• 대한수학회지
• /
• 제37권2호
• /
• pp.193-223
• /
• 2000

In the late 1970's, M. Kuranishi proposed to control the moduli of the germ of a normal Stein space by deformations of the CR structure on the boundary. I this paper, we will see that it is naturally accomplished by considering stably embeddable deformations of CR structures.

• 정보처리학회논문지D
• /
• 제10D권7호
• /
• pp.1077-1088
• /
• 2003

공간 데이터베이스 시스템에서 검색의 성능을 높이기 위해서는 공간국부성을 고려한 공간색인 방법이 요구되며, 공간국부성은 객체들의 위치 속성과 관계가 있다. 기존의 공간색인 방법들에서는 객체가 가질 수 있는 순환적인 위치 속성이 고려되지 않았다. 본 논문에서는 순환 및 선형 도메인들로 구성된 검색공간에서 객체의 순환적인 위치 속성을 고려한 공간색인 구조인 $Cr^*$-트리를 제안하고 그 성능을 평가하였다. 실험결과에 의하면 $Cr^*$-트리는 객체의 분포형태와 버켓 용량에 관계없이 낮은 디스크 접근 횟수와 높은 버켓 이용률을 보였다.

• 대한수학회보
• /
• 제44권1호
• /
• pp.109-116
• /
• 2007

We study an (n+1)($(n{\geq}3)$-dimensional contact CR-submanifold of (n-1) contact CR-dimension in a (2m+1)-unit sphere $S^{2m+1}$, and to determine such sub manifolds under conditions concerning the second fundamental form and the induced almost contact structure.

• 한국표면공학회지
• /
• 제36권6호
• /
• pp.423-429
• /
• 2003

It has been investigated corrosion resistance and crystal structure of Zn-Cr coatings fabricated by electroplating method and electron-beam physical vapor deposition method(EB-P VD). The electroplated Zn-Cr alloy consists mainly of η'-Zn phase for the lower Cr content than 7.9 wt% Cr and ${\gamma}$'-ZnCr phase for the higher Cr content. In the Zn-Cr alloy fabricated by EB-PVD the ${\gamma}$'-ZnCr phase appeared clearly at 3 wt% Cr and it became the sole phase at 50 wt%Cr. The amount of η'-Zn phase decreased obviously with increasing Cr content when it exceeded 15 wt% Cr. The electrochemical measurement of the electroplated Zn-Cr film has shown corrosion potential of about -1000 mV. The current density of active region and the amount of dissolved Zn and Cr decreased significantly with increasing Cr content. The electrochemical characteristics of Zn-Cr alloy fabricated by EB-PVD have shown that the alloy of 50 wt% Cr had the highest corrosion potential(-500 mV) and the lowest critical passive current density than that of the electroplated.

• 한국표면공학회지
• /
• 제37권5호
• /
• pp.296-300
• /
• 2004

The defects of partial denture frameworks are mainly shrinkage porosity, inclusions, micro-crack, particles from investment, and dendritic structure. In order to investigate a good casting condition of partial denture frameworks, the three casting alloys and casting methods were used and detected casting defects were analyzed by using electrochemical methods. Three casting alloys (63Co-27Cr-5.5Mo, 63Ni-16Cr, 63Co-30Cr-5Mo) were prepared for fabricating partial denture frameworks with various casting methods; centrifugal casting (Kerr, USA), high frequency induction casting (Jelenko Eagle, USA), vacuum pressure casting (Bego, Germany). The casting temperature was $1,380^{\circ}C$ (63Co-27Cr-5.5Mo and 63Ni-16Cr) and $1,420^{\circ}C$ (63Co-30Cr-5Mo). The casting morphologies were analyzed using FE-SEM and EDX. The corrosion test of the dendritic structure was performed through potentiodynamic method in 0.9% NaCl solutions at $36.5^{\circ}C$ and corrosion surface was observed using SEM. The defects of partial denture frameworks improved in the order of centrifugal casting, high frequency induction casting, and vacuum pressure casting method, especially, pore defects were found at part of clasp in the case of centrifugal casting method. The structure of casting showed dendritic structure for three casting alloys. In the 63Co-27Cr-5.5Mo and 63Co-30Cr-5Mo, $\alpha$-Co and $\varepsilon$-Co phases were identified at matrix and $${\gamma}$-Ni_2$Cr second phase were shown in 63Ni-16Cr. Also, the corrosion resistance of cast structure increased in the order of vacuum pressure casting, high frequency induction casting, and centrifugal casting method.

• Applied Microscopy
• /
• 제45권1호
• /
• pp.32-36
• /
• 2015

The microstructural features of FeCoCrNi, FeCoCrNiAl and FeCoCrNiSix (x=0, 5, 10, 15, 20) alloys have been investigated in the present study. The microstructure of FeCoCrNi alloy changes dramatically with equiatomic addition of Al. The fcc irregular shaped grain structure in the as-cast FeCoCrNi alloy changes into the bcc interconnected structure with phase separation of Al-Ni rich and Cr-Fe rich phases in the as-cast FeCoCrNiAl alloy. The microstructure of FeCoCrNi alloy changes with the addition of Si. With increasing the amount of Si, the fcc structure of the grains is maintained, but new phase containing higher amount of Si forms at the grain boundary. As the amount of Si increases, the fraction the Si-rich grain boundary phase increases.

• 말소리와 음성과학
• /
• 제6권3호
• /
• pp.121-130
• /
• 2014

This study investigates the acoustic property of aspiration realized in English voiceless stops of /Cr/ and /sCr/ clusters. VOT is measured from stops in these clusters produced by two groups; one from native speakers of English and the other from Korean native speakers. Aspiration of stops in different types of clusters is compared to various phonological factors such as location of stress, syllable type, and position in word. Pursuing the idea that phonetic realization is correlated with phonological representation, attempts are made to account for the gradient nature of aspiration of stops on the basis of syllable structure at the phonetic level, which may vary in the wake of resyllabification. Voiceless stops in /Cr/ and /sCr/ clusters are further compared to results obtained in the previous study on /sC/ cluster. Variations in aspiration are also characterized in terms of segmental precedence relation of stops in the clusters, namely, post-[s], pre-[r], or both.

• 대한수학회논문집
• /
• 제13권3호
• /
• pp.561-577
• /
• 1998

We study (n＋3)-dimensional contact three CR submanifolds of a Riemannian manifold with Sasakian three structure and investigate some characterizations of $S^{4r＋3}$(a) $\times$ $S^{4s＋3}$(b) ($a^2$＋ $b^2$=1, 4(r ＋ s) = n - 3) as a contact three CR sub manifold of a (4m＋3)-dimensional unit sphere.

• 한국재료학회지
• /
• 제4권6호
• /
• pp.704-709
• /
• 1994

Crystal Structure and Magnetic Properties of $(LaS)_xCrS_2(x \approx 1.20$)가 1273K에서 $La_S_3$ , Cr, S의 혼합물의 반응으로부터 합성되었다. $(LaS)_xCrS_2( x\approx 1.20$)의 XRD회절 pattern은 monoclinic의 LaS-부격자, triclinic의 $CrS_{2}$-부격자와 그들의 초격자로서 해석되었다. 부격자의 온도의존성을 저온에서 X-선 회절분석으로 조사하였다. 77K~실온의 온도역에서 $(LaS)_xCrS_2(x \approx 1.20$)의 자기자화율을 Faraday balance법으로 측정하였다. $(LaS)_xCrS_2(x \approx 1.20$)은 실온 $\sigma$ -H plot에서 paramagnetic한 거동을 나타내었다. 관측된 유효자기 moment($\mu_{eff}$)는 $Cr^{3+}$을 spin-only에 의한 것과 $La^{3+}$을 spin-only와 orbital에 의한 것으로 계산할 경우 잘 일치되었다.

• 한국자기학회지
• /
• 제16권2호
• /
• pp.111-114
• /
• 2006

Zinc-blonde 구조를 가지는 CrAs와 MnAs에서 (110)면 원자층으로 이루어진 초격자의 자성을 제일원리 방법을 이용하여 연구하였다. 이를 위해 CrAs와 MnAs의 (110)층이 각기 세 층씩 교대로 반복되는 $(CrAs)_3(MnAs)_3(110)$ 초격자계의 전자구조를 총 퍼텐셜 선형보강평면파동(FLAPW) 에너지띠 방법을 이용하여 계산하였다. Cr-As로 이루어진 층과 Mn-As로 이루어진 층이 접합되는 계면에 있는 Cr과 Mn원자의 자기모멘트를 계산한 결과 각기 $3.07\;\mu_B$와 $3.74\;\mu_B$로 가운데 층의 Cr과 Mn의 자기모멘트 값인 $3.06\;\mu_B$와 $3.76\;\mu_B$보다 약간 크거나 작았다. 계산된 상태밀도로부터 이 계의 전자구조와 반쪽금속성을 고찰하였다.