• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.181-182
• /
• 2008

In this paper, an cost-effective system architecture is proposed to implement digital predistortion scheme for linearizing the PA amplifing TDD wideband signal. To make digital predistorted signal for compensating nonlinearity of PA, a dedicated ADC and a frequency-down converter are necessary. Proposed scheme is based on the TDD feature that the RF receiver frontend is idle state during the downlink signal processing time and utilize them to make the digital predistorted signal for PA.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.5
• /
• pp.3-12
• /
• 2016

Recently, the study on 5G mobile communication systems using the millimeter-wave frequency band have been actively promoted and the importance of compensation of the nonlinearity of power amplifier caused by the characteristics of millimeter-wave frequency propagation attenuation is increasing. In the paper, we propose a piecewise polynomial model based on subdivision coefficient which are characteristics of power amplifier separated linear section and a non-linear section. In addition, the structure of digital predistortion based on the proposed model and direct learning method are proposed to implement a digital predistortion. To verify the proposed model, digital predistortion based on the proposed model and direct learning method for 60 GHz power amplifier using LTE signal implemented in the FPGA. And the hardware test bench measured performance and complexity. The proposed model achieves 3.3 dB gain over the single polynomial model in terms of the ACLR and reduces 7.5 percent in terms of the complexity.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.3 s.357
• /
• pp.92-97
• /
• 2007

Switching mode amplifiers have been studied widely for use at microwave frequency range, and the class E amplifier which is a type of switching mode amplifier offers very high efficiency approaching 100%. In this paper, 2.4GHz microwave class E amplifier with 66% power added efficiency (PAE) and 17.6dBm output has been linearized for use at wireless LAN transmitter, and digital predistortion technique with look up table is applied. With -3dBm input power of wireless LAN, measured output spectrum can meet the required IEEE 802.11g standard spectrum mask, and the digital predistortion output spectrum has been improved by 5dB of ACPR at 20MHz offset from center frequency.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.12
• /
• pp.2382-2390
• /
• 2007

A new polynomial-based predistortion method for linearizing nonlinear power amplifier is proposed. The proposed method finds the predistortion parameter directly without the help of postdistorter whereas most existing polynomial-based predistortion methods calculate the predistortion parameter indirectly from the prostdistorter. First, a new predistortion algorithm is derived based on the assumption that the characteristic of the amplifier is modeled by piecewise linear function. Then it is modified into a proposed method which does not require any assumption or prior knowledge of the amplifier. The proposed method is derived based on the RLS (recursive least squares) algorithm. The proposed technique is simpler to implement than the existing methods and the computer simulation demonstrates that the proposed method is more robust to the initial condition and the saturation region of the amplifier.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.4
• /
• pp.430-439
• /
• 2011

In this paper, we design a digital predistortion(DPD) for linearity enhancement of RF power amplifier operating in 900 MHz band. We verify improvement of linearity by comparing the proposed DPD using tanh as a nonlinear indexing function and the DPD using linear indexing function based on signal amplitude. The digital predistortion is realized by look-up table(LUT) method, and the Saleh model is employed for power amplifier modeling, then a commercial power amplifier module is used for measurement. The LUT has 256 tables, and the NLMS(Normalized Least Mean Square) algorithm was utilized for an adaptive algorithm for estimation. As a result, we improve the ACLR(Adjacent Channel Leakage Ratio) by around 15 dB.

• Journal of electromagnetic engineering and science
• /
• v.9 no.3
• /
• pp.152-158
• /
• 2009

We have developed a novel digital feedback predistortion(DFBPD) linearization based on RF feedback PD for the wide bandwidth modulated signals. The wideband PD operation is carried out by combining the DFBPD and memory lookup table(LUT). To experimentally demonstrate the linearization performance of the proposed PD technique for wideband signal, a class-AB amplifier using an LDMOSFET MRF6S23140 with 140-W peak envelope power is employed at 2.345 GHz. For a forward-link 2FA wideband code-division multiple-access signal with 10 MHz carrier spacing, the proposed DFBPD with memory LUT delivers the adjacent channel leakage ratio at an 10 MHz offset of -56.8 dBc, while those of the amplifier with and without DFBPD are -43.2 dBc and -41.9 dBc, respectively, at an average output power of 40 dBm. The experimental result shows that the new DFBPD with memory LUT provides a good linearization performance for the signal with wide bandwidth.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.3
• /
• pp.73-79
• /
• 2013

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.12
• /
• pp.1289-1295
• /
• 2012

An adaptive digital predistortion (PD) technique is proposed for linearization of power amplifiers (PAs) in multiple-input multiple-output (MIMO) transmitters. We consider a PD structure equipped with only one combined feedback path while conventional systems have multiple feedback paths. Hence, the proposed structure is much simpler than that of multiple feedback paths. Based on the structure, a new PD algorithm is derived. The simulation results show that linearization performance of the proposed method is almost the same as the conventional multiple feedback technique while the former is much simpler to implement than the latter.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.10 s.113
• /
• pp.959-966
• /
• 2006

This paper proposes a new concept about dual band predistortion linear power amplifier(PD LPA) using diplexer for digital cellular ($f_o$=880 MHz) and IMT-2000($f_o$=2,140 MHz) base stations. The diplexer is composed of low pass filter having defected ground structure(BGS) microstrip line and high pass filter having high-Q lumped capacitors and distributed elements. The proposed predistorter adopts a reflection type intermodulation signal generator with 3 dB hybrid coupler for good reflection characteristic. for a forward link one carrier CDMA IS-95A 1FA and WCDMA 1FA signal, the proposed dual band PD LPA shows the adjacent channel leakage ratio(ACLR) improvement about 10 dB and 9.36 dB for digital cellular and IMT-2000 band, respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.9 s.339
• /
• pp.1-10
• /
• 2005

In this paper, we proposed predistortion algerian that can compensate temperature distortion by digital. Predistortion algorithm produces compensation value of distortion by temperature as well as system nonlinear distortion by input level, and warps beforehand signal of baseband. To prove excellency of such algorithm we applied predistortion algorithm to Saleh's high power amplifier model, and did computer simulation. As a result, P1dB increased about 0.5 dBm phase shift reduced about $0.8^{o}$ than existent the A&P PD, and predistiortion algorithm to apply temperature compensation techniques improved P1dB about 2dBm and stabilized phase shift by about $0.1^{o}$ low. When approved UMTS's sample signal to this amplifier, IMD3 of amplifier decreased 10dBm than is no temperature compensation techniques, and reduced 19dBm than signal that is no distortion.