• Journal of the Korean housing association
• /
• v.7 no.1
• /
• pp.105-116
• /
• 1996

The purpose of this study is to improve the quality of the light environment of classroom. To attain this purpose, this study estimated the physical factor and evaluation of the subjective response of classroon located in south and north in the summer and the winter. The results are as followed. 1. The evaluation of the illumination, uniformity factor, daylight factor as physical factor of light environment is good as classroom, but the classroom in south is better that that in north, the light environment in summer is better than winter. 2. The subjective response to light environment of classroom is positive on both seasons at all calssroom. Comparing summer with winter, I found that the difference of subjective response between both classrooms on summer is attentive. 3. The realtion between subjective response and physical factor of light environment in classroom is attentive on the light sense, content sense, uniformity.

• Journal of Sensor Science and Technology
• /
• v.30 no.2
• /
• pp.99-104
• /
• 2021

In this study, we utilized the duty factor of the transition frequency modulation (TFM) for the illumination control of the light emitting diode (LED) light in visible light communication (VLC). The average optical power is linearly proportional to the duty factor in TFM waveforms. We used the transition frequencies of Na=5 and Nb=1 for the high and the low bits, respectively, of the non-return-to-zero (NRZ) data in the VLC transmitter. A resistor and capacitor high-pass filter (HPF) was used in the VLC receiver to eliminate the 120 Hz optical noise from adjacent lighting lamps and the spikes at the HPF output were used to recover NRZ data from the TFM waveform. In experiments, the illumination of the LED light was controlled in the range of 25-90% of the constant-wave optical power by changing the duty factor of the TFM waveforms.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.8 no.4
• /
• pp.81-85
• /
• 2008

In this study, Standards of Lighting Appliance and Standard of Model Approval and Inspection Technology for EXIT LIGHT are compared so as to analyze stability of a exit light which is fire product. Test items, which are not included in Standard of Model approval and Inspection Technology for EXIT LIGHT, are deduced from aforementioned comparison and analysis. Also the derived test items are experimented with a exit light. For a power factor correction, a power factor correction circuit is designed and power factor, crest factor, asymmetry ratio, luminance variation are analyzed. In order to show the validity of designed circuit, current waveform and voltage waveform are measured.

• IMMUNE NETWORK
• /
• v.4 no.2
• /
• pp.116-122
• /
• 2004

Background: LIGHT (TNFSF14) is a member of tumor necrosis factor superfamily and is the ligand for TR2 (TNFRSF14/HVEM). LIGHT is known to have proinflammatory roles in atherosclerosis. Methods: To find out the expression pattern of LIGHT in atherosclerotic plaques, immunohistochemical analysis was performed on human carotid atherosclerotic plaque specimens. LIGHT induced atherogenic events using human monocytic cell line THP-1 were also investigated. Results: Immunohistochemical analysis revealed expression of LIGHT and TR2 in foam cell rich regions in the atherosclerotic plaques. Double immunohistochemical analysis further confirmed the expression of LIGHT in foam cells. Stimulation of THP-1 cells, which express TR2, with either recombinant LIGHT or immobilized anti-TR2 monoclonal antibody induced interleukin-8 and matrix metalloproteinase(MMP)-9. Electrophoretic mobility shift assay demonstrated that LIGHT induces nuclear localization of transcription factor, nuclear factor $(NF)-{\kappa}B$. LIGHT induced activation of MMP-9 is mediated by $NF-{\kappa}B$, since treatment of THP-1 cells with the $NF-{\kappa}B$ inhibitor PDTC (pyrrolidine dithiocarbamate) completely blocked the activation of MMP-9. Conclusion: These data indicate that LIGHT is expressed in foam cells in atherosclerotic plaques and is involved in atherogenesis through activation of pro-atherogenic cytokine IL-8 and destabilization of plaque by inducing matrix degrading enzyme.

• The Journal of Korean Academy of Prosthodontics
• /
• v.16 no.1
• /
• pp.38-44
• /
• 1978

Color is an important factor in dental esthetics. Application of natural tooth color will not fail to produce pleasing results. But a standardized method of shade matching has not been adopted. If we are to overcome the color matching problem in dentistry, an understanding of the nature of color and light is essential. The purpose of this study was to compare the effects of different light sources and different background colors on the ability of observers to correctly match shades of artifical teeth. And observation was made to determine if the time spent in making a shade match was a factor in the correctness of the response. A test method was devised and 50 individuals made observations which were recorded and analyzed. $X^2$-test gave results indicating that the time factor had no effect on the response made. An analysis of variance showed the following effects significant at the five percent level; (1) light source (2) background color (3) subject. The following conclusions can be drawn from this study; (1) The time spent in making shade selection is not a factor in the correctness of the selections. (2) The light source used is an important factor in matching tooth shade; and there is no significant difference between the light sources in shade matching. (3) Under the conditions of this study, the greatest accuracy in shade matching was obtained on the brown background.

• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.9 no.4
• /
• pp.49-54
• /
• 1995

This paper is an experimental study on the influence of the demonstration effect by color and light source in show window. This experiment used semantic differentical method in model show window of actual size. The important outcomes of this study are summarized below. 1. In the result by factor analysis, three factors are classified. They are diversity, emotion, lightness. 2. In the study on the influence by light source, incandescence lamp is the most effective light source in every items. 3. In the result of the study on the influence by color source, according to each factor bring out following result ; Green is the most effective in diversity factor and ligthness factor. Yellow is the most effective in emotion factor.

• Journal of Sensor Science and Technology
• /
• v.29 no.3
• /
• pp.149-155
• /
• 2020

In this study, we employed Manchester code for illumination control and flicker prevention of the light-emitting diode (LED) used in a visible light communication (VLC) system. In the VLC transmitter, the duty factor of the Manchester code was utilized for illumination control; in the VLC receiver, the spike signal from an RC-high pass filter was utilized to recover the transmitted signal whilst suppressing the 120-Hz noise arising from adjacent lighting lamps. Instead of the clock being transmitted in a separate channel, a syncmark signal was transmitted in front of each data byte and used as the reference time for transforming the Manchester code to non-return-to-zero (NRZ) data in the receiver. In experiments, the LED illumination was controlled in the range of approximately 12-84% of the constant wave (CW) light via changing of the duty factor from 10% to 90%. This scheme is useful for constructing indoor wireless sensor networks using LED light that is flicker-free and presents capability for illumination control.

• Journal of Applied Biological Chemistry
• /
• v.62 no.2
• /
• pp.181-186
• /
• 2019

The optimum design of LED device for irradiation of 460 nm blue light on extruded rice cake using simulation and the effect of the blue light on the inactivation of Bacillus cereus (B. cereus) group on the rice cake were investigated. The irradiated light intensity patterns on the surface area of the sample were simulated with three different LED arrays (centered, cross, and evenly spaced) and at various distances (22, 32, 42 mm) between the LED modules and the sample. In addition, the uniformity was calculated as Petri factor. The evenly spaced array resulted the most uniform light intensity pattern in the simulation, and the Petri factor of 32 and 42 mm of the distances showed higher than 0.9, which represents the ideal uniformity of LED device. The bacterial population of the rice cake decreased to less than the initial bacterial population during exposure to LED blue light, whereas the bacterial population of the control sample increased. The bacterial count of the rice cake after blue light irradiation for 24 h was 1.21 log CFU/g lower than the control sample. Petri factor increased with increase of the distance between the light source and sample, however, the reduction rate of B. cereus group decreased. Therefore, the design of LED device, that represented the Petri factor higher than 0.9 and inactivated the population of B. cereus group, with evenly spaced and 32 mm of distance between the light source and sample was suitable for extending shelf-life of rice cake.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.23 no.2
• /
• pp.236-242
• /
• 1986

The dependence of the current-voltage characteristics of hydrogenated amorphous silicon pin solar cells on the illumimination light intensity has been investigated. The open circuit voltage increases linearly with increasing the logarithm of light intensity up to AM 1, and nearly saturates above AM 1, indicating the open circuit voltage approaching the built-in potential of the pin solar cell above AM 1. The short circuit current density increase with light intensity in proportion to I**0.85 before and I**0.97 after light exposure. Since the series resistance devreses and shunt resistance increases with light intensily, the fill factor increases with light illumination. To increase the fill factor at high illumination in large area solar cells, t6he grid pattern on the ITO substrates should be made. Long light exposure on the solar cells gives rise to the increase of bulk resistance and defect states, resulting in the decrease of the fil factor and short circuit current density. The potential drop in the bulk of the a-Si:H pin solar cells at short circuit condition increases with decreasing temperature, and increases after long light exposure.

• Journal of Ecology and Environment
• /
• v.35 no.3
• /
• pp.227-234
• /
• 2012

Quercus aliena and Q. serrata are both occur as natural vegetation alongside natural freshwater bodies of the southern Korea Peninsula. Q. serrata dominates over Q. aliena as secondary forest vegetation in the present day. In order to explain these natural distributional traits of the oak species, we conducted some experiments with oak seedlings which treated with major important environmental resources, including light, moisture and nutrients, under controlled conditions. We then measured the ecological niche breadths and overlap from 15 eco-morphological characteristics. The ecological niche breadth of Q. aliena and Q. serrata were higher in terms of the nutrient factor applied, but was lower terms of light. The niche breadth of Q. serrata was wider than that of Q. aliena in light and moisture exposure. On the other hand, the niche breadth of Q. aliena was similar with that of Q. serrata in terms of the nutrient factor applied. These results imply that Q. serrata has a broader ecological distribution in over a wider variety of light and moisture environments than that of Q. alien. Ecological niche overlap between two oak species was the widest in terms of the light treatment factor applied, and narrowest in terms of moisture. This response pattern was also verified by cluster and principle component analysis. These results suggest competitive interactions between Q. serrata and Q. aliena seedlings may be higher for light resources than moisture or nutrient resources, and that Q. serrata is more shade tolerant than Q. aliena.