• 복합신소재구조학회 논문집
• /
• 제2권1호
• /
• pp.8-14
• /
• 2011

본 연구는 Primary Anchor의 비선형 유한요소해석을 통해 구조적 성능을 파악하는데 목적이 있다. Primary Anchor Unit은 ALC 패널 커튼월과 RC 슬래브 또는 주골조 사이에 연결장치로 사용할 수 있다. 항복강도, 초기강성과 최대하중과 같은 구조적 특성을 구하고 자세히 비교분석하였다.

• 한국지반공학회논문집
• /
• 제30권11호
• /
• pp.61-69
• /
• 2014

본 연구에서는 수치해석을 이용하여 모래지반에 설치된 병렬식 그룹석션앵커의 인발하중에 대한 거동을 분석하였다. 단일형과 병렬식 그룹석션 앵커에 대한 수치 모델을 구성하고 인발하중을 재하하여 하중재하점의 위치, 길이/직경비, 하중경사 및 단위앵커간 간격에 따른 그룹형 석션앵커의 인발지지력에 대한 영향을 연구하였다. 더블형과 트리플 그룹앵커의 인발지지력은 단일앵커의 인발지지력 대비 1.7배와 2.4배로 나타났고, 설치간격이 증가함에 따라 그 증가율은 증가하였다. 하중재하점, 하중경사, 단위앵커의 형상비의 차이는 그룹앵커의 인발저항력 증가비에 큰 영향을 주지 않는 것으로 나타났다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2001년도 가을 학술발표회 논문집
• /
• pp.1097-1102
• /
• 2001

Seismic safety of continuous span concrete bridge can be enhanced by distributing a large seismic lateral load to each supporting pier. A new viscoelastic device called Shock Transmission Unit(STU), which is a simple cylinder-piston assembly packed with a so-called silicone putty compound, enables the lateral seismic load to be transmitted to the pier by installation of the device to movable bearings of the bridge. The seismic safety of concrete bridges having the STU depends on not only safety of the bridges globally but also safety of anchor systems which anchors the STU to concrete pier. An experimental investigation is performed to study the behavior of cast-in-place anchor and post-installed anchor subjected to shear load statically and cyclically according to different edge distance, embedment length, and anchor spacing. Finally, the experimental results are compared with results by design methods of ACI and CCD, and results by FEM analysis.

• Geomechanics and Engineering
• /
• 제5권3호
• /
• pp.187-194
• /
• 2013

The most soil anchor works have been concerned with the uplift problem on embedded in non-reinforced soils under pullout test. Symmetrical anchor plates are a foundation system that can be resisting tensile load with the support of around soil in which symmetrical anchor plate is embedded. Engineers and authors proved that the uplift response can be improved by grouping the symmetrical anchor plates, increasing the unit weight, embedment ratio and the size of symmetrical anchor plates. Innovation of geosynthetics in the field of geotechnical engineering as reinforcement materials found to be possible solution in symmetrical anchor plate responses. Unfortunately the importance of reinforcement in submergence has received very little attention by researchers. In this paper, provision of tensile reinforcement under embedded conditions has been studied through uplift experiments on symmetrical anchor plates by few researchers. From the test results it has been showed that the provision of geogrid reinforcement system enhances the uplift response substantially under uplift test although other results are such as increase the ultimate uplift response of symmetrical anchor plate embedded using geosynthetic and Grid Fixed Reinforced (GFR) and symmetrical anchor plate improvement is very dependent on geosynthetic layer length and increases significantly until the amount of beyond that further increase in the layer length does not show a significant contribution in the anchor response.

• 한국농공학회지
• /
• 제32권4호
• /
• pp.71-80
• /
• 1990

Model tests for the ultimate pullout resistance of anchorages and investigation of failure behaviors in cohesionless soil have been conducted. The factors affecting the anchorage are mostly the geometry of the system, and soil properties of sands. The main conclusions of the experimental work were as follows. 1. The load - displacement relationship can be a form of parabolic curve for all plates. 2. The change in ultimate pullout resistance of anchor is mostly affected by embedment ratio and size of anchor, and influenced to a lesser degree by its shape. 3. Critical embedment ratio which is defined as the failure mode changes from shallow to deep mode is increased with increasing height of anchor. 4. For a constant anchor height, as the width of anchor increases the ultimate pullout resistance also increases. However, considering the efficiency of anchor for unit area, width of anchor does not appear to have any sigrnificant contribution on increasing anchor city. 5. Anchor capacity has a linear relation to sand density for any given section and the rate of change increases as the section increases. Critical depth determining the failure patterns of anchor is decreased with a decrease of sand density. 6. With increasing inclination angle, size of anchor, and decreasing embedment ratio, the ultimate pullout resistance of anchor under inclined loading is significantly decreased. 7. The ultimate pullout resistance of double anchor, a method of improving single of anchor capacity, is influenced by the center - to - center spacing adjacent anchors. It is also found that tandem and parallel anchor rigging arrangements decrease the anchor system capacity to less than twice the single anchor capacity due to anchor interference.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2005년도 지반공학 공동 학술발표회
• /
• pp.517-520
• /
• 2005

The embedded suction anchor(ESA) is and anchor that is driven by a suction pile. The cross-sectional shape of the ESA anchor is circle. Its diameter is the same as that of the suction pile that is used to drive it into the seafloor. For the installation, the anchor is attached to the tip of the suction pile and then driven as a unit with the pile by and applied suction pressure. Once the ESA anchor reaches the desired depth, the pile is retrieved by applying a positive pressure. Finally, only the ESA anchor remains in the soil layer. This paper presents the results of centrifuge model tests to investigate ESA pullout capacity. The main parameters that have effects on the pullout capacity of ESA may include g-level, embedded depth, direction of loading, and loading point. The results of tests show that the pullout loading capacities increase as the loading point shift toward the tip of the anchors for a given loading direction. They also indicate that the loading point associated with the maximum pullout loading capacity is located at approximately 67 percent of the anchor length from the top for the horizontal load.

• 한국멀티미디어학회논문지
• /
• 제10권5호
• /
• pp.559-568
• /
• 2007

앵커 장면 검출은 내용기반 뉴스 비디오 색인과 검색 시스템에서 비디오 장면의 의미적 파싱과 색인을 추출하는데 중요한 역할을 한다. 이 논문은 스포츠 뉴스의 단위 구조화를 위해서 뉴스 동영상에 존재하는 앵커 구간을 구분해내는 효율적인 알고리즘을 제안한다. 앵커 장면을 검출하기 위해서, 우선 MPEG4 압축 비디오에서 DCT 계수치와 모션 방향성 정보를 이용하여 앵커 후보 장면을 결정한다. 그리고 검출된 후보앵커 장면으로부터 영상처리 방법을 활용하여 뉴스 비디오를 앵커 장면과 비앵커(스포츠) 장면으로 분류한다. 제안된 방법은 앵커 장면 검출 실험에서 평균적으로 98%의 정확도와 재현율을 얻었다.

• Geomechanics and Engineering
• /
• 제5권4호
• /
• pp.299-312
• /
• 2013

The horizontal pullout capacity of a group of two vertical strip plate anchors, placed along the same vertical plane, in a fully cohesive soil has been computed by using the lower bound finite element limit analysis. The effect of spacing between the plate anchors on the magnitude of total group failure load ($P_{uT}$) has been evaluated. An increase of soil cohesion with depth has also been incorporated in the analysis. For a weightless medium, the total pullout resistance of the group becomes maximum corresponding to a certain optimum spacing between the anchor plates which has been found to vary generally between 0.5B and B; where B is the width of the anchor plate. As compared to a single plate anchor, the increase in the pullout resistance for a group of two anchors becomes greater at a higher embedment ratio. The effect of soil unit weight has also been analyzed. It is noted that the interference effect on the pullout resistance increases further with an increase in the unit weight of soil mass.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2006년도 추계학술대회논문집
• /
• pp.111-118
• /
• 2006

The Emergency Diesel Generator(EDG) is a very important piece of equipment for the safety of a Nuclear Power Plant(NPP). In this study, the operating vibration or three kinds or EDG system was measured. The target EDG systems art Yonggwang 5 unit, Ulchin 2 unit and Ulchin 3 unit. The Yonggwang 5 and Ulchin 3 unit EDG system is the same type but the foundation systems are different. One is an anchor bolt type and the other is a spring and viscous-damper type. The purpose of this measurement is for a verification of the vibration isolation effect according to the foundation system. As a result. it can he said that the spring and viscous damper system of the EDG performed well for the vibration isolation.

• 방송공학회논문지
• /
• 제6권3호
• /
• pp.260-269
• /
• 2001

본 논문은 뉴스의 단위 구조화를 위해서 뉴스 동영상에 존재하는 앵커구간을 구분해내는 효율적인 알고리즘을 제안한다. 이를 위하여 본 논문은 단순히 장면 전환 지점을 이용하기 보다는 화면에 존재하는 앵커의 얼굴을 이용한다. 앵커구간에서는 앵커 얼 굴 위치의 프레임 변화량을 계산하는 FRFD(Face Region Frame difference)를 이용하여 앵커구간의 마지막을 찾는다. 한편 비앵 커구간에서는 앵커 얼굴 추출을 이용하여 앵커구간의 시작점을 찾는다. 앵커 얼굴 추출은 처리 속도를 빠르게 하기 위해서 MPEG .동영상 부분 복호화를 통한 대략적 분석과 전체 복호화를 통해 얻어진 앵커 얼굴 후보를 검증하는 두 단계로 이루어져 있다. 이렇게 얻어진 앵커구간은 뉴스 분석의 기본 단계에서 이용이 가능하다. 특히 빠른 속도와 높은 recall 비율은 실제 뉴스 서비스 활용에 적당하다.