• Journal of Korean Society of Environmental Engineers
• /
• v.37 no.6
• /
• pp.357-362
• /
• 2015

A novel $TiO_2$-Coconut Shell Powder Composite (TCSPS), prepared by the controlled sol-gel method with subsequent heat treatment, was evaluated as an innovative photocatalytic absorbent for the removal of methylene blue. Optimal preparation conditions of TCSPC were obtained by a response surface methodology and a central composite design model. As compared with the results obtained from one-factor-at-a-time experiments, the values were approximated to the nearest condition of these values and the following experimental parameters were set as the optimum : $600^{\circ}C$ calcination temperature and 20 g of coconut shell powder loading amount.

• Journal of the Korea Institute of Building Construction
• /
• v.23 no.2
• /
• pp.153-164
• /
• 2023

The objective of this study is to examine the removal rate of air pollutants, specifically sulfur oxides (SO_x) and nitrogen oxides(NO_x), using concrete permeable blocks containing zeolite beads coated with materials capable of eliminating these pollutants. Titanium dioxide(TiO₂) powder and coconut shell powder were utilized for the removal of SO_x and NO_x and were applied as coatings on the zeolite beads. Concrete permeable block specimens embedded with the coated zeolite beads were produced using an actual factory production line. Test results demonstrated that the concrete permeable block containing zeolite beads coated with coconut shell powder in the surface layer achieved SO_x and NO_x removal rates of 12.5% and 99%, respectively, exhibiting superior performance compared to other blocks. Additionally, the flexural strength and slip resistance were 5.3MPa and 65BPN or higher, respectively, satisfying the requirements specified in KS F 4419 and KS F 4561. Conversely, the permeability coefficient exhibited low permeability, with grades 2 and 3 before and after contaminant pollution, according to the standard for 'design, construction, and maintenance of pavement using permeable block'. In conclusion, incorporating zeolite beads coated with coconut shell powder in the surface layer enables simultaneous removal of SO_x and NO_x, irrespective of ultraviolet rays, while maintaining adequate flexural strength and slip resistance. However, the permeability is significantly reduced, necessitating further improvements.

• Korean Journal of Materials Research
• /
• v.14 no.2
• /
• pp.157-162
• /
• 2004

The object of this research is to develop a carbon molecular sieve(below CMS) which can separate selectively to convert mixture gases spout at waste landfill into fuel. And this research is meaningful from the viewpoint of a quality improvement of CH$_4$ gas and an utilization of by-product. CMS was prepared using coconut shell powder as starting material and the effects of activators, temperature and modifier on the reaction were investigated in this research. Also, pore diameter, surface area of CMS and adsorption rate were measured and studied by cahn balance and ASAP2010. Its specific surface area and pore distribution were controlled easily at 800^{\circ}C and adsorption rate was very good. The CMS prepared in this research is shown to be able to separate landfill gases very effectively.

• Applied Chemistry for Engineering
• /
• v.9 no.6
• /
• pp.798-802
• /
• 1998

Carbon granules were prepared by granulating a mixture of coconut shell powder and coal tar solution, and then by carbonizing at different temperatures. To control micropores of the carbonized granules, the deposition time of benzene vapor under nitrogen atmosphere was varied. For each prepared sample, SEM morphology and true density were investigated. The adsorption rates on the granules were measured with respect to oxygen and nitrogen by means of the Cahn D-200 system. Diffusivity, selectivity and amount of equilibrium adsorption for the gases were obtained from the measurement of adsorption rate. Based on the analysis of the adsorption characteristics, the optimum temperature and the deposition time for preparation of the molecular sieve carbon granules were found to be $800^{\circ}C$ and 10 minutes, respectively. At these optimal conditions, the selectivity coefficient, 26.4, 0f oxygen and nitrogen was obtained.