• Journal of Trauma and Injury
• /
• 제33권2호
• /
• pp.81-87
• /
• 2020

Purpose: Chronic subdural hematoma (CSDH) is a common disease in elderly patients and is usually treated by burr-hole drainage. However, the optimal surgical technique for treating CSDH has not been determined. In this study, we analyzed outcomes and recurrence rates after burr-hole drainage with or without irrigation in patients with CSDH. Methods: Eighty-two CSDH patients treated with burr-hole drainage at Wonju Severance Christian Hospital from March 2015 to June 2016 were enrolled in this study. The subjects were divided into three groups based on the surgical technique performed as follows: single burr-hole drainage without irrigation (group A, n=47), single burr-hole drainage with irrigation (group B, n=14), or double burr-hole drainage with irrigation (group C, n=21). These three groups were compared with respect to clinical and radiological factors and the recurrence rate, and independent factors predicting recurrence were sought. Results: After burr-hole drainage, CSDH recurred in 15 (18.3%) of the 82 patients, and six patients (7.3%) required reoperation. More specifically, recurrence was observed in 12 patients (25.5%) in group A, one (7.1%) in group B, and two (9.5%) in group C. The number of burr-holes did not significantly affect recurrence (odds ratio [OR]=0.38; 95% confidence interval [CI]: 0.60-2.38), but irrigation had a significant effect (OR=0.20; 95% CI: 0.04-0.97). Conclusions: This study shows that irrigation during burr-hole surgery in CSDH patients significantly reduced the risk of recurrence, regardless of the number of burr-holes used. We therefore recommend the use of active irrigation during burr-hole drainage surgery in CSDH patients.

• Journal of Korean Neurosurgical Society
• /
• 제58권3호
• /
• pp.167-174
• /
• 2015

Objective : This study investigates the role of a burr hole and calvarial bone marrow-derived stem cells (BMSCs) in a transient ischemic brain injury model in the rat and postulates a possible mechanism for the efficacy of multiple cranial burr hole (MCBH) surgery in moyamoya disease (MMD). Methods : Twenty Sprague-Dawley rats (250 g, male) were divided into four groups : normal control group (n=5), burr hole group (n=5), ischemia group (n=5), and ischemia+burr hole group (n=5). Focal ischemia was induced by the transient middle cerebral artery occlusion (MCAO). At one week after the ischemic injury, a 2 mm-sized cranial burr hole with small cortical incision was made on the ipsilateral (left) parietal area. Bromodeoxyuridine (BrdU, 50 mg/kg) was injected intraperitoneally, 2 times a day for 6 days after the burr hole trephination. At one week after the burr hole trephination, brains were harvested. Immunohistochemical stainings for BrdU, CD34, VEGF, and Doublecortin and Nestin were done. Results : In the ischemia+burr hole group, BrdU (+), CD34 (+), and Doublecortin (+) cells were found in the cortical incision site below the burr hole. A number of cells with Nestin (+) or VEGF (+) were found in the cerebral parenchyma around the cortical incision site. In the other groups, BrdU (+), CD34 (+), Doublecortin (+), and Nestin (+) cells were not detected in the corresponding area. These findings suggest that BrdU (+) and CD34 (+) cells are bone marrow-derived stem cells, which may be derived from the calvarial bone marrow through the burr hole. The existence of CD34 (+) and VEGF (+) cells indicates increased angiogenesis, while the existence of Doublecortin (+), Nestin (+) cells indicates increased neurogenesis. Conclusion : Based on these findings, the BMSCs through burr holes seem to play an important role for the therapeutic effect of the MCBH surgery in MMD.

• Journal of Korean Neurosurgical Society
• /
• 제46권2호
• /
• pp.87-92
• /
• 2009

Objective: Chronic subdural hematoma (CSDH) is one of the most common types of traumatic intracranial hemorrhage, usually occurring in the older patients, with a good surgical prognosis. Burr hole craniostomy is the most frequently used neurosurgical treatment of CSDH. However, there have been only few studies to assess the role of the number of burr holes in respect to recurrence rates. The aim of this study is to compare the postoperative recurrence rates between one and two burr craniostomy with closed-system drainage for CSDH. Methods: From January 2002 to December 2006, 180 consecutive patients who were treated with burr hole craniostomy with closed-system drainage for the symptomatic CSDH were enrolled. Pre- and post-operative computed tomography (CT) scans and/or magnetic resonance imaging (MRI) were used for radiological evaluation. The number of burr hole was decided by neurosurgeon's preference and was usually made on the maximum width of hematoma. The patients were followed with clinical symptoms or signs and CT scans. All the drainage catheters were maintained below the head level and removed after CT scans showing satisfactory evacuation. All patients were followed-up for at least 1 month after discharge. Results: Out of 180 patients, 51 patients were treated with one burr hole, whereas 129 were treated with two burr holes. The overall postoperative recurrence rate was 5.6% (n = 10/180) in our study. One of 51 patients (2.0%) operated on with one burr hole recurred, whereas 9 of 129 patients (7.0%) evacuated by two burr holes recurred. Although the number of burr hole in this study is not statistically associated with postoperative recurrence rate (p> 0.05), CSDH treated with two burr holes showed somewhat higher recurrence rates. Conclusion: In agreement with previous studies, burr hole craniostomy with closed drainage achieved a good surgical prognosis as a treatment of CSDH in this study. Results of our study indicate that burr hole craniostomy with one burr hole would be sufficient to evacuate CSDH with lower recurrence rate.

• Journal of Korean Neurosurgical Society
• /
• 제46권6호
• /
• pp.592-595
• /
• 2009

Cerebellar hemorrhage is an unusual complication of supratentorial neurosurgery. To the best of our knowledge, only three case reports have described the occurrence of cerebellar hemorrhage after burr hole drainage for the treatment of chronic subdural hematoma (SDH). We present the case of a patient with this rare postoperative complication of cerebellar hemorrhage after burr hole drainage of a chronic SDH. Although burr hole drainage for the treatment of chronic SDH is rare complication, it is necessary to be aware of the possibility of cerebellar hemorrhage after supratentorial surgery, even with limited surgery such as burr hole drainage of a chronic SDH.

• Journal of Yeungnam Medical Science
• /
• 제32권1호
• /
• pp.8-12
• /
• 2015

Background: Enlargement of subdural hematomas is relatively rapid in subacute stage of hematoma with clinical deterioration, which eventually necessitates surgery. The purpose of this study is to investigate the feasibility and safety of burr hole drainage using urokinase for management of patients with subacute subdural hematoma (SASDH). Methods: Nine patients with SASDH were treated by burr hole drainage using urokinase. Under local anesthesia a catheter was inserted into the hematoma through a burr hole. Burr hole drainage was followed by hematoma thrombolysis with instillation of urokinase (10,000 units) every 12 hours. Drainage was discontinued when a significant decrease of hematoma was observed on cranial computed tomography. Results: The patients' median age was 70 years (range, 62-87). The median Glasgow Coma Scale score before surgery was 15 (range, 11-15). Drainage was successfully performed in all patients. All patients had Glasgow Outcome Scale scores of 5 at discharge. There was no surgery-related morbidity or mortality. Conclusion: A burr hole drainage using urokinase could be a safe, feasible and effective minimally invasive method with low morbidity in treatment of selected patients with SASDHs.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2000년도 추계학술대회 논문집
• /
• pp.823-826
• /
• 2000

Burr formed in drilling are classified into three types. no burr, burrs with cap, teared burr. To control burr size in drilling. the second type burrs with cap are to be formed because it is small and uniform. It is necessary to understand the mechanism of cap formation to derive the burr formation into second type burr with cap. In several materials, second type burrs are formed in drilling by changing cutting conditions. It is observed that cap is formed as a result of the plastic deformation along the outside of exit hole. According to the tension behavior of the material in concentrated region between hole and drill outside edge, the geometry of burr with cap is determined.

• 대한기계학회논문집A
• /
• 제21권12호
• /
• pp.1984-1991
• /
• 1997

Recently burr technology is rising in the fields of the precision manufacturing and the high quality machining, deburring has treated as a difficult problem on going to the high efficiency, automation in the FMS. Removal of burr with various shapes, dimensions and properties couldn't be standardized and has depended on manual treatment. Especially, deburring for cross hole inside owing to passing through out perpendicular to a main hole is more difficult, the electrochemical method is proper as its solution at practical aspects. Burr elimination in the cross hole drilling of governor shaft used in the automobile engine so far has been worked by a manual post-processing by a skillful worker, which becomes a factor of productivity-down and cost-up so that improvement of machining process is needed. Therefore, for the high efficiency and automation of internal deburring in the cross hole, development of electrochemical deburring technology is needed. So, the new process in the burr treatment is supposed. In this study, characteristics of electrochemical deburring through experiments were identified and factors such as electrolytic gap and electorlytic fluid contributed to removal burr height were analyzed. Also, deburring efficiency and electrolytic performance for cross hole were examined according to electrolytic current and electrochemical deburring condition corresponding to acquired edge quality was found out.

• 한국공작기계학회논문집
• /
• 제13권3호
• /
• pp.61-67
• /
• 2004

In micro hole punching process the burr occurs inevitably, but the burr must be minimized in order to improve the quality and accuracy of the product. In this study, magnetic field-assisted polishing technique is applied to remove the burr which exists in nozzles for ink-jet printer head and proved to be a feasible for deburring by experiment. The deburring characteristics of sheet metals was investigated changing with polishing time and magnetic abrasive size. After the deburring, the burr size has remarkably reduced and roundness of the hole also has improved.

• 한국공작기계학회:학술대회논문집
• /
• 한국공작기계학회 2003년도 추계학술대회
• /
• pp.329-333
• /
• 2003

In micro hole punching process the burr occurs inevitably, but the burr must be minimized in order to improve the quality and accuracy of the product. In this study, magnetic field assisted polishing technique is applied to remove the burr which exists in nozzles for ink-jet printer head and proved to be a feasible for deburring by experiment. The deburring characteristics of sheet metals was investigated changing with polishing time. After the deburring, the burr size has remarkably reduced and roundness of the hole also has improved.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2011년도 춘계학술대회 논문집
• /
• pp.201-202
• /
• 2011