• Biotechnology and Bioprocess Engineering:BBE
• /
• v.11 no.4
• /
• pp.277-281
• /
• 2006

Spherical micro silica sol-gel immobilized enzyme beads were prepared in an emulsion system using cyclohexanone and Triton-X 114. The beads were used for the in situ immobilization of transaminase, trypsin, and lipase. Immobilization during the sol to gel phase transition was investigated to determine the effect of the emulsifying solvents, surfactants, and mixing process on the formation of spherical micro sol-gel enzyme beads and their catalytic activity. The different combinations of sol-gel precursors affected both activity and the stability of the enzymes, which suggests that each enzyme has a unique preference for the silica gel matrix dependent upon the characteristics of the precursors. The resulting enzyme-entrapped micronsized beads were characterized and utilized for several enzyme reaction cycles. These results indicated improved stability compared to the conventional crushed form silica sol-gel immobilized enzyme systems.

• Journal of the Korean Chemical Society
• /
• v.59 no.5
• /
• pp.407-412
• /
• 2015

A preconcentration procedure for determination of palladium by laser thermal lens spectrometry (TLS) is proposed. It is based on cloud point extraction of palladium(II) ions as 2-(3,5-dichloro-2-pyridylazo)-5-dimethylaminoaniline (3,5-diCl-PADMA) complexes using octylphenoxypolyethoxyethanol (Triton X-114) as surfactant. The effects of various experimental conditions such as pH, concentration of ligand and surfactant, equilibration temperature and time on cloud point extraction were studied. Under the optimized conditions, the calibration graph was linear in the range of 0.15~6 ng mL⁻¹, and the detection limit was 0.04 ng mL⁻¹ with an enrichment factor of 22. The sensitivity was enhanced by 846 times when compared with the conventional spectrophotometric method. The recovery of palladium was in the range of 96.6%~104.0%. The proposed method was applied to the determination of palladium in water samples.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.8
• /
• pp.1133-1136
• /
• 2004

The need for highly reliable methods for the determination of trace metals is recognized in analytical chemistry and environmental science. A method based on the cloud-point extraction (CPE) technique for the trace analysis of Pb and Cu in water samples is described in this study. The analytes in the initial aqueous solution are complexed with pyrogallol, and 0.1%(w/v) Triton X-114 is added as surfactant. Following phase separation at $50^{\circ}C$, based on the cloud point of the mixture and dilution of the surfactant-rich phase with acidified methanolic solution, the enriched analytes are determined by flame atomic absorption spectrometry. After optimization of the complexation and extraction conditions, the enrichment factors of Pb and Cu were found to be 72 and 85, respectively. Under optimum conditions, the preconcentration of 60 mL of samples in the presence of 0.1%(w/v) Triton X-114 permitted the detection of 0.4 ${\mu}gL^{?1}$ of Pb and 0.05 ${\mu}gL^{?1}$ of Cu. The proposed method was applied successfully to the determination of Pb and Cu in water samples.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.37 no.11
• /
• pp.1507-1514
• /
• 2008

Cholesterol oxidase catalyses the conversion of cholesterol to 4-cholesten-3-one. This enzyme has been used for clinical assay of human serum cholesterol and for reduction of cholesterol level in foods and feeds. In order to search the microorganism which has a high extracellular and stable activity of cholesterol oxidase, soil microorganisms were screened. As a result, the one with the highest extracellular cholesterol oxidase activity was obtained and named as the BEN 115. The BEN 115 strain was identified as one of the Nocardia species based on our taxonomic studies. The cholesterol oxidase from this strain was shown to have two bands of extracellular proteins on SDS-PAGE and Western blot. Their molecular masses were estimated to be about 55 and 57 kDa, respectively. In addition, this cholesterol oxidase was considerably stable at the broad range of pH $3.5{\sim}9.5$ and at the temperature of $25{\sim}55^{\circ}C$. The optimum pH and temperature of this cholesterol oxidase were pH 5.5 and $35^{\circ}C$, respectively. The activity of extracellular cholesterol oxidase could be enhanced 1.6 to 2.0 folds by the addition of nonionic detergent such as Triton X-114, Triton X-100, or Tween-80 into the culturing broth. The substrate specificities against campesterol, sitosterol and stigmasterol were measured to be 50%, 50%, and 27%, respectively, compared to the cholesterol. These results suggest that Nocardia sp. BEN 115 may be useful as a microbial source of cholesterol oxidase production.

• Journal of the Korean Chemical Society
• /
• v.52 no.2
• /
• pp.140-147
• /
• 2008

.A new approach for a cloud point extraction-electrothermal atomic absorption spectrometric method was used for determining bismuth. The aqueous analyte was acidified with sulfuric acid (pH 3.0-3.5). Triton X-114 was added as a surfactant and natriumdiethyldithiocarbaminat (Na-DDTC) was used as a complexing agent. After phase separation at 50oC based on the cloud point separation of the mixture, the surfactant-rich phasen was diluted using tetrahydrofuran (THF). Twenty microliters (20 L) of the enriched solution and 10 l of 0.1% (w/v) Pd(NO3)2 as chemical modifier were dispersed into the graphite tube and the analyte determined by electrothermal atomic absorption spectrometry. After optimizing extraction conditions and instrumental parameters, a preconcentration factor of 195 was obtained for a sample of only 10 mL. The detection limit was 0.04 ng ml-1 and the analytical curve was linear for the concentration range of 0.04-0.70 ng mL-1. Relative standard deviations were <5%. The method was successfully applied for the extraction and determination of bismuth in water samples.

• Korean Journal of Veterinary Research
• /
• v.50 no.4
• /
• pp.285-295
• /
• 2010

Protein expression patterns in Salmonella enterica subspecies enterica serovar Typhimurium (S. Typhimurium) strains with diverse phenotypes, such as phage type, antibiotic resistance pattern and plasmid profiles were examined. For detailed analysis of proteins expressed by different S. Typhimurium strains, protein fractions were divided into detergent-rich phase (DP) and aqueous phase (AP) using triton X-114 detergent. The two phases were subjected to two-dimensional gel electrophoresis (2-DE), followed by protein identification using peptide mass fingerprinting (PMF). In the results, PMF showed that DP fractions consisted mainly of outer membrane proteins, whereas the AP fractions included cytosolic proteins. Comparison of 2-DE profiles of DP did not show any distinct protein spots which could be correlated with phage type, antibiotic resistance pattern or plasmid profile. However, comparisons of 2-DE profiles of the AP revealed differences in the protein spots, which could be correlated with the plasmid profile and phage types. Among these protein spots, flagellin was specific for strains containing a 90 kb plasmid. Compared to DT193 phage type, three protein spots in the range of pI 5.0-5.5 and MW 8-15 kDa of AP 2-DE profiles were absent in the DT104 phage types. Additionally, a protein spot with PI in the range of 4.5-5.0 and molecular weight (MW) between 51-69 kDa was specific for phage type DT104, while a protein spot with pI in the range of 4.0-4.8 and MW between 18-20 kDa was specific for DT193 phage type. These protein spots may be useful for discriminating phage types of S. Typhimurium.

• Korean Journal of Food Science and Technology
• /
• v.27 no.5
• /
• pp.658-665
• /
• 1995

Low yield of a thermostable pectinesterase(TSPE) from citrus fruits has made its detailed study extremely tedious and difficult; therefore, maximizing TSPE extraction is desirable. It is assumed that TSPE is bound to the cell components via ionic linkage and covalent bonds. Therefore, in this study, variations in extraction time, pH, NaCl concentration and commercial enzyme preparations were used to increase the yield of TSPE from Valencia orange. The largest recovery of TSPE, obtained by heating extracted pectinesterase(PE) at $70^{\circ}C\;for\;5{\sim}10$ minute, was achieved using actate buffer(pH 4.14) with 1 M NaCl and 0.2% $Cytolase^{TM}$ 104(a mixture of cellulase, hemicellulase and pectinase; Genecor, Inc). The two aquous phase partitioning with 5.0% Triton X-114 could be used as a tool for separation of thermolabile pectinesterase(TLPE) and TSPE from crude PE. Also, water extraction and $0{\sim}0.3$ ammonium sulfate fractionation could be used for removing non-pectinesterase protein.

• Bulletin of the Korean Chemical Society
• /
• v.27 no.10
• /
• pp.1604-1608
• /
• 2006

A simple and efficient cloud point extraction-spectrofluorimetric method for the determination of thiamine in human urine is proposed. The procedure is based on the oxidation of thiamine with ferricyanide to form thiochrome, its extraction to Triton X-114 micelles and spectrofluorimetric determination. The variables affecting oxidation of thiamine, extraction and phase separation were studied and optimized. Under the experimental conditions used, the calibration graphs were linear over the range 2.5-1000 ng $mL^{-1}$. The limit of detection was 0.78 ng $mL^{-1}$ of thiamine and the relative standard deviation for 5 replicate determinations of thiamine at 400 ng $mL^{-1}$ concentration level was 2.42%. Average recoveries between 93-107% were obtained for spiked samples. The proposed method was applied to the determination of thiamine in human urine.

• Bulletin of the Korean Chemical Society
• /
• v.27 no.11
• /
• pp.1780-1784
• /
• 2006

Cloud point extraction was used to extract mefenamic acid (MF) from human urine, and spectrofluorimetry and spectrophotometry were used to analyze extracted MF. The variables affecting extraction and phase separation, i.e. HCl and Triton X-114 concentration, temperature and time of equilibration, were optimized. Under the experimental conditions used the limit of detection for extraction of 25 mL of sample was 0.006 and 0.045 mg $L^{-1}$, with relative standard deviations of 2.52 and 1.45% (n = 5) for spectrofluorimetric or spectrophotometric methods, respectively. Good recoveries in the range of 95-107% were obtained for spiked samples. The proposed methods were applied to the determination of MF in human urine.

• Journal of the Korean Ceramic Society
• /
• v.44 no.10
• /
• pp.574-579
• /
• 2007

Porous $Al_2O_3$ ceramics were prepared by the gelcasting foams method (a slurry foaming process) with acrylamide monomer. The foaming and gelation behavior was investigated with the parameters such as the type and concentration of surfactant, solid loading of slurry, and the concentrations of initiator and catalyst. Density, porosity, microstructure, and strength of the green and sintered samples were characterized. Of the four kinds of surfactants tested, Triton X-114 showed the highest foaming ability for the solid loading of 55-30 vol%. The gelation condition giving the idle time off min was found to set the foamed structure without significant bubble enlargement and liquid lamella thinning. The green samples were fairly strong and machinable and showed maximum strength of 2.4 MPa in diametral compression. The sintered samples showed densities of 10-36% theoretical (i.e. porosity 90-64%) with a highly interconnected network of spherical pores with sizes ranging from 30 to $600{\mu}m$. The pore size and connectivity increased but the cell strut thickness decreased with decreasing the solid loading. Flexural strength of 37.8-1.7 MPa was obtained for the sintered samples.