• 제목/요약/키워드: Starting mode

검색결과 149건 처리시간 0.031초

Free-Piston 엔진용 평판형 선형 발전기를 이용한 기동모드 해석 (Starting Mode Analysis of Flat-type Linear Generator for Free-Piston Engine)

  • 김영욱;임재원;정현교
    • 전기학회논문지
    • /
    • 제57권6호
    • /
    • pp.966-971
    • /
    • 2008
  • Free-piston engine system is a new type energy converter which uses a linear motion of piston by using linear generator. In free-piston engine system, the piston is not connected to a crank-shaft. The major advantages of free-piston engine system are high efficiency and low mechanical loss from the absence of motion conversion devices. Linear generator of free-piston engine system is used as generator and starting motor. In design step, considering of back-emf and detent force characteristics for generating mode and thrust and control characteristics for starting mode is needed. In this research, generating mode of flat-type linear generator and tubular-type linear generator is analyzed by finite element analysis method and starting mode of both type linear generators is analyzed by using capability curve. Capability curve is plotted from electrical parameters of both type linear generator and motion profile is calculated from mechanical parameters.

슬라이딩 모드 제어를 이용한 단상 유도전동기의 저 전류 기동 시뮬레이션 (The Low Current Starting Simulation of a Single Phase Induction Motor Using Sliding Mode Control)

  • 김효기;이병하
    • 조명전기설비학회논문지
    • /
    • 제21권8호
    • /
    • pp.44-53
    • /
    • 2007
  • 단상유도전동기의 기동전류를 줄이기 위하여 슬라이딩모드 제어기가 적용된다. 단상유도전동기의 기동전류가 정격치 이하로 유지되도록 슬라이딩모드 제어기의 스위칭 기능을 조절함으로써 전동기 입력전압이 제어되며 또한 속도도 제어된다. 슬라이딩 모드 제어기의 스위칭은 속도 오차 신호와 속도 변화량에 대하여 적절이 수행된다. 단상 유도 전동기의 기동특성이 슬라이딩 제어기를 사용하여 크게 향상될 수 있음을 보여 준다.

터보 블로워용 고속 유도전동기의 새로운 기동방법 (Novel Starting Method of High Speed Induction Motor for Turbo Blowers)

  • 이진우
    • 전력전자학회:학술대회논문집
    • /
    • 전력전자학회 2016년도 전력전자학술대회 논문집
    • /
    • pp.253-254
    • /
    • 2016
  • This paper proposes a novel starting method of a high speed induction motor with air bearings for turbo blowers. The friction of air bearings varies according to rotating speed, operating temperature and usage time. Specially, friction torque at initial starting state under low bearing temperature usually results in starting failures of the conventional V/F control method. Therefore, this paper proposes a new starting method, which consists of an initial I/F control mode and smooth transition method to V/F control mode to overcome the starting failure. The experimental results are shown to verify the analysis and the usefulness of the proposed method.

  • PDF

무전극 램프에서의 히스테리시스와 모드 변환 (Hysteresis and Mode Transition in Electrodeless Fluorescent Lamp)

  • 이주호;박대희
    • 한국전기전자재료학회:학술대회논문집
    • /
    • 한국전기전자재료학회 2007년도 하계학술대회 논문집 Vol.8
    • /
    • pp.453-453
    • /
    • 2007
  • Electrodeless fluorescent lamp exhibit two modes of operation: a low density mode in which the power is capacitively coupled to the plasma and which is known as the E-mode, and a higher density mode which is an inductive discharge known as the H-mode. The transition between these two(E to H) mode exhibits hysteresis. It is observed that transition currents change at different frequencies and hysteresis exists not only between the starting and minimum maintaining currents of the electromagnetic mode (H mode) discharge but also between the starting and minimum maintaining currents of the electrostatic mode (E mode) discharge. Hysteresis effect can be important role in dimming system.

  • PDF

무전극램프 에서의 Hysteresis와 모드 변환 특성 (Hysteresis and Mode Transition in Electrodeless Lamp)

  • 이주호;양종경;이종찬;박대희
    • 대한전기학회:학술대회논문집
    • /
    • 대한전기학회 2007년도 제38회 하계학술대회
    • /
    • pp.1560-1561
    • /
    • 2007
  • Electrodeless fluorescent lamp exhibit two modes of operation : a low density mode in which the power is capacitively coupled to the plasma and which is known as the E-mode, and a higher density mode which is an inductive discharge known as the H-mode. The transition between these two(E to H) mode exhibits hysteresis. It is observed that transition currents change at different frequencies and hysteresis exists not only between the starting and minimum maintaining currents of the electromagnetic mode (H mode) discharge but also between the starting and minimum maintaining currents of the electrostatic mode (E mode) discharge. Hysteresis effect can be important role in dimming system.

  • PDF

M/G/1 복수 휴가 모델을 이용한 IEEE 802.16e 무선 MAN 수면모드 작동에 대한 성능분석

  • 정성환;홍정완;장우진;이창훈
    • 한국경영과학회:학술대회논문집
    • /
    • 한국경영과학회 2007년도 추계학술대회 및 정기총회
    • /
    • pp.195-203
    • /
    • 2007
  • In this paper, an analytic model of sleep model operation in the IEEE 802.16e is investigated. A mobile subscribe. station (MSS) goes to sleep mode after negotiations with the base station (BS) and wakes up periodically for a short interval to check whether there is downlink traffic to it. If the arrival of traffic is notified, an MSS returns to wake mode. Otherwise, it again enters increased sleep interval which is double as the previous one. In order to consider the situation more practically, we propose the sleep mode starting threshold, during which MSS should await packets before it enters the sleep mode. By modifying the M/G/1 with multiple vacations model, energy consumption ratio(ECR) and average packet response time are calculated. Our analytic model provides potential guidance in determining the optimal parameters values such as sleep mode starting threshold, minimal sleep and maximal sleep window.

  • PDF

Novel Soft Starting Algorithm of Single Phase Induction Motors by Using PWM Inverter

  • Kim, Hae-Jin;Hwang, Seon-Hwan;Kim, Jang-Mok
    • Journal of Power Electronics
    • /
    • 제18권6호
    • /
    • pp.1720-1728
    • /
    • 2018
  • This paper proposes a novel soft starting algorithm by using PWM inverter technique to control an amplitude of the motor starting current at a single-phase induction motor (SPIM). Traditional SPIM starting methods such as a Split-Phase, Capacitor-Start, Permanent-Split Capacitor (PSC), Capacitor-Start Capacitor-Run (CSCR), basically cannot control the magnitude of starting current due to the fixed system structures. Therefore, in this paper, a soft starting algorithm based on a proportional resonant (PR) control with a variable and constant frequency is proposed to reduce the inrush current and starting up time. In addition, a transition algorithm for operation modes is devised to generate a constant voltage and constant frequency (CVCF). The validity and effectiveness of the proposed soft starting method and transition algorithm are verified through experimental results.

구조물의 고유모드 해석을 위한 가속화된 초기벡터 구성기법 (Accelerated Starting Vectors for Analysis of Natural Modes of Structures)

  • 김병완;정형조;이인원
    • 한국소음진동공학회:학술대회논문집
    • /
    • 한국소음진동공학회 2004년도 춘계학술대회논문집
    • /
    • pp.784-787
    • /
    • 2004
  • Modified version of subspace iteration method using accelerated starting vectors is proposed to efficiently calculate free vibration modes of structures. Proposed method employs accelerated Lanczos starting vectors that can reduce the number of iterations in the subspace iteration method. Proposed method is more efficient than the conventional method when the number of required modes is relatively small. To verify the efficiency of proposed method, two numerical examples are presented.

  • PDF

M/G/1 복수 휴가 모델을 이용한 IEEE 802.16e 무선 MAN 수면모드 작동에 대한 성능분석 (Performance Analysis of a Sleep Mode Operation in the IEEE 802.16e Wireless MAN with M/G/1 Multiple Vacations Model)

  • 정성환;홍정완;장우진;이창훈
    • 한국경영과학회지
    • /
    • 제32권4호
    • /
    • pp.89-99
    • /
    • 2007
  • In this paper, an analytic model of a sleep mode operation in the IEEE 802.16e is investigated. A mobile subscriber station(MSS) goes to sleep mode after negotiations with the base station(BS) and wakes up periodically for a short interval to check whether there is downlink traffic to it. If the arrival of traffic is notified, an MSS returns to wake mode. Otherwise, it again enters increased sleep interval which is double as the previous one. In order to consider the situation more practically, we propose the sleep mode starting threshold, during which MSS should await packets before it enters the sleep mode. By modifying the M/G/l with multiple vacations model, energy consumption ratio(ECR) and average packet response time are calculated. Our analytic model provides potential guidance in determining the optimal parameters values such as sleep mode starting threshold, minimal sleep and maximal sleep window.

고유모드 계산을 위한 초기 반복벡터의 효율성 연구 (Investigation of Efficiency of Starting Iteration Vectors for Calculating Natural Modes)

  • 김병완;경조현;홍사영;조석규;이인원
    • 한국소음진동공학회논문집
    • /
    • 제15권1호
    • /
    • pp.112-117
    • /
    • 2005
  • Two modified versions of subspace iteration method using accelerated starting vectors are proposed to efficiently calculate free vibration modes of structures. Proposed methods employ accelerated Lanczos vectors as starting iteration vectors in order to accelerate the convergence of the subspace iteration method. Proposed methods are divided into two forms according to the number of starting vectors. The first method composes 2p starting vectors when the number of required modes is p and the second method uses 1.5p starting vectors. To investigate the efficiency of proposed methods, two numerical examples are presented.