• Journal of Positioning, Navigation, and Timing
• /
• v.4 no.4
• /
• pp.195-203
• /
• 2015

In this study, the carrier acceleration-ramp-step test was applied to GPS carrier phase measurements, and the results were compared and analyzed. In the carrier acceleration-ramp-step test, the acceleration, ramp, and measurements are estimated using 10 consecutive carrier phase measurements for satellites observed at the same time based on the least square method. As for the characteristic of this test, if failure occurs in the measurement, the value jumps significantly compared to the previous result; but it judges that failure has occurred in all the satellites although failure has occurred in one satellite. Therefore, in this study, a method that eliminates a satellite with failure was suggested, and thresholds of the carrier acceleration, ramp, and step were suggested. The evaluation of the failure detection performance of carrier phase measurement using the suggested thresholds showed that failure could be detected when the carrier phase measurement changed abruptly by more than about 0.1 cycles.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.146-146
• /
• 2000

This paper presents field test results of the GPS precise positioning using carrier phase observable. The Least-squares AMBiguity Decorrelation Adjustment(LAMBDA) method is implemented to resolve integer ambiguity problem for two epoch Ll carrier phase measurement data. Field test results show that the GPS precise positioning of cm-level accuracy is obtainable with conventional low cost, single frequency C/A code GPS receivers.

• Journal of Advanced Navigation Technology
• /
• v.14 no.5
• /
• pp.640-647
• /
• 2010

Many methods have been proposed to detect faults of carrier phase measurements, but there are no distinguished methods for land transportation systems. in this paper, the baseline constraints are used to detect faults in GPS carrier phase measurements with vehicle dynamic information. The faults include the multipath on GPS carrier measurements. Multiple antenna groups are used for this research. In the measurement domain the fault detection has been accomplished so that the implementation is easier than other methods.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.1
• /
• pp.179-184
• /
• 2006

Rapid and high-precision positioning with a Global Navigation Satellite System (GNSS) is feasible only when very precise carrier-phase observations can be used. There are two kinds of mathematical models for ambiguity resolution. The first one is based on both pseudorange and carrier phase measurements, and the observation equations are of full rank. The second one is only based on carrier phase measurement, which is a rank-defect model. Though the former is more commonly used, the latter has its own advantage, that is, ambiguity resolution will be freed from the effects of pseudorange multipath. Galileo will be operational. One of the important differences between Galileo and current GPS is that Galileo will provide signals in four frequency bands. With more carrier-phase data available, frequency combinations with long equivalent wavelength can be formed, so Galileo will provide more opportunities for fast and reliable ambiguity resolution than current GPS. This paper tries to investigate phase only fast ambiguity resolution performance with four Galileo frequencies for short baseline. Cascading Ambiguity Resolution (CAR) method with selected optimal frequency combinations and LAMBDA method are used and compared. To validate the resolution, two tests are used and compared. The first one is a ratio test. The second one is lower bound success-rate test. The simulation test results show that, with LAMBDA method, whether with ratio test or lower bound success rate validation criteria, ambiguity can be fixed in several seconds, 8 seconds at most even when 1 sigma of carrier phase noise is 12 mm. While with CAR method, at least about half minute is required even when 1 sigma of carrier phase noise is 3 mm. It shows that LAMBDA method performs obviously better than CAR method.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.35 no.3
• /
• pp.215-226
• /
• 1999

The experimented rangefinder consist of sets of V/A-Code GPS and sets of L1 C/A-code & carrier phase receivers connected by two spread spectrum radio modems in order to measure relative range and bearing between two ship antennas by real time, comparing and analyzing accuracy of both GPS receivers at the fix point on the land by means of executing zero baseline test by C/A code and by carrier phase as well as measuring distance range 5m, 10m, 15m between each other receivers. The results from the measurement of relative range and bearing are as follows as ;1. According to the results from zero baseline test, the average error by C/A-code receiver is less than 0.1m, which proves theories from published books but when each GPS receivers track different satellites, the range accuracy error becomes up to 100m by means of S/A. Because of this sudden wide range error, rangefinder is not appropriate at relative range measurement without additional modification of the algorism of the GPS receiver itself.2. According to relative range measurement by Carrier Phase and zero baseline test at static condition, the range error is less than 3.5cm in case that it passes more than 5 minutes after GPS sets can track simultaneously more than 6 satellites. Its main reason is understood that the phase center of antenna is bigger than geodetic antenna.3. When range measurement of two receivers from 5m, to 10m to 15m, the each range error is 0.340m, 0.190m, 0.011m and each standard variation is 0.0973m, 0.0884m, 0.0790m. The range error and standard variation are in inverse proportion to distance between two receivers. 4. L1 Carrier Phase GPS generally needs 5 minutes to fix and during this ambiguity search, the relative range and bearing angle is shown to be various.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.8 no.3
• /
• pp.292-298
• /
• 2003

Most of the three phase inverters for adjustable speed drive of AC machines are equipped with two or three current sensors for measurement of three phase current. One method to reduce the number of current sensors is that single current sensor measures the DC link current, then three phase current is reconstructed using the measured value and the switching status. To improve the measurement accuracy, switching state should be maintained for more than minimum switching time. Many papers have been published, which focused on the readjustment of pulse width and compensation of voltage distortion. Those methods are suitable for space vector modulation. But there are some difficulties in applying these methods to carrier-based PWM which is widely used in industry. In this paper, new current measurement method and voltage compensation method are proposed which are suitable for carrier-based PWM, then, the validity of proposed method is confirmed through experiment.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.1239-1243
• /
• 2005

A multipath mitigation method using the fault detection and isolation technique is proposed for the CDGPS. The base station is assumed to be immune to the effect of the multipath. With this reasonable assumption, the effect of multipath in moving station is mitigated. For that, the double difference measurement is produced, and then another additional difference between code pseudorange and acclumulated carrier phase is calculated. The test statistic is constituted with those differences. The hypothesis testing is applied to that test statistic. The proposed test statistic makes use of the effect of multipath in code pseudoranges and it does not use time differences. Therefore the detection ability for multipath is improved in most environments. However, the increased number of differences makes the measurement noises larger. The performance of the method is compared with that of the conventional parity space method with code pseudorange.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.4 no.1
• /
• pp.1-6
• /
• 2005

As an application of the GPS/SDINS integration for its synergistic results, the alignments of the SDINS utilizing GPS carrier phase rate measurements is introduced. A measurement model of GPS carrier phase rate, which does not require integer ambiguity determination process, is newly derived in order to be adopted with the SDINS in-flight alignment process. For in-flight alignment, the performance of the GPS/SDINS integration method suggested in this paper is analyzed using the covariance analysis.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.6 no.1
• /
• pp.49-58
• /
• 2003

Compared with generic GPS receiver, post-processing software GPS receiver has many advantages for high dynamic vehicle tracking. It has the advantage of the application of various tracking algorithms and aiding schemes. The post-processing system observes the carrier phase measurement data from the recorded GPS signals, detects and isolates the cycle slip. The observed carrier phase data and the raw data of the reference station are processed by carrier phase DGPS scheme. And the integer ambiguity resolution algorithm is used for resolving single frequency carrier phase ambiguity. The results of static and real flight test are presented and show that the proposed GPS translator processing system satisfies submeter accuracy.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.34 no.11
• /
• pp.42-46
• /
• 2006

As an application of SDINS/GPS integration for its synergistic results, the SDINS alignments utilizing GPS carrier phase rate measurements. A measurement model of GPS carrier phase rate is derived in order to be used with SDINS alignment process. For in-flight alignment, the performance of the suggested SDINS/GPS integration method is analyzed using the covariance analysis and its results are confirmed by those of van test. Consequently, it is shown that all states of the SDINS integrated system by utilizing GPS carrier phase rate measurements can be estimated more efficiently than a general SDINS/GPS during in-flight alignment.