• Journal of Radiation Protection and Research
• /
• v.30 no.4
• /
• pp.231-236
• /
• 2005

Dosimeters are manufactured from same process in the manufacturer but the deviation of TL raw counts exists among the dosimeters. TL raw counts are also gradually degrade due to multiple readings and physical abuse. ECF (Element Correction Factor) correct the degradation and deviation of TL raw counts to the average TL raw counts of reference dosimeters. Procedures for producing ECF of thermoluminescent dosimeters were described In detail. ECFs of 319 reference, control and field dosimeters were measured three times and average of three ECF values was calculated. Also, % CV(Coefficient of Variation) of three ECF values was calculated to verify ECF. ECF & % CV distributions for the field and control dosimeters are presented. TL raw counts of field dosimeters, being used about 6 times for the past 3 years, were almost unchanged, but those of control dosimeters being used more frequently, were degraded about 4.7 %.

• Journal of the Korean Society for Precision Engineering
• /
• v.24 no.12
• /
• pp.95-103
• /
• 2007

This paper presents a liquid cooling concept for heat rejection of high power electronic devices existing in notebook computers etc. The design, fabrication, and performance of the planar ECF pump and farced-liquid cooling system are summarized. The electro-conjugate fluid (ECF) is a kind of dielectric and functional fluids, which generates jet flows (ECF-jets) by applying static electric field through a pair of rod-like electrodes. The ECF-jet directly acts on the working fluid, so the proposed planar ECF pump needs no moving part, produces no vibration and noise. The planar ECF pump, consists of a pump housing and electrode substrate, achieves maximum flow rate and output pressure of $5.5\;cm^3/s$ and 7.2 kPa, respectively, at an applied voltage of 2.0 kV. The farced-liquid cooling system, constructed with the planar ECF pump, liquid-cooled heat sink and thermal test chip, removes input power up to 80 W keeping the chip surface temperature below $70\;^{\circ}C$. The experimental results demonstrate that the feasibility of forced-liquid cooling system using ECF is confirmed as an advanced cooling solution on the next-generation high power electronic devices.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2007.06a
• /
• pp.107-108
• /
• 2007

• Korean Journal of Soil Science and Fertilizer
• /
• v.45 no.6
• /
• pp.1022-1026
• /
• 2012

To evaluate the application level of expeller cake fertilizer (ECF), we have investigated soil chemical properties, leaf mineral contents and yield of red mustard in plastic film greenhouse. Four levels of fertilizer were applied as 50% (ECF 50), 75% (ECF 75), 100% (ECF 100) and 150% (ECF 150) by base $1,848kg\;kg^{-1}$ of ECF. In 2010, red mustard was planted on April 28 in silt loam soil and harvested on July 7. Commerical yields were measured 12 times from May 14 to July 7. Electrical conductivity ($3.40{\sim}3.54dS\;m^{-1}$), available $P_2O_5$ ($580{\sim}618mg\;kg^{-1}$) and exchangeable cations ($K^+$, $Ca^{2+}$ and $Mg^{2+}$) were tended to increase by the application of ECF. However, the range of those was not so big increasing amount. The content of T-N, K, Ca and P of red mustard leaves was $63.2{\sim}66.4g\;kg^{-1}$, $55.1{\sim}56.4g\;kg^{-1}$, $8.6{\sim}9.5g\;kg^{-1}$ and $5.7{\sim}6.3g\;kg^{-1}$, respectively. The nitrogen utilization rate of red mustard was 38~52%, and it was decreased with increased application of ECF. The yield of red mustard was 13,670 to $14,460kg\;ha^{-1}$ on the basis of application amount of ECF and the yield did not increased in spite of increased ECF. The optimum dose of application of ECF for cultivation of red mustard was from $924kg\;ha^{-1}$ (ECF 50) to $1,386kg\;ha^{-1}$ (ECF 75). Environment-friendly and economical amount of applied fertilizer is more important than yield for cultivation of red mustard.

• Korean Journal of Environmental Agriculture
• /
• v.33 no.3
• /
• pp.149-154
• /
• 2014

BACKGROUND: To evaluate the application level of expeller cake fertilizer(ECF), we have investigated soil chemical properties, leaf mineral contents and yield of tah tasai Chinese cabbage in a plastic film greenhouse. METHODS AND RESULTS: Five levels of fertilizer were applied as 0%(ECF 0), 50%(ECF 50), 75%(ECF 75), 100% (ECF 100) and 150%(ECF 150) by base 1,848 kg/ha of ECF. In 2012, tah tasai Chinese cabbage was planted on April 28 in a silt loam soil and harvested on July 12. Commercial yields were measured 10 times from May 10 to July 12. Electrical conductivity (2.24~3.09 dS/m), available $P_2O_5$(484~581 mg/kg) and exchangeable cations($K^+$, $Ca^{2+}$ and $Mg^{2+}$) were tended to increase by the application of ECF. However, the range of those was not significant. The contents of T-N, K, Ca and P of tah tasai Chinese cabbage leaves were 62.2~66.5 g/kg, 44.3~48.7 g/kg, 5.1~5.9 g/kg and 5.6~6.2 g/kg, respectively. The nitrogen utilization rate of tah tasai Chinese cabbage was 39.4~51.6%, and it was decreased with increased application amount of ECF. The yield of tah tasai Chinese cabbage was 9,806 to 12,730 kg/ha on the basis of application amount of ECF and it was not increased in spite of increased ECF. CONCLUSION: The optimum dose of application of ECF for cultivation of tah tasai Chinese cabbage was ranged from 924 kg/ha(as ECF 50) to 1,386 kg/ha(as ECF 75). Environment-friendly and economical amount of applied fertilizer is more important than yield for cultivation of tah tasai Chinese cabbage.

• Journal of Animal Environmental Science
• /
• v.14 no.3
• /
• pp.193-200
• /
• 2008

The results of the research on the amount of water evaporation from composting facilities operated in swine farms are below. The number of swine per a farm was 1433 head/farm for a Simple Composting Facility (SCF) and 3500 head/farm for a Escalator composting facility(ECF) system. The capacities of the SCF and the ECF were $0.33m^3/head$ and $0.25m^3/head$, respectively. The ECF had 24.2% less capacity than the SCF. The average water contents in the swine manure for the CP and the ECF of the surveyed farms were 86.8% and 85.7%, respectively, which revealed the ECF had 1.3% less average water content than the SCF. Daily water inputs into the SCF and the ECF were $4.1kg/m^3/day$ and $6.5kg/m^3/day$, respectively. The ECF had approximately 36.9% higher water input than the SCF. Fermentation temperatures during the composting period for the SCF and the ECF were up to $45^{\circ}C$ and $70^{\circ}C$, respectively. The decreases in water contents per each square meter for the SCF and the ECF were 3.7 kg and 5.2 kg, respectively. The ECF lost approximately 28.8% more water content than the ECF, which would be caused by the difference of fermentation temperature between two systems. Fertilizer components after composting were examined. Nitrogen contents of the SCF and the ECF were similar (0.84% and 0.86%, respectively) and ${P_2}{O_5}$ contents were 0.78% and 0.74%, respectively, showing the SCF had slightly higher content than the ECF. However, OM and OM/N did not show the difference between two systems. Hence, efforts to increase composting efficiency with considerations of the water content of swine manure, fermentation temperature, and water evaporation potential should be done when the SCF and the ECF were used in swine farms.

• Asian Pacific Journal of Cancer Prevention
• /
• v.15 no.16
• /
• pp.6727-6732
• /
• 2014

Objectives: Advanced gastric cancer (AGC) patients have a poor prognosis. The best benefit of chemotherapy is usually achieved by first line setting. Very few studies have compared combination regimens. This study was designed to compare two combination regimens. Methods: Patients with advanced gastric cancer receiving first line chemotherapy were retrospectively collected, and divided into two groups, receiving DCF (docetaxel, cisplatin and fluorouracil) or ECF (epirubicin, cisplatin and fluorouracil) regimens. Data were collected for the retrospective analysis in a single center. Results: Eighty-six patients were eligible for analysis. Median overall survival (OS) was 10.0 months in the ECF group and 11.0 months in the DCF group (p=0.31). Median progression free survival (PFS) for ECF and DCF was equal at 6.0 months. Second line chemotherapy were administered in more than one third of patients. Both regimens had similar toxicity. Conclusions: This is the first study investigating the outcomes of gastric cancer chemotherapy in this region. ECF and DCF regimens have similar efficacy and a similar tolerability profile for first line treatment of advanced gastric cancer. The decision of the first line chemotherapy in advanced gastric cancer could be improved with patient selection according to clinical parameters and molecular markers.

• The Korean Journal of Physiology and Pharmacology
• /
• v.4 no.5
• /
• pp.393-401
• /
• 2000

To define the postnatal changes in ANP secretion in response to mechanical stretch and atrial compliance, experiments have been done in perfused nonbeating rabbit atria with different ages: 1-day, 1-, 2-, 3-, 4-, and 8-wk-old. In 1-day-old-rabbits, an increase in intraatrial pressure resulted in an increase in atrial volume, which was higher than that in 1-wk-old rabbits. Increases in atrial volume stimulated the secretion of ANP with concomitant translocation of extracellular fluid (ECF) into the atrial lumen. However, mechanically stimulated ECF translocation was lower in 1-day-old rabbits than that in 1-wk-old rabbits. Therefore, positive relationship between mechanically stimulated ECF translocation and ANP secretion was shifted upward in 1-day-old rabbits, as compared to 1-wk-old rabbits. Changes in atrial volume and ECF translocation were gradually increased with aging and reached the peak value at 4 wk. The stretch-induced ANP secretion in terms of ECF translocation (the interstitial ANP concentration) was also increased with aging and reached the peak value at 4 wk. The interstitial ANP concentration was dependent on the atrial content of ANP. These data suggest that the higher level of atrial ANP secretion is related to the postnatal changes in atrial volume and unidentified factor.

• Proceedings of the International Microelectronics And Packaging Society Conference
• /
• 2005.09a
• /
• pp.201-212
• /
• 2005

[ $Epoxy/BaTiO_3$ ] composite embedded capacitor films (ECFs) were newly designed fur high dielectric constant and low tolerance (less than ${\pm}15\%$) embedded capacitor fabrication for organic substrates. In terms of material formulation, ECFs are composed of specially formulated epoxy resin and latent curing agent, and in terms of coating process, a comma roll coating method is used for uniform film thickness in large area. Dielectric constant of $BaTiO_3\;&\;SrTiO_3$ composite ECF is measured with MIM capacitor at 100 kHz using LCR meter. Dielectric constant of $BaTiO_3$ ECF is bigger than that of $SrTiO_3$ ECF, and it is due to difference of permittivity of $BaTiO_3\;and\;SrTiO_3$ particles. Dielectric constant of $BaTiO_3\;&\;SrTiO_3$ ECF in high frequency range $(0.5\~10GHz)$ is measured using cavity resonance method. In order to estimate dielectric constant, the reflection coefficient is measured with a network analyzer. Dielectric constant is calculated by observing the frequencies of the resonant cavity modes. About both powders, calculated dielectric constants in this frequency range are about 3/4 of the dielectric constants at 1 MHz. This difference is due to the decrease of the dielectric constant of epoxy matrix. For $BaTiO_3$ ECF, there is the dielectric relaxation at $5\~9GHz$. It is due to changing of polarization mode of $BaTiO_3$ powder. In the case of $SrTiO_3$ ECF, there is no relaxation up to 10GHz. Alternative material for embedded capacitor fabrication is $epoxy/BaTiO_3$ composite embedded capacitor paste (ECP). It uses similar materials formulation like ECF and a screen printing method for film coating. The screen printing method has the advantage of forming capacitor partially in desired part. But the screen printing makes surface irregularity during mask peel-off, Surface flatness is significantly improved by adding some additives and by applying pressure during curing. As a result, dielectric layer with improved thickness uniformity is successfully demonstrated. Using $epoxy/BaTiO_3$ composite ECP, dielectric constant of 63 and specific capacitance of 5.1nF/cm2 were achieved.

• Environmental Engineering Research
• /
• v.20 no.4
• /
• pp.392-396
• /
• 2015

This work aims to investigate the oily wastewater treatment by the electrocoagulation-flotation (ECF) and propose a mathematical model for the efficiency prediction. Cutting oil was used to prepare the synthetic oily wastewater with submicron droplet sizes. The chemical coagulation by aluminium sulfate was firstly tested following by the electrocoagulation-flotation with aluminium electrodes. Both processes gave the effective treatment performance with the efficiencies higher than 90%. However, the ECF consumed less aluminium dosage as well as produced less sludge, which were its advantage on the chemical coagulation. The performance of the ECF was found to be affected by the current density, oil concentration, and reaction time according to the analysis by the design of experiment (DOE). Finally, the prediction model was proposed by two approaches, including linear and logarithm function. The latter model gave more accuracy prediction results in terms of treatment efficiency and duration in the lag and stable stages.