• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.25 no.11
• /
• pp.1720-1729
• /
• 2001

Wear characteristics of Nylon and acetal pinions against steel gears for different pitch line velocities was studied with a power circulating gear test rig under unlubricated condition. Specific wear rate was measured as a function of tooth number, module, tooth width and total revolution. The worn tooth surfaces were examined with a profile projector. The Nylon pinion showed lower specific wear rate than the acetal pinion. However, the Nylon pinion was fractured at high tooth loads, whereas the acetal pinion exhibited a steady wear behavior. The wear characteristics of Nylon pinion varied significantly with the Pitch line velocity. Wear occurred most severely at the tooth tip and the region immediately below the pitch line of pinion. The dominant wear mechanisms were adhesion and abrasion.

• Phonetics and Speech Sciences
• /
• v.1 no.2
• /
• pp.75-84
• /
• 2009

The aim of this paper is to find an adequate method to study declination in Korean. In previous studies of declination in Korean, maximum and minimum pitch values in an accentual phrase were measured. But this method is inadequate when an accentual phrase is located at the intonational phrase. So in order to exclude the final tone of an intonational phrase, we propose to measure pitch values of the first and second tone in an accentual phrase when the tonal pattern of the accentual phrase is 'LHLH'. In this case, the line that connects every first tone of an accentual phrase is the baseline, and the line that connects every second tone of an accentual phrase is the topline. By a comparison of declination between focused and neutral utterances, we will show that the topline of declination is more direct to the speaker's plan than the baseline.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.26 no.6
• /
• pp.1159-1168
• /
• 2002

Power-transmission Nylon pinions against steel gears fur different pitch line velocities was studied with a power circulating gear test rig under unlubricated condition by SEM(Scanning Electron Microscope). The wear characteristics of Nylon pinions varied significantly with the pitch line velocity and applied load. Wear occurred most severely at the regions including pitch circle and root circle of Nylon pinions. It is confirmed that Nylon pinions are able to be used fer power-transmission under limited conditions.

• Journal of the Institute of Convergence Signal Processing
• /
• v.5 no.1
• /
• pp.1-5
• /
• 2004

A new method for the estimation of pitch-frequency contour of voiced speech is presented. The method is based on the double application of Kaiser's energy operator［1］, which has the capabilities of extracting amplitude and frequency of a sinusoidal waveform. According to the modulation model, a vowel can be represented by a combination of damped sinusoids representing formants, modulated by pitch pulses. Therefore, the amplitude envelope of each of the components will give a pitch-like waveform and the pitch can be obtained by averaging the frequencies of this waveform. The first part is the same as Gopalan's approach［9］, but by substituting the LPC based spectral analysis with the second application of energy operator, the algorithm becomes very simple and can be processed on-line. Although the estimation is rather coarse, the suggested algorithm can be useful for getting a general sketch of pitch contour on-line.

• Speech Sciences
• /
• v.11 no.1
• /
• pp.31-42
• /
• 2004

This paper presents methods using Gaussian normalization for converting pitch contours based on prosodic phrases along with experimental tests on the Korean database of 16 declarative sentences and the first sentences of the story of 'The Three Little Pigs'. We propose a new conversion method using Gaussian normalization to the pitch deviation of pitch contour subtracted by partial declination lines: by using partial declination lines for each accentual phrase of pitch contour, we avoid the problem that a Gaussian normalization using average values and standard deviations of intonational phrase tends to lose individual local variability and thus cannot modify individual characteristics of pitch contour from a source speaker to a target speaker. From the results of the experiments, we show that this slanted Gaussian normalization using these declination lines subtracted from pitch contour of accentual phrases can modify pitch contour more accurately than other methods using Gaussian normalization.

• Speech Sciences
• /
• v.14 no.2
• /
• pp.139-155
• /
• 2007

Old Korean regulated poems have a typical prosodic structure characterized by a pitch contour. This work applies Jun's finding in Seoul Korean(Jun 1993, 2000, 2005) to old Korean regulated poems, and reports some other significant phonetic characteristics, arguing that old Korean regulated poems have a regular rhythm based on the pitch contour implementing the typically hierarchical prosodic structure. The major prosodic units defined are a foot, a phrase, and a line. Next, this work proposes pitch contour characterizing prominence in a unit, boundary tones, and pauses at the boundary position, as the basic and significant cues of rhythm of a Korean poem. Specifically, some significant characteristics are discussed as follows: first, the tonal pattern of a foot is HL, starting high and ending low; second, the lowering boundary tones of HL% and L% are perceived at the end of a phrase and a line; and finally, a gradient degree of pause is observed at each unit-final position.

• Phonetics and Speech Sciences
• /
• v.2 no.3
• /
• pp.11-22
• /
• 2010

The present study attempts to investigate declination in Korean and its relevant aspects to the length of utterance, the clause boundary, and focus. More specifically, I examine the relation of declination with the length of utterance, the declination reset at the clause boundary, and the effect of focus on declination. Results showed that the length of utterance had no relation with the first and last pitch values of the utterance but that they were consistent regardless of the length of utterance. However, the declination slope changed to be relatively gentle from the fourth accentual phrase to the end of the whole intonational phrase. There was a reset of declination in such a way that the first pitch in the second phrase was always lower than that of the first phrase, but the first pitch in the third phrase was not always lower than that of the second phrase when the whole utterance was composed of three phrases. Finally, the pitch values of the focusing words decreased as their position went back in a sentence. One declination line was formed in the case of focused utterance, but in the case of an utterance that contained a clause boundary, a new declination line was formed at the start of each new clause. These findings can be applied to developing a Korean speech synthesizer that contains natural prosody; they can be also utilized for teaching Korean prosody.

• The Journal of the Acoustical Society of Korea
• /
• v.23 no.1E
• /
• pp.10-15
• /
• 2004

In performing speech conversion from a source speaker to a target speaker, it is important that the pitch contour of the source speakers utterance be converted into that of the target speaker, because pitch contour of a speech utterance plays an important role in expressing speaker's individuality and meaning of the utterance. This paper describes statistical algorithms of pitch contour conversion for Korean language. Pitch contour conversions are investigated at two 1 evels of prosodic phrases: intonational phrase and accentual phrase. The basic algorithm is a Gaussian normalization [7] in intonational phrase. The first presented algorithm is combined with a declination-line of pitch contour in an intonational phrase. The second one is Gaussian normalization within accentual phrases to compensate for local pitch variations. Experimental results show that the algorithm of Gaussian normalization within accentual phrases is significantly more accurate than the other two algorithms in intonational phrase.

• Proceedings of the KSME Conference
• /
• 2003.04a
• /
• pp.1461-1466
• /
• 2003

This paper presents the effects of the fin array and pitch on the frost layer growth of a heat exchanger. The numerical results are compared with experimental data of a cold plate to validate the present model, and agree well with experimental data within a maximum error of 8%. The characteristics of the frost formation on staggered fin array are somewhat different from those of in-line array. The frost layer at the first fin of the in-line array grows rapidly, compared to second fin, whereas the difference of the frost layer growth between the fins of the staggered array is small. For fin pitch below 10 mm, the frost layer growth of second fin in the staggered array is affected by that of first fin. The frost layer growth and heat transfer of single fin deteriorate with decreasing fin pitch regardless of fin array, however, the thermal performance of a heat exchanger, considering increase of heat surface area, becomes better.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.15 no.9
• /
• pp.711-717
• /
• 2003

This paper presents the effects of the fin array and pitch on the frost layer growth of a heat exchanger. The numerical results are compared with experimental data of a cold plate to validate the present model, and agree well with experimental data within a maximum error of 8%. The frost behaviors of the staggered fin array are somewhat different from those of in-line array. The frost layer formed on the first fin of the in-line array grows rapidly, compared to second fin, whereas the difference of the frost layer growth between the fins of the staggered array is small. For fin pitch below 10 m, the frost layer growth of second fin in the staggered array is affected by that of first fin. The thickness of the frost layer and heat transfer of single fin are reduced with decreasing fin pitch regardless of fin array. However, the thermal performance of a heat exchanger is enhanced due to the increase of heat transfer surface area.