• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.374-377
• /
• 2009

The characteristics of the deposited thin films of the zinc oxide (ZnO) at different oxygen pressures will be elucidated in this work. The resistivity of ZnO thin films were dominated by the carrier concentration under high oxygen pressure conditions while controlled by the carrier mobility at low oxygen ambiences. In addition, we will show the characteristics of the transparent ZnO based thin film transistor (TFT) fabricated at a full room temperature process with gate dielectric of gadolinium oxide ($Gd_2O_3$) thin films.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.56 no.1
• /
• pp.142-146
• /
• 2007

Nowadays, itis inevitable trend to use high Xe gas contents for increase luminous efficiency and luminance in plasma display panel. However, the increase of Xe gas contents causes the driving voltage, although the brightness is increase. In this paper, we study the characteristics of electro optical according to Xe gas contents and gas pressure. Electro-optical characteristics were investigated by the discharge voltage, luminance and luminous efficacy measurements, respectively. With some increasing Xe gas contents and pressure, the electro-optical properties increased. However, the characteristics of electro-optical begin to be saturated, when too high increased Xe gas contents and pressure.

• Proceedings of the KSRS Conference
• /
• 2005.10a
• /
• pp.633-636
• /
• 2005

An electro-optical camera system consists of many subsystems such as the optics, the detector, and the electronics and so on. They may create variations in the processed image that were not present original scene. The performance analysis of the electro-optical camera system is a mathematical construct that provides an optimum design through appropriate trade off analysis. The SNR(Signal to Noise Ratio) is one of the most important performance for the electro-optical camera system. The SNR analysis shown in this paper is performed based on the practical high resolution satellite camera design. For the purpose of the practical camera design, the analysis assumes that the defined radiance, which is calculated for the Korean peninsula, reached directly to the telescope entrance. In addition, the actual operation concept such as integration time and the normal operation altitude is assumed. This paper compares the SNR analysis results according to the various camera characteristics such as the optics, the detector, and the camera electronics. In detail, the optical characteristics can be split into the focal length, F#, transmittance, and so on. And the system responsivity, the quantum efficiency, the TDI stages, the quantization noise and the analogue noise can be used for the detector and the camera electronics characteristics. Finally this paper suggests the optimum design to apply the practical electro-optical system.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.6
• /
• pp.576-581
• /
• 2005

We fabricated red organic light emitting diodes(OLEDs) utilizing tis(8-hydroxyquinoline) aluminum $(Alq_3)$ doped with $5\%$ of (4-(dicyanomethylene)-2-i-propyl-6-(1,1,7,7-tetramethyljulolidyl-9-enyl)-4H-pyran) (DCJTI) and investigated the driving and modulation characteristics for applying to the electro-optical conversion device. To improve the driving characteristics of red OLEDs, 3 V of offset voltage, which is equal to the turn on voltage, Is applied to the device. Offset voltage enhanced the optical EL output and reduced the rise time of EL waveforms of red OLEDs, and hence the cutoff frequency is increased with increasing applied voltage. The optical pulse of 100 MHz has been obtained from red OLEDs. Therefore, we confirmed that the red OLEDs can be applied to the fields of optical communication as an electro-optical conversion device.

• Proceedings of the Optical Society of Korea Conference
• /
• 1996.09a
• /
• pp.32-32
• /
• 1996

• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.1148-1151
• /
• 2009

A self-designed, written in labview, Organic Light-Emitting Diode junction temperature measuring program was used to calculate the internal junction temperature for devices during operation, and an infrared thermometer was used to measure the backside temperature of the device substrate, to discuss the effects of the junction and substrate temperature difference to the characteristics of the device.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2003.07a
• /
• pp.531-534
• /
• 2003

The electro-optical characteristics of the In-Plane switching Twisted nematic (IT) mode were studied. The advantage of this mode is not only the wide viewing angle characteristics without adopting any compensation films, but also the wide cell gap error margin. The electro-optical characteristics of IT mode were evaluated by the experiments and computer simulation. In this paper, we studied the viewing angle characteristics, color-shift and response time.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.400-403
• /
• 2008

We have investigated the electro-optical characteristics of AC-PDP with different MgO protective layers, which have been deposited by electron beam evaporation from various sintered pellets with different temperatures. We have measured the secondary electron emission coefficient ($\gamma$) by using the Gamma Focused Ion Beam ($\gamma$-FIB) system, the static margin, and the address delay time. Also, we have investigated photoluminescence (PL) characteristics for understanding the energy levels of MgO pellets and protective layers.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2001.04a
• /
• pp.1097-1100
• /
• 2001

In this paper, the electro-chemical-machining characteristics of Ni-Ti Shape Memory Alloy(SMA) was investigated. From the experimental results, the optimal electro chemical machining conditions for satisfying the machining quality(fine surface & high recovery stress) might be confirmed. And it was concluded that optical electro chemical condition for Ni-Ti SMA could be obtained at approximately 100% current efficiency and high frequency pulse current.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.369-372
• /
• 2001

We studied the electro-optical (EO) performance in the vertical-alignment (VA) - l/4$\pi$ cell photoaligned with polarized UV exposure on a homeotropic photopolymer surfaces. Excellent voltage-transmittance curve in the VA - l/4$\pi$ cell photoaligned with polarized UV exposure for 3 min on the photopolymer containing cholesterol group of 8% can be achieved. The V-T characteristics in the VA-l/4$\pi$ cell photoaligned on the photopolymer surface can be improved by increasing cholesteryl group. For response time measurement, the transmittance characteristics of the VA-l/4$\pi$ cell photoaligned on the photopolymer surface was better than that of the VA-l/4$\pi$ cell rubbingaligned on a polyimide(Pl) surface.