• Journal of the Korea Institute of Military Science and Technology
• /
• v.18 no.5
• /
• pp.574-581
• /
• 2015

In this paper, the effect of high voltage current pulse against shaped charge jet was analyzed through the visualization of jet behavior using flash X-ray and comparison of depth of penetration(DOP) into RHA(Rolled Homogeneous Armor) witness plates. The behavior of jet particles has been acquired using a flash X-ray equipment when current pulse was applied into the metal jet of a shaped charge(SC) warhead. Typical results such as jet breakup and radial jet dispersion, which are due to electromagnetic pressure by current pulse, have been obtained. Dozens of penetration experiments using a shaped charge with 55 mm diameter were performed according to various combinations of major parametric variables such as electrode spacing, standoff distance from SC warhead to electrode, and charge voltage. Subsequently, interrelations between major parametric variables and DOPs into RHA were analyzed.

• Transactions of Materials Processing
• /
• v.27 no.6
• /
• pp.356-362
• /
• 2018

A liner is a crucial component that directly affects the penetration performance of the shaped charge warhead. If the material of the liner has fine grain size and high strength, then the penetration performance can be further improved. There have been attempts to use a preform obtained by a severe plastic deformation (SPD) process. In this study, the process of minimizing the strain deviation to maintain the characteristics of material obtained by the severe plastic deformation process was investigated. The FE analysis of liner forging process was performed using the design of experiments (DOE), to optimize various shape parameters of the forming process such as shape of preform and forging die. As a result, the combination of design variables with the minimum effective strain deviation in the liner forging process were obtained.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.14 no.6
• /
• pp.1114-1120
• /
• 2011

Shaped Charge's penetration performance is depended on the shape of warhead and explosive, liner materials. The liner that manufactured to small homogeneous grain increase the penetration performance and decrease the deviation of penetration performance. This texture is obtained by forging process but, creating the process that remove crack and get small homogeneous grain is very hard. In this study, We success to get the homogeneous small grain texture through appling the most suitable process by DEFORM CODE analysis.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.32 no.2
• /
• pp.133-140
• /
• 2019

In this paper, the penetration process of Shaped charge jet(SCJ) was simulated through finite element analysis to obtain physical quantities such as jet incidence velocity, penetration rate, and penetration increment. As a result of applying these physical quantities to the hydrodynamic theory, it was confirmed that the penetration efficiency of the jet with a high incident velocity is higher than that of the following slow jet. This efficiency decreased sharply when the jet was slower than the hydrodynamic limit(HL). On the other hand, the comparison of penetration increment and jet consumption over time showed that the length extension effect should be considered for SCJ's theoretical penetration analysis.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.32 no.3
• /
• pp.199-203
• /
• 2019

The penetration depth of a hypervelocity jet exceeding 4 km/s is described by the density ratio of the jet and the target. In the case of the same density, the difference in strength between the targets does not affect the penetration depth difference. This study focuses on the "strength irrelevance" of such a hypervelocity jet. For this purpose, the change of crater pressure caused by shaped charge jet(SCJ) was calculated by finite element analysis and the possibility of polymorphic phase transition of steel material was investigated. Hypervelocity jets were found to cause polymorphic phase transitions in the steel target craters, and the decrease in the fracture toughness of the target is predicted as the cause of the strength irrelevance.