• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.5C
• /
• pp.522-529
• /
• 2002

MMIC circuits in whole receiver system was fabricated based on GaAs pHEMT technology. And a V-band downconverter module was fabricated by integrating these circuits. The downconverter module consists of a LO drive power amplifier which generates 24dBm output power, a low noise amplifier(LNA) which shows 20 dB small signal gain, an active parallel feedback oscillator which generates 1.6 dBm output power, and a cascode mixer which shows over 6dB conversion gain. The good conversion gain performance of our mixer made no need to attach any IF amplifier which grows conversion gain. Measured results of the complete downconverter show a conversion gain of over 20 dB between 57.5 GHz and 61.7GHz without IF amplifier.

• Proceedings of the IEEK Conference
• /
• 2002.06a
• /
• pp.435-438
• /
• 2002

A design of Ku-band(11.7~12.20Hz) monolithic microwave integrated circuit(MMIC) low noise block(LNB) downconverter using self oscillating mixer (SOM) for direct broadcast satellite(DBS) application is presented The proposed LNB downconverter is composed of low noise amplifier(LNA), image reject filter(IRF), SOM , low pass filter(LPF). The conversion gain is 30dB , VSn is less than 1.7: 1 and overall noise figure is less than 1.2dB.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.1
• /
• pp.99-104
• /
• 2013

In this paper, we developed a fully integrated downconverter MMIC (monolithic microwave integrated circuit) including Lange coupler and output active balun for millimeter wave applications. Concretely, ${\lambda}$/4 transmission line was added to Lange coupler for size reduction of RF/LO input, and mixed RF/LO signals were applied to gate of the FET of mixer. Active balun was used at output port for a coupling of out-of-phase IF output signals. According to measured results, the proposed downconverter MMIC showed good RF performances. For example, the downconverter MMIC showed an LO leakage power of -25 dBc at IF output port, and a RF-LO isolation of 18 dB. Therefore, off-chip components such as LO rejection filters were not required for a normal operation of the proposed downconverter MMIC. The proposed downconverter MMIC showed a conversion gain of 10.3 dB at RF frequency of 63 GHz. The size of the downconverter MMIC including all active and passive components was $2.2{\times}1.4mm^2$.

• Journal of Advanced Marine Engineering and Technology
• /
• v.31 no.6
• /
• pp.777-783
• /
• 2007

In this work, a highly integrated downconverter MMIC employing HBT(heterojunction bipolar transistor) was developed for application to one chip tranceiver solution of Ku-band commercial wireless communication system. The downconverter MMIC (monolithic microwave integrated circuit) includes mixer filter. amplifier and input/output matching circuit. Especially, spiral inductor structures employing SiN film were used for a suppression of LO and its second harmonic leakage signals. Concretely, they were properly designed so that the self-resonance frequency was accurately tuned to LO and its second harmonic frequency, and they were integrated on the downconverter MMIC.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.12 no.3
• /
• pp.427-432
• /
• 2017

This study describes the design and implementation of SHF band Downconverter Digital Satellite Communication. The SHF band Downconverter unit consists of PLDRO and Frequency converter. In Frequency converter, microstrip BPF and LPF designed through the pre EM simulation are implemented to minimize the unwanted spurious in Frequency converter. Through the pre-simulation analysis of space environment, the possibility of and minimized about the malfunction of equipment and we designed a reliable SHF band Downconverter through simulation for a TID according to the vibration generated during the launch and space radiation environment, and compared pre-simulation of main performance results to test results about main performances of SHF band Downconverter after production.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.1
• /
• pp.68-74
• /
• 2003

This paper describes the design and the test results of the receiver-downconverter module for a Ka-band Satellite Payload. The developed module is not only a downconverter that convert the signal of 30.6 GHz∼31.0 GHz to the signal of 20.8 GHz∼21.2 GHz but also is a receiver that has the function of low noise amplification in the front stage. It has been fabricated and tested by the qualified satellite component manufacturing process and it shows the best performance of the receiver-downconverter modules operating at Ka-band frequency up to date. The module has the performance of 1.9 dB-NF, 55 dB-Gain, and 58 dBc-C/I3 fur the two tone signals of -59 dBm input power respectively at ambient temperature. It is a small and light module with the size of 93 mm${\times}$84 mm${\times}$26 mm and the weight of 240 g.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2002.11a
• /
• pp.86-90
• /
• 2002

본 논문에서는 Ka-band 위성중계기에 사용되어지는 수신하향변환기(Receiver-Downconverter) 모듈의 설계 및 제작 그리고 시험 결과에 대하여 기술하였다. 개발된 수신하향변환기는 30.6~31㎓ 대역의 신호를 입력으로 받아들여 20.8~21.2㎓ 대역의 신호를 출력하는 일종의 Downconverter 이지만, 모듈의 입력단에 저잡음 증폭부가 포함된 수신기의 역할도 하고 있다. 개발된 모듈은 제작과정 및 시험과정에 있어 위성중계기 부품 제작 규정을 준수하였으며, 그 개발된 성능은 현재까지 알려진 국내외 유사 부품중의 최고의 성능을 보여주고 있다. 측정된 모듈의 성능은 상온에서 1.9㏈의 잡음지수, 55㏈ 이득, 58dBc의 C/l3 값을 보여주고 있다. 제작된 모듈의 크기는 93mm$\times$84mm$\times$26mm이며 무게는 240g으로서 국내외 유사 제품에 비해 소형이다.

• Journal of electromagnetic engineering and science
• /
• v.6 no.1
• /
• pp.18-23
• /
• 2006

In this paper, we demonstrate a fully integrated X-band image rejection down converter, which was developed using InGaP/GaAs HBT MMIC technology, consists of two single-balanced mixers, a differential buffer amplifier, a differential YCO, an LO quadratue generator, a three-stage polyphase filter, and a differential intermediate frequency(IF) amplifier. The X-band image rejection downconverter yields an image rejection ratio of over 25 dB, a conversion gain of over 2.5 dB, and an output-referred 1-dB compression power$(P_{1dB,OUT})$ of - 10 dBm. This downconverter achieves broadband image rejection characteristics over a frequency range of 1.1 GHz with a current consumption of 60 mA from a 3-V supply.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.10A
• /
• pp.958-964
• /
• 2005

In this thesis, the matching network at the local oscillator port of the sub-harmonic mixer is optimized for reducing the conversion loss. A downconverter for point to point system applications is designed and fabricated using the such sub-harmonic mixer. The sub-harmonic mixer achieved the conversion loss of 11.8 dB at the 12 dBm input power of the local oscillator and the isolation of less than -40 dB. The downconverter achieved the IF output power flatness of 2 dB and the total noise figure of 5.9 dB.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.6
• /
• pp.1143-1150
• /
• 2001

In this paper, we designed a downconverter for K-band satellite multipoint distribution service(SMDS). The designed downconverter consists of a low noise amplifiers, bandpass filter, stable local oscillator, drain mixer and If Amplifiers. Low noise amplifiers show 28㏈ gain and 1.5㏈ noise figure in the frequency range of 19.2㎓~20.2㎓, and a band pass filter has a -l㏈ insertion loss, and 18.25㎓ Stable local oscillator which is dielectric resonant oscillation, We obtained that the output power of the 18.25㎓ oscillation frequency is 0.5㏈m and the phase noise is the -84.67㏈c at 10KHz offset frequency. With the input RF signal the 19.2㎓~20.2㎓, conversion gain of the drain mixer shows 5㏈ at the Intermediate frequency range of 950MHz~1950MHz. We have proved that the designed downconverter satisfied the specification of a K-band satellite multipoint distribution service and it can be applied to the satellite internet receiver.