• Journal of the Korean Ceramic Society
• /
• v.52 no.1
• /
• pp.28-32
• /
• 2015

In this article, the influence of a hydrolyzed wheat protein retarder on the hydration process, ion concentration in liquid phase, degree of supersaturation, and crystal morphology of plaster was investigated. Furthermore, the retarding mechanism and the strength loss of gypsum were also studied by scanning electron microscopy (SEM). The results indicate that the use of the hydrolyzed wheat protein retarder for plaster achieved a better retarding effect and lower strength loss. The combination of gypsum plaster with the retarder not only decreased the plaster's early hydration rate and prolonged its setting time efficiently, but also militated against the crystal morphology of dihydrate gypsum. For example, the crystal dimensions changed little, but the proportion of needle-shaped crystals decreased. Combination with calcium ions on the surface of dihydrate gypsum crystal nuclei may form a chemisorbed layer, reduce the surface energy of the crystal nuclei, and inhibit the growth of the crystal nuclei of dihydrate gypsum. Consequently, the hydration process of building gypsum becomes greatly extended and is slowed down significantly.

• Journal of the Korean Ceramic Society
• /
• v.33 no.3
• /
• pp.307-312
• /
• 1996

In following addition of 0.3, -0.6, 0.8, 1.0 and 5 weight percent MgSiF66H2O studies have been made of the setting and hardening characteristics of ordinary portland cement. MgSiF66H2O retarded the setting time of ordinary portland cement and extended the induction pariod of the hydration. In ordinary portland cement the setting characteristics were drastically altered especially at high MgSiF66H2O contents. Evidence was also obtained by the formation of a KSiF6 which was very fine particle. The results wee as follows. 1. Slump was slightly decreased when MgSiF66H2O added. 2. Setting time was retarded depending on the amount of retarding agent 2 to 8 hours 3. Compressive strength was almost same or some increased in comparision with opc. 4. When MgSiF66H2O was added to cement paste K2SiF6 were formed It was fine-sized distributed uniformly in cement grain and caused retardation of cement setting.

• Textile Coloration and Finishing
• /
• v.32 no.3
• /
• pp.150-157
• /
• 2020

Hexachloro-cyclophosphazene(HCCP), a formaldehyde-free flame retardant (FR), was steam-cured with triethanol amine(TEA) to impart durable flame-retardancy to cotton fabrics. While the HCCP treatment alone showed very limited resistance to repeated laundering cycles, the addition of TEA substantially improved the laundering durability of the FR cotton up to twenty laundering cycles. The extended washing resistance was accomplished by the increased nucleophilic substitution of unreacted P-Cl groups in HCCP by the TEA resulting in the more densely crosslinked FR networks. With increasing molar ratio of TEA to the HCCP up to 2, the flame retarding effectivity and the synergistic effectiveness improved to 2.8 and 1.8 respectively. TGA and microscale combustion calorimetry verified the pyrolysis and combustion behaviors of the FR-cotton, which showed lower maximum pyrolysis and combustion temperatures together with substantially decreased peak pyrolysis and heat release rate, synergistically yielding larger amounts of carbonaceous chars. The formaldehyde-free HCCP and TEA can be a durable FR finishing agents for cotton fabrics acting through a solid-phase flame-retarding mechanism.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.78-78
• /
• 2012

In this presentation I will review the expanding thermal plasma chemical vapour deposition (ETP-CVD) technology, a deposition technology capable of reaching ultrahigh deposition rates. High rate deposition of a-Si:H, ${\mu}c$-Si:H, a-SiNx:H and silicon nanocrystals will be discussed and their various applications, mainly for photovoltaic applications demonstrated. An important aspect over the years has been the fundamental investigation of the growth mechanism of these films. The various in situ (plasma) and thin film diagnostics, such as Langmuir probes, retarding field analyzer, (appearance potential) mass spectrometry and cavity ring absorption spectroscopy, spectroscopic ellipsometry to name a few, which were successfully applied to measure radical and ion density, their temperature and kinetic energy and their reactivity with the growth surface. The insights gained in the growth mechanism provided routes to novel applications of the ETP-CVD technology, such as the ultrahigh high growth rate of silicon nanorystals and surface passivation of c-Si surfaces.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2009.05a
• /
• pp.221-222
• /
• 2009

The results showed that the addition of VAE polymer strongly reduces the $Ca(OH)_2$ formation, being this result attributed to reduce degree of cement hydration caused by different ion elution amount of polymer modified cement pastes and interaction between acetate anion from the partial hydrolysis of co-polymer and Ca$^{2+}$ion from OPC hydration.

• Journal of the Korean Ceramic Society
• /
• v.34 no.2
• /
• pp.163-170
• /
• 1997

The retarding effects of MgSiF6.6H2O on the hydration of portland cement were studied. The setting time, flow value and compressive strength of mortar were measured and the mechanism of retardation was also studied by ion concentration in solution, SEM, BET, and X-ray diffraction. The results are as follows ; 1. Setting time was delayed by the addition of MgSiF6.6H2O. 2. The flow value of mortar decreases depending upon the amount of MgSiF6.6H2O. 3. The compressive strength was almost same or some increase on 28 days hydration. 4. The main retardation mechanism of MgSiF6 on the hydration of portland cement may be explained by the following hypothesis. MgSiF6 depressing the Ca++ and K+ ion concentration of cement paste solution be-cause of the recrystalization of K2SiF6 and CaF2 phase. The new products of K2SiF6 and CaF2 deposit on the surface of unhydrated cement powder and harzard the mass transfer through these layer. The low con-centration of Ca++, K+ ion in solution was decreasing the hydration rate of portland cement.

• Journal of the Korean Ceramic Society
• /
• v.31 no.10
• /
• pp.1107-1114
• /
• 1994

Although various theories have been presented on the mechanism of setting retardation of plaster in addition to organic admixtures. The purpose of this paper is that Hydration studies of plaster of paris in the presence of carboxylic acids under alkalinity are examined in the coordination chemistry. Setting of plaster of paris is retarded by the addition of carboxylic acids except oxalic acid. And setting of plaster of paris contained 5 wt% of Ca(OH)2 is also retarded by the addition of above-mentioned carboxylic acids. The degree of retarding effect under alkalinity is found to be a function of the number of the functional group and the length of carbon chain of carboxyl acids. These reasons are attributed to the soluble complex formation, that is calcium complex formation between calcium ion and carboxylic acids. The author's proposal was confirmed by the results of electrical conductivity measurement. The formation of calcium complex was surpported by IR spectra.

• Journal of the Korean Ceramic Society
• /
• v.41 no.12 s.271
• /
• pp.907-914
• /
• 2004

The nitridation mechanism of Si by SHS at $Si-NaCl-NH_{4}Cl-NaN_3$ system was investigated in this work. It was revealed that NaCl as a diluent was helpful to the perfect nitridation reaction by retarding the growth of Si particle resulted from the melting of Si at the initial stage of the nitridation reaction. And $NH_{4}Cl\;and\;NaN_3$ formed NaCl through decomposition and combination, and the preheating of pellet was helpful to the nitridation reaction in this process. The main nitridation mechanism of this system was liquid-gas reaction. The optimum porosity of the pellet for the nitridation of ${\alpha}-Si_{3}N_4$ was $67-69\%$.

• Applied Microscopy
• /
• v.45 no.3
• /
• pp.177-182
• /
• 2015

The boiler tubes of X20CrMoV12.1 used in fossil-fired power plants were obtained and analyzed for the effect of water treatment on the steam corrosion-induced oxide scale in an effort to better understand the oxide formation mechanism, as well as pertinent method of maintenance and lifetime extension. The specimens were analyzed using various microscopy and microanalysis techniques, with focuses on the effect of water treatment on the characters of scale. X-ray diffraction analysis showed that the scales of specimens were composed of hematite ($Fe_2O_3$), magnetite ($Fe_3O_4$), and chromite ($FeCr_2O_4$). Electron backscatter diffraction analysis showed that the oxides were present in the following order on the matrix: outer $Fe_2O_3$, intermediate $Fe_3O_4$, and inner $FeCr_2O_4$. After all volatile treatment or oxygenated treatment, a dense protective $Fe_2O_3$ layer was formed on the $Fe_3O_4$ layer of the specimen, retarding further progression of corrosion.

• Textile Coloration and Finishing
• /
• v.34 no.1
• /
• pp.1-9
• /
• 2022

The durable FR treatments such Pyrovatex and Proban have been used for cotton fibers, while the finishes involve toxic ammonia or formaldehyde release during finishing process or finished products. In this study, ecofriendly flame-retardant treatment of cotton fabrics was carried out using UV-curable formulations of Vinyl bisphosphonic acid (VBPA), Acrylaminide and Triacryloylhexahydro-1,3,5-triazine, as a monomer, a comonomer and a cross-linking agent respectively, which can introduce a cross-linked copolymer networks. With an optimal finish formulation, the flame retardancy of LOI 29.8 was maintained even after 10 laundering cycles. In TGA analysis, the DTGA peak decreased from 389℃ to 252℃ and the amount of char yield increased from 6.1% to 46.1% compared to the untreated cotton. In addition, MCC analysis showed that Peak HR and THR decreased by 59.4% and 69.2% respectively, compared to the untreated cotton. The pyrolysis and combustion behaviors of the FR-treated cotton implied a condensed-phase flame-retarding mechanism.