량이 130F/g으로 가장 우수하였고, 선형의 시간전압곡선에서의 IR-drop도 0.11V로 작았으며 CV(cyclic voltammetry) 분석 또한 이상적인 EDLC의 특성을 나타내었다.

• Korean Chemical Engineering Research
• /
• 제57권3호
• /
• pp.408-412
• /
• 2019

본 연구에서는 urea를 이용해 질소 도핑된 카본 펠트 전극을 제조하고 이를 바나듐 레독스 흐름 전지용 전극으로 적용하였다. Urea는 암모니아 보다 취급이 용이할 뿐 아니라 고온 열분해를 통해 $NH_2$ 라디칼이 발생하여 탄소 표면에 질소 작용기를 만들고 이는 바나듐 이온의 산화/환원 반응을 향상시키는 활성점(active site)로 작용한다. Urea로 활성화된 카본 펠트 전극은 $150mA/cm^2$의 전류 밀도에서 14.9 Ah/L의 방전 용량을 보였으며 이는 산소작용기로 활성화된 카본 펠트(OGF) 및 비활성화 카본 펠트(GF)보다 각각 23% 및 187% 더 높았다. 이러한 결과는 urea로 활성화된 카본 펠트 전극이 레독스 흐름 전지용 전극 소재로 사용될 수 있는 가능성을 보여준다.

• Carbon letters
• /
• 제26권
• /
• pp.102-106
• /
• 2018

• 전기화학회지
• /
• 제6권2호
• /
• pp.153-157
• /
• 2003

전기이중층 축전용량(electric double layer capacitance)과 유사축전용량(pseudo-capacitance)을 함께 갖는 하이브리드 전기화학 축전기에 대한 연구를 수행하였다. 양극은 $Ni(OH)_2$ 활성탄소가 복합된 전극을 사용하였으며 음극은 활성탄소를 활물질로 사용하므로써 비대칭 전극 구조를 갖는다. 셀 실험을 위하여 $5\times5cm^2$ 크기인 전극을 제작 사용하였다. Cyclic voltammetry측정 및 교류 임피던스 측정실험을 통하여 각각의 셀들이 갖는 전기화학적 거동을 조사하였고 충 방전 실험을 통하여 양극과 음극의 최적 질량비를 조사하였다.

• 한국대기환경학회지
• /
• 제29권6호
• /
• pp.830-837
• /
• 2013

The purposes of this research are to know the dust removal efficiency according to the changes of gab between positive and negative plates in dust removal chamber. The experiments for dust removal efficiencies were conducted with changing the electrode-plate gab from 2 cm to 1 cm while the electric pressure, influent flow, and linear velocity were kept 5 kV, 80 L/min, and 6 cm/sec, respectively. From the experimental results of the electrode-plate gab of 2 cm, dust removal efficiencies were decreased to as low as about 50%. Attached dust on the surface of electrodes was released due to a reverse electric charge of dust. From the experimental results of the electrode-plate gab of 1 cm, dust removal efficiencies were increased to as high as about 80% due to the dust attachment velocity to the electrodes to be far more fast than influent linear velocity. Finally, to protect a attached dust from occurring a reverse electric charge it is needed to install the non-conductor between positive and negative electrodes and also to remove air humidity.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 Vol.19
• /
• pp.353-354
• /
• 2006

This work describes the effect of binders, such as carboxymethylcellulose (CMC), CMC+Polytetrafluoroethylene (PTFE) and PTFE, on the electrochemical and mechanical properties of activated carbon-electrode for electric double layer capacitor. The cell capacitors using the electrode bound with binary binder composed of CMC and PTFE, especially m composition CMC ; PTFE = 60 : 40 wt %, has exhibited the better rate capability and the lower internal resistance than those of the cell capacitor with CMC. On the other hand, the sheet type electrode kneaded with PTFE was bonded with conductive adhesive on Al foil. This cell capacitor using the electrode with PTFE exhibited the best mechanical properties and rate capability compared to the CMC and CMC+PTFE one These behaviors could be explained by the well-developed network structure of PTFE fibrils during the kneading process.