• 제목/요약/키워드: Radial Velocity

검색결과 608건 처리시간 0.03초

BF 방법을 이용한 EX Leo의 시선속도 추정 (RADIAL VELOCITY ESTIMATION OF EX Leo USING BF ALGORITHM)

  • 강동일;박홍서;한인우;김강민
    • 천문학논총
    • /
    • 제22권2호
    • /
    • pp.35-41
    • /
    • 2007
  • We present the result of radial velocity observation of a W UMa type binary star EX Leo. We observed the star on February 16, 2003, using Long-Slit spectrograph of BOAO(Bohyunsan Optical Astronomical Observatory). Since the spectral lines are broad due to its fast rotation, it is difficult to distinguish two radial velocities from cross correlation function. Instead of cross correlation function, we used broadening function to develop our own code which estimate the radial velocity of the broadened line spectra. With our own code, radial velocities of primary and secondary stars are derived simultaneously. From the radial velocity curve fit, we obtained $K_1=50.24{\pm}8.29km/s$ and $K_2=254.05{\pm}20.984km/s$ respectively.

시선속도 변환과 불확도 전파에 관한 연구 (A Study on Radial Velocity Transformation and Uncertainty Propagation)

  • 류충호;황규환;장용식;김문기;최익환
    • 한국군사과학기술학회지
    • /
    • 제16권2호
    • /
    • pp.199-206
    • /
    • 2013
  • In general, radial velocity of a target can be obtained by acquiring doppler frequency shift in case of a doppler radar, or can be obtained by acquiring range rate in case of a pulse radar. Then radial velocity can be converted to tangential velocity using aspect angle or position variation per unit time. These two ways have the same meaning in physically, but result in different uncertainty finally. In this paper, it is described not only the two transformation procedures to calculate tangential velocity from radar measurement data, but also the result of combined uncertainty comparison between these two procedures.

CW 도플러 레이더의 시각 분해능과 시선 속도 정확도의 관계 (The Relation of Time Resolution and Radial Velocity Accuracy of a CW Doppler Radar)

  • 류충호;장용식;최익환
    • 한국전자파학회논문지
    • /
    • 제23권7호
    • /
    • pp.815-821
    • /
    • 2012
  • CW 도플러 레이더는 움직이는 물체의 속도에 비례하는 도플러 주파수 편이를 검출함으로써 속도를 계측한다. 도플러 주파수 편이를 검출하기 위해서 시간영역에서 획득한 수신 신호를 주파수 영역으로 변환하기 위한 FFT(Fast Fourier Transform)를 수행한다. 이때 FFT 개수에 의해 도플러 레이더의 시각 분해능이 달라진다. 또한, FFT 개수는 수신 신호의 신호 대 잡음비에도 영향을 미치므로, 결국 시선 속도의 정확도와도 관련 있다. 따라서 본 논문에서는 FFT 개수에 따라 달라지는 시각 분해능과 시선 속도 정확도의 관계를 제시하였다.

식쌍성 DO Cas의 광도곡선과 시선속도곡선의 분석 (AN ANALYSIS OF THE LIGHT AND RADIAL VELOCITY CURVES OF DO CAS)

  • 안영숙;김호일;이우백
    • Journal of Astronomy and Space Sciences
    • /
    • 제17권2호
    • /
    • pp.181-188
    • /
    • 2000
  • DO Cas는 최근 Shaw (1990)에 의해 근접촉쌍성으로 분류된 공전주기 0.68일의 식쌍성이다. 짧은 공전주기를 가짐에도 불구하고 Mannino (1958) 이후 분광관측에 의한 시선속도 곡선이 발표되지 않고 있다. 그런데 Hill (1991)은 Mannino의 시선속도곡선이 오류를 포함하고 있는 것으 로 보인다고 하였다. 이 연구에서 우리는 Asiago 천문대에 의뢰하여 Mannino가 분석한 분광관측 사진건판을 입수하여 PDS로 측정하여 IRAP로 재분석하였다. 이 시선속도곡선과 1998년에 관측한 BVR 광도곡선을 Wilson-Devinney 방법으로 동시에 분석하였다. 그 결과 DO Cas가 접촉 또는 주성이 로쉬엽을 채우고 있는 접촉에 매우 가까운 준분리형 쌍성임을 확인하였으며 또한 이 계의 절대량을 구하였다.

  • PDF

선회실속하의 원심 임펠러 출구 유동 특성 (Flow Characteristics of Centrifugal Impeller Exit under Rotating Stall)

  • 신유환;김광호
    • 한국유체기계학회 논문집
    • /
    • 제2권2호
    • /
    • pp.5-12
    • /
    • 1999
  • This study presents the measured unsteady flctuation of impeller discharge flow for a centrifugal compressor in an unstable operating region. The characteristics of the blade-to-blade flow at rotating stall onset were investigated by measuring unsteady velocity fluctuations at several different diffuser axial distances using a hot wire anemometer. The flow characteristics in terms of the radial and tangential velocity components and the flow angle distribution at the impeller exit were analyzed using phase-locked ensemble averaging techniques. As a result, increase or decrease of the radial velocity component during the rotating stall is dominated by that of the suction side. The radial velocity distributions show the opposite trends in the regions where the radial velocity during rotating stall onset increases and decreases.

  • PDF

선회실속하의 원심 임펠러 출구 유동 특성 (Flow Characteristics of centrifugal Impeller Exit Under Rotating Stall)

  • 신유환;김광호
    • 유체기계공업학회:학술대회논문집
    • /
    • 유체기계공업학회 1998년도 유체기계 연구개발 발표회 논문집
    • /
    • pp.129-134
    • /
    • 1998
  • This study presents the measured unsteady fluctuation of impeller discharge flow for a centrifugal compressor in unstable operating region. The characteristics of the blade-to-blade flow at rotating stall onset were investigated by measuring unsteady velocity fluctuations at several different diffuser axial distances using a hot wire anemometer. The flow characteristics in terms of the radial and tangential velocity components and the flow angle distribution at the impeller exit were analyzed using phase-locked ensemble averaging techniques. As a result, increase or decrease of the radial velocity component during the rotating stall is dominated by that on the suction side. The radial velocity distributions show the opposite trends in the regions where the radial velocity during rotating stall onset increases and decreases.

  • PDF

Peripheral Blood Flow Velocity and Peripheral Pulse Wave Velocity Measured Using a Clip-type Pulsimeter Equipped with a Permanent Magnet and a Hall Device

  • Kim, Keun-Ho;Lee, Sang-Suk
    • Journal of Magnetics
    • /
    • 제20권1호
    • /
    • pp.47-51
    • /
    • 2015
  • We measured radial arterial pulse signals using a prototype of a clip-type pulsimeter equipped with a permanent magnet and a Hall device, which produced signals through a voltage-detecting circuit. The systolic peak time and the reflective peak time for a temporally pulsed signal were analyzed for an arbitrary pulse wave at one position of a small permanent magnet. The measured value of the peripheral pulse wave velocity was about 1.25-1.52 m/s, demonstrating the accuracy of this new method. To measure the peripheral blood flow velocity, we simultaneously connected the radial artery pulsimeter to a photoplethysmography meter. The average value of the peripheral blood flow velocity was about 0.27-0.50 m/s.

분사칼럼식 직접접촉 열교환기의 최적 모델링을 위한 연구 (On the Optimum Modelization for a Spray Column Direct Contact Heat Exchanger)

  • 윤석만;강용혁;김종보
    • 설비공학논문집
    • /
    • 제3권1호
    • /
    • pp.1-10
    • /
    • 1991
  • The purpose of this study is to lay groundwork for a complete analysis of two component flow by analyzing a single component flow made of continuous fluid without dispersed phase. In order to achieve uniform velocity distributions which are desirable in designing an optimum spray column direct contact heat exchanger, the influence of injection nozzle orientation has been investigated for axial and radial injections. The results that radial injection ensures more uniform velocity distributions compared to the axial case. The flow characteristics in a spray column have been investigated with various L/D values and inlet velocities, the most uniform internal velocity distributions have been obtained for the case of L/D=10 and 0.1m/sec. In the present investigation, it is shown that radial injection method for the continuous flow is advantageous in obtaining desirable uniform velocity distributions in a spray column. It is also found that as the value of L/D increases and the inlet velocity decreases, the flow improves to be better uniform velocity distributions.

  • PDF

연기선단의 전파속도 모델에 관한 연구 (Modeling of the Velocity of the Ceiling Jet Front)

  • 김명배;한용식
    • 한국화재소방학회논문지
    • /
    • 제15권2호
    • /
    • pp.91-95
    • /
    • 2001
  • 복도나 터널과 같이 특정한 방향성을 가지는 공간에서는 천장아래에 형성되는 연기선단의 성상해석이 학술적인 면에서나 실용적인 면에서도 매우 중요하다. 본 연구는 2차원 축대칭 천장제트 선단의 전파속도를 모델화하기 위하여 상사해석 및 차원해석을 수행하였다. 실험에서는 질소와 헬륨의 혼합가스를 원형 천장에 노즐로 분출시켜 화재로 인한 연기를 구현하였으며 속도측정을 위하여 레이저와 고속카메라를 이용한 가시화 기법이 사용되었다.

  • PDF

THE VELOCITY INHOMOGENEITY IN THE COMA CLUSTER OF GALAXIES

  • KIM KWANG TAE
    • 천문학회지
    • /
    • 제28권1호
    • /
    • pp.15-30
    • /
    • 1995
  • A velocity inhomogeneity, which is defined as a regional preponderence of either radial or tangential orbits, is searched with a new technique for the Coma cluster of galaxies. It is found within $\~2h^{-1}$ Mpc from the cluster center that the Coma shows conspicuous inhomogeneities in velocity and that the inhomogeneities are real at a $99\%$ level of confidence. Even in the central region (7' - 30' from the center), zones that are dominated by radial and tangential orbits are distinguishable. Defining the cluster's 'equator' as the direction defined by the Coma-A1367 supercluster, tangential orbits dominate the 'polar' zones in the central region. Galaxies that are located in 30'-100' also inhomogeneous in velocity in that the 'polar' zones are mostly radial while the rest is nearly homogeneous. These results indicate that the Coma galaxies are exceedingly more radial in orbit, implying that merging or infalls are either still going on or an earlier virialization is likely to have occurred preferentially near the 'equator'. Incorporating the velocity inhomogeneity into mass estimators, the most appropriate mass is turned out to be $0.4\times10^{15}h^{-1}M_\bigodot(R\;\leq\;0.6h^{-1} Mpc),\;and\;1.0\times10^{15}h^{-1} M_\bigodot(R\;\leq\;2.1h^{-1}Mpc)$. The corresponding mass to blue light ratio on the average is $\~$300h. These estimates are consistent with Merritt (1987) and Hughes (1989) and the MILE is seemed to favour the mass-follows-light models than the uniform spread of dark matter throughout the cluster.

  • PDF