• 한국태양에너지학회:학술대회논문집
• /
• 2011.11a
• /
• pp.278-281
• /
• 2011

This system can predict the maximum output about all illumination levels so that the PV system designer can design the system having the best efficiency. For the output prediction exact about the solar cell, that is the device the basis most in the PV system, the basis has to be in order to try this way. The solution based on Lambert W-function are presented to express the transcendental current-voltage characteristic containing parasitic power consuming parameters like series and shunt resistances. A simple and efficient method for the extraction of a single current-voltage (I-V) curve under the constant illumination level is proposed. With the help of the Lambert W function, the explicit analytic expression for I is obtained. And the explicit analytic expression for V is obtained. This analytic expression is directly used to fit the experimental data and extract the device parameters. The I-V curve of the solar cell was expressed through the modeling using Lambert W-function and the numerical formula where there is the difficulty could be logarithmically expressed This method expresses with the I-V curve through the modeling using Lambert W-function which adds other loss ingredients to the equation2 as to the research afterward. And the solar cell goes as small and this I-V curve can predict the power penalty in the system unit.

• Proceedings of the IEEK Conference
• /
• 2001.06a
• /
• pp.333-336
• /
• 2001

This paper reports that the Lambert W function applies to a non-iterative design of minimum mean square-error scalar quantizers for a Laplacian source. The contribution of the paper is in the reduction of the time needed for the design and the increased accuracy in resulting quantization points and thresholds, because the algorithm is non-iterative and the Lambert W function can be evaluated as accurately as desired.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.62 no.8
• /
• pp.1144-1150
• /
• 2013

The stabilizing controller design problem of time-delay singularly perturbed systems is considered. The proposed approach is based on the $H_{\infty}$ norm and the composite control method. A sufficient condition for the stability of the time-delay slow subsystem is presented. Using this condition, we can construct the composite control law for the time-delay singularly perturbed system and analysis the system by the matrix Lambert W function. Illustrated examples are presented to demonstrate the validity and applicability of the proposed method.

• Journal of Power System Engineering
• /
• v.18 no.1
• /
• pp.120-127
• /
• 2014

In this study, Design methods of stabilizing controller for time-delay pure singularly perturbed systems are proposed. Based on the Chang transformation and Lambert W function, we decompose the time-delayed pure singularly perturbed systems into completely decoupled subsystems and derive sufficient stability conditions for $2{\times}2$ time-delayed pure singularly perturbed systems. An illustrated example is presented to demonstrate the validity and applicability of the proposed methods.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.6A
• /
• pp.524-532
• /
• 2002

This paper reports that the Lambert W function applies to a non-iterative design of minimum mean square-error scalar quantizers for a Laplacian source. Specifically, it considers a non-iterative design algorithm for optimum quantizers for a Laplacian source; it finds that the solution of the recursive nonlinear equation in the non-iterative design is elegantly expressed in term of the principal branch of the Lambert W function in a closed form; and it proves that the non-iterative algorithm applies only to exponential or Laplacian sources. The contribution of the paper is in the reduction of the time needed for the design and the increased accuracy in resulting quantization points and thresholds, because the algorithm is non-iterative and the Lambert W function can be evaluated as accurately as desired. Also, numerical results show how optimal quantization distortion converges monotonically to the Panter-Dite constant and help derive an approximation formula for the key parameters of optimum quantizers.

• Journal of the Semiconductor & Display Technology
• /
• v.21 no.1
• /
• pp.114-118
• /
• 2022

The photovoltaic system is affected by various conditions such as temperature and irradiance. Because non-uniform irradiation and partial shading conditions affect the entire string of cells connected in series, a bypass diode is used to bypass the current flow normally. In order to find the maximum power point in partial shade conditions, it is necessary to estimate various methods of maximum power point tracking. In this paper, the hybrid method of MPPT using Lambert W function and perturbation & observation algorithm is proposed under partial shading conditions. The simulation results are obtained using MATLAB/Simulink and shows the improvement of the accuracy of MPPT.

• The Journal of the Acoustical Society of Korea
• /
• v.34 no.3
• /
• pp.184-191
• /
• 2015

In this paper, a normal mode reverberation model for a range-independent environment of shallow water is proposed to calculate the reverberation level in the low-frequency range. Normal mode is used to calculate the acoustic energy propagating from the source to the scattering area and from the scattering area to the receiver. Each mode is decomposed into up and down going waves to consider scattering strength at the scattering area. The scattering functional form combines Lambert's law with a Gaussian-like term near the specular direction based on Kirchhoff approximation considering bottom condition. For verification of the suggested model, the result is relatively compared to several solutions of the problem XI and XV in the Reverberation Modeling Workshop I sponsored by the US Office of Naval Research.

• 제어로봇시스템학회:학술대회논문집
• /
• 1999.10a
• /
• pp.238-243
• /
• 1999

Minimum-fuel and -time orbit transfer are two major goals of the satellite trajectory optimization. In this paper, we consider satellites in two coplanar elliptic orbits when the apsidal lines coincide, and analytically find the conditions for the two-impulse minimum-time transfer orbit using Lambert's theorem. The transfer time is a decreasing function of a variable related to the transfer orbit's semimajor axis in the minimum-time case. In the minimum-time case, there is no unique minimum-time solution, but there is a limiting solution. However, there exists a unique solution in the case of minimum-fuel transfer, fur which we find analytically the necessary and sufficient conditions. As a special case, we consider when the transfer angle is one hundred and eighty degrees. In this case, we show that we obtain the classical fuel-optimal Hohmann transfer orbit. We also derive the Hohmann transfer rime and delta-velocity equations from more general equations, which are obtained using Lambert's theorem. We note the tradeoff between minimum-time and - fuel transfer. An optimal coplanar orbit maneuver algorithm to trade off the minimum-time goal against the minimum-fuel goal is proposed. Finally, the numerical simulation results are given to demonstrate the derived theory and the algorithm.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.3
• /
• pp.19-24
• /
• 2015

We introduce an optimization of the number of base station antennas in massive multiple-input multiple-output (MIMO) wireless powered communication network (WPCN). We use channel hardening property of massive MIMO system to approximate channel gain in terms of the number of base station antennas. Then, we find an optimal solution by partial differential and obtain a closed form solution by using Lambert-W function. The simulation results show that the approximation and the method of solving the optimization problem are reasonable, and the optimal solution of proposed scheme is almost identical to the optimal number of base station antennas by the exhaustive search method.

• YAKHAK HOEJI
• /
• v.38 no.4
• /
• pp.366-371
• /
• 1994

To improve the identification power of TLC/HPTLC the in situ reflectance spectra obtained directly from plates with commercial scanner are used. The spectrum normalization should be carried out prior to comparing and searching the spectra from library for the identification of compounds. Because the reflectance does not obey the Lambert-Beer's law, there arise some problems in normalization. These problems could be solved to some extent by normalizing the spectra with regression methods. The spectra are manipulated with the regression function of a curve obtained from the correlation plot. When the parabola was used as the manipulating function, the spectra were identified with the accuracy of 97% and this result was better than that of conventionally used the point and area normalization method.