• Journal of Korean Society on Water Environment
• /
• v.30 no.3
• /
• pp.304-310
• /
• 2014

The conventional methods for total residual chlorine such as iodometry and DPD colorimetric can cause secondary pollution due to additional agents, also have a wide error range. As for alternative, electrochemical method can measure TRC(Total residual chlorine), and is not required as additional agents, also very suitable for using the fields of ballast water because test time is relatively fast. Therefore, this study was investigated for changing charge by agitation, salt concentration, and temperature change. Charge showed differences based on changes of reduction peak with or without agitation. In contrast, TRC and charge were well correlated in constant agitation speed. As TRC and charge were analyzed with high correlations in constant salinity and temperature of ocean, thereby conductivity was firstly measured, and charge had high correlation for TRC in spite of changing salinity and temperature Pt electrode revealed high reliability ($r^2=0.960$) because it was rarely effected by TRC, On the other hand, Au electrode appeared inadequate ($r^2=0.767$) to use sensor in less than 1.0 ppm of TRC. For high accuracy and detection of TRC, Pt and Au electrodes for test time were, respectively, 14 and 22 seconds. As a result, Pt electrode was more valuable than Au electrode in terms of response time.

• Journal of Korean Society on Water Environment
• /
• v.30 no.3
• /
• pp.298-303
• /
• 2014

We measured by electrochemical method for TRC (total residual chlorine) in ocean. From the results of Au electrode used for working electrode through cyclic voltammetry test, we obtained charge in voltage ranged from 0.0V-1.0V, and analyzed correlations of charge for TRC. Reduction peak TRC was investigated to be approximately 0.65 V vs. Ag/AgCl, and in the case that salt concentrations and temperatures in ocean appeared different, charge was analyzed for being different in the same TRC. However, in the case that each condition was constant, charge was measured at highly correlations for TRC.

• Journal of Microbiology and Biotechnology
• /
• v.26 no.5
• /
• pp.953-958
• /
• 2016

Chitosan-based film-forming gel is regarded as a promising vehicle for topical delivery of antimicrobial agents to skin wounds, since it protects from microbial infection and the cationic polymer itself possesses antibacterial activity. In this study, possible synergistic interaction against common skin pathogens between the cationic polymer and tyrothricin (TRC), a cyclic polypeptide antibiotic, was investigated, by determining the concentration to inhibit 90% of bacterial isolates (MIC). The addition of the polysaccharide to TRC dramatically reduced the MIC values of TRC by 1/33 and 1/4 against both methicillin-resistant and methicillin-susceptible Staphylococcus aureus, respectively. The synergism of TRC and chitosan combination against both strains was demonstrated by the checkerboard method, with a fractional inhibitory concentration index below 0.5. Moreover, co-treatment of TRC and chitosan exhibited antibacterial activity against Pseudomonas aeruginosa, due to the antibacterial activity of chitosan, whereas TRC itself did not inhibit the gram-negative bacterial growth. These findings suggested that the use of chitosan-based film for topical delivery of TRC could be an alternative to improve TRC antimicrobial activity against strains that are abundant in skin wounds.

• 한국ITS학회:학술대회논문집
• /
• v.2007 no.10
• /
• pp.85-91
• /
• 2007

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.11 no.3
• /
• pp.169-181
• /
• 2011

In this present paper, a comprehensive drain current model incorporating the effects of channel length modulation has been presented for multi-layered gate material engineered trapezoidal recessed channel (MLGME-TRC) MOSFET and the expression for linearity performance metrics, i.e. higher order transconductance coefficients: $g_{m1}$, $g_{m2}$, $g_{m3}$, and figure-of-merit (FOM) metrics; $V_{IP2}$, $V_{IP3}$, IIP3 and 1-dB compression point, has been obtained. It is shown that, the incorporation of multi-layered architecture on gate material engineered trapezoidal recessed channel (GME-TRC) MOSFET leads to improved linearity performance in comparison to its conventional counterparts trapezoidal recessed channel (TRC) and rectangular recessed channel (RRC) MOSFETs, proving its efficiency for low-noise applications and future ULSI production. The impact of various structural parameters such as variation of work function, substrate doping and source/drain junction depth ($X_j$) or negative junction depth (NJD) have been examined for GME-TRC MOSFET and compared its effectiveness with MLGME-TRC MOSFET. The results obtained from proposed model are verified with simulated and experimental results. A good agreement between the results is obtained, thus validating the model.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.5 no.1
• /
• pp.76-84
• /
• 2017

This study selected a method which uses high early strength cement as a way to reduce the curing time and curing energy source of concrete secondary products and reviewed the improvement in the initial strength of concrete secondary products setting the target strength of the concrete capable of removing the form to 15MPa and the curing time to 6 hours. As a result of the test, the only specimen which achieved the form removal strength of 15 MPa only through atmospheric curing within the target curing time of 6hours was ACC-100, and the specimens of TRC-100 and TRC-50 satisfied the values of 6 hours and 15MPa through steam curing. However, we could see that it was difficult to secure workability in the case of the specimen of ACC-100 due to its high rapid setting property and a retarder such as anhydrous citric acid was required to be used to improve the workability. When we look into the pattern following changes in the water to binder ratio, while, in the case of stream curing, OPC-100, TRC-100, and TRC-50 were all found to satisfy achievement of the form removal strength within 6hours as the water to binder ratio decreased, in the case of atmospheric curing, TRC-100, and TRC-50 achieved 15MPa within 12hours.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.10 no.4
• /
• pp.397-404
• /
• 2008

Excessive amount of groundwater flowed into tunnel, while constructing Incheon international airport railway. Tunnel passes under subway line no. 2 with only 1.76 m below. To protect the existing structure, TRcM excavation method was applied. As station and construction shaft are already constructed, which are located back and forth of TRcM section, 86.4 ton per day of groundwater inflow is against expectation. To identify mechanism of excessive water inflow, hydraulic back analyses were performed. Then, hydro-mechanical coupled analysis were also performed with the hydrogeologic parameters identified, whose results are investigated for checking the stability of adjacent structures to the tunnel under construction. And a number of mechanical analyses were also performed to check the hydro-mechanical coupling effect. The result from the mechanical analysis shows that subsidence and tunnel ceiling displacement will be 0.85 mm and 1.32 mm. The result of hydro-mechanical couple analysis shows that subsidence and maximum tunnel ceiling displacement will be 1.2 mm and 1.72 mm. Additional displacements caused by groundwater draw down were identified, however, displacement is minute.

• Journal of the Korea Society for Simulation
• /
• v.18 no.3
• /
• pp.91-102
• /
• 2009

The average window size is most closely related to average throughput. In order to improve fairness, the proposed dropper tries to control the window size of each flow to equal level by intentional packet drop. Intentional packet drop is performed only to the flows that have been occupied bandwidth in a large amount. Because of intentional packet drop, this flow cut down its transmission rate to a half. Accordingly, somewhat capacity of core link comes into existence. And other flow can use this new capacity of this link. Hence other flows have more throughput than before. In this paper, we propose the TRC (Transmission Rate Control) Dropper improving the fairness between individual flows of aggregated sources on DiffServ network. It has the fairness improvement mechanism mentioned above paragraph.

• Proceedings of the Korean Society of Toxicology Conference
• /
• 2001.05a
• /
• pp.120-120
• /
• 2001

Exposure of testis to 2-BP is known to cause degeneration of male germ cells. However, the mechanism underlying this process is poorly understood. The objective of this study was to determine whether 2-BP induces apoptosis during onset of toxicity in germ cells of male Sprague-Dawley rats.(omitted)

• Proceedings of the IEEK Conference
• /
• 2007.07a
• /
• pp.227-228
• /
• 2007

The dynamic range of the radar which uses digital signal processors is limited by ADC(analog- to-digital converter). This parameter and ADC loss depend on the noise level of radar receivers. In order to stabilize the performance of radar systems, it is necessary to maintain the noise level constantly. This paper presents a noise AGC(automatic gain control) concept that can keep the noise level constantly and proves that the concept is acceptable through evaluation and hardware test.