• Wind and Structures
• /
• v.34 no.4
• /
• pp.355-369
• /
• 2022

Section model test, as the most commonly used method to evaluate the aerostatic and aeroelastic performances of long-span bridges, may be carried out under different conditions of incoming wind speed, geometric scale and wind tunnel facilities, which may lead to potential Reynolds number (Re) effect, model scaling effect and wind tunnel scale effect, respectively. The Re effect and scale effect on aerostatic force coefficients and aeroelastic characteristics of streamlined bridge decks were investigated via 1:100 and 1:60 scale section model tests. The influence of auxiliary facilities was further investigated by comparative tests between a bare deck section and the deck section with auxiliary facilities. The force measurement results over a Re region from about 1×10⁵ to 4×10⁵ indicate that the drag coefficients of both deck sections show obvious Re effect, while the pitching moment coefficients have weak Re dependence. The lift coefficients of the smaller scale models have more significant Re effect. Comparative tests of different scale models under the same Re number indicate that the static force coefficients have obvious scale effect, which is even more prominent than the Re effect. Additionally, the scale effect induced by lower model length to wind tunnel height ratio may produce static force coefficients with smaller absolute values, which may be less conservative for structural design. The results with respect to flutter stability indicate that the aerodynamic-damping-related flutter derivatives 𝘈^*₂ and 𝐴^*₁𝐻^*₃ have opposite scale effect, which makes the overall scale effect on critical flutter wind speed greatly weakened. The most significant scale effect on critical flutter wind speed occurs at +3° wind angle of attack, which makes the small-scale section models give conservative predictions.

• New & Renewable Energy
• /
• v.3 no.3
• /
• pp.54-62
• /
• 2007

The present paper describes the scale effect correction methods for scaled NREL Phase VI wind turbines by using CFD[computational fluid dynamics). For the corrections of wind turbine scale effect, various researches on the helicopter rotor scale effect were investigated and the feasibility study of the methods was performed to correct wind turbine scale effect. The present paper also introduces scale effect correction methods based on two dimensional lift slope. In order to test the present method, performance analyses of NREL Phase VI wind turbines under various scale conditions were carried out and new correction method was applied. Granting that the new correction method is valid only above Reynolds No. 100,000, it showed reasonable agreement between model and full scale wind turbines in the linear torque region.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.11a
• /
• pp.241-244
• /
• 2006

The present paper describes the scale effect correction method for wind turbine by using CFD(computational fluid dynamics). For the correct ions of wind turbine scale effect, various researches on the helicopter rotor scale effect were Investigated and feasibility study of methods was performed to correct wind turbine scale effect The present paper also introduces new scale effect correction method based on two dimensional lift slope modification. In order to test the Present method, performance analyses of NREL Phase VI wind turbines under various scale conditions were carried out by using CFD. The present method showed reasonable results when applied to NREL Phase VI wind turbine.

• Journal of Korean Society of Rural Planning
• /
• v.29 no.1
• /
• pp.11-17
• /
• 2023

In this study, the effect of orchard expansion, structural improvement, and potential demand of the orchard scale-up project implemented since 2004 to strengthen the competitiveness of orchard farmers was examined. The results of the analysis are summarized as follows. First, looking at the effect of scale-up by checking the standard income data of the Rural Development Administration, it was possible to confirm the effect of scale-up in that the income per unit area increases as the scale increases. Second, through the scale-up project, the effect of structural improvement in transferring the orchards of the aged farm households to the younger farm households was confirmed to be 13 years old on average in the case of a sale business and 16 years old in the case of a lease business. Third, it was found that income increased at a statistically significant level after participating in the orchard scale-up project for major fruit crops such as apples, pears, and peaches. Fourth, it was found that age and cultivated area had a statistical effect on the probability of participating in the orchard scale-up project for farmers who did not participate in the project. The potential business demand using the estimated results was found to be between 25,203 and 37,089.

• Proceedings of the Korean Nuclear Society Conference
• /
• 2005.05a
• /
• pp.693-694
• /
• 2005

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.12 no.1
• /
• pp.569-577
• /
• 2020

Based on laboratory experiments and numerical simulations, the scale effect of Internal Solitary Wave (ISW) loads on spar platforms is investigated. First, the waveforms, loads, and torques on the spar model at a laboratory obtained by the experiments and simulations agree well with each other. Then, a prototype spar platform is simulated numerically to elucidate the scale effect. The scale effect for the horizontal forces is significant owing to the viscosity effect, whereas it is insignificant and can be neglected for the vertical forces. From the similarity point of view, the Froude number was the same for the scaled model and its prototype, while the Reynolds number increased significantly. The results show that the Morison equation with the same set of drag and inertia coefficients is not applicable to estimate the ISW loads for both the prototype and laboratory scale model. The coefficients should be modified to account for the scale effect. In conclusion, the dimensionless vertical forces on experimental models can be applied to the prototype, but the dimensionless horizontal forces of the experimental model are larger than those of the prototype, which will lead to overestimation of the horizontal force of the prototype if direct conversion is implemented.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.1
• /
• pp.131-139
• /
• 2004

When calculating bearing capacity and settlement of actual foundation from plate test result fur design and construction of shallow foundation, scale effect should be considered. But, adequate guide and test result of scale effect were not prepared yet in Korea. So, to analyze the relations of bearing capacity and settlement as the difference of loading plate sizes, model test and field loading test were performed with different loading plate on weathered-granite layer. Model tests were conducted with water content, compaction number, saturated unit weight and plate size(Dl5, 25cm) in soil-box$(2,000\times 2,000\times 1,000mm)$ formed soil layer. Field loading tests were carried out with diameters of loading plate$(D15, 25, 30, 40, 75\times 75, 140\times 210cm)$ on the same soil condition. Finally, we presented the prediction formula of bearing and settlement for computating scale offset in design of shallow foundation through result analysis of load test and numerical simulation on weathered soil and rock.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2003.11a
• /
• pp.156-161
• /
• 2003

Mechanical behavior of rock joints usually can be characterized by small-scale laboratory shear tests due to economical and technical limitations, but their applicability to the behaviour of rock mass has been always questioned by a number of researchers because of scale effect. Though there have been several researches regarding the scale effect, it has been a controversial problem how to apply the result of small-scale laboratory shear test directly to field design from different conclusions among researchers. In order to grasp the trend of scale effect of shear behavior, a series of direct shear tests on replicas of natural rock joint surfaces made of gypsum cement with different size and roughness were conducted and analyzed. Result showed that as the size of the specimen increased, average peak shear displacement increased, but average shear stiffness and average peak dilation angle decreased. As for the dependency of scale on shear strength, the degree of scale effect was dependent on normal stress and roughness of rock joint. For the condition of low normal stress and high roughness, decrease of average peak shear strength with increasing size of joint was evident.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2002.10a
• /
• pp.350-357
• /
• 2002

The scale effect should be considered to determine the bearing capacity and settlement of footings from Plate-Load Test, because of the size difference between a footing and a loading plate. To analyze characteristics of bearing capacity and settlement according to the difference of loading plate sizes, model tests were peformed with four different sizes of square plate, which is B=10, 15, 20 and 25cm respectively, on five different kinds of subsoil, which is pure sand(100:0), sand-clay mixed soil(75:25, 50:50, 25:75), and pure clay(0:100). Based on the analyzed results, this paper also proposed a method of bearing capacity and settlement determination, where scale effect is considered depending on the mixing ratio of sand and clay. Applying the formular proposed in this research to field problems, it is expected that evaluation of bearing capacity and settlement of footings can be more reliable and more economic construction can be achieved.

• Journal of Acupuncture Research
• /
• v.25 no.4
• /
• pp.141-148
• /
• 2008

Objectives : The purpose of this study is to report the effect of acupotomy for patients with shoulder disease. Methods : We treated Five patients who have shoulder disease with acupotomy. To check the effect and satisfaction of acupotomy we used visual analog scale(VAS) and Five-point Likert scale. At the same time, we measured Change of shoulder range of motion(ROM). Results : After treatment pain were improved, VAS score decreased significantly to 2.5. The Likert scale point were checked 4.4, the patients were satisfied with the effect of acupotomy. Conclusions : This study shows acupotomy has useful effect on shoulder disease. An acupotomy is an alternative effective treatment modality for shoulder disease.