• ETRI Journal
• /
• v.38 no.3
• /
• pp.455-462
• /
• 2016

Frequency hopping (FH) is a common characteristic of a wide variety of communication systems. On the other hand, software-defined radio (SDR) is an increasingly utilized technology for implementing modern communication systems. The main challenge when trying to realize an SDR FH system is the frequency tuning time, that is, the higher the hopping rate, the lower the required frequency tuning time. In this paper, significant universal hardware driver tuning options (within GNU Radio software) are investigated to discover the tuning option that gives the minimum frequency tuning time. This paper proposes an improved SDR frequency tuning algorithm for the generation of a target signal (with a given target frequency). The proposed algorithm aims to improve the frequency tuning time without any frequency deviation, thus allowing the realization of modern communication systems with higher FH rates. Moreover, it presents the design and implementation of an original GNU Radio Companion block that utilizes the proposed algorithm. The target SDR platform is that of the Universal Software Radio Peripheral USRP-N210 paired with the RFX2400 daughter board. Our results show that the proposed algorithm achieves higher hopping rates of up to 5,000 hops/second.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.27 no.8
• /
• pp.1259-1265
• /
• 2003

We present a new post-fabrication frequency tuning method for laterally driven electrostatic microresonators using a DC-biased electrostatic comb array of linearly varied finger-length. The electrostatic tuning force and the equivalent stiffness, adjusted by the DC-biased tuning-comb array, have been formulated as functions of geometry and DC tuning voltage. A set of frequency-turnable microresonators has been designed and fabricated by 4-mask surface-micromachining process. The resonant frequency of the microfabricated microresonator has been measured for a varying tuning voltage at the reduced pressure of 1 torr. The maximum 3.3% reduction of the resonant frequency is achieved at the tuning voltage increase of 20V.

• 한국정보통신설비학회:학술대회논문집
• /
• 2009.08a
• /
• pp.293-297
• /
• 2009

In this thesis, design of a VCO(Voltage controlled Oscillator) with a novel tuning mechanism is presented for the Radar system. This circuit, the 9.5 GHz oscillator is designed and implemented by restructuring microstrip resonator to raise Q value and to require a wide frequency tuning range. This product is fabricated on 2.6 Teflon substrate and device is NE722S01. In this paper, The new microstrip resonator VCO is proposed to achieve the characteristic of a wide frequency tuning range. This microstrip resonator VCO shows the phase noise characteristic of -108.3 dBc/Hz at 1 MHz offset from the fundamental frequency, the output power of 5.7 dBm and the second harmonic suppression of -38 dBc for the VCO are obtained. The manufacture VCO shows a frequency tuning range of 193.8 MHz. The proposed micro trip resonator VCO can be used for X-band Radar System with required tuning range.

• Transactions of the Society of Information Storage Systems
• /
• v.10 no.1
• /
• pp.23-26
• /
• 2014

In this paper, we present a novel approach for tuning the resonant frequency of torsionally driven vertical comb actuators. The tuning unit composed of thermal actuator, scissor mechanism and V-shape shaft enables continuous and reversible resonant frequency tuning. The proposed method is based on the stiffness alteration of the V-shape shaft. It is experimentally verified that the resonant frequency of the torsional microscanner is shifted up to 1.59 kHz from 1.51 kHz showing the maximum tuning ratio of 5.29%.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.8
• /
• pp.64-72
• /
• 2010

This paper presents a wide range VCO with fine coarse tuning step using a sigma-delta modulation technique for UWB frequency synthesizer. The proposed coarse tuning scheme provides the low effective frequency resolution without any degradation of phase noise performance. With three steps coarse tuning, the VCO has wide tuning range and fine tuning step simultaneously. The frequency synthesizer with VCO was implemented with 0.13 ${\mu}m$ CMOS technology. The tuning range of the VCO is 5.8 GHz~6.8 GHz with the effective frequency resolution of 3.9 kHz. It achieves the measured phase noise of -108 dBc/Hz at 1 MHz offset and a tuning range 16.8 % with 5.9 mW power. The figure-of-merit with the tuning range is -181.5 dBc/Hz.

• Proceedings of the Korean Society of Machine Tool Engineers Conference
• /
• 2005.05a
• /
• pp.87-90
• /
• 2005

An experimental investigation of the basic characteristics of a micro-cantilever sensor was performed by inspecting the amplitude and frequency characteristics using a commercial tuning fork. Application of acetone and ethanol with a volume of $1 {\mu}l$ on the tine of a vibrating tuning fork cause immediate response in its amplitude and frequency. It has shown that the tuning fork has ability to recognize a chemical agent with high sensitivity.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.12
• /
• pp.991-997
• /
• 2013

A new frequency tuning scheme and a transconductor with a wide tuning range and low harmonic distortion is presented. This frequency tuning technique is based on the relationship between the time-constant and the elapsed times in charging a capacitor up to a certain level. Its structure is as simple as that of a conventional tuning scheme using a VCF(Voltage-Controlled Filter) and it does not need a pure sine wave but uses a CLK(Clock) pulse as a reference signal, which is easily obtained from on-chip system clocks or external X-tal oscillators. When a certain reference CLK is given, without complex capacitor arrays the pole frequency of the filter can be controlled continuously in the frequency domain. Simulation results are presented to confirm the operation of the proposed approach.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.6B
• /
• pp.114-114
• /
• 2000

In this paper, a current comparative frequency automatic tuning circuit for the CMOS bandpass filter are designed with the new architecture. And also, when the designed circuit is compared the typical tuning circuit, it has very simple architecture that is composed of the current comparator and charge pump and operated in 2V power supply. The proposed tuning circuit automatically compensate the difference between the operating current of the integrator and the reference current which is specified. Using CMOS 0.25um parameter, a CMOS bandpass active filter with center frequency(f0= 100MHz) is designed, and according to the transister size the variation of the center frequency is simulated. As the HSPIC simulation results, the tuning operating of the proposed current comparative frequency automatic tuning circuit is verified.

• Transactions of the Korean Society of Machine Tool Engineers
• /
• v.16 no.1
• /
• pp.86-91
• /
• 2007

A sensor using quartz toning fork is presented for measuring liquid density. It consists of a PZT plate as an actuator for piezoelectric excitation and a quartz tuning fork as a sensor for resonant frequency detection. The resonant frequency is determined from the sensing voltage measured in tuning fork when the excitation frequencies of PZT actuator are swept around the resonant frequencies of tuning fork. The resonant frequency determined the liquid density. The density values of three kinds of organic solvents are measured and compared with the standard values. The experimental results are in agreement with the standard values and the maximum standard deviation is less than 9%.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.6B
• /
• pp.1114-1119
• /
• 2000

In this paper, a current comparative frequency automatic tuning circuit for the CMOS bandpass filter are designed with the new architecture. And also, when the designed circuit is compared the typical tuning circuit, it has very simple architecture that is composed of the current comparator and charge pump and operated in 2V power supply. The proposed tuning circuit automatically compensate the difference between the operating current of the integrator and the reference current which is specified. Using CMOS 0.25um parameter, a CMOS bandpass active filter with center frequency(fo=100MHz) is designed, and according to the transister size the variation of the center frequency is simulated. As the HSPICE simulation results, the tuning operating of the proposed current comparative frequency automatic tuning circuit is verified.