• E2M - 전기 전자와 첨단 소재
• /
• 제9권7호
• /
• pp.680-689
• /
• 1996

SrCaCuO와 BiPbCuO 화합물로 이루어진 이중층시료가 만들어 졌으며, 소결과정에서 나타나는 확산과 입자간의 상호작용으로 108K의 임계온도를 나타내었다. 이 시료는 820.deg. C에서 0-210 시간동안 소결되었다. 초전도체의 생성, 성장메카니즘과 임계온도의 관계가 연구되었으며, 최적조건은 820.deg. C에서 210시간 소결하고 SrCaCuO와 BiPbCuO의 도포비가 1:0.6인 시편에서 나타났다. 또한 이중층시료에서 가장 좋은 조성비는 S $r_{2}$C $a_{2}$C $u_{2}$ $O_{x}$와 B $i_{1.9}$P $b_{0.5}$C $u_{3}$ $O_{y}$ 이었다.다.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 1999년도 High Temperature Superconductivity Vol.IX
• /
• pp.300-304
• /
• 1999

To tap the feasibility of exploiting the 2$^{nd}$ phases as flux-pinning centers in the (Bi,Pb)$_2Sr_2Ca_2CuO_{10}$ superconductor, the size and the distribution of the precipitates have been controlled by changing reaction temperature and time, oxygen partial pressure Po$_2$ and annealing condition. Various annealing heat treatments were also conducted on the as-received 61 filament Bi-2223 tapes with Bi$_{1.8}Pb_{0.4}Sr_2Ca_{2.2}Cu_3O_8$ starting composition and annealed specimen were analyzed with XRD, SEM, EDS and TEM.. The grain size of (Ca,Sr)$_2$(BiPb)O$_4$ or Bi$_{0.5}Pb_3Sr_2Ca_2CuO_{\delta}$ was controllable by optimizing the heat treatment condition and critical current density (J$_c$) showed dependence on the size of the 2$^{nd}$ phases.

• Progress in Superconductivity
• /
• 제2권2호
• /
• pp.65-70
• /
• 2001

$Pb/Bi_2Sr_2CaCu_2O_{8+\delta}$-single-crystal junctions with the tunneling direction along the c axis of the crystal were fabricated to obtain an s-wave-superconductor/d-wave-superconductor Josephson junctions. The tunneling R (T) curves and current-voltage characteristics show distinct features which can be explained only under the assumption that the order parameter of high-$T_c/Bi_2Sr_2CaCu_2O_{8+{\delta}}$ superconductors has a pure d-wave symmetry, which is in contrast to the case of $YBa_2Cu_3O_{7+{\delta$}}$erconductors where a minor s-wave component is also present..

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.500-502
• /
• 2000

BiPbSrCaCuO 계 초전도체에서 관측되는 자기부양효과에 대하여 연구를 수행하였다. BiPbSrCaCuO 계 초전도체에 산화은을 첨가한 시료와 첨가하지 않은 시료의 자기적 특성을 측정하여 자기부양효과의 메카니즘에 대하여 고찰하였다. toroidal자석에서 관측되는 자기부양 효과는 자석의 중심부분에서만 발생하며, 자석의 ring 부분에서는 관측되지 않았다. 이 결과는 본 연구의 자기 부양효과의 발생에는 자석의 형상 및 자속의 분포 형태와 밀접한 관련이 있음을 의미한다.

• 대한전기학회논문지
• /
• 제43권5호
• /
• pp.795-801
• /
• 1994

The BiPbSrCaCuO superconductor was fabricated by diffusion of The dual layer composed of SrS12TCaS11TCuS12TOS1xT in upper layer and BiS12TPbSI0.3TCuS12TOS1yT in lower layer, and varified growh-mechanism of BiPbSrCaCuO superconducting phase. And, we produced optimum conditions of spread volume and each stage of sintering time were upper layer:Lower layer=1:0.2, 1:0.4, 1:0.6 and 24hr., 120hr., 210hr. From the result, the optimum conditions are spread volume(Upper layer:Lower layer=1:0.6), sintering time(210hrs.) at 820$^{\circ}C$.The BiPbSrCaCuO superconductor, fabricated optimum condition, showed zero resistance at critical temperature of 70k.

• 한국재료학회지
• /
• 제17권3호
• /
• pp.147-151
• /
• 2007

Cu-free multi-component sol, of which final oxide composition becomes $Bi_{1.9}Pb{0.35}SrCaO,\;Bi_{1.8}Pb_{0.2}SrCaO\;and\;Bi_{1.5}SrCaO$, respectively, was prepared through sol-gel route and coated on a bare Cu substrate. Starting materials were metal-alkoxides as follows.; [$Bi(OC_{2}H_{5})_{3}\;Pb(O^{1}C_{3}H_{7})_{2},\;Sr(O^{i}C_{3}H_{7})_{2},\;Ca(OC_{2}H_{5})_{2}$] as a reagent grade. Transparent light yellowish sol was obtained in the case of $Bi_{1.9}Pb_{0.35}SrCaO\;and\;Bi_{1.8}Pb_{0.2}SrCaO$ composition and $Bi_{1.5}SrCaO$ composition's sol was light greenish. Each sol was repeatedly dip-coated on Cu substrate four times and pre-heated at $400^{\circ}C$ and finally heat-treated in the range of $740{\sim}900^{\circ}C$. In the results, crystalline phases confirmed by XRD were (2201) orthorhombic and monoclinic phases. However, only $Bi_{1.9}Pb_{0.35}SrCaO_{x}$ composition showed pseudo-superconductive behavior after heat-treatment at $900^{\circ}C$ for 12 seconds and then onset temperature was 77 K, even though it did not exhibit zero resistance below Tc.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1992년도 춘계학술대회 논문집
• /
• pp.64-69
• /
• 1992

Bi-Sr-Ca-Cu-O superconducting system have the low and high Tc phases. In order to get the superconductor above crtitical temperature 100K, we added with Pb and sintered for a long time about 200 hrs. In this study, the influence of superconducting characteristics on the Bi(Pb)SrCaCuO system characteristics on the Bi(Pb)SrCaCuO system dopped Sb was investigate too. Adding Sb of 0.1 mol, the sintering time is short than that dopped Pb only. We could get the critical temperature 102 K at sintered for 24 hrs and 109 K for 210 hrs.

• 한국재료학회지
• /
• 제6권7호
• /
• pp.684-691
• /
• 1996

Bi-계 고온초전도체인 Bi2Sr2Ca2Cu3O10(Bi-2223)단일상을 반응시간을 줄이면서 합성하기 위하여 Bi-Sr-Ca-Cu-O계 내에 존재하는 Bi2Sr2Ca2Cu3O10(Bi-22o1), Bi2Sr2Ca2Cu3O10(Bi-2212), (Ca0.91Sr0.09)-CuO2의 혼합물, 특히 정확한 Bi1.7Pb0.4Sr2Ca2Cu3O10+x의 조성대신 (Ca0.91Sr0.09)CuO2가 많이 첨가된 조성의 혼합물에서 Bi-2223가 가장 쉽게 형성되었다. Bi-2223상은 86$0^{\circ}C$와 87$0^{\circ}C$에서 60시간 이내에 형성되었다. 소량의 Bi-2212상은 장시간의 반응후에도 여전히 존재하였다. 중간화합물을 이용한 합성방법이 통상의 소결방법에 비해 반응시간내에 소량의 불순물상들을 가진 Bi-2223상을 형성시킬 수 있다.

• 수산해양기술연구
• /
• 제30권4호
• /
• pp.350-356
• /
• 1994

We have prepared superconducting Bi-Pb-Sr-Ca.Cu-O thin films by RF magnetron sputtering technique, on heated MgO(100) substrates. Sputtering was carried out in a mixture of argon and oxygen(10%) and the pressure was maintained at 5 mTorr during deposition. The substrate temperature was maintained $400^{\circ}C$ during deposition. The films sputtered were amorphous and insulating. All the films became superconducting by annealing, The films annealed at $880^{\circ}C$ for 30 minutes in air showed high-Tc phase with zero resistivity of 93K. These results indicate that the growth of the high-Tc phase is promoted by the presence of Pb at annealing temperature.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1990년도 추계학술대회 논문집
• /
• pp.26-30
• /
• 1990

Bi$\_$0.7/Pb$\_$0.3/Sr$_1$Ca$_1$Cu$\_$1.8/Ox thick films were screen printed on magnesia(MgO), silver and yttrium stabilized zirconia (YSZ) substrates and were sintered in a boat with cover to prevent the evaporation. The high-Tc phase increase and the low-Tc phase and Ca$_2$PbO$_4$ decrease with an increase in sintering temperature from 835$^{\circ}C$ to 860$^{\circ}C$. YSZ substrate interact strongly with the oxide resulting in poor superconductor, while the Ag and MgO substrates were satisfactory to make screen printed superconductors. The Bi$\_$0.7/Pb$\_$0.3/Sr$_1$Ca$_1$Cu$\_$1.8/Ox thick films screen printed both on Ag and MgO substrates show high Tc phase of ~85% and Tc of 96K.