• Wind and Structures
• /
• 제34권4호
• /
• pp.355-369
• /
• 2022

Section model test, as the most commonly used method to evaluate the aerostatic and aeroelastic performances of long-span bridges, may be carried out under different conditions of incoming wind speed, geometric scale and wind tunnel facilities, which may lead to potential Reynolds number (Re) effect, model scaling effect and wind tunnel scale effect, respectively. The Re effect and scale effect on aerostatic force coefficients and aeroelastic characteristics of streamlined bridge decks were investigated via 1:100 and 1:60 scale section model tests. The influence of auxiliary facilities was further investigated by comparative tests between a bare deck section and the deck section with auxiliary facilities. The force measurement results over a Re region from about 1×10⁵ to 4×10⁵ indicate that the drag coefficients of both deck sections show obvious Re effect, while the pitching moment coefficients have weak Re dependence. The lift coefficients of the smaller scale models have more significant Re effect. Comparative tests of different scale models under the same Re number indicate that the static force coefficients have obvious scale effect, which is even more prominent than the Re effect. Additionally, the scale effect induced by lower model length to wind tunnel height ratio may produce static force coefficients with smaller absolute values, which may be less conservative for structural design. The results with respect to flutter stability indicate that the aerodynamic-damping-related flutter derivatives 𝘈^*₂ and 𝐴^*₁𝐻^*₃ have opposite scale effect, which makes the overall scale effect on critical flutter wind speed greatly weakened. The most significant scale effect on critical flutter wind speed occurs at +3° wind angle of attack, which makes the small-scale section models give conservative predictions.

• 신재생에너지
• /
• 제3권3호
• /
• pp.54-62
• /
• 2007

The present paper describes the scale effect correction methods for scaled NREL Phase VI wind turbines by using CFD[computational fluid dynamics). For the corrections of wind turbine scale effect, various researches on the helicopter rotor scale effect were investigated and the feasibility study of the methods was performed to correct wind turbine scale effect. The present paper also introduces scale effect correction methods based on two dimensional lift slope. In order to test the present method, performance analyses of NREL Phase VI wind turbines under various scale conditions were carried out and new correction method was applied. Granting that the new correction method is valid only above Reynolds No. 100,000, it showed reasonable agreement between model and full scale wind turbines in the linear torque region.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2006년도 추계학술대회
• /
• pp.241-244
• /
• 2006

The present paper describes the scale effect correction method for wind turbine by using CFD(computational fluid dynamics). For the correct ions of wind turbine scale effect, various researches on the helicopter rotor scale effect were Investigated and feasibility study of methods was performed to correct wind turbine scale effect The present paper also introduces new scale effect correction method based on two dimensional lift slope modification. In order to test the Present method, performance analyses of NREL Phase VI wind turbines under various scale conditions were carried out by using CFD. The present method showed reasonable results when applied to NREL Phase VI wind turbine.

• 농촌계획
• /
• 제29권1호
• /
• pp.11-17
• /
• 2023

In this study, the effect of orchard expansion, structural improvement, and potential demand of the orchard scale-up project implemented since 2004 to strengthen the competitiveness of orchard farmers was examined. The results of the analysis are summarized as follows. First, looking at the effect of scale-up by checking the standard income data of the Rural Development Administration, it was possible to confirm the effect of scale-up in that the income per unit area increases as the scale increases. Second, through the scale-up project, the effect of structural improvement in transferring the orchards of the aged farm households to the younger farm households was confirmed to be 13 years old on average in the case of a sale business and 16 years old in the case of a lease business. Third, it was found that income increased at a statistically significant level after participating in the orchard scale-up project for major fruit crops such as apples, pears, and peaches. Fourth, it was found that age and cultivated area had a statistical effect on the probability of participating in the orchard scale-up project for farmers who did not participate in the project. The potential business demand using the estimated results was found to be between 25,203 and 37,089.

• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 2005년도 춘계학술발표회
• /
• pp.693-694
• /
• 2005

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제12권1호
• /
• pp.569-577
• /
• 2020

Based on laboratory experiments and numerical simulations, the scale effect of Internal Solitary Wave (ISW) loads on spar platforms is investigated. First, the waveforms, loads, and torques on the spar model at a laboratory obtained by the experiments and simulations agree well with each other. Then, a prototype spar platform is simulated numerically to elucidate the scale effect. The scale effect for the horizontal forces is significant owing to the viscosity effect, whereas it is insignificant and can be neglected for the vertical forces. From the similarity point of view, the Froude number was the same for the scaled model and its prototype, while the Reynolds number increased significantly. The results show that the Morison equation with the same set of drag and inertia coefficients is not applicable to estimate the ISW loads for both the prototype and laboratory scale model. The coefficients should be modified to account for the scale effect. In conclusion, the dimensionless vertical forces on experimental models can be applied to the prototype, but the dimensionless horizontal forces of the experimental model are larger than those of the prototype, which will lead to overestimation of the horizontal force of the prototype if direct conversion is implemented.

• 한국지반공학회논문집
• /
• 제20권1호
• /
• pp.131-139
• /
• 2004

지내력기초 설계와 시공을 위해 실시하는 평판재하시험 결과로부터 실제 기초지반의 지지력 및 침하량을 산정할때 scale effect를 고려해야 하는데 국내에는 scale effect 적용기준이나 관련 시험자료가 없다. 그래서, 화강풍화토 지반에서 재하판 크기별 지지력 및 침하량의 상관관계를 파악하기 위해 모형토조 및 현장 평판재하시험을 실시하였다. 토조시험은 토조내에 지층을 형성한후 함수비 조건, 다짐횟수, 습윤 단위중량, 및 재하판 직경(D15, 25cm)별로 모형토조$(2,000\times 2,000\times 1,000mm)$에서 실시하였다. 현장 재하시험은 재하판 직경$(D15, 25, 30, 40, 75\times 75, 140\times 210cm)$별로 실시하였다. 재하시험 결과분석과 수치해석을 통해 토사 및 암반지반에서 지내력 기초설계시 Scale effect를 계산하기 위한 지지력 및 침하량 산정식을 제시하였다.

• 한국지구물리탐사학회:학술대회논문집
• /
• 한국지구물리탐사학회 2003년도 Proceedings of the international symposium on the fusion technology
• /
• pp.156-161
• /
• 2003

Mechanical behavior of rock joints usually can be characterized by small-scale laboratory shear tests due to economical and technical limitations, but their applicability to the behaviour of rock mass has been always questioned by a number of researchers because of scale effect. Though there have been several researches regarding the scale effect, it has been a controversial problem how to apply the result of small-scale laboratory shear test directly to field design from different conclusions among researchers. In order to grasp the trend of scale effect of shear behavior, a series of direct shear tests on replicas of natural rock joint surfaces made of gypsum cement with different size and roughness were conducted and analyzed. Result showed that as the size of the specimen increased, average peak shear displacement increased, but average shear stiffness and average peak dilation angle decreased. As for the dependency of scale on shear strength, the degree of scale effect was dependent on normal stress and roughness of rock joint. For the condition of low normal stress and high roughness, decrease of average peak shear strength with increasing size of joint was evident.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2002년도 가을 학술발표회 논문집
• /
• pp.350-357
• /
• 2002

The scale effect should be considered to determine the bearing capacity and settlement of footings from Plate-Load Test, because of the size difference between a footing and a loading plate. To analyze characteristics of bearing capacity and settlement according to the difference of loading plate sizes, model tests were peformed with four different sizes of square plate, which is B=10, 15, 20 and 25cm respectively, on five different kinds of subsoil, which is pure sand(100:0), sand-clay mixed soil(75:25, 50:50, 25:75), and pure clay(0:100). Based on the analyzed results, this paper also proposed a method of bearing capacity and settlement determination, where scale effect is considered depending on the mixing ratio of sand and clay. Applying the formular proposed in this research to field problems, it is expected that evaluation of bearing capacity and settlement of footings can be more reliable and more economic construction can be achieved.

• Journal of Acupuncture Research
• /
• 제25권4호
• /
• pp.141-148
• /
• 2008

Objectives : The purpose of this study is to report the effect of acupotomy for patients with shoulder disease. Methods : We treated Five patients who have shoulder disease with acupotomy. To check the effect and satisfaction of acupotomy we used visual analog scale(VAS) and Five-point Likert scale. At the same time, we measured Change of shoulder range of motion(ROM). Results : After treatment pain were improved, VAS score decreased significantly to 2.5. The Likert scale point were checked 4.4, the patients were satisfied with the effect of acupotomy. Conclusions : This study shows acupotomy has useful effect on shoulder disease. An acupotomy is an alternative effective treatment modality for shoulder disease.