• Journal of Biosystems Engineering
• /
• v.34 no.6
• /
• pp.411-419
• /
• 2009

This study was carried out to develop a shredding-burying machine for application of gramineae green manure crops that were tall and had high biomass yield such as sudan grass and rye. We made a prototype to operate both shredding and burying concurrently to attach at middle-sized tractors. Field tests were performed with the prototype to treat rye and sudan grass. The test results showed that the average cutting length became shorter and the quantity of entwined stem became obviously decreased when the PTO shaft speed was fast and running speed was slow. Also, We found, when the cut stem length became shorter, the burying ratio became more increasing and the PTO power requirement became more decreasing. Working efficiency of the prototype was better than conventional Rotary. The test results for treating rye/sudan grass with prototype showed that average cutting length was 21.2/22.5 cm and burying ratio was 98.4/98.1% when the PTO shaft speed was 1,000/1,000 rpm and running speed was 0.25/0.17 m/s. Also, the working performance of the prototype was 0.79 and 1.14 h/10 a for rye and sudan grass, respectively. Finally, we found that the prototype of shredding-burying machine was better for labor than conventional method that required at least 3 times bigger tractor.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.44 no.1
• /
• pp.32-37
• /
• 1999

The experiment was conducted to investigate emergence response of lowland weeds at different soil moisture contents, burying depths and upon changes in soil moisture. Rice germination was over 50% at all burying depths under aerobic condition, but the emergence rate of the soil surface placed seeds in saturated and flooded conditions decreased by 19% and 29%, respectively, as compared with that of aerobic condition. Rice seeds at burying depth of over 3 cm did not emerge at all. The emergence rate of Echinochloa crus­galli (L.) Beauv. in aerobic condition was lower than 30%, but the emergence pattern of E. crus galli (L.) Beauv. at different soil moisture contents and seeding depths was similar to that of rice. Emergence behavior of lschaemum rugosum Salisb., Ludwigia octovalvis (Jacq.) Raven and Sphenoclea zeylanica Gaertn. which are dominant lowland weed species in the Philippines also differed depending on soil moisture conditions and burying depths. lschaemum rugosum Salisb. emerged at all burying depths under aerobic condition, whereasLudwigia octovalvis (Jacq.) Raven emerged only at 0 cm deep under saturated and aerobic condition and Sphenoclea zeylanica Gaertn. at 0 cm deep under flooding condition. Weed seeds planted at 1, 3, and 5 cm deep in continuous flooded and saturated condition did not emerge at all, but upon a change of soil moisture condition from saturated to drainage (S$\rightarrow$D) and flooded to drainage (F$\rightarrow$D), grass weeds began to germinate again and the average emergence rate in S$\rightarrow$D and F$\rightarrow$D were 26% and 5% forE. crus­galIi (L.) Beauv., 9% and 8% forI. rugosum SaIisb., respectively. Weed seeds buried in soil in the pot showed great emergence at S$\rightarrow$D but did not emerge under continuous flooded condition. The diversity index accounting for dominance degree and occurrence aspect of weed, was the lowest at F$\rightarrow$D.

• Proceedings of the KIEE Conference
• /
• 2002.07a
• /
• pp.484-486
• /
• 2002

In this paper, installation type is analyzed into a single and mixed burying type on burying situation of domestic underground transmission cables, and problem of underground cable is discussed with investigating the relation between burying type and sheath circulation current. Investigated cable systems are 520 T/L which have 512T/L for 154kV and 8T/L for 345kV. The authors consider that the analysis of sheath circulating current with burying type will contribute for setting reduction methods of sheath circulation current.

• Journal of Acupuncture Research
• /
• v.19 no.4
• /
• pp.27-41
• /
• 2002

Objective : The purpose of this study is to compare the effect of two other groups(Group A and B) which were treated with two other auricular acupuncture therapy to quit smoking. Methods : Seventy three high-school students were devided in two groups. Group A was treated with auricular acupuncture therapy by burying a needle in one side ear. Group B was not only treated with auricular acupuncture therapy by burying a needle in one side ear, but also treated with venesection on the other side ear. The effects of auricular acupuncture therapy to quit smoking were evaluated at two weeks and six months after the therapy. Results : Group A's score to quit smoking after the auricular acupuncture therapy was higher than Group B's score. Conclusions : Treating with auricular acupuncture therapy by burying a needle in one side ear and venesection on the other side, was effective neither on decreasing the amount of smoking nor on decreasing the desire to smoke compared with the only needle burying treatment.

• Journal of the Korean Society of Industry Convergence
• /
• v.26 no.1
• /
• pp.193-199
• /
• 2023

In this study, an analysis was conducted to analyze the structural stability of the piezoelectric power generation module and to determine the optimal burying hole interval for concrete, the installation site of the power generation module. A piezoelectric element refers to a functional ceramic having a piezoelectric direct effect that converts mechanical energy into electrical energy and a piezoelectric reverse effect. In the analysis of the piezoelectric power generation module, the load condition was applied with about 16 tons and a total of 10 wheels in consideration of the container trailer. The purpose was to evaluate the stability of major components of the piezoelectric power generation module through finite element analysis. In order to determine the optimal burying location of the concrete ground for burying the piezoelectric power generation module, the stability of the ground structure according to the distance of the holes was determined. As a result of the analysis, the maximum stress of the piezoelectric power generation module was generated in the support spring, showing a stress of about 276.7 MPa. It was found that the spacing of holes for embedding the piezoelectric power generation module should be set to a minimum of 100 mm or more.

• Horticultural Science & Technology
• /
• v.16 no.4
• /
• pp.517-519
• /
• 1998

This experiment was carried out to find out the effects of heat conservation materials (burying in soil, lagging, lagging +straw, nonwoven fabric, nonwoven fabric+straw) on freezing damage, labor saving, and crown gall occurrence of 'Kyoho' grapes. Temperature differences in burying in soil and lagging with $2.8^{\circ}C$ and $6.4^{\circ}C$, respectively and were considered favorable for over-wintering of grapevines. Heat conservation index in lagging +straw and burying in soil calculated from degree-hours below $-10^{\circ}C$ was 5 to 7 times higher than that of open field. Budbreak started earlier in lagging with+straw and nonwoven fabric+straw covering, and percent budbreak was increased by 22% and 7%, respectively, as well as higher than burying in soil. Diameter of bearing mother branch and length of internode and daughter branch were gross or long with soil and lagging straw and nonwoven fabric+straw. Cane growth was enhanced by burying in soil and lagging with+straw treatment. Crown gall occured higher in soil covered grape vines Labor saving was obtained in lagging with as much as 44% compared to burying in soil.

• Korean Journal of Weed Science
• /
• v.32 no.3
• /
• pp.180-187
• /
• 2012

Panicum maximum, Panicum repens, Imperata cylindrica, Pennisetum polystachion and Cyperus rotundus are five rhizomatous grass weeds that exist and are problematic in the coconut lands of Sri Lanka. Rhizomatous weeds are the most difficult to control because of their vegetative reproduction by underground propagules. Therefore chemical and biological techniques have failed to control these weeds to acceptable levels. Experiments were conducted to investigate the impact of depth of burial, duration of sun drying or duration of air drying rhizomes of the selected weed species on germination. Depth of burial reduced germination of all species. Burying rhizomes at depths less than 10 cm inhibited germination of P. maximum and P. polystachion. Burying depths below 30~40 cm inhibited germination of all species. Sun drying or air drying rhizomes for durations less than 5 days inhibited germination of P. maximum and P. polystachion. Germinations of all species were inhibited by sun drying rhizomes for 15 days or air drying rhizomes for 20 days. Sun drying of rhizomes of all species for five days reduced the moisture content to a greater extent than air drying. The results indicated that burying rhizomes at the depthsbelow 30~40 cm, sun drying rhizomes for durations beyond 15 days or air drying rhizomes for durations beyond 20 days would be effective in controlling germination of these species. The investigations of the experiments also suggest that keeping rhizomes on the soil surface without burying, sun drying rhizomes or air drying rhizomes for durations of 5~15 days would produce weak plants.

• Journal of Animal Environmental Science
• /
• v.16 no.3
• /
• pp.245-252
• /
• 2010

Disposal methods of managing carcass in Korea livestock production systems include burying, digesting, rendering, carcass dumping to manure pile, dead animal disposer and mini-incinerator. Burying was usually the most practical method of carcass disposal in our livestock farms. Burying, carcass dumping to manure pile, dead animal disposer and mini-incinerator may have environmental regulatory and economic liabilities when used as a means of carcass disposal. In many cases in this survey, these disposal methods offer a poor choice for the producer due to individual site conditions, geology, cost, air emissions, rendering plants. A survey questionnaire that addressed the issues to livestock producers was prepared. The questionnaire addressed two main topics as follows: 1) types of livestock and generation amounts of carcass 2) Number of breeding animals and disposal methods of livestock mortality. A total of 36 livestock producers were interviewed. The results of obtained in this survey were summarized as follows: The number of breeding poultry, swine, beef cow and dairy cow was 251,000, 2,600, 142 and 92 heads per year and the generation amounts of annually carcass was 0.46, 15.32, 0.36, 1.36 tons per year of each poultry, swine, beef cow and dairy cow farms, respectively. The disposal methods of carcass were burying (42%), carcass dumping to manure pile (36%), rendering (8%), incineration (6%), digesting (6%), carcass disposer (2%), respectively. These results can be used as basic information to establish the standard of carcass composting facility.

• Korean Journal of Ecology and Environment
• /
• v.56 no.4
• /
• pp.375-383
• /
• 2023

To determine the cause of the population decline in Gobiobotia naktongensis, substrate preference and burying behaviour were investigated in this study. In general, the species was shown to prefer a substrate size of 1 mm or less, depending on the flow. In addition, the burying depth varied according to the size of the fish and increased with a decrease in water temperature. Our findings showed that the main cause of the population reduction was the physical changes in the substrate structure due to the dams or barrages construction. Notably, the accumulation of silt and mud in the substrate upon the formation of an upstream lentic water region for structural construction and bed armouring caused by scouring and reduced downstream inflow of fine sediment were deterministic in the fish habitat changes, causing problems in burying. As sand substrate structure is critical for the survival and inhabitation of psammophilous species, efficient strategies should be developed with proper habitat management to reduce the anthropogenic damage

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.2
• /
• pp.329-334
• /
• 2012

The distribution submarine cables are normally used for power supply at island, which are mostly installed in the southern coast of KOREA, and partially installed in the west coast and Jeju-Island. There are two way of submarine cable burying system, buried and unburied type. Since 2003, KEPCO is entirely being constructing the distribution submarine cable by buried type. In this case, 'burial depth' is key index for evaluating the suitability of the buried situation. Therefore, the measurement accuracy of 'burial depth' is a big issue for burying system in the distribution submarine cable. This paper demonstrates the measurement error of burial depth that is affected by electrical factor such as grounding type of submarine cable in case of magnetic field detection method, and indicates the method to reduce the measurement error in buried type of distribution submarine cable system.