• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.16 no.3
• /
• pp.95-100
• /
• 2006

Synthesis of the non-swelling property micas was carried out by hydrothermal method. In order to artificially induce the diffusion of ions, a rotating system was attached to the hydrothermal apparatus and by adding 0.7 mm zircon beads, synthesis of the non-swelling property micas could be performed in a low temperature area. The hydrothermal conditions for the preparation of micas were a reaction temperature of $260^{\circ}C$, for 72 hrs, using $1K_2O,\;1Al(OH)_3,\;4Mg(OH)_2\;and\;6SiO_2$ as the starting materials and a 8M-KOH solution as the hydrothermal solvent. The micas obtained under these conditions were a plate shape with a size of $2.89{\mu}m$ and showed a whiteness of over 97 %. Also, through the FT-IR analysis, because the absorption peak of the $Mg_3OH$ vibration was observed at approximately $3700cm^{-1}$, it could be known that it was phlogopite of non-swelling property showing the chemical composition of $KMg_3AlSi_3O_{10}(OH)_2$. This result was very consistent with the EDS analysis where O (41.34 %), Mg (3.88 %), Al (11.45 %), Si (17.62 %) and K (25.71%) elements were detected.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.18 no.3
• /
• pp.131-135
• /
• 2008

This study is to establish the coating technique for synthetic mica and to prepare synthetic mica with the non-aqueous property. The surface coating of synthetic mica is prepared with stearic acid using the high speed stirrer. The characterizations for mica powders coated the stearic acid are carried out by the deposition test, XRD and SEM. The results of research could be coated the stearic acid on the mica by 1600 rpm/min at $70^{\circ}C$ for 10 min. From the observation of SEM was found that the non-aqueous property mica could obtained by mixture ratios for stearic acid and mica, the inner temperature and rotation speed of the stirrer but treated time be unrelated.

• Geomechanics and Engineering
• /
• v.29 no.1
• /
• pp.91-97
• /
• 2022

The cohesive non-swelling soil (CNS) cushion technology has been widely applied in the subgrade and slope improvement at expansive soil regions. However, the mechanism of the inhibition effect of the CNS layer on expansive soil (ES) has not been fully understood. We performed four outdoor model tests to further understand the inhibition effect, including different kinds of upper layer and thickness, under the unidirectional seepage condition. The swelling deformation, soil pressure, and electrical resistivity were constantly monitored during the saturation process. It is found that when a CNS layer covered the ES layer, the swelling deformation and electrical resistivity of the ES layer decreased significantly, especially the upper part. The inhibition effect of the CNS layer increases with the increase of CNS thickness. The distribution of vertical and lateral soil pressure also changed with the covering of a CNS layer. The electrical resistivity can be an effective index to describe the swelling deformation of ES layer and analyze the inhibition effect of the CNS layer. Overall, the CNS deadweight and the ion migration are the major factors that inhibit the swelling deformation of expansive soil.

• Geomechanics and Engineering
• /
• v.22 no.3
• /
• pp.227-236
• /
• 2020

Expansive soils are renowned for their swelling-shrinkage property and these volumetric changes resultantly cause huge damage to civil infrastructures. Likewise, subgrades consisting of expansive soils instigate serviceability failures in pavements across various regions of Pakistan and worldwide. This study presents the use of polypropylene fibers to improve the engineering properties of a local swelling soil. The moisture-density relationship, unconfined compressive strength (UCS) and elastic modulus (E₅₀), California bearing ratio (CBR) and one-dimensional consolidation behavior of the soil treated with 0, 0.2, 0.4, 0.6 and 0.8% fibers have been investigated in this study. It is found that the maximum dry density of reinforced soil slightly decreased by 2.8% due to replacement of heavier soil particles by light-weight fibers and the optimum moisture content remained almost unaffected due to non-absorbent nature of the fibers. A significant improvement has been observed in UCS (an increase of 279%), E₅₀ (an increase of 113.6%) and CBR value (an increase of 94.4% under unsoaked and an increase of 55.6% under soaked conditions) of the soil reinforced with 0.4% fibers, thereby providing a better quality subgrade for the construction of pavements on such soils. Free swell and swell pressure of the soil also significantly reduced (94.4% and 87.9%, respectively) with the addition of 0.8% fibers and eventually converting the medium swelling soil to a low swelling class. Similarly, the compression and rebound indices also reduced by 69.9% and 88%, respectively with fiber inclusion of 0.8%. From the experimental evaluations, it emerges that polypropylene fiber has great potential as a low cost and sustainable stabilizing material for widespread swelling soils.

• Elastomers and Composites
• /
• v.41 no.4
• /
• pp.223-230
• /
• 2006

Rubber compounds have a high viscoelastic property. One of the viscoelastic behaviors during profile extrusion is the swelling of extrudate, and the amount of swelling varies with operational conditions in extrusion. It is well recognized that the elastic portion in the viscoelastic property plays an important role in the extrudate swell. In this study computer simulation of the die swell at the capillary die for several rubber compounds has been performed using commercial CFD code, Polyflow. A non-linear differential viscoelastic model, Phan-Thien-Tanner (PTT) model, was used in the computer simulation. Non-isothermal behavior was considered in the calculation. Distribution of pressure, velocity and temperature in the reservoir and capillary die, and extrudate profiles were predicted through the simulation. The amount of the die swell fur the different rubber compounds was investigated for various flow rates and three types of length to diameter of the capillary die. It is concluded that the PTT model successfully represented viscoelastic behavior of rubber compounds.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2007.05a
• /
• pp.209-212
• /
• 2007

Rubber compounds have high viscoelastic property. One of the viscoelastic behaviors during profile extrusion is the swelling of extrudate. In this study, die swell of rubber compounds at the capillary die have been investigated through an experiment and computer simulation. They have been performed using fluidity tester in experiment and commercial CFD code, Polyflow in computer simulation. Die swell of rubber compounds for relaxation time at several modes under same conditions with the experiment were predicted using non-linear differential viscoelastic model, Phan-Thien-Tanner (PTT) model. The simulation was analyzed compared with the experiment. Viscoelastic behaviors for pressure, velocity and shear rate distribution were analyzed at the capillary die. It is concluded that the PTT model successfully represented the amount of the optimal die swell of rubber compounds for relaxation time at different modes.

• Transactions of Materials Processing
• /
• v.16 no.4 s.94
• /
• pp.260-265
• /
• 2007

Rubber compounds have high viscoelastic property. One of the viscoelastic behaviors during profile extrusion is the swelling of extrudate. In this study, die swells of rubber compounds at the capillary die have been investigated through experiment and computer simulation. Experiments and simulations have been performed using fluidity tester and commercial CFD code, Polyflow respectively. Die swells of rubber compounds in a capillary die were predicted using non-linear differential viscoelastic model, Phan-Thien-Tanner(PTT) model for various relaxation times and relaxation modes. The results of simulation were compared with the experiments. Pressure and velocity distribution, and circulation flows at the comer of capillary die have been investigated through computer simulation. It is concluded that the PTT model successfully represented the amount of the die swell of rubber compounds for various relaxation times at different modes.

• Korean Journal of Food Science and Technology
• /
• v.25 no.4
• /
• pp.355-359
• /
• 1993

The effects of alum un the physicochemical properties of non-waxy and waxy rice starches were investigated. The swelling powers of non-waxy and waxy rice starches with $0.05{\sim}1.0%(w/w)$ alum were increased remarkably in comparison with rice starches without alum, but those of rice starches with alum above 1.0%(w/w) concentration were decreased slowly with the increasing amount of alum. While solubility of the non-waxy starch with $0.05{\sim}1.0%(w/w)$ alum was elevated gradually with the increasing temperature. that of the waxy starch was decreased regardless temperature. But solubilities of both rice starches with alum concentration above 1.0%(w/w) exhibited no significant changes. The more alum in the system, the higher and the lower blue value were resulted in non-waxy rice starch and waxy rice starch, respectively. From amylograms, it was found that alum increased breakdown and initial pasting temperatures for both rice starches, but reduced setback.

• The Journal of Korean Medicine
• /
• v.29 no.2
• /
• pp.32-40
• /
• 2008

Background: Angelica dahurica has been used in various clinical cases. Its taste is hot and its property is warm, dry and nonpoisonous. Its efficacy is to remove wind-damp, cure swelling and edema, exhaust pus, stop itching, rhinitis and leukorrhea. Object: To test through experiment Angelica dahurica's analgesic and anti-inflammatory efficacy. Method: Inject acetic acid as a pain-inducing substance to the mice and measure visceral pain bywrithing reflex. Inject carrageenan that is an edema-inducing substance to the rat's paw and measure volume of edema. Take thermal pain to mice with plantar test and measure paw withdrawal latency. Normal group is non Angelica dahurica-treated group and treated group is Angelica dahurica-treated group. Results: In acetic acid-induced visceral model, treatment with Angelica dahurica suppressed writhing reflex significantlyand dose-dependently. In carrageenan-induced paw edema model, treatment with Angelica dahurica suppressed carrageenan-induced paw edema. In plantar test model, no significant effect on the withdrawal latency of thermal stimulation-induced nociception was observed. Conclusion: Angelica dahurica has analgesic and anti-inflammatory efficacy.

• Archives of Pharmacal Research
• /
• v.14 no.1
• /
• pp.12-18
• /
• 1991

The effect of urea and urea derivatives on the percutaneous absorption of salicylic acid and sodium salicylate through the skin of rabbit from petrolatum ointment was investigated. It was found that addition of urea or urea derivatives to the ointment base significantly increased the percutaneous absorption of the drugs in proportion to the concentratoin of the additive. The percutaneous absorptoin-enhancing activities of these compounds were that urea derivatives with the more and longer alkyl substituents showed the stronger activities. These activities of urea and urea derivatives were ascribed to the binding of these compounds with the lipids and proteins of the stratum corneum of the skin and the swelling of the tissues, which leads to the reduction of the barrier property of the layer. The preliminary skin irritation test showed that urea and urea derivatives were quite non-irritating to the skin. These results suggest that urea derivatives have a strong possibility to be developed as a percutaneous absorption enhancer.