• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.464-465
• /
• 2009

A new level shifter using n-channel aluminum-doped zinc tin oxide (AZTO) thin film transistors (TFTs) was proposed to integrate driving circuits on qVGA panels for mobile display applications. The circuit used positive feedback loop to overcome limitations of circuits designed with oxide TFTs which is depletion mode n-channel TFTs. The measured results shows that the proposed circuit shifts 10 V input voltage to 20 V output voltage and its power consumption is 0.46 mW when the supply voltage is 20 V and the operating frequency is 10 kHz.

• Proceedings of the KIEE Conference
• /
• 1993.07b
• /
• pp.1250-1252
• /
• 1993

Enhancement mode n-channel TFT leakage current(off current : $V_G<0$) that is little agreement on the conduction mechanism is major disadvantage of poly-silicon TFT in practical use, characteristic analysis and model ing. In this paper, new modeling of leakage current is proposed. The activation energy of leakage current, which is dependent on gate voltage, and leakage current dependent on poly silicon thickness are plausibly explained with this model. This model indicate that the reduction of leakage current is attributable to a decrease of maximum laterial electric field strength in the drain depletion region and to the density of trap.

• Transactions on Electrical and Electronic Materials
• /
• v.18 no.5
• /
• pp.250-252
• /
• 2017

High-performance full swing logic inverters were fabricated using amorphous 1 wt% Si doped indium-zinc-oxide (a-SIZO) thin films with different channel layer thicknesses. In the inverter configuration, the threshold voltage was adjusted by varying the thickness of the channel layer. The depletion mode (D-mode) device used a TFT with a channel layer thickness of 60 nm as it exhibited the most negative threshold voltage (-1.67 V). Inverters using enhancement mode (E-mode) devices were fabricated using TFTs with channel layer thicknesses of 20 or 40 nm with excellent subthreshold slope (S.S). Both the inverters exhibited high voltage gain values of 30.74 and 28.56, respectively at $V_{DD}=15V$. It was confirmed that the voltage gain can be improved by increasing the S.S value.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.311-311
• /
• 2016

최근 고성능 디스플레이 개발이 요구되면서 기존 비정질 실리콘(a-Si)을 대체할 산화물 반도체에 대한 연구 관심이 급증하고 있다. 여러 종류의 산화물 반도체 중 a-IGZO (amorphous indium-gallium-zinc oxide)가 높은 전계효과 이동도, 저온 공정, 넓은 밴드갭으로 인한 투명성 등의 장점을 가지며 가장 연구가 활발하게 보고되고 있다. 기존에는 SG(단일 게이트) TFT가 주로 제작 되었지만 본 연구에서는 DG(이중 게이트) 구조를 적용하여 고성능의 a-IGZO 기반 박막 트랜지스터(TFT)를 구현하였다. SG mode에서는 하나의 게이트가 채널 전체 영역을 제어하지만, double gate mode에서는 상, 하부 두 개의 게이트가 동시에 채널 영역을 제어하기 때문에 채널층의 형성이 빠르게 이루어지고, 이는 TFT 스위칭 속도를 향상시킨다. 또한, 상호 모듈레이션 효과로 인해 S.S(subthreshold swing)값이 낮아질 뿐만 아니라, 상(TG), 하부 게이트(BG) 절연막의 계면 산란 현상이 줄어들기 때문에 이동도가 향상되고 누설전류 감소 및 안정성이 향상되는 효과를 얻을 수 있다. Dual gate mode로 동작을 시키면, TG(BG)에는 일정한 positive(or negative)전압을 인가하면서 BG(TG)에 전압을 가해주게 된다. 이 때, 소자의 채널층은 depletion(or enhancement) mode로 동작하여 다른 전기적인 특성에는 영향을 미치지 않으면서 문턱 전압을 쉽게 조절 할 수 있는 장점도 있다. 제작된 소자는 p-type bulk silicon 위에 thermal SiO2 산화막이 100 nm 형성된 기판을 사용하였다. 표준 RCA 클리닝을 진행한 후 BG 형성을 위해 150 nm 두께의 ITO를 증착하고, BG 절연막으로 두께의 SiO2를 300 nm 증착하였다. 이 후, 채널층 형성을 위하여 50 nm 두께의 a-IGZO를 증착하였고, 소스/드레인(S/D) 전극은 BG와 동일한 조건으로 ITO 100 nm를 증착하였다. TG 절연막은 BG 절연막과 동일한 조건에서 SiO2를 50 nm 증착하였다. TG는 S/D 증착 조건과 동일한 조건에서, 150 nm 두께로 증착 하였다. 전극 물질과, 절연막 물질은 모두 RF magnetron sputter를 이용하여 증착되었고, 또한 모든 patterning 과정은 표준 photolithography, wet etching, lift-off 공정을 통하여 이루어졌다. 후속 열처리 공정으로 퍼니스에서 질소 가스 분위기, $300^{\circ}C$ 온도에서 30 분 동안 진행하였다. 결과적으로 $9.06cm2/V{\cdot}s$, 255.7 mV/dec, $1.8{\times}106$의 전계효과 이동도, S.S, on-off ratio값을 갖는 SG와 비교하여 double gate mode에서는 $51.3cm2/V{\cdot}s$, 110.7 mV/dec, $3.2{\times}108$의 값을 나타내며 훌륭한 전기적 특성을 보였고, dual gate mode에서는 약 5.22의 coupling ratio를 나타내었다. 따라서 산화물 반도체 a-IGZO TFT의 이중게이트 구조는 우수한 전기적 특성을 나타내며 차세대 디스플레이 시장에서 훌륭한 역할을 할 것으로 기대된다.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.49 no.2
• /
• pp.15-22
• /
• 2012

A low power consumption scan driver using depletion-mode n-type InGaZnO thin-film transistors is proposed. The proposed circuit uses 2 clock signals and generates the non-overlap output signals without the additional masking signals and circuits. The power consumption of the proposed circuit is decreased by reducing the number of the clock signals and short circuit current. The simulation results show that the proposed circuit operates successfully when the threshold voltage of TFT is varied from -3.0V to 1.0V. The proposed scan driver consumes 4.89mW when the positive and negative supply voltage is 15V and -5V, respectively, and the operating frequency is 46KHz on the XGA resolution panel.

• Journal of the Korean Vacuum Society
• /
• v.16 no.5
• /
• pp.359-365
• /
• 2007

In this paper we present a bottom-gate type of zinc oxide (ZnO) and Gallium (Ga) doped zinc oxide (GZO) based thin film transistors (TFTs) through applying a radio frequency (RF) magnetron sputtering method at room temperature. The gate leakage current can be reduced up to several ph by applying $SiO_2$ thermally grown instead of using new gate oxide materials. The root mean square (RMS) values of the ZnO and GZO film surface were measured as 1.07 nm and 1.65 nm, respectively. Also, the transmittances of the ZnO and GZO film were more than 80% and 75%, respectively, and they were changed as their film thickness. The ZnO and GZO film had a wurtzite structure that was arranged well as a (002) orientation. The ZnO TFT had a threshold voltage of 2.5 V, a field effect mobility of $0.027\;cm^2/(V{\cdot}s)$, a on/off ratio of $10^4$, a gate voltage swing of 17 V/decade and it operated in a enhancement mode. In case of the GZO TFT, it operated in a depletion mode with a threshold voltage of -3.4 V, a field effect mobility of $0.023\;cm^2/(V{\cdot}s)$, a on/off ratio of $2{\times}10^4$ and a gate voltage swing of 3.3 V/decade. We successfully demonstrated that the TFTs with the enhancement and depletion mode type can be fabricated by using pure ZnO and 1wt% Ga-doped ZnO.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.49 no.1
• /
• pp.1-7
• /
• 2012

We have developed a new gate driver circuit for liquid crystal displays using oxide thin-film transistors (TFTs). In the new gate driver, negative gate bias is applied to turn off the oxide TFTs because the oxide TFT occasionally has negative threshold voltage (VT). In addition, we employed three parallel pull-down TFTs that are turned on in turns to enhance the stability. SPICE simulation showed that the proposed circuit worked successfully covering the VT range of -3 V ~ +6 V And fabrication results confirmed stable operation of the new circuit using oxide TFTs.