• Journal of Navigation and Port Research
• /
• v.31 no.9
• /
• pp.763-769
• /
• 2007

A narrow loop noise bandwidth method is desirable to reduce the error of raw measurements due to the thermal noise. However, it degrades the performance of GPS initial synchronization such as mean acquisition time. And it restricts the loop noise bandwidth to a fixed value determined by the lower bound of the allowable range of carrier-to-noise power ratio, so that it is difficult to optimally track GPS signal. In order to make up for the weak points of the fixed-type narrow loop noise bandwidth method and simultaneously minimize the error of code and carrier measurements, this paper proposes a stepwise-type adaptive bandwidth algorithm for DGPS reference receivers. In this paper, it is shown that the proposed adaptive bandwidth algorithm can provide more accurate measurements than those of the fixed-type narrow loop noise bandwidth method, in view of analyzing the simulation results between two signal tracking algorithms. This paper also carries out sensitivity analysis of the proposed adaptive bandwidth algorithm due to the estimation uncertainty of carrier-to-noise power ratio. Finally the analysis results are verified by the experiment using GPS simulator.

• Proceedings of the KIEE Conference
• /
• 2002.07c
• /
• pp.1655-1657
• /
• 2002

Ultra-wide bandwidth (UWB), narrow bandwidth (single frequency), and a combination of both technologies have been studied for the ultra-high frequency (UHF) partial discharge (PD) monitoring system as a detection scheme. We have experimentally compared those detection methods using a mock-up of 362 kV class single phase gas-insulated switchgear (GIS) and a stable PD source. A rolling-ball type PD cell that produces PDs of about 10 pC, is placed at one end of the GIS. An internal UHF PD sensor was attached several meters away from the PD source. The PD spectrum was measured up to 3 GHz. A useable bandwidth of more than 1 GHz was used to measure UWB signals from the PD. To simulate the narrow bandwidth scheme a bandwidth of 100 kHz centered at several different frequencies was used.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2021.11a
• /
• pp.856-859
• /
• 2021

Image transmission by means of telecommunications is an essential task for information sharing. For considerable distances, wireless channels can be utilized and tuned for proper uses of image data exchange. However, the disturbances that a radio wave encounter during transmission causes partial or total loss of information. Result of such communications is a distorted image at the receiver's end. This paper proposes an auto-encoder architecture as an image enhancement method for narrow-bandwidth radio images. With this method, a distorted image can be improved for better receiver satisfaction. The proposed auto-encoder is trained with many narrow-bandwidth radio image data; hence it enhances a given distorted image. Also, the results were verified with the original image data being the reference images.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.24 no.1
• /
• pp.1-11
• /
• 2021

Thermal protection system structures such as double-panel structures are used on the skin of the fuselage and wings to prevent the transfer of high heat into the interior of an high supersonic/hypersonic aircraft. The thin-walled double-panel skin can be exposed to acoustic loads by high power engine noise and jet flow noise, which can cause sonic fatigue damage. In order to predict the fatigue life of the skin, the octave bandwidth SPL should be calculated as narrow bandwidth PSD or acoustic load history using interpolation method. In this paper, a method of converting the octave bandwidth SPL acoustic load into a narrow bandwidth PSD and reconstructed acoustic load history was investigated. The octave bandwidth SPL was converted to the narrow bandwidth PSD using various interpolation methods such as flat, log and linear scale, and the probabilistic characteristics and fatigue damage results were compared. It was found that average error of fatigue damage index by the log scale interpolation method was relatively small among three methods.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.6 no.2
• /
• pp.85-91
• /
• 1986

Fatigue life is an important consideration for the design of offshore structures in deep sea and in hostile environments. In this paper, the effect of the bandwidth of random stresses on the fatigue life estimation of fixed offshore structures is investigated. The dynamic analysis is carried out in the frequency domain by using the equivalent linearization technique. Fatigue damages are calculated by two stress cycle counting methods; i.e., the narrow band method and the wide band method using rainflow counting technique. Example studies are carried out for two different structures. Numerical results indicate that the wide band approach, which is more complex but theoretically more appropriate pridicts smaller values of fatigue damages compared with those by the narrow band approach for all seastate conditions. Such trend becomes more apparent for the cases of severe seastates where the bandwidth of random stresses becomes large.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.10
• /
• pp.2269-2274
• /
• 2015

In this paper, the reduced size in horizontal sizes of the narrow band pass filter (BPF) with λg/4 short stub using S shaped folded coupling structure is presented. This BPF with narrow bandwidth show flexible bandwidth with variation of the position of the stubs using the Qe(external quality factor) without changing the impedance value. On the other hand, by replacing the horizontal quarter-wavelength transmission lines with the equivalent S shaped coupled line, the BPF with reduced the size of horizontal can be realized. The proposed BPF shows the insertion loss of 1.46 dB and the return loss of 16.5 dB with bandwidth of 3.4 % at the center frequency of 5.8 GHz, respectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.2A
• /
• pp.167-173
• /
• 2008

In this paper, the flexible narrow bandpass filters (BPFs) with ${\lambda}$g/4 short and ${\lambda}$g/2 open stubs by microstrip line on duroid substrate are suggested. These BPFs with narrow bandwidth show flexible bandwidth with variation of the position of the stubs using the Qe (external quality factor) without changing the impedance value at microwave range. On the other hand, by replacing the series quarter-wavelength connecting lines with the equivalent T-shaped line of bandstop filter(BSF), the compact stub bandpass filter with harmonics suppression can be realized. The BPF with ${\lambda}$g/4 short stubs shows the insertion loss of 2.1 dB and the return loss of 18 dB and BPF with ${\lambda}$g/2 open stubs shows the insertion loss of 1.2 dB and the return loss of 21.9 dB at the center frequency of 5.8 GHz and the bandwidth of 10 %.

• Journal of the Optical Society of Korea
• /
• v.17 no.2
• /
• pp.177-181
• /
• 2013

We present an all-fiberized power-scalable, sub-nanosecond mode-locked laser based on a frequency-shifted-feedback ring cavity comprised of an erbium-doped fiber, a downshifting acousto-optic modulator (AOM), and a bandpass filter (BPF). With the aid of the frequency-shifted feedback mechanism provided by the AOM and the narrow filter bandwidth of 0.45 nm, we generate self-starting, mode-locked optical pulses with a spectral bandwidth of ~0.098 nm and a pulsewidth of 432 to 536 ps. In particular, the output power is readily scalable with pump power while keeping the temporal shape and spectral bandwidth. This is obtained via the consolidation of bound pulse modes circulating at the fundamental repetition rate of the cavity. In fact, the consolidated pulses form a single-entity envelope of asymmetric Gaussian shape where no discrete internal pulses are perceived. This result highlights that the inclusion of the narrow BPF into the cavity is crucial to achieving the consolidated pulses.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.12
• /
• pp.197-204
• /
• 2013

In this paper, we propose a new method for artificial bandwidth extension of narrow-band signal in frequency domain. In the proposed method, a narrow-band signal is decomposed into excitation signal and spectral envelope, which are extended independently in frequency domain. The excitation signal is extended such that low-band harmonic structure is maintained in high band, and the spectral envelope is extended based on sub-band energy using NMF. Finally, the spectral phase is determined based on signal correlation between frames in time domain, resulting in the final wide-band signal. The subjective evaluation verified that the wide-band signal generated by the proposed method has a higher quality than the original narrow-band signal.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.11
• /
• pp.84-90
• /
• 2010

In this paper, the reduced size of broad bandpass filter with parallel coupled line structure is presented. This proposed filter can control bandwidth of narrow to broadband by adjusting the coupling coefficient. The conventional filter is operated with a narrow band. If a higher bandwidth is desired than the conventional narrow bandwidth, it is hard to realize due to the coupling coefficient between feeding line and resonator. In this paper, to overcome this limitation, a proposed bandpass filter is designed with reduced size due to SIR(Stepped Impedance Resonator) and multi-grade type structures than conventional one, and it has characteristics of adjusting bandwidth freely as per quantity of coupling coefficient. The proposed bandpass filter that, experimental results of insertion and return losses are 0.42 dB and 20.9 dB with bandwidth of 60 % at the center frequency of 5.8 GHz, respectively.