• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.8
• /
• pp.1854-1860
• /
• 2014

In this paper, the energy saving on mobile communication repeater is studied. DB(Dual Band) small repeater, which is currently used in the field for indoor coverage, is adopted as a test unit. For reducing the power consumption, PFC (Power Factor Correction) is included on SMPS (Switching Mode Power Supply) of the DB small repeater. The test results show that approximately 38.9% of the power consumption is reduced comparing with the repeater without PFC. It means that approximately 230.43kWh per unit can be saved annually.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.8C
• /
• pp.605-612
• /
• 2008

This paper researches the estimating location using repeater effect adjustment method in CDMA based system. Repeaters are commonly used by commercial and amateur radio operators to extend signals in the radio frequency range from one receiver to another. The repeater signals are increasing arrival time from base station to mobile station. So if we calculates the mobile station using repeater signals, the estimating position error is increased. However nobody researched about adjusting repeater effects. This paper proposes repeater effect adjustment algorithm. For adjusting repeater effects, we make the triangle using mobile station, reference base station and neighbor base station, and then detect the repeater effects using the triangle characteristic. The proposed method system showed the improved performance in estimating parameters and locating positions by computer simulations.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2002.05a
• /
• pp.359-362
• /
• 2002

The increase in the number of PCS base station and repeater has increased the level of interference between PCS carriers. In this paper, interference of singular PCS repeater out-of-band noise power on mobile phone is analysed and compared with that of unified PCS repeater for multiple PCS carriers. It is shown that unified PCS repeater provide about 2∼3dB signal gain in comparison with conventional PCS repeater. As a result, the interference of out-of-band noise power on mobile phone is reduced. It is expected that PCS carriers are able to build an environmentally-friendly communications infrastructure and reduce the cost by using unified PCS revealer and apply it for the deployment of IMT-2000 network.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.11
• /
• pp.1125-1132
• /
• 2011

The purpose of this study is to suggest installation methods of a mobile-communication repeater into a lift system with consideration of EMC. Two approaches, one(Solution 1) is realized with a repeater installed in a lift hoistway and another(Solution 2) installed inside a lift, were proposed. It is confirmed that the Solution 1 is more effective than the Solution 2. And it is suggested that the EIRP of a repeater must be limited to be ${\leq}$-5 dBm by considering electromagnetic immunity level for a lift and safety margin of 20 dB. This limit can provide suitable electromagnetic environment inside a lift with precise power-control mechanism of mobile communication systems. This study could be a good example of Green ICT by improving electromagnetic environment in spite of radio use.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.277-280
• /
• 2005

In this paper, we propose a frequency synthesizer for dualband repeater. The dual-band RF technology for applications to the wireless repeater for CDMA and WCDMA mobile communications has been developed in this paper. The dualband PLL module consisted of dual-band VCO and one PLL IC has been developed. The main technological efforts for the dual-band PLL module is to suppress the intermodulation distortion by applying the miniature ceramic filter using the slow wave characteristics. The dual-band miniature RF module including dual-band PLL module and one MCU controller is very attractive for applications to the miniature dual-band RF mobile repeaters.

• Journal of electromagnetic engineering and science
• /
• v.18 no.4
• /
• pp.261-266
• /
• 2018

This paper reports on the proposed design of a low profile broadband array antenna for home repeater applications. The proposed antenna consists of $1{\times}4$ patch elements and two ground planes, one of which is slitted. By using the gap feeding method, the impedance matching of the antenna is improved by a multi-resonance phenomenon. The proposed antenna provides a wide -10 dB reflection coefficient bandwidth simultaneously covering the Global System for Mobile communications (GSM-1800), Personal Communications Service (PCS), and the Universal Mobile Telecommunication System (UMTS) bands (1.67-2.32 GHz). In order to reduce the mutual coupling between adjacent patch elements, slits are embedded in the ground plane. An isolation level of -20 dB is realized over the entire operating frequency band.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.1
• /
• pp.33-39
• /
• 2002

In mobile communication systems, there are areas where signal coverage is not adequately accomplished by base stations. These areas may be underground parking zones, underground stores, tunnels, and insides of buildings, etc. In these areas, repeaters are broadly used as an economical solution. However, the capacity is decreased as the number of repeaters increases because the noise power that flows to a base station in the reverse link is proportional to the number of repeaters. The reduction of capacity in the reverse link is no longer negligible in the case that several tens or hundreds repeaters are connected to a base station. In this paper, we propose c repeater that is switched off automatically when there is no active user within its coverage. With the switching repeater, we can reduce the unnecessary noise level enhancement when there is no active user within the repeaters coverage. The reverse link capacity of a DS/CDMA system with AOS repeater is analyzed mathematically and compared with that without switching repeater. From the numerical results, noticeable improvement with the switching repeaters is shown.

• 한국정보통신설비학회:학술대회논문집
• /
• 2006.08a
• /
• pp.57-61
• /
• 2006

As high speed internet users are tremendously increasing, three are keenly in need of development of high speed portable internet technology which can provide high quality wireless internet service cheaply even in the mobile. Unlike the FDD-CDMA, TDD-OFDMA has relatively poor wave environment with inducing interference, fading and delay because it agrees to multi-carrier modulation method and time-division radio telecommunication system. To solve this problem, it is necessary to develop repeater operating by digital signal processing method which have more strict wireless channel control and wave signal processing technology over TDD telecommunication equipments. This thesis is dealing with design and implementation of Digital RF Repeater which implemented 'Synchronization Acquisition Unit', 'TDD signal switching Unit', 'Feedback Signal Cancellation Unit'. Over this argument, we will develop digital RF repeater with more cheap, more adaptive in wave environment like oscillation control, adaptive wave monitoring and output increasing and having control function as a result it will be helpful for success in high speed portable internet service business.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.2A
• /
• pp.91-99
• /
• 2011

Several repeater systems are used to enhance the cell coverage to location such as shadow and rural areas in mobile systems. But the general RF repeater solutions are not suitable for high power outdoor environment because it has the weakness such as self oscillation problem With adoption of a adaptive digital filter technology, feedback interference cancellation repeater prevents oscillation by detecting and canceling the unwanted feedback signal between transmission and receiver antenna. In this paper, dual NLMS based interference cancellation method is proposed and the step size adaptation can be implemented by the estimation of the feedback channel Doppler frequency characteristics. The performance of the proposed algorithm is quantified via analysis and simulation for the static and multipath fading feedback channels.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.4C
• /
• pp.333-341
• /
• 2002

This article is written to make a foundation for effective radio network engineering by enabling the accurate traffic assumption between Base Station (BTS : Base Station Transceiver Subsystem) md Repeater through the scientific and systematic analysis of mobile traffic dealt within CDMA Base Station. Among these, Repeater, having direct physical connection with BTS, simply does the remote relay function but the volume of the traffic flowed into the repeater is not accountable. The total BTS traffic is the sum of traffic dealt by the BTS and multiple Repeaters. In this article, we tried traffic analysis of this kind by adopting RTD (Round Trip Delay) which is specially designed to measure distribution of the distance between the Base Station and the Mobile station by differentiating the traffic dealt by BTS from traffic dealt by Repeaters. The fact that the connection between mobile station and BTS via Repeater (which is located remotely) yields far more delay than the direct connection between mobile station and BTS is the clue of this article. Based on this fact, Time Delay equipment was put at the receiving side of the Repeater to add certain amount of delay to the traffic to BTS and the result showed that the 99.78% of the traffic can be identified.