• Journal of electromagnetic engineering and science
• /
• 제18권3호
• /
• pp.188-198
• /
• 2018

In this study, we propose an approach for the design and satisfy the requirements of the fabrication of a small, lightweight, reliable, and stable ultra-wideband receiver for millimeter-wave bands and the contents of the approach. In this paper, we designed and fabricated a stable receiver with having low noise figure, flat gain characteristics, and low noise characteristics, suitable for millimeter-wave bands. The method uses the chip-and-wire process for the assembly and operation of a bare MMIC device. In order to compensate for the mismatch between the components used in the receiver, an amplifier, mixer, multiplier, and filter suitable for wideband frequency characteristics were designed and applied to the receiver. To improve the low frequency and narrow bandwidth of existing products, mathematical modeling of the wideband receiver was performed and based on this spurious signals generated from complex local oscillation signals were designed so as not to affect the RF path. In the ultra-wideband receiver, the gain was between 22.2 dB and 28.5 dB at Band A (input frequency, 18-26 GHz) with a flatness of approximately 6.3 dB, while the gain was between 21.9 dB and 26.0 dB at Band B (input frequency, 26-40 GHz) with a flatness of approximately 4.1 dB. The measured value of the noise figure at Band A was 7.92 dB and the maximum value of noise figure, measured at Band B was 8.58 dB. The leakage signal of the local oscillator (LO) was -97.3 dBm and -90 dBm at the 33 GHz and 44 GHz path, respectively. Measurement was made at the 15 GHz IF output of band A (LO, 33 GHz) and the suppression characteristic obtained through the measurement was approximately 30 dBc.

• ETRI Journal
• /
• 제31권4호
• /
• pp.472-474
• /
• 2009

In this letter, an ordered successive interference cancellation (OSIC) scheme is applied for multiple-input multiple-output (MIMO) detection in ultra-wideband (UWB) communication systems. The error rate expression of an OSIC receiver on a log-normal multipath fading channel is theoretically derived in a closed form solution. Its bit error rate performance is analytically compared with that of a zero forcing receiver in the UWB MIMO detection scheme followed by RAKE combining.

• ETRI Journal
• /
• 제27권4호
• /
• pp.453-456
• /
• 2005

The ultra-wideband (UWB) signal radiation process in an antenna is different from that of a narrowband signal. In this paper, we study the degradation of the desired signal component according to the antenna structure and location of a receiver in a bipolar time-hopping UWB system. And we propose a receiver structure with an adaptive template waveform generator to compensate for the degradation caused by a realistic TX-RX antenna system.

• ETRI Journal
• /
• 제30권4호
• /
• pp.495-505
• /
• 2008

This paper presents a parallel processing searcher structure for the initial synchronization of a direct sequence ultra-wideband (DS-UWB) system, which is suitable for the digital implementation of baseband functionalities with a 1.32 Gsample/s chip rate analog-to-digital converter. An initial timing acquisition algorithm and a data demodulation method are also studied. The proposed searcher effectively acquires initial symbol and frame timing during the preamble transmission period. A hardware efficient receiver structure using 24 parallel digital correlators for binary phase-shift keying DS-UWB transmission is presented. The proposed correlator structure operating at 55 MHz is shared for correlation operations in a searcher, a channel estimator, and the demodulator of a RAKE receiver. We also present a pseudo-random noise sequence generated with a primitive polynomial, $1+x^2+x^5$, for packet detection, automatic gain control, and initial timing acquisition. Simulation results show that the performance of the proposed parallel processing searcher employing the presented pseudo-random noise sequence outperforms that employing a preamble sequence in the IEEE 802.15.3a DS-UWB proposal.

• 한국통신학회논문지
• /
• 제31권9C호
• /
• pp.905-913
• /
• 2006

펄스 방식(Impulse radio)의 초광대역(Ultra-Wideband) 시스템의 타이밍 동기과정에서 획득/추적 과정이 이상적으로 수행되더라도 잔여 타이밍 오차는 존재하게 된다. 이러한 잔여 타이밍 오차는 시스템의 성능에 큰 영향을 미치게 된다. 본 논문에서는 상관 검출 수신기에서 미세 타이밍 오차를 보상하기 위해 보조신호(Reference signal)를 이용한 디지털 위상고정 루프(Digital Phase-Locked Loop)를 제시한다. 우선, 미세 타이밍 오차에 의한 비트에러률(Bit Error Rate:BER)의 성능 열화를 고찰한 후, 타이밍 추적기를 사용함으로써 타이밍 오차가 보상되는 과정과 보상 후 BER 성능을 제시한다. 그리고 타이밍 검출기는 보조신호와 수신신호간의 상관을 이용하는 방식이 제안되었으며 샘플링 주기는 프레임 단위로 이루어지도록 설계되었다. 또한, 본 논문은 성능비교를 위해 여러 종류의 가우시안 모노사이클 펄스에 대해 성능 평가를 수행한다.

• 한국통신학회논문지
• /
• 제33권5A호
• /
• pp.500-508
• /
• 2008

Direct-sequence ultra-wideband(DS-UWB) system is being considered as one of promising transmission technologies for wireless personal area networks(WPANs). Due to relatively low spreading factors and huge bandwidth of transmit signal, a DS-UWB receiver needs to be equipped not only with a rake receiver but also with an equalizer, of which the equalizer is not required for traditional direct-sequence code division multiple access(DS-CDMA) systems. The number of rake fingers is limited in practice, influencing the performance of the subsequent equalizer. In this paper, we derive a decision feedback equalizer(DFE) for DS-UWB systems based on the minimum mean square error(MMSE) criterion, and investigate the impact of various parameters on the DFE performance in realistic scenarios. In particular, we propose an approach to improving the performance of the DFE using additional channel estimates for multipaths not combined in the rake receiver, and discuss how the accuracy of channel estimation affects desirable DFE configuration. Moreover, we present simulation results that show the impact of turbo equalization on the DFE performance.

• 전기전자학회논문지
• /
• 제17권2호
• /
• pp.176-181
• /
• 2013

This paper presents a CMOS impulse radio ultra-wideband (IR-UWB) receiver implemented using IBM 0.13um CMOS technology for inner/inter-chip wireless interconnection. The IR-UWB receiver is based on the non-coherent architecture which removes the complexity of RF architecture (such as DLL or PLL) and reduces power consumption. The receiver consists of three blocks: a low noise amplifier (LNA) with active balun, a correlator, and a comparator. Simulation results show the die area of the IR-UWB receiver of 0.2mm2, a power gain (S21) of 12.5dB, a noise figure (NF) of 3.05dB, an input return loss (S11) of less than -16.5dB, a conversion gain of 18dB, a NFDSB of 22. The receiver exhibits a third order intercept point (IIP3) of -1.3dBm and consumes 22.9mW of power on the 1.4V power supply.

• 한국통신학회논문지
• /
• 제35권7A호
• /
• pp.682-687
• /
• 2010

The IEEE 802.15.4a specification targets the low-rate (LR) Impulse-radio (IR) ultra-wideband (UWB) system which is now widely applied in the WPANs considering rather short distance communications with low complexity and power consumption. The physical (PHY) layer uses concatenated coding with mixed binary phase-shift keying and binary pulse-position modulation (BPSK-BPPM), and direct sequence spreading with time hopping in order that both coherent and non-coherent receiver architectures are supported. In this paper, the performances of multiple access schemes compliant with IEEE 802.15.4a specification are investigated with energy detection receiver, which allow avoiding the complex channel estimation needed by a coherent receiver. However, the performance of energy detection receiver is severely degraded by multi-user interference (MUI), which largely diminishes one of the most fascinating advantages of UWB, namely robustness to MUI as well as the possibility to allow parallel transmissions. So as to improve the performance of multiple access schemes, we propose to apply the novel TH sequences as well as to increase the number of TH positions. The simulation results show that our novel multiple access schemes significantly improve the performance against MUI.

• ETRI Journal
• /
• 제32권3호
• /
• pp.460-463
• /
• 2010

This letter proposes an energy-detection-based non-data-aided weighted non-coherent receiver (NDA-WNCR) scheme for impulse radio ultra-wideband (IR-UWB) pulse-position modulated signals. Compared to the conventional WNCR, the optimal weights of the proposed NDA-WNCR are tremendously simplified as the maximum eigenvector of the IR-UWB signal energy sample autocorrelation matrix. The NDA-WNCR serves to blindly obtain the optimal weights and entirely circumvent the transmission of training symbols or channel estimation in practice. Analysis and simulation results verify that the bit error rate (BER) performance of the NDA-WNCR closely approaches the ideal BER of the conventional WNCRs.

• Journal of information and communication convergence engineering
• /
• 제10권3호
• /
• pp.215-219
• /
• 2012

This paper applies transmit antenna selection algorithms to spatial-temporal combining-based spatial multiplexing (SM) ultra-wideband (UWB) systems. The employed criterion is based on the largest minimum output signal-to-noise ratio of the multiplexed streams. It is shown via simulations that the bit error rate (BER) performance of the SM UWB systems based on the two-dimensional Rake receiver is significantly improved by antenna diversity through transmit antenna selection on a log-normal multipath fading channel. When the transmit antenna diversity through antenna selection is exploited in the SM UWB systems, the BER performance of the spatial-temporal combining-based zero-forcing (ZF) receiver is also compared with that of the ZF detector followed by the Rake receiver.