• Journal of the Korean Institute of Navigation
• /
• v.23 no.4
• /
• pp.21-28
• /
• 1999

In some cases a towing vessel and her tow, a fishing boat, and a vessel at anchor have a priority against a general power-driven vessel underway in the application of collision rule. This article aims at suggesting a practical guide for the construction of the meaning of a vessel engaging in fishing, a vessel engaged in towing operation such as severely restricts the towing vessel and her tow in their ability to deviate from their course and a vessel at anchor, which are permitted to have the above priority. The construction of the application of the collision rule on the above vessels is supported by the decisions of MAIA and the judgment of civil courts.

• Ocean Systems Engineering
• /
• v.12 no.4
• /
• pp.413-437
• /
• 2022

An innovative concept for wet-transportation and stepwise installation of mono-bucket foundation for 15 MW offshore wind turbine is proposed. Case studies for two different mono-bucket and wrap-buoy dimensions are conducted and their hydrostatic and hydrodynamic performances are compared for both wet-towing and lowering operations. The intact stability and transient responses are analyzed in detail for various stages of lowering operation. Wave-induced motion statistics during wet tow in sea state 4 (highest operational window) are checked. The proposed concept is found to be feasible and can be an alternative cost-effective solution without using heavy-lift crane vessel in practice.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.19 no.6
• /
• pp.637-642
• /
• 2013

In this paper, an analysis results of towing force and towing points which are dominating factors to determine the behavior of towed ship are introduced. The towing force and towing points to achive the desired posture and its position of the towed vessel are derived based on simplified dynamics and linearization method. LQR algorithm for posture control is applied to linearized system and numerical simulation is also executed. Force based on COG(cneter of gravity) and gain of controller to achieve desired posture for target vessel are obtained by using Riccati matrix equation and pseudo inverse matrix is applied to analyze the relation between the derived force and its towing point. Based on this analysis method, towing force need to move the towed vessel from its initial position to target position can be calculated. The towing method including towing point and direction is also considered on this method. Finally, the relation between towing force and towing point is confirmed from the analysis and the results can be applied to arrangement of tug boats during salvage works.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.21 no.2
• /
• pp.94-101
• /
• 2017

Tow Prepreg is the intermediate material for filament winding process that has been "pre-impregnated fiber tow" with resin system. As "dry filament winding" process emerges as a reliable alternative to conventional filament winding (called "wet filament winding") process, interest in tow prepreg as a material for dry filament winding is rising as well. In this article, we have reviewed the recent research trends in carbon fiber tow prepreg for high-performance rocket motor cases, fuel tanks for hydrogen vehicles and other high-quality commercial pressure vessels.

• Journal of Navigation and Port Research
• /
• v.39 no.2
• /
• pp.83-88
• /
• 2015

Korea has a systemic problem with lack of engine maintenance, especially among the Commercial Fishing Vessel fleet. This results in a inordinate percent of SAR call-outs for vessels with engine failure. These SAR call-outs lead to a free tow to shore by KCG or by one of its volunteer associates. Although these tows are not a terrible economic burden on KCG, it is a burden in terms of time and resources mis-allocated. This paper proposes a Commercial Fishing Vessel Examination (CFVE) program modeled after the program run by USCG. It is expected that adopting the CFVE program, KCG may be able to create a culture of safety among fishermen; thus, replicating the USCG's success rates.

• Journal of Navigation and Port Research
• /
• v.38 no.5
• /
• pp.463-470
• /
• 2014

In this paper, calculation of towing force required to tow the ship and experiments to verify its appropriacy are discussed. Friction, wind and wave-making resistance of vessel are considered to calculate towing force of specified vessel. Propeller resistance is also reflected and it is assumed that the propellers are locked. Node analysis to estimate additional resistance on towline is applied. Total towing force could be obtained by adding the ship's resistance and towline resistance. Experiments with training ship SAE YU DAL was executed to check the effectiveness of calculation methods and some comparison between experiments and calculation results was also done. From the comparative analysis, we confirmed that towing speed is primary terms in the calculation of towing force and propeller resistance is a major elements of ship's resistance with the increasing of towing speed. We can see that additional resistance induced by yawing of ship during towing have to be considered for total tow resistance.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.8 no.6
• /
• pp.537-553
• /
• 2016

This paper addresses the safety of two-row tank design by performing the extensive sloshing model tests. Owing to the uncertainties entangled with the scale law transforming the measured impact pressure up to the full scale one, so called comparative approach was taken to derive the design sloshing load. The target design vessel was chosen as 230 K LNG-FPSO with tow-row tank arrangement and the reference vessel as 138 K conventional LNG carrier, which has past track record without any significant failure due to sloshing loads. Starting with the site-specific metocean data, ship motion analysis was carried out with 3D diffraction-radiation program, then the obtained ship motion data was used as 6DOF tank excitation for subsequent sloshing model test and analysis. The statistical analysis was carried out with obtained peak data and the long-term sloshing load was determined out of it. It was concluded that the normalized sloshing impact pressure on 230 K LNG-FPSO with two-row tank arrangement is higher than that of convectional LNG carrier, hence requires the use of reinforced cargo containment system for the sake of failure-free operation without filling limitation.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.21 no.4
• /
• pp.421-427
• /
• 2015

This study aims at reviewing first the cases of marine accidents of small fishing vessels and vessels towing and being towed and, the problems concerning such lights and shapes that could be misunderstood for those in concerned Rules, or that could impair their distinctive characteristics or obstruct to keep a proper look-out. And then I wish to make a suggestion of the necessity of amending the National Laws which stipulate the rules for the ship's lights and shapes as follows; Firstly, by amending the "Standard of Construction and Equipment for the Less Than 10 Gross Tonnage of Small Fishing Vessels" small fishing vessel must be equipped with the lights and shapes that are the same as those of "vessel engaged in fishing" prescribed by Rule 26 of the "COLREG 1972" and Rule 84 of the "Maritime Safety Law Act". Secondly, "Standard of Fishing Vessels Equipment" which stipulate the rules concerning the exception of the running lights and radar reflector for the small fishing vessels must be amended to meet the requirement of Rule 20 of the "Maritime Safety Act". Thirdly, the definition of "Length of the tow" which prescribed by Rule 2 of the "Maritime Safety Act" must be amended to meet the Rule 24 of the "COLREG 1972". And also I wish to adhere to the importance of displaying the adequate vessel lights and shapes by every mariner for preventing marine accidents.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.28 no.3
• /
• pp.252-261
• /
• 1992

The accuracy of the position fixing with telemetry techniques depends in general on the accuracy of the location of the receiving point(hydrophone). To increase the accuracy of the coordinates of four hydrophones suspended down at both sides of the vessel anchored, each hydrophone motion is compensated using a depth pinger mounted on the seabed of 30m depth. The pinger location is calculated with a hyperbolic method. Using this technique so called hydrophone coordinates calibration, the movement of the Remotely Operated Vehicle(ROV), which has the same type of pinger mentioned above could be tracked down more accurately. Under the maximum variation ranges of a hydrophone of 5.2m in athwartships, 3.2m in alongship, and about 0.2m/s of the moving velocity in both directions, the ROV track with calibration is more close to the reality than that without calibration Tow depth pingers of same frequency can be distinguished by the use of three factors; The pulse period, the phase and the pulse period variation allowed in acquisition of the pinger as far as its pulse period is varied in smooth.

• Journal of Navigation and Port Research
• /
• v.43 no.6
• /
• pp.437-443
• /
• 2019

Aid to navigation is a navigational aid facility that informs a sailing vessel of its location and direction as well as a location of a specific obstacle by means of a light, shape, color, sound, radio wave, etc. It can be valuable in improving the safety of day and night vessel navigation at sea. For the safety of the tug boat, the minimum equipment requirements for each type of tug boat are arranged. Despite these preparations, the collision accidents between tug boats, barges, and light buoys can occur when the tug boat turns due to the length of the tow-line, tidal current, and the barge's momentum etc. The purpose of this study was to propose the basic system that analyzes the physical relationship between two vessels regarding the tug boat-barge-light buoy dynamics and propagate the corresponding data through the aid to navigation management & operation systems in use at each regional oceans and fisheries.