• Elastomers and Composites
• /
• v.51 no.4
• /
• pp.317-341
• /
• 2016

Polyamide (PA) is one of five engineering plastic materials which has good mechanical properties and competitive price compared to other engineering plastics and it has various applications including in the areas of automotives, electronics and aerospace industry. Even though PA market grows fast compared to other engineering plastics, it has few organized literatures regarding researches and applications. In this paper, we review overall background, characteristics, formulation, current market trends and technology development of PA resins and their composites.

• Journal of Korean Society of Water and Wastewater
• /
• v.19 no.3
• /
• pp.312-317
• /
• 2005

The 15 month pilot study was performed to investigate the effect of pretreatment by monochloramine ($NH_2Cl$) on the performance of RO membranes made of cellulose acetate (CA) and polyamide (PA). Both RO membranes experienced severe biological fouling without any pretreatment during the treatment of highly organic surface water in Florida, USA. Feed monochloramination at 5 mg/L significantly minimized productivity loss by effective control of biofouling. The CA membrane did not show any structural damages by monochloramine, while the PA membrane suffered from a gradual loss of membrane integrity by chlorine oxidation, which was characterized as an increase in productivity and a decrease in selectivity. The degradation of PA membrane increased with increasing monochloramine dose.

• Membrane Journal
• /
• v.24 no.4
• /
• pp.317-324
• /
• 2014

It is very well known that the conventional polyamide (PA) thin film composite (TFC) reverse osmosis (RO) membranes have excellent permselective properties, but their chlorine tolerance is not good enough. In this study, to improve such chlorine tolerance, microporous membranes containing hydrophilic functional groups such as -COOH were used as a support to prepare PA TFC RO membranes, employing the conventional interfacial polymerization method. Meta-phenylene diamine (MPD) and 2,6-diamine toluene (2,6-DAT) were used as diamine monomers and tri-mesoyl chloride (TMC) as an acid monomer. The membranes prepared were characterized using various instrumental analytical methods and permeation test set-up. The flux obtained from the membranes prepared so was more than $1.0m^3/m^2day$ at 800 psi of operating pressure, while the salt rejection was over 99.0%. The chlorine tolerance of them was also found to be better than that of the membrane prepared by using conventional polysulfone support without hydrophilic functional groups.

• Membrane Journal
• /
• v.18 no.4
• /
• pp.317-324
• /
• 2008

Polysulfone membranes were prepared via the phase inversion process. With propionic acid as a nonsolvent additive, polysulfone casting solutions were solidified in an isopropanol bath. Propionic acid (PA) worked as a thermodynamic enhancer for phase separation and as a rheological suppressor for kinetic hindrance. Morphology of the prepared membranes significantly varied with propionic acid content in the casting solution. The dense skin layer, which was identified in the membrane prepared without PA, almost disappeared in the membrane prepared trom PA 10wt%. With 30wt% PA, the membrane revealed the morphological gradient from a nodular skin structure to a sponge-like substructure, including the finger-like cavity. Water permeability increased with PA content, and polyethylene glycol rejection decreased with the nonsolvent content.

• Journal of Microbiology
• /
• v.39 no.4
• /
• pp.300-304
• /
• 2001

Epstein-Barr Virus(EBV)-transformed lymphoblastoid B cell lines, BLCL which expresse antigens, are potential antigen-presenting cells(APCs) for the induction of CTL in vitro. However transfection of BLCLs with subsequent selection by antibiotics is notoriously difficult because plating efficiencies of BLCLsare reported to be 1% or less. To generated stable transfectants of BLCLs we produced high titers of retroviruess encoding pp 65 antigen of human cytomegalovirus of foreign antigens and trans-duced them of BLCLs. The pp 65 gene was cloned into the retroviral vector pLXSN. The recombinant retroviral vector was transfected to ecotropic packaging cell line, CP&E86, and this polyclonal recom-binant retrovirus was transduced to PA317 that is amphotropic pakaging cell line. The titers of colned PA317 amphotropic retroviruses ranged from 5 to $\times$10$^{6}$ colony forming units (CFU)per ml (CFU/ml) We performed three rounds of consecutive transductions to BLCLs in order to improve the clon-ing effieiencies. The expression of recombinant HCMV-pp65 antigen was more than 20% after the final transduction. THe third-transduced BLCLs were easily selected in optimal concentration of G418. BLCLs expressing foreign antigens could be used as target cells for CTL assay and/or as APCs for induction of in vitro CTL responses specific for viral and tumor antigens.

• Journal of the Korean Applied Science and Technology
• /
• v.26 no.3
• /
• pp.317-327
• /
• 2009

In this study DMT(Dimethylterephthalate), NDC(Dimethyl-2, 6-Naphthalene Dicarboxylate) were used to synthesize polyester polyol which shows enhanced storage stability, improved flame retardancy, and good compressive strength. If DMT and NDC react respectively with DEG(Diethylene Glycol) which is kind of linear diol, the obtained polyester polyols tend to crystallize easily after the reaction. In case of DMT, PA(Phthalic Anhydride) which has asymmetric structure was introduced to retard the crystallization. In case of NDC, DPG(Dipropylene Glycol) which has an methyl side chain was introduced to prevent the crystallization. It was found that to introduce DPG was much more effective method to prevent the crystallization than PA. NDC and DMT were reacted together with DPG for various compositions of NDC:DMT(8:2, 6:4, 4:6 mol ratio). The obtained NDC-DMT-DPG based polyester polyol showed improved flame retardancy, and good compressive strength with increasing the content of NDC.

• Journal of the Korean Geotechnical Society
• /
• v.15 no.6
• /
• pp.307-317
• /
• 1999

The purpose of this study is to utilize conventional procedures for evaluation of liquefaction potential and to compare the results obtained by modified detailed method based on Korean earthquake magnitude (M=6.5). Liquefaction potential is assessed by comparing liquefaction strength of soil and cyclic shear stress generated in the soil layers during earthquakes. The cyclic shear stress is computed from the earthquake response analysis, and liquefaction strength of soil is evaluated by using results from cyclic triaxial tests. The cyclic triaxial tests are performed on many different conditions of sample ; relative densities(50%, 60%, and 70%), initial effective confining pressures (70kPa, 100kPa, and 150kPa), and fine contents(10%, 20%, and 30%). From the result of comparing the conventional procedure with the modified detailed method, it is found that the modified detailed method tends to evaluate larger safety factor against liquefaction in the weak sand site$(FS \leq1.5)$. Therefore in this case, it is suggested that liquefaction potential should be evaluated by using the modified detailed method based on cyclic triaxial tests. It is also found that in modified detailed method based on earthquake magnitude 6.5, critical depth where liquefaction can be generated is around 15m from the ground surface.

• Research in Plant Disease
• /
• v.18 no.4
• /
• pp.317-323
• /
• 2012

The study aims to identify the pathogenicity of Phytophthora. capsici isolates in major pepper-producing areas in Korea and the inherit genetic pattern of phytophthora blight resistance by inocula. With five kinds of testing materials including 'Kataguma (Sakata Korea)' peppers, a disease-susceptible material, '#308', a phytophthora blight resistance material, 'CM334', and their $F_1$ and $F_2$, respective isolates of P. capsici obtained from Icheon, Eumseong, Buan, Imsil and Yeongyang regions together with six kinds of peppers' inoculum including PA-159 (KACC No.40482) received from Korean Agricultural Culture Collection were used for inoculation. The disease-susceptible material '#308', the resistant material 'CM334' and the non-segregating generation of $F_1$ represented 4.94-5.00, 1.00-1.07, and 1.01-1.08 phytophthora blight incidence respectively in the group comparison by isolate. This result means that the phytophthora blight resistance was clearly distinguished among testing materials in the group comparison by P. capsici isolate. Moreover, $F_2$ segregating generation showed 1.79-2.31 phytophthora blight incidence which turned out to be identical in the group comparison by the six isolates of P. capsici isolate and with similarity between both the resistant and susceptible materials. Thus, the result proved that using the six isolates of P. capsici tested as inocula was suitable to investigate the phytophthora blight resistance. When it comes to group comparison of $F_2$ segregation generation, however, isolates were divided with PA-159 isolate being the center: a group consisting of isolates from Icheon, Buan, and Imsil and a group consisting of Yeongyang and Eumseong isolates with higher pathogenicity. The expected segregation ratio of the phytophthora blight resistance in $F_2$ generation by isolate was analyzed. PA-159 isolate showed 3:1 or 9:3:3:1, indicating that one to two genes were involved. On the other hand, results also proved that there is an interaction of genes since both Eumseong and Yeongyang isolates showed a segregation ratio of 11:5 while the Icheon isolate represented 12:3:1.

• Preventive Nutrition and Food Science
• /
• v.9 no.4
• /
• pp.317-323
• /
• 2004

Photostimulated Luminescence (PSL), Electron Spin Resonance (ESR) and Thermoluminescence (TL) analysis were conducted to detect irradiation treatment of imported whole and ground spices. The screening by PSL detected no irradiation treatment, except un the ground thyme and bay leaves which exhibited photon counts in the intermediate level. Irradiation of the two spices was detected after irradiating them at 1.0, 3.0, 5.0 and 10.0 kGy, and then subjecting them to PSL analysis, which resulted in the significantly low photons of non-irradiated spices compared to that at 1.0 kGy, indicating that the photon counts varied depending on the amount of inorganic mineral debris in the spices. To confirm a successful detection by using PSL, ESR and TL methods, some spices were selected, irradiated at 5.0 and 10.0 kGy, and subjected to the detection methods. PSL identified the irradiated spices except the cassia, which showed very weak PSL sensitivity, but was identified by ESR analysis. Also, the ESR and TL exhibited the typical signals induced by irradiation treatment and were able to successfully detect all of the irradiated spices. In addition, we found a positive correlation between the intensity of ESR and TL signals and irradiation doses.

• Natural Product Sciences
• /
• v.26 no.4
• /
• pp.317-325
• /
• 2020

A new dimer stilbene [Monalittorin (1)] and ten known compounds [engeletin (2), aurantiamide acetate (3), lupeol (4), friedelin (5), quercetin (6), tiliroside (7), rutoside (8), astragalin (9), isoquercitrin (10) and quercimeritroside (11)] have been isolated from the leaves of Monanthotaxis littoralis (Annonaceae). The structures of these compounds were established by interpretation of their data, mainly, HR-TOFESIMS, 1-D NMR (1H and 13C) and 2-D NMR (1H-1H COSY, HSQC, HMBC and NOESY) and by comparison with the literature. The evaluation of their antimicrobial activities against three bacteria (Staphylococcus aureus ATCC 25923, Escherichia coli S2 (1) and Pseudomonas aeruginosa PA01) and three fungal strains (Candida albicans ATCC10231, Candida tropicalis PK233 and Cryptococcus neoformans H99) using broth micro dilution method, showed the largest antimicrobial activities of EtOAc fraction and compounds 1, 5, 6, 8 and 11 (MIC = 8 - 64 ㎍/mL). In addition, EtOAc fraction presented synergistic effect with Vancomycin and fluconazole against the tested microorganisms.