• Journal of Pharmaceutical Investigation
• /
• v.26 no.2
• /
• pp.137-144
• /
• 1996

The study was carried out for the preparation and evaluation of a buoyant hydrogel matrix (BHM), which is buoyant in a neutral or in pH 2.0 buffer solution, by the aspects of buoyancy, swelling, and drug release. Physical mixtures of HPC and CP in various molar ratio were employed as a mucoadhesive polymer which swells and controls the rate of drug release. Anhydrous citric acid and sodium bicarbonate in the molar ratio of 1:3 were employed as effervescing agents which provide a buoyancy for the mucoadhesive polymeric matrix. The buoyancy in vitro was expressed as both floating time$(T_{fl})$ and surfing time$(T_{sf})$, which are the time required for floating from the bottom to the surface of the medium and the time to keep the floated state at the surface of medium during release studies, respectively. A close relationship was observed between the buoyancy and the amount of effervescing agent added. $T_{fl}$ of the buoyant hydrogel matrices were decreased to about 10 seconds linearly with increasing the amount of effervescing agent in the range of 5 to 15%. $T_{sf}$ of the buoyant hydrogel matrices were varied from 1 to 3 hr depending on the amount of effervescing agent. The swelling was observed by changes in diameter of the buoyant hydrogel matrices in distilled water or acidic buffer solution, resulted in dependences on pH and the amount of effervescing agents. The release of hydrochlorothiazide from the buoyant hydrogel matrices were followed by apparent zero-order kinetics, while the buoyant hydrogel matrices were floated at the surface and maintaining their swollen shapes.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2004.05b
• /
• pp.463-467
• /
• 2004

Rosette-type diffusers with four-ports per riser are constructed in relatively shallow water in Korea. However, the trajectorial bending phenomena due to lower-pressure inside the surrounded buoyant jets on the riser was not considered in most models and was not observed without any experimental results. The buoyant jet behavior affected by the bending effect where there have been growing interests need to be verified experimentally and need to be preceded in the analysis of the characteristics of the buoyant jets oil a riser. The hydraulic model experiments have been carried out to investigate the characteristics of the behavior of horizontal buoyant jets discharged from a Rosette-type riser with four ports as well as single port over a certain range of the experimental conditions including initial momentum and initial buoyancy using LIF (Laser Induced Fluorescence) system to obtain concentration fields. The intensity of the fluorescent light in each pixel on the images obtained from LIF system with the tracer of Rhodamine H was converted to the local dye concentration with a set of calibration procedures to account for the non-uniform distribution of light intensity and the attenuation of light energy by water medium. The experimental results shows that the trajectories from Your ports tend to bend more and more to the inner side with the increase of the densimetric Froude number while the buoyant jet from a single port rises up without any bending phenomena. The previous models, VISJET and Seo et al. (2002), do not simulate the trajectories well except the region before the bending section. This study will focus on the analysis of the behavior of the buoyant jets for mainly a Rosette-type riser by conducting hydraulic model experiments using LIF system.

• Journal of Microbiology and Biotechnology
• /
• v.11 no.2
• /
• pp.326-328
• /
• 2001

Pseudomonas diminuta (ATCC 19146) has been typically used in the bacterial challenge test for validation of the sterilizing filtration process. Cell size is critical for determining the retention characteristics of membrane filters with pore-size of $0.2{\mu}m$. The changes of cell sizes after osmotic shocks at 150, 260, 500, and 700 mosM were measured by a particle size analyzer and the changes of their buoyant densities were analyzed with a Percoll gradient. The results indicated that there were no significant differences when cells were cultured in 260 mosM medium and osmotically shocked at 500 and 700 mosM. However, the osmotically shocked cells at 150 mosM showed a 38% increase of the cell size compared to the cells at 260 mosM. From these study, we concluded that the worst case condition for validation of a sterilizing filter would be 500 mosM, not because of changes in the cell size, but due to decrease in cell viability under those conditions.

• Journal of Korean Society of Water and Wastewater
• /
• v.19 no.2
• /
• pp.149-154
• /
• 2005

Conventionally used flocculation tanks require large space and high energy requirement for mixing. Static flocculators using gravel bed filter operate at a lower flow rate ($5-10m^3/m^2{\cdot}h$). Further, the cleaning of this system is difficult. A novel high rate static flocculator/filter developed at UTS packed with buoyant media such as polystyrene, polypropylene has been found to operate at higher filtration rates (30-45 $5-10m^3/m^2{\cdot}h$). They can easily be cleaned with minimal energy. Detailed experiments conducted with an artificial kaolin clay solution show that buoyant media is an excellent static flocculator in producing uniform filterable microflocs (12-15 m) even when it is operated at a high rate of 30-40 m/h. Detailed filtration experiments were conducted in a wastewater treatment plant to treat the biologically treated effluent with a floating media of depth of 120 cm. This filter was able to remove majority of phosphorus and remaining solids. It reduced significantly the fecal coliforms and fecal streptoccoci, thus requiring less amount of chlorine for disinfection. The advantage of this system is the low energy and water requirement for cleaning of filter bed. The periodic backwash adopted 30 seconds air and water and 30 seconds water cleaning every 90 minutes filter operation. Thisis equivalent to 1-2% of filtered water production. Mechanical cleaning system on the other hand, requires very low energy requirement (<1% of filtered water production).

• 한국기계연구소 소보
• /
• s.14
• /
• pp.157-168
• /
• 1985

In cargo vessels, hatch covers are used to prevent sea water from penetrating into the cargo hold and to keep the vessels buoyant. And also they can be used as cargo loading devices as in container ships. In this paper, hatch covers are classified according to their operation method and their characteristics are briefly demonstrated. Systematic description on the scantling of the hatch cover panel and how to determine the capacity of the hydraulic power system fir folding hatch cover panels are also presented. The hydraulic power system is selected from the result of dynamic analysis of the movements of the hatch cover panels when stored on the upper deck. The hatch coaming height is determined as shortly as the hydraulic cylinders can be installed. This study deals with the hatch cover system of the medium sized multi-purpose cargo vessel, but the results of this study can be applied to large-sized cargo vessels with a slight change of the input data in the calculations. Further research on the high pressure pump, hydraulic cleating system and hydraulic piping will realize domestic production of the whole hatch cover system which have been supplied from foreign makers until now

• The Magazine of the Society of Air-Conditioning and Refrigerating Engineers of Korea
• /
• v.16 no.1
• /
• pp.103-108
• /
• 1987

The heat transfer processes taking place in the side wall of a thermocline enclosure have been analyzed for idealized conditions based on the assumption that, at any instant time, side wall heat transfer processses are independent of the thermocline bulk motion. However, the axial tempera-ture distribution in the thermocline core provides the means for specifying the liquid medium-side boundary condition to the enclosure side wall. A picture is drawn which reflects the side wan response to thermocline bulk motion within the frame work of a quasi-steady analytic approach. For valves of the parameters typical of systems of engineering interest, the analysis shows that a significant amount of heat transfer short - circuiting can take place along the side wall enclosure. This phenomenon is favored by high values of $H_l$ and low values of P and $H_g$ respec-tively. The location of the point of zero normal heat flux on the side wan can be expected to mark, approximately, the region of confluence of two sidewall boundary flows respectively driven by the buoyant effects.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.55 no.2
• /
• pp.162-171
• /
• 2019

This study is aimed to develop an improved shellfish dredge vessel considering the increase of the fishing safety and welfare of fishermen in Jeonnam province. We visited five fishing village societies in Korea, and conducted field surveys and survey questions to investigate the current status. In order to solve the problems presented by the investigation, a general arrangement of the improvement vessel was written and adopted after meeting between the fishermen and research team, and calculated the initial stability in five loading conditions by using the Napa program. As a result of field surveys and survey questions, the existing vessel have buoyant materials under the bow and the warp pass through the wheel-house. In addition, most fishing equipment and nets are concentrated on a narrow stern, making it difficult to work efficiently. According to the survey, fishermen also responded that operation of casting and hauling is very inconvenient. The fishing equipment of the improvement vessel was rearranged, the size of the wheel-house and the crew room was increased, and we secured a basic welfare space. As a result of the initial stability test, the stability criteria of the fishing vessel were satisfied in all loading condition.

• Microbiology and Biotechnology Letters
• /
• v.28 no.3
• /
• pp.180-184
• /
• 2000

Tn order to be helpful to control dispersed microorganisms for stabLlization of wastewater treatment in a paper-makillg process, dominant strains were isolated aerobically and anaerobically. and identified and physiological characteristics were also analyzed. Pseudomonas carboxydohydrogena, Cardiobacten'm hominis, lvIicrococcus lylae, XanfomonCls campestris p" juglandis, Micrococcus diversus, and Comamonas terrigencl as aerobic dominants, and Streptococcus bovis and Prevotella buccae as anaerobIc dominants were identified fi'om the supernatent of the primary settling tank. It seemed that microflora in the treatment process would consist of many kinds of microorganisms, whose dominant would change easily according to environmental conditions, They all grew well at $37^{\circ}C$ and at different initial medium pH's. Especially, some of them required sulfate ion for their growth, which came from a chemical coagulant of aluminium sulfate in the primary settling tank. Interestingly. many anaerobes grew well even in the aerobic wastewater treatment process and seemed to have some functions. Population of anaerobes increased three times in the supematant of primary settling tank and ten times in Lhe bottom sludge of primary settling tank than in the prime wastewater. Therefore, these anaerobes contributed to the producH tion of offensive gases, which would make some microorganisms not precLpitate and be buoyant.

• Restorative Dentistry and Endodontics
• /
• v.29 no.5
• /
• pp.479-484
• /
• 2004

Immunoinhibitory protein extracted from sonicated Treponema denticola have been shown to suppress cell cycle progression of human lymphocytes. To study in detail about the effect of this microorganism on the function of lymphocytes. we investigated the levels of Interleukin-2 (IL-2) and Interleukin-4 (IL-4) production by T lymphocytes before and after the addition of $12.5{\;}\mu\textrm{g}/ml$ T. denticola sonicated extracts. In this study. levels of IL-2 and IL-4 produced from T cells pretreated with sonicated extracts were evaluated by using the quantitative sandwich enzyme immunoassay technique. In response to phytohemagglutinin (PHA) stimulation. T cell produced increased levels of IL-2 and IL-4. However. the expressions of both cytokines were significantly inhibited when PHA activated-T cells were pre-exposed to sonicated T. denticola extracts (p < 0.05). These findings suggest that the T. denticola sonicated extracts induced-immunosuppression in Th1 and Th2 cell functions could be a part of the pathogenic mechanism of the endodontic failure associated with this microorganism.