• International Journal of Highway Engineering
• /
• v.16 no.4
• /
• pp.45-50
• /
• 2014

PURPOSES : The objective of this study is to analyze the performance of anti-stripping agent depending on its type and content to reduce pothole, an increasing pavement distress due to abnormal climate intensity. METHODS : In the past years, U.S and many countries in Europe use hydrated lime and liquid anti-stripping agent in asphalt mixtures. Hydrated lime or liquid anti-stripping agent is substituted for filler and binder, respectively, to improve the anti-stripping property of asphalt mixtures. To investigate this, indirect tensile strength test was performed and TSR values were compared for different content of hydrated lime and types of liquid anti-stripping agent in asphalt mixture. RESULTS : Test results indicate that hydrated lime remarkably increased the asphalt mixture performance on anti-stripping denoted by the increased in TSR values from 55% to 100%. Liquid anti-stripping agent also increased the value of TSR but not significant. In addition, depending on the types of aggregate, TSR values and effect of liquid anti-stripping were different. CONCLUSIONS : Using anti-stripping agents improve the anti-stripping property of asphalt mixture especially hydrated lime; however, more experiments should be conducted to improve the reliability about the effect of liquid anti-stripping agent.

• Korean Journal of Mineralogy and Petrology
• /
• v.33 no.3
• /
• pp.185-193
• /
• 2020

There have been many studies on the calcination of oyster shells in the perspective of recycling of resources. The quicklime made by the calcination of oyster shells is used either as it is or after reacting with water to transform to liquid lime before being used. However, the liquid lime made from calcined oyster shells show slightly different properties from that of limestone. In this study, to compare these properties of oyster shell with those of limestone, the samples were calcined and reacted with water at various temperatures to transform to a liquid lime and filtered using 150 ㎛ sieves to calculate the transform rate to liquid lime. The calcined limestone was transformed to liquid lime at all temperatures, but calcined oyster shell did not show any transformation at 30℃ and 50℃ under the experimental conditions of this study, and rather increased the weight for the remaining after filtration due to the presence of Ca(OH)₂ produced by the reaction with water, Even at 90℃, the transformation rate of calcined oyster shell to liquid lime was lower than that of limestone. This difference in oyster shell can be explained partly by the preventing calcined one from reacting with water by conchiolin which is protein found in the prismatic and pearl layers of oyster shell. Conchiolin is also known to be stable and does not decompose even at high temperature. However, even the calcined chalk layer without conchiolin shows lower transformation rate than that of calcined limestone, probably due to the small amount of Na in oyster shell, which may cause additional reaction including eutectic melt during calcination process.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.22 no.3
• /
• pp.46-59
• /
• 1980

This study was conducted to obtain the most effective distribution of grain size and the optimum lime content for lime-soil stabilization. To achieve the aim, the change of consistency, the characteristics of compaction and unconfined compressive strength were tested by adding of 0, 4, 6, 8, 10 and 12 percent lime by weight for all soils adjusted by given ratios of sand to clay. The results obtained were as follows; 1. There was a tendency that the plasticity index of lime-soil mixture was decreased by increasing the amount of lime, whereas the liquid limit was varied irregularly and the plastic limit was increased. 2. With the addition of more lime, the optimum moisture content of lime-soil mixture was increased, and the maximum dry density was decreased. 3. The optimum lime content of lime-soil mixture was varied from soil to soil, and the less amount of small grain size, the less value of optimum lime content. 4. The optimum distribution of grain size for lime-soil mixture was in the soil, having the ratio of about 60 percent of cohesive clay and about 40 percent of sand by weight. 5. In the soil having fine grain size, the effect of curing appeared for long periods of time, whereas the increasing rate of unconfined compressive strength was great on the soil of coarse grain size in the earlier stage of curing period.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.1
• /
• pp.545-551
• /
• 2011

Recently, demands for generating high quality tap waters are increasing with high concern of water pollution and corrosion of water pipelines. For the reasons, developing water quality stabilization technique in water purification system is sought rather than replacing to a new pipelines. In this study, high-purity liquid lime($Ca(OH)_2$) was introduced for a water quality stabilization technique in water purification process and simulated water distribution system of pilot-scale size was applied to evaluate anti-corrosion control effect. The effect of anti-corrosion control was calculated in terms of LSI(Langelier Saturation Index) In conclusion, the result of pilot plant showed improvement of corrosiveness by liquid lime($Ca(OH)_2$) with reduction of released iron(Fe). Application of anti-corrosion control technique to the mild steel coupon and the copper coupon were effective by indicating 35.4, 44.5% of improvements. Besides, sample pipes which were treated with liquid lime had formated more thicker layer of corrosion product inside of pipes. As a result, the process of injecting water stabilizer can greatly contribute to the high quality of tap water.

• Geomechanics and Engineering
• /
• v.32 no.6
• /
• pp.601-613
• /
• 2023

Low liquid limit silt, widely distributed in the middle and down reaches of Yellow River, has the disadvantages of poor grading, less clay content and poor colloidal activity. It is very easy to cause vehicle jumping at the bridge-embankment transition section when the low liquid limit silt used as the backfill at the abutment back. In this paper, a series of laboratory tests were carried out to study the physical and mechanical properties of the low liquid limit silt used as back filling. Ground granulated blast furnace slag (GGBFS) was excited by active MgO and hydrated lime to solidify silt as abutment backfill. The optimum ratio of firming agent and the compaction and mechanical properties of reinforced soil were revealed through compaction test and unconfined compressive strength (UCS) test. Scanning electron microscope (SEM) test was used to study the pore characteristics and hydration products of reinforced soil. 6% hydrated lime and alkali activated slag were used to solidify silt and fill the model of subgrade respectively. The pavement settlement regulation and soil internal stress-strain regulation of subgrade with different materials under uniformly distributed load were studied by model experiment. The effect of alkali activated slag curing agent on curing silt was verified. The research results can provide technical support for highway construction in silt area of the Yellow River alluvial plain.

• Geomechanics and Engineering
• /
• v.8 no.1
• /
• pp.113-132
• /
• 2015

In this study, lime (L), silica fume (SF), and lime-silica fume (L-SF) mix have been used for stabilizing and considering their effects on the soft clay soil. The improvement technique adopted in this study includes improving the behaviour, of a square footing over soft clay through grouting the clay with a slurry of lime-silica fume before and after installation of the footing. A grey-colored densified silica fume is used. Three percentages are used for lime (2%, 4% and 6%) and three percentages are used for silica fume (2.5%, 5%, 10%) and the optimum percentage of silica fume is mixed with the percentages of lime. Several tests are made to investigate the soil behaviour after adding the limeand silica fume. For grouting the soft clay underneath and around the footing, a 60 ml needle was used as a liquid tank of the lime-silica fume mix. Slurried silica fume typically contains 40 to 60% silica fume by mass. Four categories were studied to stabilize soft clay before and after footing construction and for each category, the effectiveness of grouting was investigated; the effect of injection hole spacing and depth of grout was investigated too. It was found that when the soft clay underneath or around a footing is injected by a slurry of lime-silica fume, an increase in the bearing capacity in the range of (6.58-88)% is obtained. The footing bearing capacity increases with increase of depth of grouting holes around the footing area due to increase in L-SF grout. The grouting near the footing to a distance of 0.5 B is more effective than grouting at a distance of 1.0 B due to shape of shear failure of soft clay around the footing.

• International Journal of Highway Engineering
• /
• v.17 no.4
• /
• pp.77-87
• /
• 2015

PURPOSES: It is theoretically well known all over the world, that porous hot mixed asphalt (HMA) with hydrated Lime improves moisture and rutting resistance, and reduces pothole occurrence frequency, as well as the life cycle cost (LCC). METHODS : Addictive in the two different formations of the liquid anti-stripping Agent and powder Hydrated-Lime was applied in this investigation in order to obtain relatively clear results according to their types and conditions. Firstly, the moisture conditions were set, and applied to the porous HMA mixtures with hydrated lime (anti-stripping agent). Next, it was followed by a non-destructive test with the application of three freeze-thaw cycles, which were individually carried out thrice to compare the results of the dynamic moduli. Lastly, the hydrated lime effect related to moisture sensibility to porous HMA has been verified through the analysis of the modulus results regarding the change rate of dynamic modulus per n-cycle. RESULTS: It is clear from this investigation, that the dynamic modulus is inversely proportional to the change in temperature, as the graph representing the rigidity of the thermorheologically simple (TRS) material showed gradual decline of the dynamic modulus with the increase in temperature. CONCLUSIONS: The porous HMA mixture with the anti-stripping agent (hydrated Lime) has been found to be more moisture resistant to freezing and thawing than the normal porous HMA mixture. It is clear that the hydrated lime helps the HMA mixture to improve its fatigue resistance.

• Applied Chemistry for Engineering
• /
• v.8 no.1
• /
• pp.99-107
• /
• 1997

This study Provides the treatment methods of liquid wastes from the dissolution/purification process of nuclear fuel raw material and the fabrication process of nuclear fuel powder. One of the treatment methods is to process liquid waste from uranium raw material dissolution/purification process. This waste, of the strong acid, can be reused to dissolve the fine ADU particles in filtrate which is ADU waste of pH 8.0 converted from AUC waste after recovery of uranium. To dissolve the fine ADU particles, ADU filtrate was pretreated to pH 4.0 with the dissolution/purification waste, and then mixed with the lime to pH 9.2 and aged for 30 minutes. From this processing, uranium content of the filtrate was decreased to below 3ppm. The waste from fuel powder fabrication is emulsified solution dispersed with fine oil droplets. This emulsion was destroyed effectively by adding and mixing the nitric acid with rapid heating at the same time. After this processing, $Na_2U_2O_7$ compound is produced by addition of NaOH. Optimum condition of this processing was shown at pH 11.5, and uranium content of the filtrate was analyzed to 5ppm. To remove the trace of uranium in the filtrate, lime should be added. Otherwise, 4N nitric acid was used to destroy the emulsion directly, and then lime was added to this waste. Uranium content of the treated filtrate was below 1 ppm. In addition to these wastes, the trace of uranium in filtrate after recovery of uranium from the AUC waste which is produced during PWR power preparation, is treated with NaOH to takeup fluorine(F) in the waste because fluorine is valuable and toxic material. In the finally treated waste, uranium was not detected.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.7 no.1
• /
• pp.81-89
• /
• 2005

The experiment was conducted to evaluate the effect of fruit skin spray of the lime fertilizer in 'Campbell Early' grapes. The T-N, P, K, Ca and Mg of fruit skin and cluster weight, berry weight, cluster length showed no difference between control and lime fertilizer. But soluble solids in fruit was reduced by fruit skin spray of liquid calcium fertilizer extracted from oyster shell after bagging(LCaB). The anthocyanin content of fruit skin was decreased by air-slaked lime(HCa) and LCaB treatment. Also, occurrence of fruit skin bloom was significantly reduced by HCa and oyster shell powder(OS-CaP) treatment. The berry firmness was significantly increased through liquid calcium fertilizer extracted from oyster shell(LCa) and HCa treatment. Conspicuously, berry elasticity was rather decreased by OS-CaP treatment. However, there was no difference of weight loss of fruit among treatments during room temperature storage.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.1
• /
• pp.529-536
• /
• 2011

In this study, we confirmed that the SWRO(Sea Water Reverse Osmosis) production water has more hard corrosiveness than the tap water by fundamental experiment. According to the result, the target of this study was aimed at developing maintenance and anti-corrosion method. In the early stages of the research, batch tests using mild steel coupons and electrochemical experiments were applied to compare the corrosiveness between SWRO production water and the tap water. After then, two corrosion control methods for SWRO production water were applied. Liquid lime($Ca(OH)_2$) and Carbon Dioxide($CO_2$) were inserted and compared with the combination of liquid lime with phosphate corrosion inhibitor and carbon dioxide. The water qualities were evaluated through LSI(Langelier Saturation Index) and proper injection ratio was deduced by the result. Since then, simulated loop system test were performed to evaluate anti-corrosion effect depending on corrosion inhibitors. Subsequently, carbon steel pipes equipped at the loop system were detached for SEM, EDX and XRD analysis to acquire quantitative and qualitative data of the major corrosion products inside the pipes. In conclusion, the controled groups with anti-corrosion techniques applied were effective by appearing 97.4% and 90.9% of improvements in both case of liquid lime and the liquid lime with a phosphate corrosion Inhibitor. furthermore, major components of scale were iron oxides, on the other hand, protective effect of film formation by calcium carbonate($CaCO_3$) could be confirmed.