• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.3
• /
• pp.499-505
• /
• 2016

In this Paper, we propose a body-area localization technique based on WUSB (Wireless USB) over WBAN (Wireless Body Area Networks) protocol required for wearable computer systems. The proposed localization algorithm is executed on the basis of WUSB over WBAN protocol at each sensor node comprising peripherals of a wearable computer system. To increase the accuracy of input information through various body motions in wearable computer systems, a new localization technique with high precision must be developed. To achieve the goal, This paper proposes a combined TDoA/FDoA/AoA (Time Of Arrival/Time Difference Of Arrival/Angle Of Arrival) localization technique with more than four WUSB over WBAN devices to estimate body-area location accurately. The combined TDoA/FDoA/AoA technique reduces 10mm in location estimation errors comparing with a combined TDoA/FDoA technique. This performance enhancement in location error reduction can be ignored at other systems but is meaningful results in body-area localization-based communications.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2018.05a
• /
• pp.441-444
• /
• 2018

In this paper, a microstrip antenna for LTE / WiMAX is designed for UWB communication. The proposed antenna is designed for FR-4 (er = 4.3), 29[mm] x 45[mm], and can be used in the LTE frequency band of 1.82[GHz] and the WiMAX frequency band of 3.5[GHz]. Studio 2014 was used. The simulation results show 1.785[dB] at 1.82[GHz] and 1.720[dB] at 3.5[GHz]. S-parameters were also found to be less than -10dB (WSWR2: 1) in the desired frequency band. In order to achieve broadband, miniaturization, low cost and low loss, Width, length, width of transmission line, etc. were calculated. Therefore, it is considered that the applicable antenna can be applied satisfying the desired condition.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.9A
• /
• pp.830-837
• /
• 2005

ISI is caused by delay spread in the multipath channel environment. There are two kinds of channel equalizer: Linear and Non-Linear type according to the structures. In this paper, we propose an improved adaptive linear equalizer to mitigate ISI. The proposed adaptive equalizer is constructed by using asymmetrical Dsmvenu filter based on USE sub-optimal receiver. Asymmetrical structure of the transversal filter is realized by moving the main tap position from center to side. If this structure is used, we can divide ISI to precusor and postcusor. As a result the proposed equalizer has a larger extended compensation range than conventional adaptive linear equalizer. In computer simulation, we compare the bit error rate performance of the proposed linear equalizer with the conventional one on the S-V channel which is modeled for WB systems.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2008.05a
• /
• pp.1784-1788
• /
• 2008

전자파표면유속계는 여러 측정지점을 가능한 신속하게 이동하면서 홍수시 유속을 측정하는데 그 목적이 있다. 또한 홍수시 유속은 시간대 별로 급격히 변하는 속성을 가지고 있으므로 유량측정 지점의 유량을 실시간으로 획득하기 위해서는 현장 측정에서 측정한 유량데이터가 실시간으로 집계 되어야한다. 현재의 시스템은 측정 정보를 실시간으로 전송하기 위하여 현장 측정자에게 PDA가 보급되어 있으며 CDMA망을 통해서 유량 측정을 위한 각종 정보 및 측정결과를 실시간 전송하도록 되어있다. 그러나 전자파표면유속계를 비롯한 각종 유속계가 PDA와 무선으로 통신을 할 수 있게 되어있지 않기 때문에 열악한 여건의 현장에서 측정한 데이터를 야장에 수기로 기록한 후 이를 다시 PDA에 수동으로 입력시켜야하는 불편함이 있다. 전자파표면 유속계를 제외한 다른 측정 장비는 제조회사가 수자원공사와 독립적인 업체이므로 통신 접속을 하기위한 특정 인터페이스를 알아내기가 어려운 실정이다. 그러나 전자파표면유속계는 수자원공사에서 개발한 장비로서 핵심기술을 수자원공사에서 보유하고 있으므로 PDA와 통신을 가능하게 하는 장치의 개발이 가능하다. 이에 이러한 불편한 문제점을 개선하여 현장에서 홍수 유량 측정시 작업자들의 편이성을 증대시키고자 전자파표면유속계와 PDA간에 근거리통신기법을 적용하였다. 이를 위하여 Bluetooth, UWB(Ultra-Wide Band, 초광대역통신), Zigbee 등 적용가능한 근거리 통신기법을 조사하였다. 그 결과 Zigbee가 소비전력이 적어 현장에서 홍수유량측정에 이용되는 전자파표면유속계에 적용성이 가장 뛰어난 것으로 나타났다. 무선통신 모듈과 연동되는 전자파표면유속계는 이동식을 기준으로 적용하였으며 기존 신호처리부에 무선통신 모듈을 장착할 수 있는 구조로 설계하였다. 장착 방식은 기존 이동식 유속계의 신호처리부의 RS-232 포트에 무선통신 모듈을 장착하면 사용할 수 있는 구조로 되어있다. 신호처리부 RS-232 포트는 현재까지는 측정한 유속값을 PC로 전송받는 용도로 활용되었으나 무선모듈 장착 시에는 무선통신 할 수 있는 이중화 구조를 채택하였다. 두 가지 방식에 대한 통신구별은 초기에 송수신하는 데이터에 따라 구별되도록 하였다. 신호처리부에서 무선통신 추가에 따른 운용 방식은 별도의 수자원공사 모드를 추가하여 운용하도록 수정하였다. 유속 측정 시에는 무선통신 모듈을 제거한 상태에서 측정한 후, 측정한 데이터를 PDA로 전송할 때 아를 부착하여 사용할 수 있는 구조를 갖도록 제작하였다. 이러한 방식을 적용시킨 이유는 기존에 보급된 유속계에 무선모듈을 장착한 후, 신호처리부 운용 프로그램을 업그레이드하면 바로 사용할 수 있도록 하기 위함이다.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.9
• /
• pp.60-65
• /
• 2009

In this paper, we present a compact Ultra-Wideband band-pass later with notched band at fireless-LAN band using a band-pass and band-notch filter. The structure of our proposed band-pass filter is very simple, and the DGS(Defected Ground Structure) structure is used to get the low-pass filter characteristic, and an embedded open-stub structure is used to get the notched filter. Our proposed band-pass filter can be much smaller than a cascaded filter. As a result of measurement, the insertion loss is less than 0.7dB throughout the pass-band of $2.21GHz{\sim}10.92GHz$, the return loss is more than 17dB and the group delay maximum variation is 0.24ns and a notched band is at $5.3GHz{\sim}5.7GHz$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.12A
• /
• pp.1174-1182
• /
• 2005

This paper, we propose a new channel Estimation method for MB-OFDM(Multi-Band OFDM) system that is suggested as one of standards in IEEE 802.15 TG3a for high data rate(110Mbps${\~}$480Mbps) WPAN system. The proposed method uses correlation characteristic of the PS(Packet Synchronization) sequence for timing synchronization. It can reduce the influence of noise compared with the conventional algorithm which based on LS(Least square) algorithm is redundancy without using the CE(Channel Estimation) Sequence for channel Estimation. We simulate both conventional method and proposed method for performance analysis in S-V channel environment which proposed by IEEE 802.15.3a. Simulation results show the proposed algorithm outperforms conventional algorithm about 1${\~}$1.5dB of Eb/NO.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.1
• /
• pp.103-109
• /
• 2008

In this papaer, a new type of ${\lambda}_g/4$ short stub band pass filter and ${\lambda}_g/2$ open stub band pass filter are purposed. Both are designed using FSCS technique for harmonic suppression. The proposed filters that used FSCS technique and a broadband stop filter is integrated to band pass filter to suppress the harmonics. The BSF are also placed between stubs so that the size is larger than prevent as compared to conventional one. The propose filters have center frequency of 5.8 GHz, bandwidth of 50% and harmonics suppressin is 120% has in bandwith. The measurement results in the case of ${\lambda}_g/4$ short stub filter, insertion loss of 0.5 dB, return loss of 14 dB are achieved and in the case of ${\lambda}_g/2$ open stub filter, loss of 0.8 dB, return loss of 14.4 dB are achieved. The simulation results and the measurement results are almost the same.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.4 no.1 s.6
• /
• pp.63-71
• /
• 2005

This paper proposes the channel estimation method robust to severe frequency selective fading channels in O%M system using wide bandwidth for the high data rate transmission. DDCE, which uses data between the high correlated symbols, is usually used for channel estimation in the slow fading channels. DDCE can get high gains in the non-selective channels. As the bandwidth of system gets wider, it becomes more severe frequency selective fading environments so that the reliability of data becomes lower and error flow is occurred. FE method, this paper proposed, uses the relation between sub-carriers of OFDM in frequency selective fading channels so FE method gets some gains by adapting the power value at a target frequency to the mean value of channel estimated values of adjacent sub-carriers. Because FE uses only preamble unlike DDCE using data, it is independent of data rate related to the reliability of data and the number of multipath. Consequently, FE can obtain considerable gains in the wideband systems where the errorflow of DDCE is occurred, and FE is applicable to frequency selective fading environments.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.5
• /
• pp.424-429
• /
• 2016

This paper presents dual-mode ring-resonator bandpass filter using LUC of artificial-transmission-lines. The conventional ring-resonator bandpass filter has limitation in miniaturization because the conventional ring-resonator is based on a one wavelength operation, and problem due to undesire harmonics. The ring-resonator bandpass filter is miniaturized and show higher order mode rejection by configuring a ring-resonator with LUC of artificial-transmission-lines. The two-stage bandpass filter is designed and fabricated with a ring-resonator and input/output interdigital coupled line. A fabricated filter shows dual-mode, rejection of whole ultra wide band, sharp skirt characteristics and has ring area reduced by 60 % compared to the conventional ring-resonator bandpass filter.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.5
• /
• pp.416-423
• /
• 2016

In this paper, a conformal type $1{\times}4$ microstrip patch array antenna with tilted antenna beam is presented for UWB sensor applications. Each antenna element comprises E-shaped patch with L-probe feeding to increase the bandwidth. The tilted antenna beam of 20 degree can be achieved with 42 ps microstrip delay lines at the series feeding network with T-junctions. The measured reflection coefficient is >9 dB at 3.5~4.5 GHz. The measured antenna gain and HPBW are >10 dBi and <30 degree at 3.75~4.25 GHz.