• KIEE International Transactions on Power Engineering
• /
• v.5A no.2
• /
• pp.152-158
• /
• 2005

This paper describes a reactive optimal power flow incorporating margin enhancement constraints. Margin sensitivity at a steady-state voltage instability point is calculated using invariant space parametric sensitivity, and it can provide valuable information for selection of effective control parameters. However, the weakest buses in neighboring regions have high margin sensitivities within a certain range. Hence, the control determination using only the sensitivity information might cause violation of operational limits of the base operating point, at which the control is applied to enhance voltage stability margin in the direction of parameter increase. This paper applies an interior point method (IPM) to solve the optimal power flow formulation with the margin enhancement constraints, and shunt capacitances are mainly considered as control variables. In addition, nonlinearity of margin enhancement with respect to control of shunt capacitance is considered for speed-up control determination in the numerical example using the IEEE 118-bus test system.

• ETRI Journal
• /
• v.41 no.3
• /
• pp.383-395
• /
• 2019

Clock Controlled Dual keeper Domino logic structures (CCDD_1 and CCDD_2) for achieving a high-speed performance with low power consumption and a good noise margin are proposed in this paper. The keeper control circuit comprises an additional PMOS keeper transistor controlled by the clock and foot node voltage. This control mechanism offers abrupt conditional control of the keeper circuit and reduces the contention current, leading to high-speed performance. The keeper transistor arrangement also reduces the loop gain associated with the feedback circuitry. Hence, the circuits offer less delay variability. The design and simulation of various wide fan-in designs using 180 nm CMOS technology validates the proposed CCDD_1 and CCDD_2 designs, offering an increased speed performance of 7.2% and 8.5%, respectively, over a conventional domino logic structure. The noise gain margin analysis proves good robustness of the CCDD structures when compared with a conventional domino logic circuit configuration. A Monte Carlo simulation for 2,000 runs under statistical process variations demonstrates that the proposed CCDD circuits offer a significantly reduced delay variability factor.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.1584-1587
• /
• 2008

We proposed a technique controlling continuously pretilt angle in full range with high process margin. The proposed method is characterized by tuning thickness of heterogeneous polyimide (PI) layer that homeotropic PI is mixed with planar PIs.

• Proceedings of the KIEE Conference
• /
• 2007.04a
• /
• pp.113-118
• /
• 2007

In this paper, a new method is proposed for robust proportional- integral - derivative (PID) control that is to ensure specified phase margin and iso - damping property using reduction model. This method is based on the second order plus dead time(SOPDT) reduction model of the high order model. Reduction model used to ensure iso-damping property in the feature frequency. Simulation results gives proof of effectiveness of proposed method.

• Proceedings of the KIEE Conference
• /
• 1988.07a
• /
• pp.315-318
• /
• 1988

THE STUDY ABOUT CHARACTERISTICS OF PHOTO RESIST ITSELF (MINIMUM RESOLUTION, DEPTH OF FOCUS MARGIN AND CRITICAL DIMENSION CONTROL LATITUDE) WAS DONE AND REPORTED. THREE TYPES OF PHOTO RESISTS WERE TESTED. THE FIRST IS THE LOW MOLECULAR WEIGHT PHOTO-RESIST SHOWING THE NARROW DISTRIBUTION OF MOLECULAR WEIGHT (LOW MOLECULAR WEIGHT CONTROL TYPE), THE SECOND IS A PHOTO-RESIST CONTAINING THE INNER CONTRAST ENCHANCEMENT MATERIAL (INNER CEM TYPE) AND THE THIRD IS A NORMAL PHOTO-RESIST (HIGH MOLECULAR WEIGHT TYPE). THE INNER CEM TYPE AND THE LOW MOLECULAR WEIGHT CONTROL TYPE PHOTO-RESIST ARE MORE IMPROVED PHOTO-RESISTS. IT PROVED THAT THE MINIMUM RESOLUTION WAS IMPROVED BY 0.2 - 0.3 um, THE DEPTH OF FOCUS MARGIN WAS IMPROVED BY 0.8 - 1.2 um AND THE C.D. CONTROL LATITUIDE WAS IMPROVED.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.21 no.10
• /
• pp.940-950
• /
• 2011

This paper reports a filtered velocity feedback(FVF) controller, which is an alternative to direct velocity feedback(DVFB) controller. The instability problems at high frequencies due to non-collocated sensor/actuator configuration with the DVFB can be alleviated by the proposed FVF controller. The FVF controller is designed to filter out the unstable high frequency response. The dynamics of a clamped plate under forces and moments and the FVF controllers are formulated. The stability of the control system and performance are investigated with the open loop transfer function(OLTF). It is found that the FVF controller has a higher gain margin than the corresponding DVFB controller owing to the rapid roll-off behavior at high frequencies. Although the gain margin cannot be fully utilized because of the enhancement at the high frequencies, the vibration at the modes lower than the tuning frequency is well controlled. This performance of the FVF controller is shown to be improved from that of the DVFB controller. It is, however, noted that the stability around the tuning frequency is very sensitive so that the enhancement in vibration level should be followed. The reduction performance at low frequencies using the FVF controller should be compromised with the enhancement in the vibration at high frequencies while designing the controller.

• Korean Journal of Applied Biomechanics
• /
• v.26 no.4
• /
• pp.427-432
• /
• 2016

Objective: The goal of this study was to systematically investigate the postural stability of dancers by providing unexpected perturbations. Method: Six female dancers and college students participated in this study. Unpredictable wait-pull balance perturbations in the anterior direction were provided to the participants during standing. Three different perturbation intensities (low, moderate, and high intensity) were used by increasing perturbation forces. Spatial and temporal stability of postural control were measured by using margin of stability (MoS) and time to contact (TtC), respectively. Results: Both MoS and TtC at moderate intensity were significantly greater in the dancer group than in the control group, but no significant differences were found at low and high intensities between the groups. Conclusion: The present study showed spatial and temporal stability of dynamic postural control in dancers. We found that the dancers were more spatially and temporally stable than the ordinary participants in response to unexpected external perturbation when the perturbation intensity was moderate at two extreme intensity levels (low and high).

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.10a
• /
• pp.386-389
• /
• 2013

In this paper, for signal integrity analysing high-speed signal between a processor and a DDR2 memory, transient analysis is done and eye diagrams are generated using IBIS models of IC chips and S-parameters of transmission line. From the eye diagrams of such high-speed signals as DQ, DQS/DQSb, Clock, Address and Control, signal quality is assured through measuring timing and voltage margins during setup and hold times and verifying that the over-/under-shoot and the cross points of differential signals satisfy their specifications.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.48 no.2
• /
• pp.153-160
• /
• 1999

Dual-stage servo system for super-high density HDD has the chances of being composed of the coarse actuator(VCM) for track-seeking control and the fine actuator(microactuator) for-following control in near future. This paper presents the concept design of dual-stage servo system and the track-following control using an electrostatic microactuator for super-high density HDD. The electrostatic microactuator is designed and fabricated by MEMS(micro-electro-mechanical system) process. Both the nonlinear plant(voltage/displacement-to-electrostatic force) and the linear plant(electrostatic force-to-displacement) of the microactuator are established. Inverse function of the nonlinear plant is employed for a feedforward nonlinear compensator design. And feedforward control effect of this compensator is shown by time-domain experiments. A track-following feedback controller is designed using the feedback nonlinear compensator which is derived from the feedforward nonlinear compensator. The track-following control experiment is done to show the control efficiency of the proposed control system. And, excellent track-following control performance(2.21kHz servo-bandwidth, 7.51dB gain margin, $50.98^{\circ}$phase margin) is achieved by the proposed control system.

• Nuclear Engineering and Technology
• /
• v.30 no.4
• /
• pp.342-352
• /
• 1998

A nuclear design feasibility of soluble boron free(SBF core for the medium-sized(600MWe) PWR was investigated. The result conformed that soluble boron free operation could be performed by using current PWR proven technologies. Westinghouse advanced reactor, AP-600 was chosen as a design prototype. Design modification was applied for the assembly design with burnable poison and control rod absorber material. In order to control excess reactivity, large amount of gadolinia integral burnable poison rods were used and B4C was used as a control rod absorber material. For control of bottom shift axial power shape due to high temperature feedback in SBF core, axial zoning of burnable poison was applied to the fuel assemblies design. The combination of enrichment and rod number zoning for burnable poison could make an excess reactivity swing flat within around 1% and these also led effective control on axial power offset and peak pin power, The safety assessment of the designed core was peformed by the calculation of MTC, FTC and shutdown margin. MTC in designed SBF core was greater around 6 times than one of Ulchin unit 3&4. Utilization of enriched BIO(up to 50w1o) in B4C shutdown control rods provided enough shutdown margin as well as subcriticality at cold refueling condition.