• Journal of the Semiconductor & Display Technology
• /
• v.15 no.1
• /
• pp.70-75
• /
• 2016

GZO films prepared on ITO glasses were annealed at various temperatures in a vacuum condition to research the relationship between oxygen vacancies and optical properties. GZO films after annealing in a vacuum showed the various optical-chemical properties depending on the annealing temperatures and oxygen gas flow rate during the deposition. The oxygen vacancy of GZO film prepared by oxygen gas flows of 22 sccm increased with increasing the annealing temperatures, because of the extraction of oxygen by the annealing. But the intensity of photoluminance of GZO with 22 sccm decreased in accordance with the annealing temperature, because of the reduction of ionized charge carriers. The oxygen vacancy by the extraction of oxygen enhanced a depletion, so the widen depletion had the strong Schottky barrier and the PL intensity due to the low carrier density decreased.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.1
• /
• pp.28-32
• /
• 2000

Structural and electrical properties of (Ba, Sr)TiO\ulcorner (BST) thin films prepared by pulsed laser depositon were investigated to verify the influences of post-annealing in oxygen ambient. Increase of post-anneal-ing time in oxygen ambient resulted in not only grain growth but also improvement of crystallinity of BST films. Although the post-annealing in oxygen ambient resulted in the increase of surface roughness, it assisted the dielectric constant increase by eliminating oxygen vacancies. The electrical property enhancement including high dielectric constant and low leakage current density was associated with introducing high pressure of oxygen during the post-annealing.

• Journal of the Semiconductor & Display Technology
• /
• v.15 no.2
• /
• pp.11-15
• /
• 2016

This paper, Ga-doped ZnO (GZO) thin films which were deposited on Corning glass substrate using an magnetron sputtering deposition technology and then the post deposition annealing process was conducted for 30 minutes at different temperature of 100, 200, 300, and $400^{\circ}C$, respectively. So as to investigate the properties for the relevant the Concentration and Oxygen Vacancy with Annealing temperature of Ga-doped ZnO thin films by RF Sputtering method. The Carrier concentration is enhanced as annealing temperature decreases, and also the oxygen vacancy concentration is enhanced as annealing temperature decreased. Oxygen vacancy will decrease along with Carrier concentration. This change in Carrier concentration is related to changes in oxygen vacancy concentration. The figure of merit obtained in this study means that Ga-doped ZnO films which annealed at $400^{\circ}C$ have the lowest Carrier concentration and Oxygen vacancy, which have the highest optoelectrical performance that it could be used as a transparent electrode.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.251.1-251.1
• /
• 2013

Combination of oxidative vacuum annealing and oxygen plasma treatment can serve as a simple and efficient method of line-width modification of imprinted nanopatterns. Since the vacuum annealing and oxygen plasma could lead mass loss of polymeric materials, either one of the process can yield a narrowed patterns. However, the vacuum annealing process usually demands quite high temperatures (${\geq}300^{\circ}C$) and extended annealing time to get appreciable line-width reduction. Although the plasma treatment may be considered as an effective low temperature rapid process for the line-width reduction, it is also suffering for the lowered controllability on application to very fine patterns. We have found that the vacuum annealing temperature can be lowered by introducing the oxygen in the vacuum process and that the combination of oxygen plasma treatment with the vacuum annealing could yield the best result in the line-with reduction of the imprinted polymeric nanopatterns. Well-defined line width reduction by more than 50% was successfully demonstrated at relatively low temperatures. Furthermore, it was verified that this process was applicable to the nanopatterns of different shapes and materials.

• The Korean Journal of Ceramics
• /
• v.6 no.1
• /
• pp.68-73
• /
• 2000

The effects of oxygen annealing on the carbon content in MgO thin films were investigated, MgO thin films were deposited on Si(100) substrate at different temperatures of 400 to $700^{\circ}C$ and different deposition rates of 3.4 to 11.6$\AA$/min. Using rf magnetron sputtering method. Carbon content change on the surface of MgO thin films with the oxygen annealing at different temperatures was investigated using various method. The carbon content decreased as the annealing temperature increased. $Pb(Zr_{0.53}Ti_{0.47})O_3$(PZT) thin films were deposited on the MgO/Si(100) substrates. The effects of carbon content on the phase formation and the electrical properties of PZT thin films were also investigated.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.9
• /
• pp.705-710
• /
• 1998

Intrinsic gettering is usually to improve wafer quality, which is an important factor for reliable ULSI devices. In order to generate oxygen precipitation in lightly and heavily boron doped silicon wafers with or without high $^75 As^+$ ion implantation, the 2-step annealing method was adopted. After annealing, the were cleaved and etched with th Wright etchant. The morphology of cross section on samples was inspected by FESEM(field emission scanning electron microscopy). The morphology of unimplanted samples was rater rough than that of the implanted. Oxygen precipitation density observed by an optical microscope in lightly boron doped samples was about 3$\times10^6/cm^3$. However, in heavily boron doped samples, the density of oxygen precipitation was largest at $600^{\circ}C$ in 1st annealing, and decreased abruptly until $800^{\circ}C$, But it increased slightly at $1000^{\circ}C$ and was independent with the implantation.

• Journal of the Semiconductor & Display Technology
• /
• v.13 no.1
• /
• pp.63-66
• /
• 2014

ZnO is a wide bandgap (3.3 eV) semiconductor with high mobility and good optical transparency. However, off-current characteristics of ZnO thin-film transistor (TFT) need improvements. In this work we studied the variation in ZnO TFT current under different annealing conditions. Annealing usually modifies gas adsorption at grain boundaries of ZnO. When oxygen is adsorbed, electron density decreases due to strong electronegativity of the oxygen, and TFT current decreases as a result. Our experiments showed that current increased after vacuum annealing and decreased after air annealing. We explain that the change of off-current is caused by the desorption and adsorption of oxygen at the grain boundaries.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.12
• /
• pp.1003-1010
• /
• 2000

Thin films of vanadium oxide(VOx) have been deposited by r.f. magnetron sputtering from V$_2$O$\_$5/ target in gas mixture of argon and oxygen. Crystal structure, surface morphology, chemical composition, molecular structure and optical properites of films in-situ annealed in O$_2$ambient with various heat-treatment conditions are characterized through XRD, SEM, AES, RBS, RTIR and optical absorption measurements. The films annealed below 200$\^{C}$ are amorphous, and those annealed above 300$\^{C}$ are polycrystalline. The growth of grains and the transition of vanadium oxide into the higher oxide have been observed with increasing the annealing temperature and time. The increase of O/V ratio with increasing the annealing temperature and time is attributed to the diffusion of oxygen and the partial filling of oxygen vacancies. It is observed that the oxygen atoms located on the V-O plane of V$_2$O$\_$5/ layer participate more readily in the oxidation process. Also indirect and direct optical band gaps were increased with increasing the annealing temperature and time.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07b
• /
• pp.589-592
• /
• 2002

The $Sr_{0.7}Bi_{2.3}Ta_2O_9$(SBT) thin films are deposited on Pt-coated electrode(Pt/TiO2/SiO2/Si) using RF magnetron sputtering method. The structural and electric properties of SBT capacitors were influenced with annealing atmosphere. In the XRD pattern, the SBT thin films in all annealing atmosphere had (105) orientation. In the SEM images, Bi-layered perovskite phase was crystallized in all annealing atmosphere and grains largely grew in oxygen annealing atmosphere. The maximum remanent polarization and the coercive electric field in oxygen annealing atmosphere are $12.40{\mu}C/cm^2$ and 48kV/cm respectively. The dielectric constant and leakage current density annealing in oxygen atmosphere are 340 and $6.81{\times}10^{-10}A/cm^2$ respectively. The fatigue characteristics of SBT capacitors did not change up to $10^{10}$ switching cycles.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.54 no.3
• /
• pp.103-108
• /
• 2005

ZnO thin films on (001) sapphire substrates have been deposited by pulsed laser deposition(PLD) technique using an Nd:YAG laser with a wavelength of 266nm. Before post-annealing treatment in the oxygen ambient, the experiment of the deposition of ZnO thin films has been performed for substrate temperatures in the range of $300\~450^{\circ}C$ and oxygen gas flow rate of $100\~700\;sccm$. In order to investigate the effect of post-annealing treatment of ZnO thin films, films have been annealed at various temperatures after deposition. After post-annealing treatment in the oxygen ambient, the structural properties of ZnO thin films were characterized by X-ray diffraction(XRD), scanning electron microscopy(SEM) and the optical properties of the ZnO were characterized by photoluminescence(PL).