• Journal of the Korean Institute of Telematics and Electronics
• /
• v.15 no.1
• /
• pp.5-11
• /
• 1978

Si-ZnSe n-n heterojunction was made by growing ZnSe thin film on the Si single crystal (111) surface with Bash evaporating method in vacuum. This heterojunction was found to be a useful device for frequency meter in the visible wave-length from the measuring of the photovoltaic effect of the heterojunction.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.13 no.2
• /
• pp.23-27
• /
• 1976

$Si{\cdot}SnO_{2}$ heterojunction was prepared by oxidzing at oxygen atmosphere $SnO_{2-X}$ Which made by Flith evaporation of $SnO_{2}$ powder on III surface of p and n type Si single crystals. The energy band Profile of $Si{\cdot}SnO_{2}$ heterojunction was depicted from its physical properties. This heterojunction was very good rectifying junction, very sensitive in spectral response of Photovoltage at from 400nm to 1200nm, and -10$^{18}$sec of time contant. From above properties, this heterojunction was found ps good high speed photovoltaic device and solar cell.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2022.11a
• /
• pp.181-182
• /
• 2022

The properties of cement mortar with nano-heterojunction photocatalysts were investigated in this study. The following tests were conducted with the cement mortar : (1) Flow test of fresh cement mortar, (2) compressive strength and (3) acetaldehyde removal efficiency under visible light. Results indicated that the cement mortar with nano-heterojunction photocatalysts showed higher compressive strength and higher acetaldehyde removal efficiency as the mixing ratio of nano-heterojunction increased.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.12 no.4
• /
• pp.35-40
• /
• 1975

The Zn7e-lnSb heterojunctions was prepared by interface alloying technique. The structure of this beterojunction had p-i-n which semi-insulating ZnTe laver at interface of this heterojunction was formed by diffusing In of InSb into ZnTe crystal. The current transport mechanism of this heterojunction was Spacecharge-Limited-Current(SCLC) mechanism by hole at semi-insulating ZnTe layer. The hole wart injected from valence band of p- type SnTe crystal. Orange color electroluminescence was observed at this heterojunction when forward and reversed bias voltage applied.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.209-209
• /
• 2012

High-efficient transparent conductive oxide (TCO) film-embedding Si heterojunction solar cells were fabricated. An additional doping was not applied for heterojunction solar cells due to the spontaneous junction formation between TCO films and an n-type Si substrate. Three different TCO coatings were formed by sputtering method for an Al-doped ZnO (AZO) film, an indium-tin-oxide (ITO) film and double stacks of ITO/AZO films. An improved crystalline ITO film was grown on an AZO template upon hetero-epitaxial growth. This double TCO films-embedding Si heterojunction solar cell provided significantly enhanced efficiency of 9.23% as compared to the single TCO/Si devices. The effective arrangement of TCO films (ITO/AZO) provides benefits of a lower front contact resistance and a smaller band offset to Si leading enhanced photovoltaic performances. This demonstrates a potential scheme of the effective TCO film-embedding heterojunction Si solar cells.

• Current Optics and Photonics
• /
• v.6 no.4
• /
• pp.367-374
• /
• 2022

A photodetector based on a reduced graphene oxide (RGO)/n-Si heterojunction with high responsivity, detectivity and fast response speed is presented. Here, we put forward a simple vacuum filtration method to prepare RGO film and transfer it onto an n-Si substrate to form an RGO/n-Si heterojunction. The experimental results show that the heterojunction has good rectification characteristics, and the response and recovery time are less than 0.31 s and 0.25 s, respectively. Under 470 nm light conditions at -2 V applied voltage, the responsivity and detectivity of the device are 65 mA/W and 4.02 × 10¹⁰ cmHz^1/2W^-1, respectively. The simple preparation process and good performance of the RGO/n-Si heterojunction make it a promising material for photoelectric detection, especially in the near-ultraviolet band.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.1332_1333
• /
• 2009

The electrical properties of an inorganic/organic heterojunction has been investigated by spin coating the p-type polymer poly(3,4 ethylenedioxythiophene) : poly(styrenesulfonate) (PEDOT:PSS) on an n-type gallium doping zinc oxide (GZO) film. Current-voltage (I-V) characteristics of the fabricated heterojunction diodes have a good rectifying characteristics. The barrier height is calculated 0.8 eV.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.30A no.3
• /
• pp.88-94
• /
• 1993

In this paper, a simple Ebers-Moll Model for the heterojunction bipolar transistor is presented. Using the model structure for the npn type HBT, the current-voltage characteristics was analyzed. And from the obtained terminal currents, the Ebers-Moll equations were derived. Then substituting the physical parameters for heterojunction to those for homojunction, this model would be used to analyze the characteristics of single and/or duble heterojunction HBT's. And directly relating model parameters to device parameters, it would be also used to optimize the characteristics of HBT's. The simulated results using this model were in good agreement with experimental data.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.6
• /
• pp.1349-1354
• /
• 2011

In this work, we fabricated the CdZnS/CdTe heterojunction and investigated the C-V characteristics to determine the depletion width and the charge density distribution. A parallel experiment on CdS/CdTe heterojunction was also carried out for comparison. The depletion region width, for CdZnS/CdTe heterojunction, was nearly constant, regardless of bias voltage. However, the depletion region was wider than that of CdS/CdTe heterojunction due to high resistivity of CdZnS film. The interface charge density of CdZnS/CdTe heterojunction was increased linearly with the bias voltage and showed lower values than those for CdS/CdTe junction. The open circuit voltage of CdZnS/CdTe heterojunction solar cells increased with zinc mole ratio due to reducing of the electron affinity difference between CdZnS and CdTe films. However, the increase of series resistance due to the high resistivity of Cd1-xZnxS films results in reducing conversion efficiency.

• Journal of the Semiconductor & Display Technology
• /
• v.19 no.2
• /
• pp.55-59
• /
• 2020

Copper Oxide (CuO) films were deposited on the n-type silicon wafer by rf magnetron sputtering for heterojunction solar cells. And then the samples were treated as a function of the annealing temperature (300-600℃) in a vacuum. Their electrical, optical and structural properties of the fabricated heterojunction solar cells were then investigated and the power conversion efficiencies (PCE) of the fabricated p-type copper oxide/n-type Si heterojunction cells were measured using solar simulator. After being treated at temperature of 500℃, the solar cells with CuO film have PCE of 0.43%, Current density of 5.37mA/㎠, Fill Factor of 39.82%.