• 한국세라믹학회지
• /
• 제23권4호
• /
• pp.85-89
• /
• 1986

Electrical conductivity have been measured as function of temperature in MgO.$P_2O_5$ glasses containing small amounts of water. Conduction was due to the contribution of $H^+$ and the mobility of protons in the glass increased linearly with increasing its concentration. The conductivity was pro-portional to the square of the proton concentration and the activation energy decreased linerly with increasing logarithm of the proton concentration, And $$\sigma$_0$ and $A_0$ was independent of the proton concentration but not on glass compositions.

• Journal of Photoscience
• /
• 제1권1호
• /
• pp.15-23
• /
• 1994

The absorption and fluorescence spectral properties of piroxicam (PRX) in the hydrogenbonding solvents show the most sensitive dependence on the concentration ranging from 8 x 10$^{_5}$ to 2 x10$^{_5}$ M. These are attributed to both the solvent-mediated ground-state intermolecular proton transfer (GSIerPT) leading to formation of the ground state anion and the excited-state intmmolecular proton transfer (ESIraPT). The concentration dependences of the time-resolved emission kinetics at both room temperature and 77 K have also been investigated. It is shown that in the excited state, the ESIraPT of PRX is the dominant process to form a keto tautomer at the high concentration, whereas at the low concentration the excited-state conformational change of the anion is an additional process leading to formation of a zwitterion. The ESI~PT of PRX in the hydrogenbonding solvent is coupled with the ultrafast excited-state solvent reorganization.

• 한국세라믹학회지
• /
• 제33권2호
• /
• pp.163-168
• /
• 1996

Measurements of proton adsorption density have been conducted in preparing alumina suspensions with aqueous solutions of HCL, HNO3, H2SO4 and H3PO4 And effects of anion acid concentration proton adsorption density and solid loading on the viscosity of the alumina suspensions have been investigated. Aqueous solutions of HCl. or HNO3 were suitable for the preparation of highly concentrated suspensions as the generation of surface charge on alumina particles was depressed by the specific adsorption of {{{{ {SO }`_{4 } ^{2- } }} and {{{{ { PO}`_{4 } ^{3- } }} Optimum conditions for maximizing solid loading were dependent upon proton adsorption density and acid concentration.

• 한국세라믹학회지
• /
• 제53권5호
• /
• pp.521-528
• /
• 2016

Kinetic Monte Carlo (KMC) and graph searches show that proton conduction limiting barriers and trajectories in $BaZr_{0.875}Y_{0.125}O_3$ are affected by the presence of other protons. At 1000 K, KMC limiting conduction barriers increase from 0.39 eV to 0.45 eV as the proton number is increased. The proton-proton radial distribution begins to rise at $2{\AA}$ and peaks at $4{\AA}$, which is half the distance expected, based on the proton concentration. Density functional theory (DFT) calculations find proton/proton distances of 2.60 and $2.16{\AA}$ in the lowest energy two-proton configurations. A simple average of the limiting barriers for 7-10 step periodic long range paths found via graph theory at 1100 K shows an increase in activation barrier from 0.32 eV to 0.37 eV when a proton is added. Both KMC and graph theory show that protons can affect each other's pathways and raise the overall conduction barriers.

• 대한방사선기술학회지:방사선기술과학
• /
• 제44권4호
• /
• pp.315-325
• /
• 2021

The purpose of this study is to investigate the changes in lipid proton (LP) composition according to the induced obese fatty liver and to use it as basic data for treatment and diagnosis of fatty liver in the future. The phantom study was conducted to identify differences between STEAM and PRESS Pulse sequences in LP concentration. A high-fat diet (60%) was administered to eight Sprague-Dawley rats to induce obesity and fatty liver disease. Baseline magnetic resonance imaging /spectroscopy data were obtained prior to the introduction of high-fat diet, and data acquisition experiments were performed after eight weeks using procedures identical to those used for baseline studies. The six lipid proton metabolites were calculated using LCModel software. The correlation between the fat percentage and each LP, revealed that the methylene protons at 1.3 ppm showed the highest positive correlation. The α-methylene protons to carboxyl and diallylic protons showed negative correlation with fat percentage. The methylene proton showed the highest increase in the LP; however, it constituted only 71.86% of the total LP concentration. The methylene proton plays a leading role in fat accumulation in liver parenchyma.

• 한국세라믹학회지
• /
• 제53권3호
• /
• pp.301-305
• /
• 2016

We investigate proton conduction in a nonstoichiometric ${\Sigma}3$ $BaZrO_3$ (210)[001] tilt grain boundary using density functional theory (DFT). We employ the space charge layer (SCL) and structural disorder (SD) models with the introduction of protons and oxygen vacancies into the system. The segregation energies of proton and oxygen vacancy are determined as -0.70 and -0.54 eV, respectively. Based on this data, we obtain a Schottky barrier height of 0.52 V and defect concentrations at 600K, in agreement with the reported experimental values. We calculate the energy barrier for proton migration across the grain boundary core as 0.61 eV, from which we derive proton mobility. We also obtain the proton conductivity from the knowledge of proton concentration and mobility. We find that the calculated conductivity of the nonstoichiometric grain boundary is similar to those of the stoichiometric ones in the literature.

• 대한화학회지
• /
• 제38권2호
• /
• pp.129-135
• /
• 1994

Acyclic polyether dicarboxylic acid는 액체막계에서 금속이온의 운반체로 연구되었다. 수소이온이 이온화될 수 있는 리간드는 금속이온의 이동에 수소이온이 반대방향으로 이동된다. 이와 같은 리간드는 pH를 변화시키면 효과적으로 금속이온을 분리할 수 있고 농축시킬 수도 있다. 금속이온의 이동은 source phase의 염기의 농도와 receiving phase의 산의 농도를 증가시키면 증가된다. Acyclic polyether dicarboxylic acids를 운반체로 사용한 경쟁이동반응에서 칼슘이온을 선택적으로 분리할 가능성이 있다.

• 한국의학물리학회지:의학물리
• /
• 제12권1호
• /
• pp.31-39
• /
• 2001

핵자기공명분광학(NMR Spectroscopy)을 이용해서 우리는 생물체의 조직안에 있는 각종 대사물질들을 측정할 수 있게 되었으며, 이것은 또 지금까지 알려진 여러 방법 중에서 생물체내의 신진대사 물질이나 생화학적인 변화를 비침습적(noninvasive)으로 알아낼 수 있는 유일한 방법에 속한다. 양성자 핵자기공명분광학은 최근들어 사람이나 흑은 동물뇌의 생화학적인 특성을 연구하는데 많이 사용되어오고 있다. 핵자기공명영상은 주로 물분자에 있는 양성자의 밀도와 그들의 이완현상(relaxation phenomena)을 측정하여 영상화하지만 핵자기공명분광학은 생체조직내의 신진대사에 관한 생화학적인 정보를 제공한다. 많은 경우에 있어서 핵자기공명분광학은 CT나 MRI 영상에서는 발견할 수 없는 정보를 제공함으로써 특정질병의 진단에 사용될 수 있으며, 따라서 환자들의 질병상태를 효과적으로 진단하는데 쓰여질 수 있다. 따라서 본 연구에서는 사람의 뇌에서 수소 핵자기공명분광학을 이용하여 대사물질들의 농도를 정량화하는 방법을 시도하였다. 이를 위해 펀텀을 이용하여 대사물질들 각각의 스팩트럼을 구했고, 성인 남녀 16명을 대상으로 insula gray matter 부위의 대사물질들의 농도를 측정하였다. 그리고 이 값들은 다른 연구자들에 의해 밝혀진 값들과 매우 근사한 값을 제공하였다.

• 한국세라믹학회지
• /
• 제51권4호
• /
• pp.248-259
• /
• 2014

Acceptor-doped cerium pyrophosphates have shown significant proton conductivity of > $10^{-2}Scm^{-1}$ in the range of $100-300^{\circ}C$ and are considered promising candidates for use as electrolytes in proton-conducting, ceramic electrolyte fuel cells (PCFCs). But, cerium pyrophosphates themselves do not have structural protons, and protons incorporate into their material bulk only as impurities on exposure to a hydrogen-containing atmosphere. However, proton incorporation and proton conduction in these materials are expected to be affected by factors such as the nature (ionic size and charge) and concentration of the aliovalent dopant, processing history (synthesis route and microstructure), and the presence of residual phosphorous phosphate ($P_mO_n$) phases. An exact understanding of these aspects has not yet been achieved, leading to large differences in the magnitude of proton conductivity of cerium pyrophosphates reported in various studies. Herein, we systematically address some of these aspects, and present an overview of factors affecting proton conductivity inacceptor-doped $CeP_2O_7$.

• Journal of Electrochemical Science and Technology
• /
• 제9권2호
• /
• pp.99-108
• /
• 2018

Proton exchange membrane (PEM) water electrolysis systems offer several advantages over traditional technologies including higher energy efficiency, higher production rates, and more compact design. In this study, all the experiments were performed with a self-designed PEM electrolyser operated at 1 atm and $25^{\circ}C$. Two types of electrolyte were used: (i) potassium hydroxide (KOH), and (ii) sulfuric acid ($H_2SO_4$). In the experiments, the voltage, current, and time were measured. The concentration of the electrolyte significantly affected the electrolyser performance. Overall the best case was with 15 wt% $H_2SO_4$ at the anode channel and 20 wt% at the cathode channel with. In addition, increasing the difference in concentration of the sulfuric acid had an effect on the diffusion. The diffusion flux became larger when the difference in concentration became larger, increasing electrolyser efficiency without the addition of extra energy.