• 대한의용생체공학회:의공학회지
• /
• 제35권5호
• /
• pp.125-131
• /
• 2014

The purpose of this study is to verify the utility of reflected photoplethysmography sensor using two green light emitting diodes that influenced by ambient light. Recently it has been studied that green light emitting diode is suitable for light source of reflected photoplethysmography sensor at low temperature and high temperature. Another study showed that, green light is better for monitoring heart rate during motion than led light. However, it has a bad characteristic about ambient light noise. To verify the utility of reflected photoplethysmography sensor using green light emitting diode, this study measures the photoplethysmography signal that is distorted by ambient light and will propose a solution. This study has two parts of research method. One is measurement system that composed sensor and board. The sensor is made up PE-foam and Non-woven fabric for flexible sensor. The photoplethysmography signal is measured by measurement board that composed high-pass filter, low-pass filter and amplifier. Ambient light source is light bulb and white light emitting diode that has three steps brightness. Photoplethysmography signal is measured with lead II electrocardiography signal at the same time and it is measured at the finger and radial artery for 1 minute, 1000 Hz sampling rate. The lead II electrocardiography signal is a standard signal for heart rate and photoplethysmography signal that measured at the finger is a standard signal for waveform. The test is repeated 3 times using three sensor. The data is processed by MATLAB to verify the utility by comparing the correlation coefficient score and heart rate. The photoplethysmography sensor using two green light emitting diodes is shown better utility than using one green light emitting diode and red light emitting diode at the ambient light. The waveform and heart rate that measured by two green light emitting diodes are more identical than others. The amount of electricity used is less than red light emitting diode and error peak detectability factor is the lowest.

• 한국세라믹학회지
• /
• 제42권3호
• /
• pp.145-149
• /
• 2005

[ $Eu^{2+}$ ]-activated barium magnesium silicate phosphor, $(Ba,Ca)_{3}MgSi_{2}O_{8}:Eu_{x}$, has been known to emit blue-green light. In this study we report the manufacturing processes for producing either pure green or pure blue light-emitting phosphor from the same composition of $Ba_{2-x}Ca_{2}CaMgSi_{2}O_{8}:Eu_{x}$ (0 < x < 1) by controlling heat treatment conditions. Green light emitting phosphor of $Ba_{1.9}CaMgSi_{2}O_{8}:Eu_{0.1}$ can be produced under the sample preparation condition of highly reducing atmosphere of $23\%\;H_2/77\%\;N_2$, while blue or blue-green light emitting phosphor under reducing atmosphere of $5\~20\%\;H_2\;/\;95\~80\%$ N_2. The green light-emitting phosphors are prepared in two steps: firing at $800\~1000^{\circ}C$ for $2\~5$ h in air then at $1100\~1350^{\circ}C$ for 2-5 h under reducing atmo­sphere $23\%$ $H_2/77\%\;N_2$. The excitation spectrum of the green light-emitting phosphor shows a broadband of $300\~410$ nm. The emission spectrum has a maximum intensity at the wavelength of about 501 nm. The CIE value of green light emission is (0.162, 0.528). The pure blue light-emitting phosphors can be produced using the $Ba{2_x}CaMgSi_{2}O_{8}:Eu_{x}$ by introducing additional firing step at $1150\~1300^{\circ}C$ in air before the final reducing treatment. The XRD analysis shows that the green light-emitting phosphor mainly consisted of $Ba_{1.31}Ca_{0.69}SiO_{4}$ (JCPDS $\#$ 36-1449) and other minor phases i.e., $MgSiO_3$ (JCPDS $\#$ 22-0714) and $Ca_{2}BaMgSi_{2}O_{8}$ (JCPDS $\#$ 31-0128). The blue light-emitting phosphor mainly consisted of $Ca_{2}BaMgSi_{2}O_{8}$ phase.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2002년도 International Meeting on Information Display
• /
• pp.762-765
• /
• 2002

The bilayer organic light-emitting diode using Al (DBM) $_3$ (DBM=Dibenzoylmethane) as an emitting material and poly (N-vinylcarbazole) (PVK) as hole-transport material, emitted bright blue-green light instead of blue light. The blue-green emission is attributed to exciplex formation at the solid interface between Al (DBM) $_3$ and the hole-transport material. The exciplex formation was evidenced by the measurement of the photoluminescence spectra and lifetimes of Al (DBM) $_3$, PVK and an equimolar amount of mixture of Al (DBM) $_3$ and PVK.

• 공업화학
• /
• 제25권3호
• /
• pp.233-236
• /
• 2014

유기발광 다이오드(Organic light emitting diodes)는 차세대 평판디스플레이로 학문적으로나 산업적으로 많은 관심을 받고 있다. 그러나 고성능 유기발광 다이오드의 생산을 위해서는 극복해야 할 많은 과제들이 여전히 남아있다. 그중 청색발광물질은 자체의 넓은 밴드갭으로 인해 녹색과 적색 발광재료에 비해 낮은 효율을 보이고 있다. 그러므로 많은 사람들이 높은 효율을 가진 청색 발광물질을 개발하기 위해 많은 노력을 기울이고 있다. 따라서 본 논문에서는 유기발광 다이오드의 기본개념과 청색 발광물질의 개발에 대해 간략하게 소개하였다.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2014년도 제46회 동계 정기학술대회 초록집
• /
• pp.246.2-246.2
• /
• 2014

Green-light emitting OLED with single layer of Alq3 and orange-light emitting OLED with double layer of rubrene/Alq3 as EML were fabricated and characterized comparatively. The two OLED devices were based on an anode of ITO, HTL of TPD, and cathode of Al, respectively. The green light emitting OLED was then prepared with Alq3 as both ETL and EML, while the orange-light emitting OLED was prepared with rubrene deposited on Alq3. All the component layers of the OLED devices were deposited by a thermal evaporation technique in vacuum. Photoluminescence characteristics of the EML layers were investigated. Electrolumiscence characteristics of the OLED devices were comparatively investigated.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2007년도 7th International Meeting on Information Display 제7권1호
• /
• pp.648-650
• /
• 2007

We demonstrate highly efficient White Polymer Electrophosphorescent Light-emitting Diode using newly developed green and red light emitting heteroleptic iridium complex, Ir-(pq)2tpy, and blue light emitting fluorescent dopant, BczVBi. The best luminous efficiency reached 28cd/A with maximum luminance of 87000cd/m2. The scheme for determining optimum device architecture and dopant concentrations were constructed.

• Journal of Applied Biological Chemistry
• /
• 제57권3호
• /
• pp.255-257
• /
• 2014

배추좀나방에 대한 light emitting diode (LED) 트랩의 시설재배지내 이용가능성을 평가하기 위해 LED 트랩의 유인활성을 광원이 장착되지 않은 no light 트랩과 상업적 대조구인 black-light 트랩과 비교하였다. 그 결과 green LED 트랩에서 가장 높은 유인활성을 나타내었으며, 상업적 대조구로 사용된 black-light의 경우 광원이 설치되지 않은 no light와 비교하여 유인활성을 나타내었으나 green LED 보다 낮은 활성을 나타내었다. 이러한 결과를 바탕으로 green LED 트랩이 시설재배지내에서 친환경적 해충방제법으로의 가능성을 보여주었다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제29권7호
• /
• pp.795-800
• /
• 2005

The optical properties of $ZnS_{y}Se_{1-x-y}:Te_x\;(x\;<\;0.08,\;y\∼0.11$) alloys grown by molecular beam epitaxy (MBE) have been investigated by photoluminescence (PL) and PL-excitation (PLE) spectroscopy. Good optical properties and high crystal quality were established with lattice match condition to GaAs substrate. At room temperature, emission in the visible spectrum region from blue to green was obtained by varying the Te content of the ZnSSe:Te alloy. The efficient blue and green emission were assigned to $Te_{1}$Tel and $Te_{n}$ (n$\geq$2) cluster bound excitons, respectively. Bright blue (462 nm) and green (535 nm) light emitting diodes (LEDs) have been developed using ZnSSe:Te system as an active layer.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2002년도 춘계학술대회논문집
• /
• pp.167-171
• /
• 2002

We have investigated the optical properties of Te-doped ZnSSe:Te epitaxial layers grown on (100) GaAs substrates by molecular beam epitaxy. The Te-doped ternary specimen shows strong blue or green emission (at 300k) which is assigned to Te$_{1}$ or Te$_{n}$( n$\geq$2) cluster bound exciton. Bright green and blue light-emitting diodes (LEDs) have been developed using ZnSSe:Te system as an active layer. The green LEDs exhibit a fairly long device lifetime (>2000 h) when operated at 3 A/cm$^{2}$ under CW condition at room temperature. It is confirmed that the Te-doping induced "crystal-hardening effect" plays a significant role in both efficient and strong suppression of the optical device degradation.gradation.

• Journal of Information Display
• /
• 제9권2호
• /
• pp.14-17
• /
• 2008

A charge trapping host structure was developed to improve the light-emitting efficiency of green phosphorescent organic light-emitting diodes. N, N'-dicarbazolyl-3,5-benzene(mCP) and a spirobifluorene based triplet host(PHl) were co-deposited as hosts in the emitting layer and the device performance was examined according to the composition mCP and PH1. The results showed that the quantum efficiency could be improved by 30 % using a mixed host of mCP and PH1.