• Current Optics and Photonics
• /
• v.7 no.6
• /
• pp.665-672
• /
• 2023

This study focuses on investigating the impact of the spectral linewidth of a seed laser in a master-oscillator power amplifier (MOPA) configuration on stimulated Brillouin scattering and the beam quality of the output diffracted by a grating. To conduct the study, a distributed feedback (DFB) laser is modulated in a pseudorandom binary sequence (PRBS) and amplified by a two-stage Yb-doped fiber amplifier to achieve an output power of over 1 kW. The spectral linewidth of the seed laser is systematically varied from 1 to 12 GHz in the frequency domain by varying the PRBS modulation parameters. The experimental results reveal a tradeoff between suppressing stimulated Brillouin scattering and enhancing beam quality with increased spectral linewidth. Therefore, the study provides valuable insights into optimizing spectral beam combining to achieve high beam quality and scalable power upgrade in fiber lasers.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.496-496
• /
• 2007

Low level laser has various therapy effects. This paper performed the basic study for fabricating the low level laser therapy apparatus, and one of the goals of this paper was to make this apparatus used handily. The apparatus has been fabricated using the laser diode and microprocessor unit. The apparatus used a 660nm Laser diode for blood stream improvement and was designed for a pulse width modulation type to increase stimulation effects. In result, we could get the light power of 660nm wavelength and the 1~10Hz irradiation frequency could be controlled stably.

• Proceedings of the Optical Society of Korea Conference
• /
• 1989.02a
• /
• pp.73-75
• /
• 1989

Chaotic states of a low-frequency modulating C.W .Co2 laser beam is observed. The output behaviors appear quasi-periodicity and chaotic states when the laser beam is modulated from 100Hz to 1000Hz by using an intracavity chopper. And the output characteristics of the laser beam show a route to chaos as increasing input power when the modulation speed is 500Hz.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.12 no.3
• /
• pp.13-19
• /
• 1975

A detailed analysis has been carried out of a zigzag traveling wave electro-optic laser modulator usin3 CuCl, KDP Crystal. The inclusion of such practical factors as M/W and optical loss results in an optimum design in which modulator dimensions and bandwidth limitation are uniquely determined by optical and M/W dielectic properties of modulating crystal. The main conclusion of the analysis are: (1) CuCl, KDP may be used to produce 50% modulation over bandwidth of 10(GHz) with less than (watt) of modulating power. (2) The upper modulation frequency limit is set by a cutoff frequency which arises from finite width of optical beam.

• Journal of the Optical Society of Korea
• /
• v.19 no.2
• /
• pp.130-135
• /
• 2015

Based on the extended nonlinear Schr$\ddot{o}$dinger equation, the influences of the filter effect on pulse splitting in a passively mode-locked erbium-doped fiber laser with positive dispersion cavity are investigated theoretically. Numerical results show that, as the bandwidth of the spectral filter decreases, the nonlinear chirp appended to the pulse increases under the combined action of the filter effect of the super-Gaussian spectral filter and the self-phase modulation effect. On further decreasing the bandwidth, the wave breaking of the pulse takes place. In addition, by varying the pump power of the laser or the profile of the spectral filter, the influences of the filter effect on pulse splitting also change accordingly.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.10
• /
• pp.139-143
• /
• 1996

We report on the static and dynamic characteristics of optically modulated resonant tunneling diode oscillator (RTDO) formed in double-barrier quantum-well structure. Under the illumination of Ti:Sapphire laser, the dc current-voltage (I-V) curves of RTDO shifted towared lower voltages. This characteristic was found to odify the series resistance, negtive differential resistance, capacitance, and the inductance of the RTDO. As a result, the resonant frequency of TRDO centered at 5.302 GHz was found to decrease about 20 MHz under the laser illumination. At a constnat bias voltage, the oscillation frequency decreased linearly as the laser power was increased.

• Korean Journal of Optics and Photonics
• /
• v.15 no.4
• /
• pp.337-342
• /
• 2004

Laser optical power stabilization of a radio frequency excited $CO_2$ slab laser using the opto-Hertzian effect generated from the laser itself is achieved on the peak of the Doppler broadened gain curve. The opto-Hertzian signal was generated by a modulation of the optical flux circulating inside the laser cavity from a variation in the cavity length caused by the vibrations of the PZT. The opto-Hertzian signal is directly coupled from a RE discharge chamber via a loop antenna into a detector and applied to a lock-in stabilizer as an reference signal. The power stability of an RF excited slab laser is estimated to be better then 0.2%.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.6
• /
• pp.15-20
• /
• 1998

The linewidth enhancement factor $\alpha$ and fiber dispersion of 1.55 ${\mu}{\textrm}{m}$ strained multi-quantum well laser diodes are measured using small signal power modulation transfer function in a dispersive fiber. The measured fiber dispersion values are between 16.766 and 16.786ps/nm/km and these are the expected values from standard single mode fiber. To measure the $\alpha$ parameter in the actual operational range of the laser diodes, the dependence of $\alpha$ on laser output power is measured. The $\alpha$ parameter increases linearly as the power of the laser diode increases. This result can explain the non-linear gain effect on the $\alpha$ parameter more accurately than any other measurements.

• Journal of Power Electronics
• /
• v.2 no.3
• /
• pp.206-211
• /
• 2002

Silent gas discharge method has been widely applied fur ozone production, ultraviolet light and UV laser generation. Since ozone and ultraviolet applications have tendency to spread widely in industry, the development of efficient and low - cost power supply for such systems is an important task at present. This paper introduces high-frequency inverter type mode power supply designed fur ozone generation tube and ultraviolet generation excimer lamp and considerations on the design of the inverter and pulse density modulation control strategy applied in it.

• ETRI Journal
• /
• v.35 no.3
• /
• pp.459-468
• /
• 2013

A novel integrated laser, that is, a distributed reflector laser diode integrated with an electroabsorption modulator, is proposed to improve the output efficiency, single-mode stability, and chirp. The proposed laser can be realized using the selective metalorganic vapor phase epitaxy technique (that is, control of the width of the insulating mask), and its fabrication process is almost the same as the conventional electroabsorption modulated laser (EML) process except for the asymmetric coupling coefficient structure along the cavity. For our analysis, an accurate time-domain transfer-matrix-based laser model is developed. Based on this model, we perform steady-state and large-signal analyses. The performances of the proposed laser, such as the output power, extinction ratio, and chirp, are compared with those of the EML. Under 10-Gbps NRZ modulation, we can obtain a 30% higher output power and about 50% lower chirp than the conventional EML. In particular, the simulation results show that the chirp provided by the proposed laser can appear to have a longer wavelength side at the leading edge of the pulse and a shorter wavelength side at the falling edge.