• Proceedings of the Korea Water Resources Association Conference
• /
• 2020.06a
• /
• pp.95-95
• /
• 2020

Urban flooding occurs in the form of internal-water inundation on roads and lowlands due to heavy rainfall. Unlike in the case of rivers, inundation in urban areas there is lacking in research on predicting and warning through measurement data. In order to analyze urban flood patterns and prevent damage, it is necessary to analyze flooding measurement data for various rainfalls. In this study, the pattern of urban flooding caused by rainfall was analyzed by utilizing the urban flooding measuring sensor, which is being test-run in the flood prone zone for urban flooding management. For analysis, 2019 rainfall data, surface water depth data, and water level data of a street inlet (storm water pipeline) were used. The analysis showed that the amount of rainfall that causes flooding in the target area was identified, and the timing of inundation varies depending on the rainfall pattern. The results of the analysis can be used as verification data for the urban inundation limit rainfall under development. In addition, by using rainfall intensity and rainfall patterns that affect the flooding, it can be used as data for establishing rainfall criteria of urban flooding and predicting that may occur in the future.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2020.06a
• /
• pp.97-97
• /
• 2020

Flooding in urban areas is caused by heavy rains for a short period of time and drains within 1 to 2 hours. It is also characterized by a small flooding area. In addition, flooding is often caused by various and complex causes such as land use, basin slope, pipe, street inlet, drainage pumping station, making it difficult to predict flooding. Therefore, this study analyzes the effect of each basin characteristic on the occurrence of flooding in urban areas by correlating various basin characteristics, whether or not flooding occurred, and rainfall(Limit Rainfall), and intends to use the data for urban flood prediction. As a result of analyzing the relationship between the imperviousness and the urban slope, pipe, threshold rainfall and limit rainfall, the pipe showed a correlation coefficient of 0.32, and the remaining factors showed low correlation. However, the multiple correlation analysis showed the correlation coefficient about 0.81 - 0.96 depending on the combination, indicating that the correlation was relatively high. In the future, I will further analyze various urban characteristics data, such as area by land use, average watershed elevation, river and coastal proximity, and further analyze the relationship between flooding occurrence and urban characteristics. The relationship between the urban characteristics, the occurrence of flooding and the limiting rainfall amount suggested in this study is expected to be used as basic data for the study to predict urban flooding in the future.

• Proceedings of the KSR Conference
• /
• 2007.11a
• /
• pp.1209-1212
• /
• 2007

Urban flooding with surcharges in sewer system was investigated because of unexpected torrential storm events these days, causing significant amounts of human and economic damages. Although there are limitations in forecasting and preventing natural disasters, integrated urban flooding management system using the SWMM(Storm Water Management Model) engine and Web technology will be an effective tool in securing safety in operating rubber-tired transportation system. In this study, the study area, located in Chuncheon, Kangwon province, was selected to evaluate the applicability of the SWMM model in forecasting urban flooding due to surcharges in sewer system The catchment are 21.10 ha in size and the average slope is 2% in lower flat areas. Information of subcatchment, conjunctions, and conduits was used as the SWMM interface to model surface runoff generation, water distribution through the sewer system and amount of water overflow. Through this study, the applicability of the SWMM for urban flooding forecasting was investigated and probability distribution of storm events module was developed to facilitate urban flooding prediction with forecasted rainfall amounts. In addition, this result can be used to the establishment of disaster management system for rainfall safety of rubber-tired tram in the future.

• Journal of People, Plants, and Environment
• /
• v.24 no.1
• /
• pp.39-51
• /
• 2021

Background and objective: Urban topology can be characterized as impervious, which changes the hydrologic features of an area, increasing surface water flow during local heavy rain events. The pluvial flooding is also influenced by the vertical structures of the urban area. This study suggested a modified digital elevation model (DEM) to identify changes in urban hydrological conditions and segmentalized urban micro catchment areas using a geographical information system (GIS). Methods: This study suggests using a modified DEM creation process based on Rolling Ball Method concepts along with a GIS program. This method proposes adding realized urban vertical data to normal DEM data and simulating hydrological analyses based on RBM concepts. The most important aspect is the combination of the DEM with polygon data, which includes urban vertical data in three datasets: the contour polyline, the locations of buildings and roads, and the elevation point data from the DEM. DEM without vertical data (DCA) were compared with the DEM including vertical data (VCA) to analyze catchment areas in Shin-wol district, Seoul, Korea. Results: The DCA had 136 catchments, and the area of each catchment ranged from 3,406 m² to 423,449 m². The VCA had 2,963 catchments, with the area of each ranging from 50 m² to 16,209 m². The most important finding is that in the overlapped VCA; the boundary of areas directly affected by flooding and the direction of surface water flow could be identified. Flooding data from September 21, 2010 and July 27, 2011 in the Shin-wol district were applied as ground reference data. The finding is that in the overlapped VCA; the boundary of areas directly affected by flooding and the direction of surface water flow could be identified. Conclusion: The analysis of the area vulnerable to surface water flooding (SWF) was more accurately determined using the VCA than using the DCA.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2005.05b
• /
• pp.159-162
• /
• 2005

Urban flooding is usually caused by the surcharge of storm sewers. For that reason, domestic studies about urban flooding are concentrated on the simulation of urban drainage system. However these approaches that find the pipes which have insufficient drainage capacity are very approximate and unreasonable ways. In this study, an accurate mathematical modeling is developed to analyze the impacts of an urban inundation for both flood prevention and flood-loss reduction planning and it is verified by using the simulation of July 2001 flooding in Seoul. The result of this study can be used to construct fundamental data for a flood control plan and establish a urban flood forecasting/warning system.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.17 no.4
• /
• pp.129-143
• /
• 2014

The purpose of this study is to evaluate flooding vulnerability considering spatial characteristics focused on Changwon-si, Gyeongsangnam-do. Assessment Factors are water cycle area ratio, surface runoff, and precipitation. And construction of assessment factors and vulnerability was analyzed by GIS program. Water cycle ratio and surface runoff were vulnerable in urban area. Precipitation was often distributed in agriculture of the northern region. Results of flooding vulnerability were low in agriculture and forest of the northern region. In contrast, urban area was high because there has covered impervious land cover. Analytical results of flooding vulnerability density using hotspot spatial cluster analysis were high in urban area. And these areas were situated in down stream so flooding were generated. Therefore, flooding vulnerability assessment of this study can help for selecting construction sites of pervious land cover and rainwater management facilities in urban and environmental planning.

• Journal of the Korean Society of Safety
• /
• v.35 no.2
• /
• pp.100-110
• /
• 2020

Recently, the frequency of typhoon and torrential rain due to climate change is increasing. In addition, the upsurge in the complexity of urban sewer network and impervious surfaces area aggravates the inland flooding damage. In response to these worsening situations, the central and local governments are conducting R&D tasks related to predict and mitigate the flood risk. Researches on the analysis of inundation in urban areas have been implemented through various ways, and the common features were to evaluate the accuracy and justification of the model by comparing the model results with the actual inundation data. However, the evaluation procesure using available urban flooding data are not consistent, and if there are no quantitative urban inundation data, verification has to be performed by using press releases, public complaints, or photos of inundation occurring through 'CCTV'. Because theses materials are not quantitative, there is a problem of low reliability. Therefore, this study intends to develop a comparative analysis procedure on the quantitative degree and applicability of the verifiable inundation data, and a systematic framework for the performance assessment of urban flood analysis model was proposed. This would contribute to the standardization of the evaluation and verification procedure for urban flooding modelling.

• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.1
• /
• pp.47-55
• /
• 2009

Sewers are important national infrastructure and play an essential part by handling both wastewater and stormwater to minimise problems caused to human life and the environment. However, they can cause urban flooding when rainfall exceeds the system capacity. Sewer flooding is an unwelcome and increasingly frequent problem in many urban areas, and its frequency will increase over time with urbanisation and climate change. Under current standards, sewers are designed to drain stormwater generated by up to 10 year return period storms, but data suggests that many in practice have been experienced flooding with exceeding system capacity under increased storm events. A large number of studies has considered upgrading or increasing the design standard but there are still lack of information to propose a suitable return period with the corresponding system quantity to achieve. A methodology is required to suggest a proper level of standard within a suitable sewerage rehabilitation planning that can avoid the exceedance problem. This study aimed to develop a methodology to support effective sewer rehabilitation that could prevent urban flooding mainly resulted from the exceedance of existing storm sewer system capacity. Selected sewerage rehabilitation methods were examined under different storm return periods and compared to achieve the best value for money.

• Proceedings of the KSR Conference
• /
• 2008.11b
• /
• pp.61-65
• /
• 2008

Urban flooding with surcharges in sewer system was investigated because of unexpected torrential storm events these days, causing significant amounts of human and economic damages. Although there are limitations in forecasting and preventing natural disasters, integrated urban flooding management system using the SWMM engine and Web technology will be an effective tool in securing safety in operating Bi-modal transportation system. In addition, the integrated urban flooding management system can be linked with general and transportation-related disaster management system in the future. In this study, With simulated values by the SWMM, which is a core engine of the Bi-modal disaster management system, flash flooding area estimation module was developed. Thus, the SWMM system codes were modified and new module was developed and integrated with the existing SWMM interface using the Delphi programming language. The flash flooding area estimation module is fully integrated with the SWMM interface, thus the area is estimated on-the-fly inside the system.

• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.3
• /
• pp.265-270
• /
• 2009

A nationwide questionnaire survey was conducted to investigate the actual conditions of local authorities in operating and maintaining sewerage systems especially for urban flooding. The questionnaire includes the incidences of flooding since 1980, the existence of any guidance for preventing flood damage and the design frequency currently used for sewers in each local authority. Among 160 local authorities responded to the survey, 95(59.3%) has experienced flooding more than once since 1980 while only 36(37.9%) of the 95 has prepared operation/maintenance guidelines for flooding. Most of the respondents have applied the 10 year design frequency for sewer design and 57(35.6%) of them agreed to adjust the 10 year design frequency regulation.