• 대한수학회논문집
• /
• 제11권4호
• /
• pp.1061-1066
• /
• 1996

We will give an example which is a normal Hausdorff countable dense homogeneous space but not a densely homogeneous space. Next, we will give a proof for the fact that every nondegenerate component of densely homogenous spaces is open and densely homogeneous.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2011년도 추계학술발표대회
• /
• pp.32.1-32.1
• /
• 2011

Ultra thin tantalum nitride (TaNx) films with various thicknesses (10 nm to 40 nm) have been deposited by rf magnetron sputtering technique on glass substrates. The as deposited films were systematically characterized by several analytical techniques such as X-ray diffraction, X-ray photoelectron spectroscopy, field emission scanning electron microscopy, atomic force microscopy, UV-Vis-NIR double beam spectrophotometer and four point probe method. From the XRD results, the as deposited films are in amorphous nature, irrespective of the film thicknesses. The films composition was changed greatly with increasing the film thickness. SEM micrographs exhibited the densely pack microstructure, and homogeneous surface covered by small size grains at lower thickness deposited films. The surface roughness of the films was linearly increases with increasing the films thickness, consequently the transmittance decreased. The absorption edge was shifted towards higher wavelength as the film thickness increases.

• 치과방사선
• /
• 제25권2호
• /
• pp.561-567
• /
• 1995

Pleomorphic adenoma is a benign salivary gland tumor with histologic diversity. The majority of these tumor occurs in the parotid gland. The authors experienced the patients, who complained the tumor-like soft tissue mass on the palatal area. After careful analysis of clinical, radiological and histopathological findings, we diagnosed it as pleomorphic adenoma in the palatal area, and obtained characteristic features were as follows: 1. Main clinical symptom was a painless, slow growing, soft tissue mass with normal intact overlying mucosa on the palatal area. 2. In the radiographic examminations, well encapsulated homogeneous soft tissue mass was shown in the lesion site, and cortical thinning on the palate was also observed. 3. In histopathologic examminations, proliferated cellular components in the hyaline stroma were observed as double layered duct-like structure and densely solid sheet appearance.

• 대한금속재료학회지
• /
• 제46권11호
• /
• pp.701-707
• /
• 2008

This study examined the creation mechanism of free volume during homogeneous deformation induced by the elastostatic compression at room temperature. Experiments demonstrated that amorphous alloys subjected to the elastostatic compression underwent structural disordering, during which densely packed polyhedra breakdown to form new, loosely packed ones, resulting in the creation of excess free volume. A combination of experiments and molecular dynamics simulations are used to explore fundamental issues on how free volume is created during elastostatic compression.

• Animal cells and systems
• /
• 제7권1호
• /
• pp.35-41
• /
• 2003

The principal fibers used in constructing the cocoon in the garden spider, Argiope aurantia, are large-diameter fibers developed from tubuliform glands and small-diameter fibers presumed to be spun by the aciniform silk glands. Scanning electron micrographs of the large-diameter fibers on both surfaces of the cocoon clearly reveal their fine structural differences. While the silk fibers on the inner surface have smooth and homogeneous appearances, each fiber on the outer surface represents a multicomponent internal structure. Examination of each fibers using transmission electron microscope also provides additional evidence that the multicomponent fibers contain numerous electron lucent fibrils embedded in an amorphous electron dense matrix. It has been also revealed that two types of secretory granules presumed to be the precursors of tubuliform fibers are closely related to the production of distinct coloration in luminal contents - brownish and yellowish components. Moreover, these electron-dense granules, possibly precursor of fibrillar component, and electron-lucent granules, possibly precursor of matrix component, are densely packed and remain close to each other without fusion. It is critical evidence that the individual tubuliform fiber is not only heterogeneous and multicomponent but also takes place in a variety at manners throughout the length of the gland.

• Journal of Communications and Networks
• /
• 제18권3호
• /
• pp.364-374
• /
• 2016

With vast amounts of spectrum available in the millimeter wave (mmWave) band, small cells at mmWave frequencies densely deployed underlying the conventional homogeneous macrocell network have gained considerable interest from academia, industry, and standards bodies. Due to high propagation loss at higher frequencies, mmWave communications are inherently directional, and concurrent transmissions (spatial reuse) under low inter-link interference can be enabled to significantly improve network capacity. On the other hand, mmWave links are easily blocked by obstacles such as human body and furniture. In this paper, we develop a multi-hop relaying transmission (MHRT) scheme to steer blocked flows around obstacles by establishing multi-hop relay paths. In MHRT, a relay path selection algorithm is proposed to establish relay paths for blocked flows for better use of concurrent transmissions. After relay path selection, we use a multi-hop transmission scheduling algorithm to compute near-optimal schedules by fully exploiting the spatial reuse. Through extensive simulations under various traffic patterns and channel conditions, we demonstrate MHRT achieves superior performance in terms of network throughput and connection robustness compared with other existing protocols, especially under serious blockage conditions. The performance ofMHRT with different hop limitations is also simulated and analyzed for a better choice of the maximum hop number in practice.

• 한국재료학회지
• /
• 제16권10호
• /
• pp.606-613
• /
• 2006

This study was purposed to evaluate the influence of anodically oxidized film on titanium (Ti) onto MG-63 osteoblast-like cell attachment and activity. Only scratch lines created by polishing were seen in ASR and ANO-1 groups. About $1.5{\mu}m$-thick homogeneous oxide film which has pores of about $0.5{\mu}m$ diameter were formed in ANO-12. The crystalline structure of the oxide films formed by anodization in phosphoric acid electrolyte was $TiP_2O_7$. The total protein amounts of ANO-1 and ANO-12 groups showed higher values of maximum protein amount than that of AS-R group. At 3 days of incubation, total protein amount showed higher value in ANO-2 when comparing to that of AS-R (p<0.05). Based on the results of ALPase activity test, the degree of MG-63 cell differentiation for initial mineralization matrix formation was similar. For all the test groups after 1 day of incubation, MG-63 cells grew healthily in mono-layer with dendritic extensions. After incubation for 3 days, the specimen surfaces were covered more densely by cells, and numerous micro filaments were extruding to the extracellular matrix.

• 한국안광학회지
• /
• 제10권3호
• /
• pp.193-203
• /
• 2005

Zn-나프텐산염을 출발 원료로 사용하고 스핀코팅 - 열분해법을 이용하여 실리카 유리 위에 c축으로 배향된 나노 결정질 ZnO 박막을 제조하였다. X-선 회절 분석을 행한 결과, 모든 시편에서 ZnO (002) 피크만이 관찰되었으며, 박막의 열처리 온도가 증가함에 따라 (002) 피크 강도가 증가하였다. 박막의 표면 미세 구조는 매우 균질하였으며, 입자들 간의 응집은 관찰되지 않았다. 박막의 topology를 주사형 탐침 현미경으로 분석한 결과에 따르면, 실리카 기판 자체의 불균질한 표면 특성과 ZnO 입자의 c축 배향 특성에 의한 것으로 보이는 3차원적인 입자성장이 모든 열처리 온도 영역에 대해 박막의 표면에서 관찰되었다. 고배향된 박막들 중에서 $800^{\circ}C$로 열처리한 박막의 표면이 가장 균질한 특성을 나타내었다. 박막의 가시영역에서의 투과율은 $1000^{\circ}C$로 열처리한 박막을 제외하고 모든 박막에 있어서 80% 이상의 투과율을 나타냈으며, 380~400nm 영역에서 날카로운 absorption edge가 나타났다. 흡수피크를 이용하여 계산된 오든 박막의 에너지 밴드 캡은 ZnO 단결정 및 다른 연구자들에 의해 보고된 박막과 같은 영역에 존재하였다. 본 연구에서 제조된 ZnO 박막들 중에 치밀한 입자 성장과 균질한 표면 특성을 보이는 $600^{\circ}C{\sim}800^{\circ}C$로 열처리된 박막은 UV차단성 투명전도막 및 렌즈 등의 광학소자에 실질적인 응용이 기대 된다.

• 폴리머
• /
• 제37권4호
• /
• pp.486-493
• /
• 2013

고분자 색전 코일을 제조하기 위하여 교대배열 PVA(s-PVA) 용액을 제조하고 젤방사 조건의 최적화를 위해 고분자용액의 유변학적 특성을 분석하였다. 현탁중합을 통해 비누화도 99%, 교대배열기 함량 56%인 s-PVA를 제조하였고 고분자 용액의 농도에 따른 점도 변화 측정을 통해 최적의 방사농도를 13 wt%로 선정하였다. S-PVA 젤 섬유의 연신비에 따른 구조, 형태, 인장 특성을 측정하였다. S-PVA 젤 섬유의 연신비가 증가함에 따라 인장강도가 증가하였고, 최대 연신비인 15배 연신하였을 때 인장강도는 580 MPa이었고 절단신도는 연신비가 증가함에 따라 감소하는 경향을 나타냈다. S-PVA 젤 섬유는 연신비에 따라 결정구조가 발달하고 배향도가 증가하는 경향을 나타내었다. 색전 코일 제조 시의 열처리온도에 따른 코일의 형태 안정성을 살펴 본 결과 열처리온도가 높을수록 코일의 형태안정성이 우수하였으며 금속 색전 코일로 제조되는 1차 코일 및 2차 코일 형태를 s-PVA 섬유를 이용해 제조하였고 이를 통해 금속 색전 코일의 고분자로의 대체 가능성을 확인하였다.